SMSheila McBreen

Sheila McBreen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Sheila McBreen has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    GRB 221009A: The B.O.A.T. Burst that Shines in Gamma Rays

    by M. Axelsson, M. Ajello, M. Arimoto, L. Baldini, J. Ballet, M. G. Baring, C. Bartolini, D. Bastieri, J. Becerra Gonzalez, R. Bellazzini, et al.

    We present a complete analysis of Fermi Large Area Telescope (LAT) data of GRB 221009A, the brightest gamma-ray burst (GRB) ever detected. The burst emission above 30 MeV detected by the LAT preceded, by 1 s, the low-energy (<10 MeV) pulse that triggered the Fermi Gamma-Ray Burst Monitor (GBM), as has been observed in other GRBs. The prompt phase of GRB 221009A lasted a few hundred seconds. It was so bright that we identify a bad time interval of 64 s caused by the extremely high flux of hard X-rays and soft gamma rays, during which the event reconstruction efficiency was poor and the dead time fraction quite high. The late-time emission decayed as a power law, but the extrapolation of the late-time emission during the first 450 s suggests that the afterglow started during the prompt emission. We also found that high-energy events observed by the LAT are incompatible with synchrotron origin, and, during the prompt emission, are more likely related to an extra component identified as synchrotron self-Compton (SSC). A remarkable 400 GeV photon, detected by the LAT 33 ks after the GBM trigger and directionally consistent with the location of GRB 221009A, is hard to explain as a product of SSC or TeV electromagnetic cascades, and the process responsible for its origin is uncertain. Because of its proximity and energetic nature, GRB 221009A is an extremely rare event.


  • Open Access

    Fermi-GBM Team Analysis on The Ravasio Line

    by Eric Burns, Stephen Lesage, Adam Goldstein, Michael S. Briggs, Peter Veres, Suman Bala, Cuan de Barra, Elisabetta Bissaldi, William H Cleveland, Misty M Giles, et al.

    The prompt spectra of gamma-ray bursts are known to follow broadband continuum behavior over decades in energy. GRB 221009A, given the moniker the brightest of all time (BOAT), is the brightest gamma-ray burst identified in half a century of observations, and was first identified by the Fermi Gamma-ray Burst Monitor (GBM). On behalf of the Fermi-GBM Team, Lesage et al. (2023) described the initial GBM analysis. Ravasio et al. (2024) report the identification of a spectral line in part of the prompt emission of this burst, which they describe as evolving over 80 s from $\sim$12 MeV to 6 MeV. We report a GBM Team analysis on the Ravasio Line: 1) We cannot identify an instrumental effect that could have produced this signal, and 2) our method of calculating the statistical significance of the line shows it easily exceeds the 5$σ$ discovery threshold. We additionally comment on the claim of the line beginning at earlier time intervals, up to 37 MeV, as reported in Zhang et al. (2024). We find that it is reasonable to utilize these measurements for characterization of the line evolution, with caution. We encourage theoretical studies exploring this newly discovered gamma-ray burst spectral feature, unless any rigorous alternative explanation unrelated to the emission from GRB 221009A is identified.

  • Open Access

    Ground-Based Characterisation of a Compact Instrument for Gamma-ray Burst Detection on a CubeSat Platform

    by Rachel Dunwoody, David Murphy, Alexey Uliyanov, Joseph Mangan, Maeve Doyle, Joseph Thompson, Cuan de Barra, Lorraine Hanlon, David McKeown, Brian Shortt, et al.

    Gamma-ray bursts (GRBs) are intense and short-lived cosmic explosions. Miniaturised CubeSat-compatible instruments for the study of GRBs are being developed to help bridge the gap in large missions and assist in achieving full sky coverage. CubeSats are small, compact satellites conforming to a design standard and have transformed the space industry. They are relatively low-cost and are developed on fast timescales, which has provided unparalleled access to space. This paper focuses on GMOD, the gamma-ray module, onboard the 2U CubeSat EIRSAT-1, launched on December 1st 2023. GMOD is a scintillation-based instrument with a cerium bromide crystal coupled to an array of sixteen silicon photomultipliers, designed for the detection of GRBs. The characterisation of GMOD in the spacecraft, along with the validation of an updated spacecraft MEGAlib model is presented and this approach can be followed by other CubeSats with similar science goals. The energy resolution of the flight model is 7.07% at 662 keV and the effective area peaks in the tens to hundreds of keV, making it a suitable instrument for the detection of GRBs. An investigation into the instrument’s angular response is also detailed. The results from this characterisation campaign are a benchmark for the instrument’s performance pre-launch and will be used to compare with the detector’s performance in orbit.


