Bei Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Bei Wang has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
Bruce Organ
Jockey Club Heavy Vehicle Emissions Testing and Research Centre, Vocational Training Council, Hong Kong, China
3 shared publications- Kin-Fai Ho
The Chinese University of Hong Kong
3 shared publications Shun-Cheng Lee
3 shared publications- Yuhan Huang
Centre for Green Technology, School of Civil and Environmental Engineering, University of Technology Sydney, NSW 2007, Australia
3 shared publications Yik-Sze Lau
JC School of Public Health and Primary Care, The Chinese University of Hong Kong, Hong Kong, China
2 shared publicationsBo-Fu Ning
Xuanwei City Center for Disease Control and Prevention—Chronic Non-infectious Disease Control Department, Xuanwei, China
1 shared publication
Latest Publications
- Open Access
- 4 July 2024
- Published by Elsevier in Journal of Environmental Sciences
- Vol. 155, 832-845
Suitability of using carbon dioxide as a tracer gas for studying vehicle emission dispersion in a real street canyon
- 4 July 2024
- Published by Elsevier in Journal of Environmental Sciences
- Vol. 155, 832-845
Open AccessSuitability of using carbon dioxide as a tracer gas for studying vehicle emission dispersion in a real street canyon
- 28 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Limitations and Solutions of LLC Topology in High Power High Step-up Applications on Aircraft
In modern aircraft, there is a huge demand for high power high step-up (HPHS) DC-DC conversion from 28V to 270V or even higher voltage, such as Start Power Unit (SPU) and backup power supply systems. Due to high efficiency, high power density, low EMI, and soft-switching capability, LLC resonant topology are receiving special attention. However, when it comes to HPHS applications, original LLC resonant topology will encounter some limitations, resulting poor parameter controllability, low power density and low efficiency. This paper first analyzed the fundamental causes of these limitations. Then, solutions are given in terms of circuit topology and system architecture, respectively. A 5kW 2SV/222V prototype was designed, fabricated and tested. The feasibility of proposed solutions is validated.
- 28 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Limitations and Solutions of LLC Topology in High Power High Step-up Applications on Aircraft
In modern aircraft, there is a huge demand for high power high step-up (HPHS) DC-DC conversion from 28V to 270V or even higher voltage, such as Start Power Unit (SPU) and backup power supply systems. Due to high efficiency, high power density, low EMI, and soft-switching capability, LLC resonant topology are receiving special attention. However, when it comes to HPHS applications, original LLC resonant topology will encounter some limitations, resulting poor parameter controllability, low power density and low efficiency. This paper first analyzed the fundamental causes of these limitations. Then, solutions are given in terms of circuit topology and system architecture, respectively. A 5kW 2SV/222V prototype was designed, fabricated and tested. The feasibility of proposed solutions is validated.
- 1 September 2021
- Published by Elsevier in Atmospheric Pollution Research
- Vol. 12 (9)
Characteristics of particle emissions from light duty diesel vehicle fueled with ultralow sulphur diesel and biodiesel blend
- 1 September 2021
- Published by Elsevier in Atmospheric Pollution Research
- Vol. 12 (9)
Characteristics of particle emissions from light duty diesel vehicle fueled with ultralow sulphur diesel and biodiesel blend
- 1 March 2021
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 405, 124613
Chemical and toxicological characterization of particulate emissions from diesel vehicles
- 1 March 2021
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 405, 124613
Chemical and toxicological characterization of particulate emissions from diesel vehicles
- 9 August 2019
- Published by Springer Nature in Air Quality, Atmosphere & Health
- Vol. 12 (9) , 1113-1126
Investigation of factors affecting the gaseous and particulate matter emissions from diesel vehicles
- 9 August 2019
- Published by Springer Nature in Air Quality, Atmosphere & Health
- Vol. 12 (9) , 1113-1126
Investigation of factors affecting the gaseous and particulate matter emissions from diesel vehicles
- Open Access
- 7 June 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (21) , 17500-17510
Cancer risk from gaseous carbonyl compounds in indoor environment generated from household coal combustion in Xuanwei, China
Airborne carbonyls were characterized from emitted indoor coal combustion. Samples were collected in Xuanwei (Yunnan Province), a region in China with a high rate of lung cancer. Eleven of 19 types of samples (58%) demonstrated formaldehyde concentrations higher than the World Health Organization exposure limit (a 30-min average of 100 μg m−3). Different positive significant correlations between glyoxal/methylglyoxal and formaldehyde/acetaldehyde concentrations were observed, suggesting possible different characteristics in emissions between two pairs of carbonyl compounds. A sample in the highest inhalation risk shows 29.2 times higher risk than the lowest sample, suggesting different coal sampling locations could contribute to the variation of inhalation risk. Inhabitants in Xuanwei also tend to spend more time cooking and more days per year indoors than the national average. The calculated cancer risk ranged from 2.2–63 × 10−5, which shows 13 types of samples at high-risk level. Cumulative effect in combination with different carbonyls could have contributed to the additive actual inhalation cancer risk. There is a need to explicitly address the health effects of environmentally relevant doses, considering life-long exposure in indoor dwellings.
