TSTimothy Sleasman

Timothy Sleasman

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Timothy Sleasman has a total of 41 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Dual-Resonance Dynamic Metasurface for Independent Magnitude and Phase Modulation

    by Timothy Sleasman, Robert Duggan, Ra’id S. Awadallah, David Shrekenhamer

    Cascaded dynamic metasurfaces with multiple control points promise augmented capabilities but have received little attention to date owing to complexity in design. The inclusion of multiple control knobs within a single surface offers more degrees of freedom, which can be optimized—jointly with the static geometry—to provide added functionality. We study a cascaded system with two dynamic layers, each possessing patchlike elements that can be tuned with a varactor diode. A resistor is additionally included to add asymmetry in the resonance loss provided by each layer. With this architecture we study the reflection properties of the surface and demonstrate the ability to independently tune the magnitude and the phase from the single, electrically thin surface. Tuning the magnitude and phase separately is a widely sought-after behavior and is used herein to demonstrate multiple communications modulation methods including phase-shift keying and 16-point quadrature amplitude modulation.


  • Implementation and Characterization of a Two-Dimensional Printed Circuit Dynamic Metasurface Aperture for Computational Microwave Imaging

    by Timothy A. Sleasman, Mohammadreza F. Imani, Aaron V. Diebold, Michael Boyarsky, Kenneth P. Trofatter, David R. Smith

    We present the design, fabrication, and experimental characterization of a 2-D, dynamically tuned, metasurface aperture, emphasizing its potential performance in computational imaging applications. The dynamic metasurface aperture (DMA) consists of an irregular, planar cavity that feeds a multitude of tunable metamaterial elements, all fabricated in a compact, multilayer printed circuit board process. The design considerations for the metamaterial element as a tunable radiator, the associated biasing circuitry, as well as cavity parameters are examined and discussed. A sensing matrix can be constructed from the measured transmit patterns, the singular value spectrum of which provides insight into the information capacity of the apertures. We investigate the singular value spectra of the sensing matrix over a variety of operating parameters, such as the number of metamaterial elements, number of masks (aka tuning states), and number of radiating elements. After optimizing over these key parameters, we demonstrate computational microwave imaging of simple test objects.


  • Top Cited Papers

    Review of Metasurface Antennas for Computational Microwave Imaging

    by Mohammadreza F. Imani, Jonah N. Gollub, Okan Yurduseven, Aaron V. Diebold, Michael Boyarsky, Thomas Fromenteze, Laura Pulido-Mancera, Timothy Sleasman, David R. Smith

    This article covers recent advances in the fusion of metasurface antenna design and computational imaging concepts for the realization of imaging systems that are planar, fast, and low cost. We start by explaining the operation of metamaterial antennas which can generate diverse radiation patterns. Their advantages and distinctions from previous antennas are elucidated. We then provide an intuitive overview of the computational imaging framework and argue that metamaterial antennas are a near ideal platform for implementing such schemes at microwave frequencies. We describe two metamaterial antenna implementations: frequency-diverse and electronically reconfigurable. The trade-offs governing the design and operation of each architecture are examined. We conclude by examining the outlook of metamaterial antennas for microwave imaging and propose various future directions.


  • S-band GaAs FET Reconfigurable Reflectarray for Passive Communications

    by R. L. Schmid, D. B. Shrekenhamer, O. F. Somerlock, A. C. Malone, T. A. Sleasman, R. S. Awadallah

    A reflectarray operating at 3.5 GHz is created with individual control of unit element reconfigurability for beamsteering in both azimuth and elevation. The unit element has been co-designed with a gallium arsenide (GaAs) FET on the back side of the reflector to allow the reflected phase to change between 0° and 180°. The phase control can be used to both beamform the reflected signal in a desired direction and modulate data onto a signal of opportunity for short range communications. The simplicity of the unit element and control routing enables the elements to be electrically small (~λ/6 spacing). Over-the-air laboratory measurements indicate the ability to modulate the reflected signal at 10 kbps with a path forward towards higher data rates.


  • Computational through-wall imaging using a dynamic metasurface antenna

    by Timothy Sleasman, Mohammadreza F. Imani, Michael Boyarsky, Kenneth P. Trofatter, David R. Smith

    We present a study of computational through-wall imaging using a dynamically reconfigurable metasurface antenna (DMA). The DMA consists of a single-feed, electrically-large microstrip line, loaded with individually addressable metamaterial radiators. Each metamaterial resonator is integrated with a diode, enabling it to be switched on (radiating) or off (non-radiating) by an externally applied voltage. By switching subsets of the array of elements on or off, spatially diverse radiation patterns are formed that are scattered by the wall and structures beyond the wall. Images can be reconstructed from these measurements, using a combination of range migration algorithms and wall compensation algorithms, with minimal frequency bandwidth requirements; even single frequency measurements are possible in conjunction with the DMA. We investigate imaging through a variety of wall materials at K-band frequencies (18-26.5 GHz), including homogeneous media with known properties and inhomogeneous materials such as plywood. We further investigate single-frequency performance against full-bandwidth measurements. The DMA used here is electrically large in one dimension, over which many spatially diverse measurements can be taken. By scanning the DMA in the perpendicular direction, full two-dimensional scans can be acquired with minimal cost and time, making the one-dimensional DMA attractive as the basis for future through-wall scanning systems.


