Peter M. Farrell
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Peter M. Farrell has a total of 199 co-authors. Here are the top co-authors by number of shared publications:
Bill Moran
RMIT University, Melbourne, VIC, Australia
13 shared publications- Greg Baxter
Optical Technology Research Laboratory, College of Engineering and Science, Victoria University, P.O. Box 14428, Melbourne, VIC 8001, Australia
13 shared publications Kerry Hinton
ARC Special Research Centre for Ultra-Broadband Information Networks, Australia
11 shared publications- Leigh A. Johnston
Graeme Clark Institute The University of Melbourne Parkville Victoria Australia
11 shared publications - Malka. N. Halgamuge
RMIT University, Melbourne, VIC, Australia
8 shared publications Sarah D. Dods
Dept. of Electr. & Electron. Eng., Univ. of Melbourne, Melbourne, VIC
8 shared publications
Latest Publications
- Open Access
- 1 August 2022
- Published by AIP Publishing in APL Photonics
- Vol. 7 (8) , 086106
High bandwidth frequency modulation of an external cavity diode laser using an intracavity lithium niobate electro-optic modulator as output coupler
We present a novel approach to high bandwidth laser frequency modulation. A lithium niobate chip is used as an intracavity electro-optic modulator in a tunable cateye external cavity diode laser. The modulator is conveniently integrated with the cateye output coupler, providing a unique approach to high bandwidth frequency stabilization and linewidth narrowing. The intracavity modulator feedback was successfully operated below 1 V and achieved superior frequency noise suppression compared to conventional feedback through diode injection current modulation. A closed loop bandwidth of 1.8 MHz was demonstrated, and the laser linewidth reduced to around 1 Hz as measured by the heterodyne measurement.
- 1 August 2022
- Published by AIP Publishing in APL Photonics
- Vol. 7 (8) , 086106
Open AccessHigh bandwidth frequency modulation of an external cavity diode laser using an intracavity lithium niobate electro-optic modulator as output coupler
We present a novel approach to high bandwidth laser frequency modulation. A lithium niobate chip is used as an intracavity electro-optic modulator in a tunable cateye external cavity diode laser. The modulator is conveniently integrated with the cateye output coupler, providing a unique approach to high bandwidth frequency stabilization and linewidth narrowing. The intracavity modulator feedback was successfully operated below 1 V and achieved superior frequency noise suppression compared to conventional feedback through diode injection current modulation. A closed loop bandwidth of 1.8 MHz was demonstrated, and the laser linewidth reduced to around 1 Hz as measured by the heterodyne measurement.
- 1 January 2018
- Published by Elsevier
Contributors
- 1 January 2018
- Published by Elsevier
- p. 317-363
Millimeter-wave integrated radar systems and techniques
- 1 January 2018
- Published by Elsevier
- p. 317-363
Millimeter-wave integrated radar systems and techniques
- 1 March 2017
- Published by Elsevier in Biomedical Signal Processing and Control
- Vol. 33, 422-428
NMR spectroscopy using Rabi modulated continuous wave excitation
- 1 March 2017
- Published by Elsevier in Biomedical Signal Processing and Control
- Vol. 33, 422-428
NMR spectroscopy using Rabi modulated continuous wave excitation
- 1 February 2014
- Published by Elsevier in Optics Communications
- Vol. 313, 256-262
Normal vector based dynamic laser speckle analysis for plant water status monitoring
- 1 February 2014
- Published by Elsevier in Optics Communications
- Vol. 313, 256-262
Normal vector based dynamic laser speckle analysis for plant water status monitoring
- 10 October 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 14 (2) , 538-546
On the Utility of Dielectric Spectroscopy Techniques to Identify Compounds and Estimate Concentrations of Binary Mixtures
An important question is whether it is possible to build a sensor to identify the constituents and estimate their volume fractions in a mixture. In this paper, frequency dependent permittivity measured from dielectric sensors was used to identify both chemical species and their volume fractions of binary mixtures. Our analysis using the data presented in the literature and on-chip coplanar waveguide measurements, in 1-30 GHz range, illustrates that complex permittivity measurements are sufficient to estimate the volume fractions when the constituents of the mixture are known. Changes in concentrations are required to identify the constituent chemicals of binary mixtures when the constituents are unknown. Additional information, such as nonlinear dielectric properties, is required to identify constituents and volume fractions in mixtures with many chemical species.
