Larisa Grigorjeva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Larisa Grigorjeva has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
- Krisjanis Smits
Baltic Biomaterials Centre of Excellence, Headquarters at Riga Technical University
10 shared publications Donats Millers
8 shared publicationsD. Millers
Institute of Solid State Physics, University of Latvia, 8 Kengaraga Str., LV-1063 Riga, Latvia
4 shared publications- Aleksejs Zolotarjovs
Institute of Solid State Physics, University of Latvia, Kengaraga Str. 8, LV-1063 Riga, Latvia
3 shared publications - Ivita Bite
Institute of Solid State Physics, University of Latvia, Kengaraga Str. 8, LV-1063 Riga, Latvia
3 shared publications Aleksejs Zolotarjovs
Univ Latvia, Inst Solid State Phys, Riga, Latvia
2 shared publications
Latest Publications
- 1 May 2019
- Published by Elsevier in Radiation Measurements
- Vol. 124, 29-34
Thermostimulated luminescence of plasma electrolytic oxidation coatings on 6082 aluminium surface
- 1 May 2019
- Published by Elsevier in Radiation Measurements
- Vol. 124, 29-34
Thermostimulated luminescence of plasma electrolytic oxidation coatings on 6082 aluminium surface
- 1 April 2019
- Published by Elsevier in Radiation Measurements
- Vol. 123, 69-73
Sub-nanosecond excitonic luminescence in ZnO:In nanocrystals
- 1 April 2019
- Published by Elsevier in Radiation Measurements
- Vol. 123, 69-73
Sub-nanosecond excitonic luminescence in ZnO:In nanocrystals
- Open Access
- 25 March 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 503 (1) , 012017
Electronic processes in doped ZnO nanopowders
ZnO nanocrystals, undoped and doped with Iridium or Indium were prepared by solar irradiation in Heliotron reactor in PROMES CNRS facilities, France. The comparative analysis of the excitonic spectra of ZnO single crystal and ZnO nanocrystals (NCs) doped with In and Ir was performed. It is shown that the excitonic processes in Ir doped nanocrystals coincide well with electronic processes in undoped NC and single crystal; however, the electronic processes in In-doped nanocrystals are significantly different from those in single crystal. The radioluminescence spectra of ZnO:In was analysed and additional luminescence band at ~3.18 eV was detected due to In-doping. The luminescence decay time depends on In concentration in nanocrystals and is significantly less in ZnO:In compared with undoped nanocrystals. The fast scintillation of ZnO:In makes this material promising for application
- 25 March 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 503 (1) , 012017
Open AccessElectronic processes in doped ZnO nanopowders
ZnO nanocrystals, undoped and doped with Iridium or Indium were prepared by solar irradiation in Heliotron reactor in PROMES CNRS facilities, France. The comparative analysis of the excitonic spectra of ZnO single crystal and ZnO nanocrystals (NCs) doped with In and Ir was performed. It is shown that the excitonic processes in Ir doped nanocrystals coincide well with electronic processes in undoped NC and single crystal; however, the electronic processes in In-doped nanocrystals are significantly different from those in single crystal. The radioluminescence spectra of ZnO:In was analysed and additional luminescence band at ~3.18 eV was detected due to In-doping. The luminescence decay time depends on In concentration in nanocrystals and is significantly less in ZnO:In compared with undoped nanocrystals. The fast scintillation of ZnO:In makes this material promising for application
- Open Access
- 1 December 2018
- Published by Walter de Gruyter GmbH in Latvian Journal of Physics and Technical Sciences
- Vol. 55 (6) , 35-42
Effect of in Doping on the ZnO Powders Morphology and Microstructure Evolution of ZnO:In Ceramics as a Material for Scintillators
Transparent ZnO ceramics are of interest for use as material for high-efficiency fast scintillators. Doping ZnO ceramics in order to improve complex of their properties is a promising direction. In the present research, the role of indium in the ZnO nanopowders surface interactions and in the change of microstructures and photoluminescence (PL) characteristics of sintered cera-mics is considered. Undoped and 0.13 wt% In doped ZnO ceramics are obtained by hot pressing sintering. It has been found that indium leads to the transition of initially faceted ZnO particles to rounded, contributing to good sintering with formation of diffusion active grain boundaries (GBs). Unlike ZnO ceramics, ZnO:In ceramics microstructure is characterised by the trans-crystalline mode of fracture, faceted GBs with places of zig-zag forms and predominant distribution of In at the GBs. Such indium induced modifications of GBs promote removal of point defects and reduce PL parameter α = I def /I exc in comparison with the undoped ceramics. Results characterise ZnO:In cera-mics with improved GBs properties as a prospective material for scintillators.