  • Top Cited Papers
    Open Access

    GRB 221009A: The BOAT

    by Eric Burns, Dmitry Svinkin, Edward Fenimore, D. Alexander Kann, José Feliciano Agüí Fernández, Dmitry Frederiks, Rachel Hamburg, Stephen Lesage, Yuri Temiraev, Anastasia Tsvetkova, et al.

    GRB 221009A has been referred to as the brightest of all time (BOAT). We investigate the veracity of this statement by comparing it with a half century of prompt gamma-ray burst observations. This burst is the brightest ever detected by the measures of peak flux and fluence. Unexpectedly, GRB 221009A has the highest isotropic-equivalent total energy ever identified, while the peak luminosity is at the ∼99th percentile of the known distribution. We explore how such a burst can be powered and discuss potential implications for ultralong and high-redshift gamma-ray bursts. By geometric extrapolation of the total fluence and peak flux distributions, GRB 221009A appears to be a once-in-10,000-year event. Thus, it is almost certainly not the BOAT over all of cosmic history; it may be the brightest gamma-ray burst since human civilization began.


  • Open Access

    Mission Test Campaign for the EIRSAT-1 Engineering Qualification Model

    by Maeve Doyle, Rachel Dunwoody, Gabriel Finneran, David Murphy, Jack Reilly, Joseph Thompson, Sai Krishna Reddy Akarapu, Joseph Mangan, Sarah Walsh, Jessica Erkal, et al.

    The compact, standardised form factor of CubeSats allows for the use of commercial off-the-shelf components, reducing traditional barriers to entry, such as cost and development time. More than 1500 of these small spacecraft have been launched in the past 20 years, with improving capabilities that enable a wide range of mission profiles. The Educational Irish Research Satellite, EIRSAT-1, is a CubeSat being developed by a student-led team with goals that span education, technology demonstration and science. A comprehensive mission test plan, in which in-flight conditions are simulated, has been developed for EIRSAT-1 and implemented using an engineering qualification model of the spacecraft. In addition to verifying 41 mission requirements, the successful execution of the mission test plan established that the full satellite system can perform the intended mission. Mission testing also proved to be an invaluable tool to prepare for launch and operations, providing the team with a more complete understanding of the satellite’s expected on-orbit behaviour. This work presents a detailed description of the mission test planning process and implementation, as well as key results and lessons learned. In doing so, this work aims to improve the on-orbit reliability of CubeSats by disseminating resources and good practice around mission testing.


  • Open Access

    Thermal Vacuum Test Campaign of the EIRSAT-1 Engineering Qualification Model

    by Rachel Dunwoody, Jack Reilly, David Murphy, Maeve Doyle, Joseph Thompson, Gabriel Finneran, Lána Salmon, Conor O’toole, Sai Krishna Reddy Akarapu, Jessica Erkal, et al.

    CubeSats facilitate rapid development and deployment of missions for educational, technology demonstration, and scientific purposes. However, they are subject to a high failure rate, with a leading cause being the lack of system-level verification. The Educational Irish Research Satellite (EIRSAT-1) is a CubeSat mission under development in the European Space Agency’s (ESA) Fly Your Satellite! Programme. EIRSAT-1 is a 2U CubeSat with three novel payloads and a bespoke antenna deployment module, which all contribute to the complexity of the project. To increase the likelihood of mission success, a prototype model philosophy is being employed, where both an engineering qualification model (EQM) and a flight model of EIRSAT-1 are being built. Following the assembly of the EQM, the spacecraft underwent a successful full functional test and month-long mission test. An environmental test campaign in ESA Education Office’s CubeSat Support Facility was then conducted with the EQM where both vibration and thermal verification test campaigns were performed. The focus of this paper is the thermal testing and verification of the EIRSAT-1 EQM. Over three weeks, the EQM was subjected to one non-operational cycle, three and a half operational cycles, and a thermal balance test in a thermal vacuum chamber. After dwelling at each temperature extreme, functional tests were performed to investigate the performance of the spacecraft in this space representative environment. The approach to planning and executing the thermal testing is described in detail including the documentation required, set up of the test equipment, and determination of the test levels. Overall, the campaign demonstrated that the mission can successfully operate in a space environment similar to that expected in orbit, despite encountering a number of issues. These issues included a payload displaying anomalous behaviour at cold temperatures and needing to redefine test levels due to an insufficient understanding of the internal dissipation in the spacecraft. A total of two major and three minor non-conformances were raised. Crucially, these issues could not have been found without thermal testing, despite the comprehensive ambient tests performed. The main results and lessons learned during this thermal test campaign are presented with the aim of guiding future missions on optimal approaches in organising and executing the thermal testing of their CubeSats.