- 10 October 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 14 (2) , 538-546
On the Utility of Dielectric Spectroscopy Techniques to Identify Compounds and Estimate Concentrations of Binary Mixtures
An important question is whether it is possible to build a sensor to identify the constituents and estimate their volume fractions in a mixture. In this paper, frequency dependent permittivity measured from dielectric sensors was used to identify both chemical species and their volume fractions of binary mixtures. Our analysis using the data presented in the literature and on-chip coplanar waveguide measurements, in 1-30 GHz range, illustrates that complex permittivity measurements are sufficient to estimate the volume fractions when the constituents of the mixture are known. Changes in concentrations are required to identify the constituent chemicals of binary mixtures when the constituents are unknown. Additional information, such as nonlinear dielectric properties, is required to identify constituents and volume fractions in mixtures with many chemical species.
- 1 September 2013
- Published by Elsevier in Optics Communications
- Vol. 305, 27-35
Dynamic laser speckle analysis via normal vector space statistics
- 1 September 2013
- Published by Elsevier in Optics Communications
- Vol. 305, 27-35
Dynamic laser speckle analysis via normal vector space statistics
- 1 September 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 21-26
Consumer radar: Technology and limitations
Recent advances in micro-electronics have created the possibility of building very low cost, very small, high performance single chip Radar systems. Concurrent with this technological advance, a diverse range of new applications for such radar systems is emerging. The coming consumer radar revolution is on the verge of entering the market place in areas including automotive radar, bicycle radar, micro-UAV radar, and many other applications. This short paper briefly describes the current state of the technology covering RF, signal processing and antenna systems. We also introduce recent work on performance limitations of such systems including radar information theory and its connections with quantum mechanics.
- 1 September 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 21-26
Consumer radar: Technology and limitations
Recent advances in micro-electronics have created the possibility of building very low cost, very small, high performance single chip Radar systems. Concurrent with this technological advance, a diverse range of new applications for such radar systems is emerging. The coming consumer radar revolution is on the verge of entering the market place in areas including automotive radar, bicycle radar, micro-UAV radar, and many other applications. This short paper briefly describes the current state of the technology covering RF, signal processing and antenna systems. We also introduce recent work on performance limitations of such systems including radar information theory and its connections with quantum mechanics.
- Open Access
- 8 May 2013
- Published by Springer Nature in Scientific Reports
- Vol. 3 (1) , srep01796-5
An ab-initio Computational Method to Determine Dielectric Properties of Biological Materials
Frequency dependent dielectric properties are important for understanding the structure and dynamics of biological materials. These properties can be used to study underlying biological processes such as changes in the concentration of biological materials, and the formation of chemical species. Computer simulations can be used to determine dielectric properties and atomic details inaccessible via experimental methods. In this paper, a unified theory utilizing molecular dynamics and density functional theory is presented that is able to determine the frequency dependent dielectric properties of biological materials in an aqueous solution from their molecular structure alone. The proposed method, which uses reaction field approximations, does not require a prior knowledge of the static dielectric constant of the material. The dielectric properties obtained from our method agree well with experimental values presented in the literature.
- 8 May 2013
- Published by Springer Nature in Scientific Reports
- Vol. 3 (1) , srep01796-5
Open AccessAn ab-initio Computational Method to Determine Dielectric Properties of Biological Materials
Frequency dependent dielectric properties are important for understanding the structure and dynamics of biological materials. These properties can be used to study underlying biological processes such as changes in the concentration of biological materials, and the formation of chemical species. Computer simulations can be used to determine dielectric properties and atomic details inaccessible via experimental methods. In this paper, a unified theory utilizing molecular dynamics and density functional theory is presented that is able to determine the frequency dependent dielectric properties of biological materials in an aqueous solution from their molecular structure alone. The proposed method, which uses reaction field approximations, does not require a prior knowledge of the static dielectric constant of the material. The dielectric properties obtained from our method agree well with experimental values presented in the literature.