Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Senad Odžak has a total of 48 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Artificial Intelligence for High-Resolution Digital Mammography: Balancing Performance and Computational Constraints

    by Ajdin Vatreš, Edin Kadrić, Adnan Beganović, Adnan Šehić, Fuad Julardžija, Senad Odžak, Adi Pandžić, Merim Jusufbegović

  • Design, Manufacturing and Quality Assessment of 3D-Printed Anthropomorphic Breast Phantom for Mammography

    by Elma Huseljić, Senad Odžak, Adnan Beganović, Almasa Odžak, Adi Pandžić, Merim Jusufbegović

  • Open Access

    Thermal stress of photovoltaic panels

    by Abdulah Akšamović, Senad Odžak, Almasa Odžak, Ajdin Fejzić

    Photovoltaic (PV) generators convert solar energy into electrical energy using the photoelectric effect. However, only a portion of the incident energy is converted into electrical energy, with up to 24 % conversion efficiency on the commercial panels. A significant portion of the incident energy is converted into heat on the PV panel, causing the cell temperature to rise above the ambient temperature by up to 30 ◦C. During normal operation, the operating point on the current-voltage (I−U ) curve lies at the maximum power point (MPP). However, the PV module can operate at points outside the MPP, including two extreme points: the short circuit and the open circuit. Of particular interest is the open circuit regime, in which the PV panel can stay on for an extended period of time. In this study, we analyzed the problem of increasing PV cell temperature in three characteristic points: MPP, short circuit and open circuit. We used a single-diode model of the PV cell to analyze power losses in individual components for all operating points on the I−U curve. Based on this analysis, we estimated the sources of PV panel heating. Measurements were performed on three panels of the same model under the same ambient conditions, with each panel at a different operating point. Our results showed that the cell temperature at the MPP ranged from 24 to 27.8 ◦C above the ambient temperature. At the short circuit point the range was 28.8 to 34.4 ◦C and at the open circuit point, it was 30.6 to 35.1 ◦C.


  • Radiation protection and estimate of commercial aircrew effective doses in Bosnia and Herzegovina

    by Hatidža Fajić, Adnan Beganović, Senad Odžak, Almasa Odžak

    Cosmic rays are the primary source of the daily exposure of aircrew and passengers to ionising radiation. This study aims to estimate the effective doses of ionising radiation for aircraft crews in Bosnia and Herzegovina by taking into consideration factors such as flight duration and altitude, as well as the geographical position of airports. The CARI-7 algorithm and neural network method were used in the analysis of data obtained from the Sarajevo International Airport. The results show that the estimated annual effective doses in 2021 range from 0.06 to 10 mSv for flights to and from Belgrade and Dubai, respectively. Both linear regression and neural network models were developed to predict the effective dose based on flight duration, average altitude, latitude and maximum altitude. The findings reveal that flight duration is the most statistically significant factor, followed by average altitude, latitude and maximum altitude.


  • Open Access

    DC Cabling of Large-Scale Photovoltaic Power Plants

    by Abdulah Akšamović, Samim Konjicija, Senad Odžak, Sedin Pašalić, Selma Grebović

    The development of Floating Solar Photovoltaic (FPV) systems is a sign of a promising future in the Renewable Energy field. Numerous solar modules and inverters are mounted on large-scale floating platforms. It is important to design the system so that the inverter operates in its optimum range most of the time. In order to achieve this goal on the DC side, serial and parallel connections of solar modules are used. As a result, the cabling of the PV array architecture is an important issue. Modern electrical installation design requires reducing costs in cabling materials, equipment installation, and maintenance. The reduction of losses and the amount of time required to complete the design are also significant. Therefore, the main topic of this paper is DC cabling in large-scale FPV power plants (>1 MV). The serial-parallel (SP) connection scheme of solar modules and the percentage of power loss in DC cables are considered. Furthermore, a general method for determining cable lengths for FPV power plants is defined. The temperature influence on losses in DC cables is analyzed. A new method for determining the current at the maximum power point (MPP) as a function of temperature is proposed. A case study is conducted using a hypothetical 3 MW FPV power plant, and the obtained results are presented and analyzed.


