Lars Vestling
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Lars Vestling has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
- Joergen Olsson
Department of Engineering Sciences, Uppsala University, Uppsala, Sweden
19 shared publications - Olof Bengtsson
Ferdinand-Braun-Institut (FBH), Berlin, Germany
6 shared publications K.-H. Eklund
Comheat Microwave AB, Uppsala, Sweden
4 shared publicationsA. Soderbarg
3 shared publicationsB. Edholm
Uppsala University
3 shared publicationsJ. Ankarcrona
3 shared publications
Latest Publications
- 1 January 2016
- Published by Elsevier in Solid-State Electronics
- Vol. 115, 179-184
A new latch-free LIGBT on SOI with very high current density and low drive voltage
- 1 January 2016
- Published by Elsevier in Solid-State Electronics
- Vol. 115, 179-184
A new latch-free LIGBT on SOI with very high current density and low drive voltage
- 1 April 2012
- Published by Elsevier in Solid-State Electronics
- Vol. 70, 14-19
LDMOS-transistors on semi-insulating silicon-on-polycrystalline-silicon carbide substrates for improved RF and thermal properties
- 1 April 2012
- Published by Elsevier in Solid-State Electronics
- Vol. 70, 14-19
LDMOS-transistors on semi-insulating silicon-on-polycrystalline-silicon carbide substrates for improved RF and thermal properties
- 1 October 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Electrical and thermal characterization of 150 mm Silicon-on-polycrystalline-Silicon Carbide hybrid substrates
150 mm Silicon-on-polycrystalline-Silicon Carbide (poly-SiC) hybrid substrates, without intermediate oxide layers have been realized by hydrophilic wafer bonding of SOI- and poly-SiC wafers. A novel rapid thermal treatment step has been introduced before furnace annealing to avoid bubble formation, cracks and breakage. The final substrates are shown to be stress-free. Electrical and thermal characterization of devices manufactured on the substrate using a MOS process show excellent performance.
- 1 October 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Electrical and thermal characterization of 150 mm Silicon-on-polycrystalline-Silicon Carbide hybrid substrates
150 mm Silicon-on-polycrystalline-Silicon Carbide (poly-SiC) hybrid substrates, without intermediate oxide layers have been realized by hydrophilic wafer bonding of SOI- and poly-SiC wafers. A novel rapid thermal treatment step has been introduced before furnace annealing to avoid bubble formation, cracks and breakage. The final substrates are shown to be stress-free. Electrical and thermal characterization of devices manufactured on the substrate using a MOS process show excellent performance.
- 1 February 2010
- Published by Elsevier in Solid-State Electronics
- Vol. 54 (2) , 171-177
Large-signal analysis of substrate effects in RF-power SOI-LDMOS transistors
- 1 February 2010
- Published by Elsevier in Solid-State Electronics
- Vol. 54 (2) , 171-177
Large-signal analysis of substrate effects in RF-power SOI-LDMOS transistors
- Open Access
- 1 September 2009
- Published by Elsevier in Procedia Chemistry
- Vol. 1 (1) , 80-83
Resistance Electric Field Dependence and Time Drift of Piezoresistive Single Crystalline Silicon Nanofilms
- 1 September 2009
- Published by Elsevier in Procedia Chemistry
- Vol. 1 (1) , 80-83
Open AccessResistance Electric Field Dependence and Time Drift of Piezoresistive Single Crystalline Silicon Nanofilms
- 24 February 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 56 (3) , 505-511
Investigation of SOI-LDMOS for RF-Power Applications Using Computational Load Pull
Small-signal and computational load-pull simulations are used to investigate the effect of substrate resistivity on efficiency in high-power operation of high-frequency silicon-on-insulator-LDMOS transistors. Identical transistors are studied on substrates with different resistivities. Using computational load pull, their high-power performance is evaluated. The results are compared to previous investigations, relating the off-state output resistance to high-efficiency operation. From the large-signal simulation, an output circuit model based on a load-line match is extracted with parameters traceable from small-signal simulations. It is shown that, albeit high off-state output resistance is a good indication, it is not sufficient for high efficiency in a high-power operation. The bias and frequency dependence of the coupling through the substrate makes a more detailed on-state analysis necessary. It is shown that very low resistivity and high-resistivity SOI substrates both result in a high efficiency at the studied frequency and bias point. It is also shown that a normally doped medium-resistivity substrate results in a significantly lower efficiency.
