Nader Mokhtarani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Nader Mokhtarani has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
Hossein Ganjidoust
Civil and Environmental Engineering Faculty, Tarbiat Modares University, 1411713116 Tehran, Iran
2 shared publicationsMohammad Kazemi Soochelmaei
Civil and Environmental Engineering Faculty, Tarbiat Modares University, Tehran, Iran
2 shared publicationsS. Yashar Yasrobi
Civil and Environmental Engineering Faculty, Tarbiat Modares University, 1411713116 Tehran, Iran
2 shared publicationsA. Baharifar
Civil and Environmental Engineering Faculty, Tarbiat Modares University, Tehran, Iran
1 shared publicationAlaa Soubh
Civil and Environmental Engineering Faculty, Tarbiat Modares University, Tehran, Iran
1 shared publication- Ali Dehnavi
Department of Civil Engineering, University of Isfahan, Isfahan, Iran
1 shared publication
Latest Publications
- Open Access
- 31 August 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
In-situ regeneration of permeable reactive barriers via the electrokinetic process for phenol-contaminated groundwater remediation
Phenol contamination poses a significant challenge for groundwater remediation, while the limited longevity of permeable reactive barriers (PRBs) remains a major obstacle to their long-term application. This study evaluates an in-situ electrokinetic (EK) regeneration approach for PRBs treating phenol under continuous-flow conditions and simultaneously investigates regeneration efficiency, PRB longevity, and intermediate by-product formation. Experiments were conducted using a continuous glass reactor consisting of a granular activated carbon (GAC) bed positioned between two graphite electrodes. The effects of initial phenol concentration and influent flow rate on PRB performance were optimized, followed by assessment of EK regeneration performance. Optimal PRB operation was achieved at an initial phenol concentration of 150 mg L −1 and a flow rate of 20 mL min −1 . Increasing the applied voltage improved regeneration efficiency, and considering both longevity and energy consumption, 15 V was identified as optimal, restoring up to 86% of the adsorbent capacity within 5 h. Regeneration was confirmed by SEM imaging and nitrogen adsorption–desorption analysis. Under optimal conditions, EK integration extended operational longevity by up to 2.75 times compared with PRB alone. During regeneration, benzoquinone was detected as an intermediate product, whereas hydroquinone was not observed. The results demonstrate the potential of in-situ EK regeneration to extend PRB operational longevity; however, the limited number of regeneration cycles and the formation of benzoquinone indicate that further techno-economic assessment and field-scale validation are required.
- 31 August 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Open AccessIn-situ regeneration of permeable reactive barriers via the electrokinetic process for phenol-contaminated groundwater remediation
Phenol contamination poses a significant challenge for groundwater remediation, while the limited longevity of permeable reactive barriers (PRBs) remains a major obstacle to their long-term application. This study evaluates an in-situ electrokinetic (EK) regeneration approach for PRBs treating phenol under continuous-flow conditions and simultaneously investigates regeneration efficiency, PRB longevity, and intermediate by-product formation. Experiments were conducted using a continuous glass reactor consisting of a granular activated carbon (GAC) bed positioned between two graphite electrodes. The effects of initial phenol concentration and influent flow rate on PRB performance were optimized, followed by assessment of EK regeneration performance. Optimal PRB operation was achieved at an initial phenol concentration of 150 mg L −1 and a flow rate of 20 mL min −1 . Increasing the applied voltage improved regeneration efficiency, and considering both longevity and energy consumption, 15 V was identified as optimal, restoring up to 86% of the adsorbent capacity within 5 h. Regeneration was confirmed by SEM imaging and nitrogen adsorption–desorption analysis. Under optimal conditions, EK integration extended operational longevity by up to 2.75 times compared with PRB alone. During regeneration, benzoquinone was detected as an intermediate product, whereas hydroquinone was not observed. The results demonstrate the potential of in-situ EK regeneration to extend PRB operational longevity; however, the limited number of regeneration cycles and the formation of benzoquinone indicate that further techno-economic assessment and field-scale validation are required.