  • Open Access

    Development of the EIRSAT-1 CubeSat through Functional Verification of the Engineering Qualification Model

    by Sarah Walsh, David Murphy, Maeve Doyle, Jack Reilly, Joseph Thompson, Rachel Dunwoody, Jessica Erkal, Gabriel Finneran, Gianluca Fontanesi, Joseph Mangan, et al.

    The Educational Irish Research Satellite (EIRSAT-1) is a 2U CubeSat developed at University College Dublin. The project aims to build, test, launch, and operate Ireland’s first satellite and to perform in-orbit demonstrations of three novel payloads developed in-house. To reduce risk within the mission, the project employs a prototype model philosophy in which two models of the spacecraft exist: an engineering qualification model (EQM) and a flight model (FM). This paper presents the verification approach of the functional tests implemented for the EIRSAT-1 project. The activities of the FlatSat and system level full functional tests of the EQM are presented and the results obtained during the test campaigns are discussed. Four test anomalies were encountered during the full functional test campaign resulting in two minor redesigns, and subsequent reassembly, of the CubeSat. The functional test campaigns highlighted the importance of FlatSat level testing of CubeSats to ensure compatibility of all subsystems prior to assembly and of thorough documentation to diagnose any unexpected behaviour of the hardware efficiently. The functional verification of the EQM proved that the system conformed to its design, verifying 57 mission requirements, and is a crucial step towards the development of the EIRSAT-1 FM.


  • The LargE Area burst Polarimeter (LEAP) – A NASA mission of opportunity for the ISS

    by Mark L. McConnell, Matthew Baring, Peter F. Bloser, Michael S. Briggs, Camden Ertley, Gregory Fletcher, Jessica Gaskin, Karen Gelmis, Adam Goldstein, J. Eric Grove, et al.

    The LargE Area Burst Polarimeter (LEAP) will radically improve our understanding of some of the most energetic phenomena in our Universe by exposing the underlying physics that governs astrophysical jets and the extreme environment surrounding newborn compact objects. LEAP will do this by making the highest fidelity polarization measurements to date of the prompt gamma-ray emission from a large sample of Gamma-Ray Bursts (GRBs). The science objectives are met with a single instrument deployed as an external payload on the ISS – a wide FOV Compton polarimeter that measures GRB polarization from 50–500 keV and GRB spectra from ~10 keV to 5 MeV. LEAP measures polarization using seven independent polarimeter modules, each with a 12x12 array of optically isolated high-Z and low-Z scintillation detectors readout by individual PMTs. LEAP is one of two NASA Missions of Opportunity proposals that are currently in a Phase A Concept Study, with a final selection due later this year.


  • Open Access

    BurstCube: status and public alerts

    by Israel Martinez, Isabella Brewer, Michael S. Briggs, Alessandro Bruno, Eric Burns, Regina Caputo, Brad Cenko, Georgia A. De Nolfo, Adam Goldstein, Sean Griffin, et al.

    BurstCube is a CubeSat Gamma-Ray Burst (GRB) detector expected to launch in 2022, significantly expanding sky coverage in the 50 keV to 1 MeV energy range and increasing the probability of detecting a gravitational wave counterpart. BurstCube will take advantage of the Tracking and Data Relay Satellite (TDRS) system in order to provide rapid public alerts and localization information, which has proven to be key to obtain valuable multi-messenger and multi-wavelength information. The BurstCube instrument is comprised of four Cesium Iodide scintillators coupled to arrays of Silicon Photomultipliers, therefore serving as a pathfinder for future missions utilizing this technology for space-based gamma-ray detection. In this presentation we will discuss the current status of the BurstCube instrument assembly, calibration and analysis pipelines. We will also describe the real-time alerts that will be sent out to the community throughout the duration of the mission.


  • Growth of trigonal gadolinium fluoride in a glass-ceramic for scintillation and optical applications

    by D. de Faoite, I. Tobin, A. Ulyanov, O.J. Roberts, B. Shortt, L. Hanlon, S. McBreen, K.T. Stanton