Erminio Salvatore
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Erminio Salvatore has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Giuseppe Modoni
University of Cassino and Southern Lazio
6 shared publications Davide Grassi
Injection & Foundation Engineering Manager, Master Builders Solutions, Via Vicinale delle Corti 21, 31100, Treviso (TV), Italy; Research Fellow, DISAT, Bicocca Univ., Piazza della Scienza 4, 20126, Milan (IT), Italy
2 shared publications- Giovanni Spagnoli
Sweco GmbH
2 shared publications Giuseppe Modoni
Full Professor, DICEM, Univ. of Cassino and Southern Lazio, Via G. Di Biasio 43, 03043, Cassino (IT), Italy
2 shared publications- Maciej Ochmański
Department of Geotechnics and Roads, Silesian University of Technology, Gliwice, Poland
2 shared publications - Paolo Croce
University of Cassino and Southern Lazio
2 shared publications
Latest Publications
- 2 September 2026
- Published by Springer Nature
- p. 146-154
Long-Term Settlements of Earth Dams
- 2 August 2026
- Published by Springer Nature
- p. 53-68
Beyond Empiricism in Ground Improvement: A Scientific Approach for Low Pressure Grouting in Liquefiable Soils
- 2 August 2026
- Published by Springer Nature
- p. 53-68
Beyond Empiricism in Ground Improvement: A Scientific Approach for Low Pressure Grouting in Liquefiable Soils
- 3 October 2024
- Published by Springer Nature
- p. 1-18
Observation and Theory to Improve the Efficiency of Jet Grouting
- 3 October 2024
- Published by Springer Nature
- p. 1-18
Observation and Theory to Improve the Efficiency of Jet Grouting
- Open Access
- 17 May 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (12) , 8007-8022
Compacted sand–bentonite mixtures for the confinement of waste landfills
This paper illustrates the results of an experimental study on sand–bentonite mixtures for their use as confinement barriers for solid waste landfills. The mixtures have been prepared parametrically varying the percentage of bentonite. The sample preparation method was established willing to simulate the compaction processes on site. In fact, the compacted samples were tested following two different stress-wetting paths representative of the possible stress and imbibition sequences occurring on a landfill confinement barrier. In the first case, the barrier comes into contact with rainwater before being subjected to the overloading stress induced by waste disposal, while, in the second case, the barrier is overloaded by the waste before being wetted by the leachate. The compressibility and permeability of the sand–bentonite mixtures were determined, in both cases, by oedometric compression tests. The experimental results are analysed and compared in order to evaluate the influence of the bentonite content on the mechanical and hydraulic behaviour of the mixture. Interpretation of the results is also accomplished with a micro-mechanical investigation of the mixtures fabric. Suitable compositions of sand and bentonite are finally proposed for the design of effective confinement barriers.
- 17 May 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (12) , 8007-8022
Open AccessCompacted sand–bentonite mixtures for the confinement of waste landfills
This paper illustrates the results of an experimental study on sand–bentonite mixtures for their use as confinement barriers for solid waste landfills. The mixtures have been prepared parametrically varying the percentage of bentonite. The sample preparation method was established willing to simulate the compaction processes on site. In fact, the compacted samples were tested following two different stress-wetting paths representative of the possible stress and imbibition sequences occurring on a landfill confinement barrier. In the first case, the barrier comes into contact with rainwater before being subjected to the overloading stress induced by waste disposal, while, in the second case, the barrier is overloaded by the waste before being wetted by the leachate. The compressibility and permeability of the sand–bentonite mixtures were determined, in both cases, by oedometric compression tests. The experimental results are analysed and compared in order to evaluate the influence of the bentonite content on the mechanical and hydraulic behaviour of the mixture. Interpretation of the results is also accomplished with a micro-mechanical investigation of the mixtures fabric. Suitable compositions of sand and bentonite are finally proposed for the design of effective confinement barriers.