- 24 February 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 56 (3) , 505-511
Investigation of SOI-LDMOS for RF-Power Applications Using Computational Load Pull
Small-signal and computational load-pull simulations are used to investigate the effect of substrate resistivity on efficiency in high-power operation of high-frequency silicon-on-insulator-LDMOS transistors. Identical transistors are studied on substrates with different resistivities. Using computational load pull, their high-power performance is evaluated. The results are compared to previous investigations, relating the off-state output resistance to high-efficiency operation. From the large-signal simulation, an output circuit model based on a load-line match is extracted with parameters traceable from small-signal simulations. It is shown that, albeit high off-state output resistance is a good indication, it is not sufficient for high efficiency in a high-power operation. The bias and frequency dependence of the coupling through the substrate makes a more detailed on-state analysis necessary. It is shown that very low resistivity and high-resistivity SOI substrates both result in a high efficiency at the studied frequency and bias point. It is also shown that a normally doped medium-resistivity substrate results in a significantly lower efficiency.
- 1 January 2009
- Published by Elsevier in Solid-State Electronics
- Vol. 53 (1) , 86-94
A computational load-pull method with harmonic loading for high-efficiency investigations
- 1 January 2009
- Published by Elsevier in Solid-State Electronics
- Vol. 53 (1) , 86-94
A computational load-pull method with harmonic loading for high-efficiency investigations
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 222-225
A Computational Load-Pull Method for TCAD Optimization of RF-Power Transistors in Bias-Modulation Applications
In this paper a method for TCAD evaluation of RF-Power transistors for high-efficiency operation using drain bias-modulation is presented. The method is based on large signal time-domain transient computational load-pull. With the method, intrinsic device parasitics and mechanisms affecting device efficiency under drain bias modulation can be investigated and optimized for the application making it very useful for RFIC design. A case study has been done on a CMOS compatible LDMOS. For verification under dynamic operation two-tone signals with varying envelope has been simulated. The results show a possible 15% increase in the efficiency of a modulated signal for the studied device at the expense of increased phase distortion observable also in the time-domain waveforms generated. Since the method is based on TCAD it is also useful in the investigation of e.g. dynamic breakdown during high envelope under bias-modulation operation.
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 222-225
A Computational Load-Pull Method for TCAD Optimization of RF-Power Transistors in Bias-Modulation Applications
In this paper a method for TCAD evaluation of RF-Power transistors for high-efficiency operation using drain bias-modulation is presented. The method is based on large signal time-domain transient computational load-pull. With the method, intrinsic device parasitics and mechanisms affecting device efficiency under drain bias modulation can be investigated and optimized for the application making it very useful for RFIC design. A case study has been done on a CMOS compatible LDMOS. For verification under dynamic operation two-tone signals with varying envelope has been simulated. The results show a possible 15% increase in the efficiency of a modulated signal for the studied device at the expense of increased phase distortion observable also in the time-domain waveforms generated. Since the method is based on TCAD it is also useful in the investigation of e.g. dynamic breakdown during high envelope under bias-modulation operation.
- 31 July 2008
- Published by Elsevier in Solid-State Electronics
- Vol. 52 (7) , 1024-1031
Investigation of the non-linear input capacitance in LDMOS transistors and its contribution to IMD and phase distortion
- 31 July 2008
- Published by Elsevier in Solid-State Electronics
- Vol. 52 (7) , 1024-1031
Investigation of the non-linear input capacitance in LDMOS transistors and its contribution to IMD and phase distortion
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE International SOI Conference
- No. 1078621X,p. 115-116
Novel Silicon-on-SiC Substrate with Superior Thermal and RF Performance
A novel Si-on-SiC hybrid substrate is demonstrated using MOSFET devices. This is the first demonstration ever of this technology, to the best knowledge of the authors. The direct bonded substrate uses polysilicon as an intermediate layer, thereby eluding the thermally unfavourable SiO2. The MOSFET characteristics as well as the absence of self-heating effects are shown and are benchmarked against devices on commercially available epitaxial and SOI wafers, as well as Si-on-poly -SiC (SoPSiC, PicoGiga). Previous efforts to improve the thermal properties by replacing the SiO2 insulator have included diamond, AIN, and Al2O3.
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE International SOI Conference
- No. 1078621X,p. 115-116
Novel Silicon-on-SiC Substrate with Superior Thermal and RF Performance
A novel Si-on-SiC hybrid substrate is demonstrated using MOSFET devices. This is the first demonstration ever of this technology, to the best knowledge of the authors. The direct bonded substrate uses polysilicon as an intermediate layer, thereby eluding the thermally unfavourable SiO2. The MOSFET characteristics as well as the absence of self-heating effects are shown and are benchmarked against devices on commercially available epitaxial and SOI wafers, as well as Si-on-poly -SiC (SoPSiC, PicoGiga). Previous efforts to improve the thermal properties by replacing the SiO2 insulator have included diamond, AIN, and Al2O3.