- 7 June 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (21) , 17500-17510
Open AccessCancer risk from gaseous carbonyl compounds in indoor environment generated from household coal combustion in Xuanwei, China
Airborne carbonyls were characterized from emitted indoor coal combustion. Samples were collected in Xuanwei (Yunnan Province), a region in China with a high rate of lung cancer. Eleven of 19 types of samples (58%) demonstrated formaldehyde concentrations higher than the World Health Organization exposure limit (a 30-min average of 100 μg m−3). Different positive significant correlations between glyoxal/methylglyoxal and formaldehyde/acetaldehyde concentrations were observed, suggesting possible different characteristics in emissions between two pairs of carbonyl compounds. A sample in the highest inhalation risk shows 29.2 times higher risk than the lowest sample, suggesting different coal sampling locations could contribute to the variation of inhalation risk. Inhabitants in Xuanwei also tend to spend more time cooking and more days per year indoors than the national average. The calculated cancer risk ranged from 2.2–63 × 10−5, which shows 13 types of samples at high-risk level. Cumulative effect in combination with different carbonyls could have contributed to the additive actual inhalation cancer risk. There is a need to explicitly address the health effects of environmentally relevant doses, considering life-long exposure in indoor dwellings.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007
- No. 10915281,p. 1-6
A/D Converter INL and DNL Estimation with a Distorted Sinusoidal Stimulus Signal
It is understood that the high precision and accurate test signal is necessary in the traditional analog to digital converter (ADC) testing. In this paper, a new method for estimating the differential nonlinearity (DNL) and integral nonlinearity (INL) of ADCs with a distorted sinusoidal stimulus is proposed. By means of a simple voltage divider circuit, let the original and divided distorted stimulus signals respectively fed into a measured ADC. Considering that the distorted stimuli are changed by the nonlinearity of the measured ADC, a Fourier series with unknown parameters is used to describe the measured ADC transition points. Since the original and divided distorted stimulus signals are used to measure the same ADC transition points, the relationships between the Fourier series with unknown parameters when the two different stimulus signals are respectively inputted to the ADC are set up. Based on the relationships, the methods for estimating the unknown parameters of the Fourier series and then the INL and DNL of the measured ADC are proposed. Both simulation and experiment results verify the effectiveness and robustness of the proposed approach.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007
- No. 10915281,p. 1-6
A/D Converter INL and DNL Estimation with a Distorted Sinusoidal Stimulus Signal
It is understood that the high precision and accurate test signal is necessary in the traditional analog to digital converter (ADC) testing. In this paper, a new method for estimating the differential nonlinearity (DNL) and integral nonlinearity (INL) of ADCs with a distorted sinusoidal stimulus is proposed. By means of a simple voltage divider circuit, let the original and divided distorted stimulus signals respectively fed into a measured ADC. Considering that the distorted stimuli are changed by the nonlinearity of the measured ADC, a Fourier series with unknown parameters is used to describe the measured ADC transition points. Since the original and divided distorted stimulus signals are used to measure the same ADC transition points, the relationships between the Fourier series with unknown parameters when the two different stimulus signals are respectively inputted to the ADC are set up. Based on the relationships, the methods for estimating the unknown parameters of the Fourier series and then the INL and DNL of the measured ADC are proposed. Both simulation and experiment results verify the effectiveness and robustness of the proposed approach.