- 1 January 2024
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 150 (1)
Nanosilica Grout Permeation in Sand: Experimental Investigation and Modeling
- 1 January 2024
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 150 (1)
Nanosilica Grout Permeation in Sand: Experimental Investigation and Modeling
- 1 April 2022
- Published by Springer Nature in Acta Geotechnica
- Vol. 17 (11) , 5073-5087
Conditioning clayey soils with a dispersant agent for Deep Soil Mixing application: laboratory experiments and artificial neural network interpretation
- 1 April 2022
- Published by Springer Nature in Acta Geotechnica
- Vol. 17 (11) , 5073-5087
Conditioning clayey soils with a dispersant agent for Deep Soil Mixing application: laboratory experiments and artificial neural network interpretation
- Open Access
- 1 October 2020
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 146 (10) , 04020108
Experimental Evidence of the Effectiveness and Applicability of Colloidal Nanosilica Grouting for Liquefaction Mitigation
The low viscosity and the ability to control solidification rate make colloidal nanosilica grout an excellent ground-improvement solution which is functional for different engineering purposes. A comprehensive experimental programme was performed to test the effectiveness and applicability of low-pressure injection of aqueous nanosilica suspensions against seismic liquefaction and to provide the experimental basis for the design, execution, and control of treatments. Scanning electron microscope and X-ray diffraction tests carried out on samples prepared with variable dosages enabled analysis of the microstructure of the original material and grouted sand. The influence of the grout composition on the solidification rate, viscosity, and shear strength of the treated sand was evaluated with preliminary tests to optimize the use of material. The efficacy of treatment in terms of stress–strain response and liquefaction resistance was investigated with a series of drained monotonic and undrained cyclic triaxial tests. A quality control procedure based on sonic wave transmission was established by performing bender element tests on samples cured for different times. The intent was to find the trade-off between a cost-effective use of materials and the mechanical performance of the treated sand.
- 1 October 2020
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 146 (10) , 04020108
Open AccessExperimental Evidence of the Effectiveness and Applicability of Colloidal Nanosilica Grouting for Liquefaction Mitigation
The low viscosity and the ability to control solidification rate make colloidal nanosilica grout an excellent ground-improvement solution which is functional for different engineering purposes. A comprehensive experimental programme was performed to test the effectiveness and applicability of low-pressure injection of aqueous nanosilica suspensions against seismic liquefaction and to provide the experimental basis for the design, execution, and control of treatments. Scanning electron microscope and X-ray diffraction tests carried out on samples prepared with variable dosages enabled analysis of the microstructure of the original material and grouted sand. The influence of the grout composition on the solidification rate, viscosity, and shear strength of the treated sand was evaluated with preliminary tests to optimize the use of material. The efficacy of treatment in terms of stress–strain response and liquefaction resistance was investigated with a series of drained monotonic and undrained cyclic triaxial tests. A quality control procedure based on sonic wave transmission was established by performing bender element tests on samples cured for different times. The intent was to find the trade-off between a cost-effective use of materials and the mechanical performance of the treated sand.
- 1 December 2019
- Published by Emerald Publishing in Géotechnique Letters
- Vol. 9 (4) , 334-339
Geostatistical analysis of strain localization in triaxial tests on sand
Strain localisation influences the behaviour of sheared soils in a way that the assumption of the continuum loses validity and may become inapplicable. This occurrence affects the interpretation of triaxial tests where samples are usually considered as representative elements of an equivalent continuum and a phenomenological interpretation is carried out to calibrate constitutive models. Considering the inherent and stress-induced heterogeneity of the material as a possible precursor of localisation, the evolution of porosity and strain fields is studied interpreting with statistical and geostatistical analyses, the results of X-ray computerised microtomography. The study is performed on sandy samples sheared in triaxial compression and extension. The analysis carried out before shearing shows a meaningful statistical heterogeneity of the porosity with correlation lengths to the order of a few grain diameters. The evolution on shearing reveals the onset of a second statistical population and of an anisotropic spatial variation dictated by strain localisation.
- 1 December 2019
- Published by Emerald Publishing in Géotechnique Letters
- Vol. 9 (4) , 334-339
Geostatistical analysis of strain localization in triaxial tests on sand
Strain localisation influences the behaviour of sheared soils in a way that the assumption of the continuum loses validity and may become inapplicable. This occurrence affects the interpretation of triaxial tests where samples are usually considered as representative elements of an equivalent continuum and a phenomenological interpretation is carried out to calibrate constitutive models. Considering the inherent and stress-induced heterogeneity of the material as a possible precursor of localisation, the evolution of porosity and strain fields is studied interpreting with statistical and geostatistical analyses, the results of X-ray computerised microtomography. The study is performed on sandy samples sheared in triaxial compression and extension. The analysis carried out before shearing shows a meaningful statistical heterogeneity of the porosity with correlation lengths to the order of a few grain diameters. The evolution on shearing reveals the onset of a second statistical population and of an anisotropic spatial variation dictated by strain localisation.
- 1 January 2018
- Published by Springer Nature
- p. 295-307
The Effects of Strain Localization on the Determination of Critical State Seen with Experimental and Numerical Models
- 1 January 2018
- Published by Springer Nature
- p. 295-307
The Effects of Strain Localization on the Determination of Critical State Seen with Experimental and Numerical Models
- Open Access
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 158, 92-97
Micromechanical Study of Cyclically Loaded Sands with x-ray Microtomography and Digital Image Correlation
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 158, 92-97
Open AccessMicromechanical Study of Cyclically Loaded Sands with x-ray Microtomography and Digital Image Correlation