  • Open Access

    Mathematical modelling of bridge crane dynamics for the time of non-stationary regimes of working hoist mechanism

    by Mirsad Čolić, Nedim Pervan, Muamer Delić, Adis J. Muminović, Senad Odžak, Vahidin Hadžiabdić

    Bridge crane is exposed to dynamic loads during its non-stationary operations (acceleration and braking). Analyzing these operations, one can determine unknown impacts on the dynamic behavior of bridge crane. These impacts are taken into consideration using selected coefficients inside the dynamic model. Dynamic modelling of a bridge crane in vertical plane is performed in the operation of the hoist mechanism. The dynamic model is obtained using data from a real bridge crane system. Two cases have been analyzed: acceleration of a load freely suspended on the rope when it is lifted and acceleration of a load during the lowering process. Physical quantities that are most important for this research are the values of stress and deformation of main girders. Size of deformation at the middle point of the main crane girder is monitored and analyzed for the above-mentioned two cases. Using the values of maximum deformation, one also obtains maximum stress values in the supporting construction of the crane.


  • Open Access

    Teaching about thermal expansion: investigating the effectiveness of a cognitive bridging approach

    by Andrej Vidak, Senad Odžak, Vanes Mešić

    Background: It is widely known that for many students it is very difficult to correctly predict how thermal expansion affects the appearance of a metal plate with a circular hole. Interviews with school teachers show that the source of this difficulty could stem from the fact that students’ internal visualizations of an arbitrary object’s thermal expansion often boil down to visualizing changes along one dimension only. Purpose: In this study, we investigated how students’ mental models about one-dimensional expansion can be extended for purposes of running mental simulations about expansion along two dimensions. Sample: To that end a pretest-posttest quasi-experiment has been conducted, with 100 students in the control group and 95 students in the experimental group. Design and methods: Whereas control group students received traditional instruction with a focus on formal representations, in the experimental group the students were led to draw an analogy between heating of a straight rod and a circular rod of same length, whereby the internal structure of the rods was represented by springs. Results: Eventually, it has been found that students from the experimental group were significantly more successful at predicting the effects of thermal expansion, especially within contexts of objects with holes. Conclusion: Analogies and extreme case reasoning can be effectively used for helping the students to correctly transfer their mental models about one-dimensional expansion to situations that require reasoning about expansion along two dimensions.


  • Open Access

    High-order harmonic generation by polyatomic molecules

    by S Odžak, E Hasović, D B Milošević

    We present a theory of high-order harmonic generation by arbitrary polyatomic molecules based on the molecular strong-field approximation (MSFA) in the framework of the S-matrix theory. A polyatomic molecule is modeled by an (N + 1)-particle system, which consists of N heavy atomic (ionic) centers and an electron. We derived various versions (with or without the dressing of the initial and/or final molecular state) of the MSFA. The general expression for the T-matrix element takes a simple form for neutral polyatomic molecules. We show the existence of the interference minima in the harmonic spectrum and explain these minima as a multiple-slit type of interference. This is illustrated by numerical examples for the nitrous oxide (N2O) molecule exposed to strong linearly polarized laser field.


  • Atomic processes in bicircular fields

    by S. Odžak, E. Hasović, W. Becker, D. B. Milošević

    Various laser-induced and laser-assisted processes in atoms exposed to bicircular fields are investigated. The strong-field ionization process is exemplified by the direct and by the high-order above-threshold detachment of negative fluorine ions both for corotating and counterrotating bicircular fields. The symmetries of the electron distributions in the momentum plane are analyzed in detail. The results for laser-assisted electron-ion recombination and for high-order harmonic generation are presented for the bicircular field with counterrotating components.