- Open Access
- 8 January 2026
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 33 (3) , 1101
Correction to: Efficacy of permeable reactive barrier with different structures for the simultaneous removal of nitrate and MTBE from polluted water
- 8 January 2026
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 33 (3) , 1101
Open AccessCorrection to: Efficacy of permeable reactive barrier with different structures for the simultaneous removal of nitrate and MTBE from polluted water
- 27 November 2025
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 32 (51) , 28976-28991
Efficacy of permeable reactive barrier with different structures for the simultaneous removal of nitrate and MTBE from polluted water
Groundwater quality is essential for water supply, and the threat of groundwater pollution poses significant risks to society and the economy. This study investigates the removal of two common pollutants, nitrate and MTBE, using chemical reduction with zero-valent iron (ZVI) and adsorption with ZSM-5, respectively, within a permeable reactive barrier (PRB). Specifically, the research evaluates the performance of two structures: a material composition system that integrates reactive materials into a single barrier and a sequential barrier system with separate layers of ZVI and ZSM-5 for the simultaneous removal of these pollutants. The study investigates the effects of four variables: initial concentrations of nitrate and MTBE and dosages of ZVI and ZSM-5, each analyzed at five levels. The results demonstrate that the material composition system was more effective at nitrate removal, with an efficiency increase from 88% (using ZVI alone) to approximately 97%. However, this system exhibited a reduced MTBE removal efficiency, decreasing from over 99% (achieved with ZSM-5 alone) to around 86%, likely due to nitrate interference. Conversely, the sequential barrier structure outperformed the material composition system in MTBE removal, achieving a maximum efficiency of 95%. However, its nitrate removal efficiency was lower, at around 92%, which, while still acceptable, was less effective than that of the material composition system. In summary, the material composition system is more suitable for nitrate removal, whereas the sequential barrier system is better suited for MTBE removal. This study provides valuable insights into optimizing PRB designs for the simultaneous remediation of groundwater contaminants.
- 27 November 2025
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 32 (51) , 28976-28991
Efficacy of permeable reactive barrier with different structures for the simultaneous removal of nitrate and MTBE from polluted water
Groundwater quality is essential for water supply, and the threat of groundwater pollution poses significant risks to society and the economy. This study investigates the removal of two common pollutants, nitrate and MTBE, using chemical reduction with zero-valent iron (ZVI) and adsorption with ZSM-5, respectively, within a permeable reactive barrier (PRB). Specifically, the research evaluates the performance of two structures: a material composition system that integrates reactive materials into a single barrier and a sequential barrier system with separate layers of ZVI and ZSM-5 for the simultaneous removal of these pollutants. The study investigates the effects of four variables: initial concentrations of nitrate and MTBE and dosages of ZVI and ZSM-5, each analyzed at five levels. The results demonstrate that the material composition system was more effective at nitrate removal, with an efficiency increase from 88% (using ZVI alone) to approximately 97%. However, this system exhibited a reduced MTBE removal efficiency, decreasing from over 99% (achieved with ZSM-5 alone) to around 86%, likely due to nitrate interference. Conversely, the sequential barrier structure outperformed the material composition system in MTBE removal, achieving a maximum efficiency of 95%. However, its nitrate removal efficiency was lower, at around 92%, which, while still acceptable, was less effective than that of the material composition system. In summary, the material composition system is more suitable for nitrate removal, whereas the sequential barrier system is better suited for MTBE removal. This study provides valuable insights into optimizing PRB designs for the simultaneous remediation of groundwater contaminants.