  • Open Access

    Implementation and Characterization of a Two-Dimensional Printed Circuit Dynamic Metasurface Aperture for Computational Microwave Imaging

    by Timothy Sleasman, Mohammadreza F. Imani, Aaron V. Diebold, Michael Boyarsky, Kenneth P. Trofatter, David R. Smith

    We present the design, fabrication, and experimental characterization of a two-dimensional, dynamically tuned, metasurface aperture, emphasizing its potential performance in computational imaging applications. The dynamic metasurface aperture (DMA) consists of an irregular, planar cavity that feeds a multitude of tunable metamaterial elements, all fabricated in a compact, multilayer printed circuit board process. The design considerations for the metamaterial element as a tunable radiator, the associated biasing circuitry, as well as cavity parameters are examined and discussed. A sensing matrix can be constructed from the measured transmit patterns, the singular value spectrum of which provides insight into the information capacity of the apertures. We investigate the singular value spectra of the sensing matrix over a variety of operating parameters, such as the number of metamaterial elements, number of masks, and number of radiating elements. After optimizing over these key parameters, we demonstrate computational microwave imaging of simple test objects.

  • Open Access

    Sub-Wavelength Focusing in Inhomogeneous Media with a Metasurface Near Field Plate

    by Andrew C. Strikwerda, Timothy Sleasman, William Anderson, Ra’id Awadallah

    Overcoming the diffraction limit, which enables focusing much less than the wavelength, requires tailoring the evanescent spectrum of an aperture’s field distribution. We model and simulate a corrugated near field plate, which can generate a sub-wavelength focus in inhomogeneous background media. All reactive coupling, between the metasurface near field plate and the focusing domain and among the corrugations in the metasurface, is taken into consideration with the finite element method, which we solve in combination with a constraint to generate a desired focus. Various geometries for the near field plate are considered and we demonstrate that the proposed method can effectively create a deeply sub-wavelength focus within a layered medium having properties resembling brain tissue. Such a device could find use as a detector of biological signals or for hyperthermic treatment near the skin surface.


  • Phaseless coherent and incoherent microwave ghost imaging with dynamic metasurface apertures

    by Aaron V. Diebold, Mohammadreza F. Imani, Timothy Sleasman, David R. Smith

    Phase information and spatially coherent illumination have usually been considered indispensable components of most microwave imaging systems. Dynamic metasurface apertures (DMAs)—with their ability to generate spatially incoherent illumination—have recently supplanted these assumptions in favor of simplified imaging hardware. In light of this development, we investigate the coherence of a phaseless imaging system based on metasurface apertures. In doing so, we propose and experimentally demonstrate coherent and incoherent computational microwave ghost imaging using DMAs. These apertures can generate a multitude of distinct speckle fields at a single frequency by modulating the electrical properties of radiating complementary metamaterial elements patterned into the surface of a waveguide. We show that a pair of dynamic apertures, one acting as transmit and the other as receive, can achieve two-dimensional, phaseless, coherent imaging. Further, by averaging the intensity measurements obtained in this manner over a random set or ensemble of receive aperture distributions, we demonstrate that an incoherent imaging system can be achieved in which single-port ensemble averaging by the electrically large DMA plays the role of spatial averaging in a bucket detector. We investigate the effects of these different imaging schemes on the resulting reconstructions and provide experimental demonstrations.


  • Enhancing Capacity of Spatial Multiplexing Systems Using Reconfigurable Cavity-Backed Metasurface Antennas in Clustered MIMO Channels

    by Insang Yoo, Mohammadreza F. Imani, Timothy Sleasman, Henry D. Pfister, David R. Smith

    We propose a spatial multiplexing system using reconfigurable cavity-backed metasurface antennas. The metasurface antennas consist of a printed cavity with dynamically tunable metamaterial radiators patterned on one side and fed by multiple RF ports on the other side (each port representing one communication node), forming a shared aperture. By individual tuning of the radiators, the antennas can generate steerable, concurrent beams that can be adapted to the properties of multiple-input-multiple-output (MIMO) channels. In this paper, we present a 2 × 2 MIMO system with simulated metasurface antennas as the transmit and receive antennas operating at 5.9 GHz. We demonstrate that the flexibility in beamforming supported by the metasurface antennas can be used to achieve low spatial correlation and high SNR-gain in clustered MIMO channels, leading to a significant improvement of the channel capacity. Numerical studies show 2.36-fold, 2.11-fold enhancements of capacity in MIMO channels with one and two clusters, respectively, compared with a MIMO system consisting of linear dipoles. The MIMO system based on the metasurface antennas can be low-cost, low profile, and low-power. The metasurface antenna thus has potential applications in small cell networks requiring high data rate under bandwidth, energy, and cost constraints.


  • Two-Dimensional Dynamic Metasurface Apertures for Computational Microwave Imaging

    by Mohammadreza F. Imani, Timothy Sleasman, David R. Smith

    We propose a single-port, two-dimensional dynamic metasurface aperture capable of generating a multitude of distinct illumination patterns at microwave frequencies. The proposed device consists of a printed cavity, with the upper conducting surface patterned with independently tunable metamaterial elements. We present numerical simulations demonstrating the operation of the proposed device in computational microwave imaging. We also investigate parameters influencing its performance and discuss its potential advantages over other devices used for computational microwave imaging.