Mohsin Saleemi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mohsin Saleemi has a total of 65 co-authors. Here are the top co-authors by number of shared publications:
- Muhammet Sadaka Toprak
KTH Royal Institute of Technology
21 shared publications Mamoun Muhammed
Department of Materials and Nano Physics, KTH Royal Institute of Technology, 16440 Kista Stockholm, Sweden
8 shared publications- Nader Nikkam
KTH Royal Institute of Technology
8 shared publications M. Muhammed
7 shared publications- Mats Johnsson
Department of Chemistry Stockholm University Stockholm Sweden
7 shared publications Rahmatollah Khodabandeh
6 shared publications
Latest Publications
- 2 February 2016
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 55 (4) , 1831-1836
Chemical Synthesis of Iron Antimonide (FeSb2) and Its Thermoelectric Properties
Low temperature thermoelectric (TE) materials are in demand for more efficient cooling and power generation applications. Iron antimonide (FeSb2) draws great attention over the past few years because of its enhanced power factor values. Polycrystalline bulk FeSb2 nanopowder was prepared via a low-temperature molten salts approach followed by subsequent thermal treatment in synthetic air and hydrogen gas for calcination and reduction reactions, respectively. Structural analysis confirms the desired final phase with submicrometer grain size and high compaction density after consolidation using spark plasma sintering (SPS). TE transport properties revealed that the material is n-type below 150 K and p-type above this temperature; this suggests antimony vacancies in FeSb2. The electrical conductivity increased significantly, and the highest conductivity achieved was 6000 S/cm at 100 K. The maximum figure-of-merit, ZT, of 0.04 is achieved at 500 K, which is about 6 times higher than the earlier reported state-of-the art ZT value for the same material.
- 2 February 2016
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 55 (4) , 1831-1836
Chemical Synthesis of Iron Antimonide (FeSb2) and Its Thermoelectric Properties
Low temperature thermoelectric (TE) materials are in demand for more efficient cooling and power generation applications. Iron antimonide (FeSb2) draws great attention over the past few years because of its enhanced power factor values. Polycrystalline bulk FeSb2 nanopowder was prepared via a low-temperature molten salts approach followed by subsequent thermal treatment in synthetic air and hydrogen gas for calcination and reduction reactions, respectively. Structural analysis confirms the desired final phase with submicrometer grain size and high compaction density after consolidation using spark plasma sintering (SPS). TE transport properties revealed that the material is n-type below 150 K and p-type above this temperature; this suggests antimony vacancies in FeSb2. The electrical conductivity increased significantly, and the highest conductivity achieved was 6000 S/cm at 100 K. The maximum figure-of-merit, ZT, of 0.04 is achieved at 500 K, which is about 6 times higher than the earlier reported state-of-the art ZT value for the same material.
- Open Access
- 1 January 2015
- Published by Wiley in Journal of Nanomaterials
- Vol. 2015 (1)
Classical Behavior of Alumina (Al2O3) Nanofluids in Antifrogen N with Experimental Evidence
A nanofluid is a suspension containing nanoparticles in conventional heat transfer fluids. This paper reports on an investigation of alumina (Al2O3) nanoparticles in Antifrogen N, also called AFN, which is a popular antifreeze coolant consisting primarily of ethylene glycol and other additives to impede corrosion. The base carrier fluid is 50% by weight of water and 50% by weight of AFN. We systematically measured the nanomaterials and heat transfer data of nanofluids for four different size particles, namely, 20, 40, 150, and 250 nm alumina particles. The pH of all the nanofluids is adjusted to have a stable dispersion. The material characterizations include SEM and DLS particle measurements. We measured thermal conductivity, viscosity, and heat transfer coefficient in developing flow of the nanofluids. We observed that these nanofluids behave as any other classical fluids in thermally developing flow and classical heat transfer correlations can be used to completely describe the characteristics of these nanofluids.
- 1 January 2015
- Published by Wiley in Journal of Nanomaterials
- Vol. 2015 (1)
Open AccessClassical Behavior of Alumina (Al2O3) Nanofluids in Antifrogen N with Experimental Evidence
A nanofluid is a suspension containing nanoparticles in conventional heat transfer fluids. This paper reports on an investigation of alumina (Al2O3) nanoparticles in Antifrogen N, also called AFN, which is a popular antifreeze coolant consisting primarily of ethylene glycol and other additives to impede corrosion. The base carrier fluid is 50% by weight of water and 50% by weight of AFN. We systematically measured the nanomaterials and heat transfer data of nanofluids for four different size particles, namely, 20, 40, 150, and 250 nm alumina particles. The pH of all the nanofluids is adjusted to have a stable dispersion. The material characterizations include SEM and DLS particle measurements. We measured thermal conductivity, viscosity, and heat transfer coefficient in developing flow of the nanofluids. We observed that these nanofluids behave as any other classical fluids in thermally developing flow and classical heat transfer correlations can be used to completely describe the characteristics of these nanofluids.