- 20 November 2025
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 205
Electro-peroxone as a novel approach for direct and efficient remediation of pesticide-contaminated soil
- 20 November 2025
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 205
Electro-peroxone as a novel approach for direct and efficient remediation of pesticide-contaminated soil
- 29 October 2025
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 197 (11) , 1-25
Evaluating municipal waste processing and disposal methods in Isfahan, Iran: a life cycle assessment approach
Proper waste management is crucial to address the severe environmental issues that have emerged in recent decades. A prominent and extensively employed approach to tackling this challenge involves the utilization of life cycle assessment (LCA), which allows for a comprehensive evaluation of the environmental impacts associated with a particular system or product. This study used the LCA technique to determine the most effective waste disposal method in Isfahan, Iran. Six scenarios were examined, incorporating various processes such as landfilling, composting, anaerobic digestion, RDF incineration, and pyrolysis. The IWM2.0.6 model was employed to calculate energy usage and emissions for each scenario, while life cycle impacts were assessed using the SimaPro software and the IMPACT World+ method. Based on the results, landfilling has fewer negative impacts on human health than thermal treatment techniques like RDF incineration and pyrolysis. In addition, anaerobic digestion significantly reduces environmental impacts on ecosystem quality and human health. As a result, Scenario-4, which combines 28% manual separation (2% sent to recycling and 26% rejected to landfill) and 72% anaerobic digestion (39% biogas and leachate, 17% compost, and 16% rejected to landfill), achieved the lowest normalized environmental impact, with −4.06 × 103 for ecosystem quality and −1.88 × 103 for human health. Consequently, Scenario 4 was selected as the most suitable waste management alternative for Isfahan. Overall, using a life cycle assessment (LCA) can considerably assist in choosing the appropriate waste management strategy and positively impact the environment.
- 29 October 2025
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 197 (11) , 1-25
Evaluating municipal waste processing and disposal methods in Isfahan, Iran: a life cycle assessment approach
Proper waste management is crucial to address the severe environmental issues that have emerged in recent decades. A prominent and extensively employed approach to tackling this challenge involves the utilization of life cycle assessment (LCA), which allows for a comprehensive evaluation of the environmental impacts associated with a particular system or product. This study used the LCA technique to determine the most effective waste disposal method in Isfahan, Iran. Six scenarios were examined, incorporating various processes such as landfilling, composting, anaerobic digestion, RDF incineration, and pyrolysis. The IWM2.0.6 model was employed to calculate energy usage and emissions for each scenario, while life cycle impacts were assessed using the SimaPro software and the IMPACT World+ method. Based on the results, landfilling has fewer negative impacts on human health than thermal treatment techniques like RDF incineration and pyrolysis. In addition, anaerobic digestion significantly reduces environmental impacts on ecosystem quality and human health. As a result, Scenario-4, which combines 28% manual separation (2% sent to recycling and 26% rejected to landfill) and 72% anaerobic digestion (39% biogas and leachate, 17% compost, and 16% rejected to landfill), achieved the lowest normalized environmental impact, with −4.06 × 103 for ecosystem quality and −1.88 × 103 for human health. Consequently, Scenario 4 was selected as the most suitable waste management alternative for Isfahan. Overall, using a life cycle assessment (LCA) can considerably assist in choosing the appropriate waste management strategy and positively impact the environment.
- 7 August 2025
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 236 (12) , 1-16
Landfill Leachate Post-Treatment Through the Innovative Synergy of Combined Adsorption/Electro-Peroxone Processes
- 7 August 2025
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 236 (12) , 1-16
Landfill Leachate Post-Treatment Through the Innovative Synergy of Combined Adsorption/Electro-Peroxone Processes
- 3 July 2024
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 235 (8) , 1-18
Selective recovery of silver from wastewater using Fe3O4@SiO2-SH magnetic composites
- 3 July 2024
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 235 (8) , 1-18
Selective recovery of silver from wastewater using Fe3O4@SiO2-SH magnetic composites
- 5 June 2024
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 21 (16) , 9921-9934
Spent caustic treatment by electrocoagulation process: effect of electrode shape and spacing
- 5 June 2024
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 21 (16) , 9921-9934
Spent caustic treatment by electrocoagulation process: effect of electrode shape and spacing
- 19 July 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 319, 115733
Leachate post-treatment by electrocoagulation process: Effect of polarity switching and anode-to-cathode surface area
- 19 July 2022
- Published by Elsevier in Journal of Environmental Management
- Vol. 319, 115733
Leachate post-treatment by electrocoagulation process: Effect of polarity switching and anode-to-cathode surface area