- 1 November 2014
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 612, 293-300
Fabrication, spark plasma consolidation, and thermoelectric evaluation of nanostructured CoSb3
- 1 November 2014
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 612, 293-300
Fabrication, spark plasma consolidation, and thermoelectric evaluation of nanostructured CoSb3
- Open Access
- 1 April 2014
- Published by Elsevier in Applied Thermal Engineering
- Vol. 65 (1-2) , 158-165
Experimental investigation on thermo-physical properties of copper/diethylene glycol nanofluids fabricated via microwave-assisted route
- 1 April 2014
- Published by Elsevier in Applied Thermal Engineering
- Vol. 65 (1-2) , 158-165
Open AccessExperimental investigation on thermo-physical properties of copper/diethylene glycol nanofluids fabricated via microwave-assisted route
- Open Access
- 20 March 2014
- Published by Springer Nature in Nano-Micro Letters
- Vol. 6 (2) , 178-189
Fabrication, Characterization and Thermo-physical Property Evaluation of SiC Nanofluids for Heat Transfer Applications
Nanofluids (NFs) are nanotechnology-based colloidal suspensions fabricated by suspending nanoparticles (NPs) in a base liquid. These fluids have shown potential to improve the heat transfer properties of conventional heat transfer fluids. In this study we report in detail on fabrication, characterization and thermo-physical property evaluation of SiC NFs, prepared using SiC NPs with different crystal structures, for heat transfer applications. For this purpose, a series of SiC NFs containing SiC NPs with different crystal structure (α-SiC and β-SiC) were fabricated in a water (W)/ethylene glycol (EG) mixture (50/50 wt% ratio). Physicochemical properties of NPs/NFs were characterized by using various techniques, such as powder X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Fouriertransform infrared spectroscopy (FTIR), dynamic light scattering (DLS) and Zeta potential analysis. Thermo-physical properties including thermal conductivity (TC) and viscosity for NFs containing SiC particles (α- and β- phase) weremeasured. The results show among all suspensions NFs fabricated with α-SiC particles have more favorable thermo-physical properties compared to the NFs fabricated with β-SiC.The observed difference is attributed to combination of several factors, including crystal structure (β- vs. α-), sample purity, and residual chemicals exhibited on SiCNFs. A TC enhancement of ∼20% while 14% increased viscosity were obtained for NFs containing 9 wt% of particular type of α-SiC NPs indicating promising capability of this kind of NFs for further heat transfer characteristics investigation.
- 20 March 2014
- Published by Springer Nature in Nano-Micro Letters
- Vol. 6 (2) , 178-189
Open AccessFabrication, Characterization and Thermo-physical Property Evaluation of SiC Nanofluids for Heat Transfer Applications
Nanofluids (NFs) are nanotechnology-based colloidal suspensions fabricated by suspending nanoparticles (NPs) in a base liquid. These fluids have shown potential to improve the heat transfer properties of conventional heat transfer fluids. In this study we report in detail on fabrication, characterization and thermo-physical property evaluation of SiC NFs, prepared using SiC NPs with different crystal structures, for heat transfer applications. For this purpose, a series of SiC NFs containing SiC NPs with different crystal structure (α-SiC and β-SiC) were fabricated in a water (W)/ethylene glycol (EG) mixture (50/50 wt% ratio). Physicochemical properties of NPs/NFs were characterized by using various techniques, such as powder X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Fouriertransform infrared spectroscopy (FTIR), dynamic light scattering (DLS) and Zeta potential analysis. Thermo-physical properties including thermal conductivity (TC) and viscosity for NFs containing SiC particles (α- and β- phase) weremeasured. The results show among all suspensions NFs fabricated with α-SiC particles have more favorable thermo-physical properties compared to the NFs fabricated with β-SiC.The observed difference is attributed to combination of several factors, including crystal structure (β- vs. α-), sample purity, and residual chemicals exhibited on SiCNFs. A TC enhancement of ∼20% while 14% increased viscosity were obtained for NFs containing 9 wt% of particular type of α-SiC NPs indicating promising capability of this kind of NFs for further heat transfer characteristics investigation.
- 1 March 2014
- Published by Elsevier in International Communications in Heat and Mass Transfer
- Vol. 52, 1-7
Accurate basis of comparison for convective heat transfer in nanofluids
- 1 March 2014
- Published by Elsevier in International Communications in Heat and Mass Transfer
- Vol. 52, 1-7
Accurate basis of comparison for convective heat transfer in nanofluids
- 13 February 2014
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 43 (6) , 2301-2306
Effect of Synthesis and Sintering Conditions on the Thermoelectric Properties of n-Doped Mg2Si
- 13 February 2014
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 43 (6) , 2301-2306
Effect of Synthesis and Sintering Conditions on the Thermoelectric Properties of n-Doped Mg2Si
- 23 November 2013
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 43 (6) , 1927-1932
Evaluation of the Structure and Transport Properties of Nanostructured Antimony Telluride (Sb2Te3)
- 23 November 2013
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 43 (6) , 1927-1932
Evaluation of the Structure and Transport Properties of Nanostructured Antimony Telluride (Sb2Te3)
- 1 September 2013
- Published by Elsevier in Experimental Thermal and Fluid Science
- Vol. 49, 114-122
Cooling performance of nanofluids in a small diameter tube
- 1 September 2013
- Published by Elsevier in Experimental Thermal and Fluid Science
- Vol. 49, 114-122
Cooling performance of nanofluids in a small diameter tube