- 1 December 2018
- Published by Walter de Gruyter GmbH in Latvian Journal of Physics and Technical Sciences
- Vol. 55 (6) , 35-42
Open AccessEffect of in Doping on the ZnO Powders Morphology and Microstructure Evolution of ZnO:In Ceramics as a Material for Scintillators
Transparent ZnO ceramics are of interest for use as material for high-efficiency fast scintillators. Doping ZnO ceramics in order to improve complex of their properties is a promising direction. In the present research, the role of indium in the ZnO nanopowders surface interactions and in the change of microstructures and photoluminescence (PL) characteristics of sintered cera-mics is considered. Undoped and 0.13 wt% In doped ZnO ceramics are obtained by hot pressing sintering. It has been found that indium leads to the transition of initially faceted ZnO particles to rounded, contributing to good sintering with formation of diffusion active grain boundaries (GBs). Unlike ZnO ceramics, ZnO:In ceramics microstructure is characterised by the trans-crystalline mode of fracture, faceted GBs with places of zig-zag forms and predominant distribution of In at the GBs. Such indium induced modifications of GBs promote removal of point defects and reduce PL parameter α = I def /I exc in comparison with the undoped ceramics. Results characterise ZnO:In cera-mics with improved GBs properties as a prospective material for scintillators.
- 30 October 2018
- Published by Elsevier in Radiation Measurements
- Vol. 119, 140-143
Magnetron sputtering fabrication of α-Al2O3:Cr powders and their thermoluminescence properties
- 30 October 2018
- Published by Elsevier in Radiation Measurements
- Vol. 119, 140-143
Magnetron sputtering fabrication of α-Al2O3:Cr powders and their thermoluminescence properties
- 1 October 2015
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 234, 290-293
Gas sensitive luminescence of ZnO coatings obtained by plazma electrolytic oxidation
- 1 October 2015
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 234, 290-293
Gas sensitive luminescence of ZnO coatings obtained by plazma electrolytic oxidation
- Retracted
- 24 December 2013
- Published by Springer Nature in Journal of Materials Science
- Vol. 49 (8) , 3297
RETRACTED ARTICLE: Sintering effects of ZnO nanopowders with different morphologies
- 24 December 2013
- Published by Springer Nature in Journal of Materials Science
- Vol. 49 (8) , 3297
RetractedRETRACTED ARTICLE: Sintering effects of ZnO nanopowders with different morphologies
- Open Access
- 13 December 2013
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 49 (1) , 012005
Characterization of hydroxyapatite by time-resolved luminescence and FTIR spectroscopy
Time-resolved luminescence and FTIR absorption spectra of undoped and Eu and Ce doped hydroxyapatite nanocrystalline powders prepared by sol-gel method were studied. The luminescence band at 350–400 nm was detected and two decay times (11 ns and 38 ns) was determinated for Ce doped samples. The luminescence spectra and decay kinetics were analized for Eu doped nanopowders. The Eu3+ ion was incorporated in different Ca sites. The process of energy transfer to Eu3+ excited state (5D0) was detected from luminescence decay kinetics.
- 13 December 2013
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 49 (1) , 012005
Open AccessCharacterization of hydroxyapatite by time-resolved luminescence and FTIR spectroscopy
Time-resolved luminescence and FTIR absorption spectra of undoped and Eu and Ce doped hydroxyapatite nanocrystalline powders prepared by sol-gel method were studied. The luminescence band at 350–400 nm was detected and two decay times (11 ns and 38 ns) was determinated for Ce doped samples. The luminescence spectra and decay kinetics were analized for Eu doped nanopowders. The Eu3+ ion was incorporated in different Ca sites. The process of energy transfer to Eu3+ excited state (5D0) was detected from luminescence decay kinetics.
- Open Access
- 1 August 2013
- Published by Walter de Gruyter GmbH in Latvian Journal of Physics and Technical Sciences
- Vol. 50 (4) , 48-55
Photocatalitic Properties of Tio2 and ZnO Nanopowders / Tio2 un Zno Nanopulveru Fotokatalitiskās Īpašības
Photocatalytic activity of TiO2 and ZnO nanopowders is studied depending on the morphology, grain sizes and method of synthesizing. Photocatalysis of the prepared powders was evaluated by degradation of the methylene blue aqueous solution. Absorbance spectra (190-100 nm) were measured during exposure of the solution to UV light. The relationships between the photocatalytic activity and the particle size, crystal polymorph phases and grain morphology were analyzed. The photocatalytic activity of prepared TiO2 nanopowders has been found to depend of the anatase-to-rutile phase ratio. Comparison is given for the photocatalytic activity of ZnO nanopowders prepared by sol-gel and solar physical vapour deposition (SPVD) methods
- 1 August 2013
- Published by Walter de Gruyter GmbH in Latvian Journal of Physics and Technical Sciences
- Vol. 50 (4) , 48-55
Open AccessPhotocatalitic Properties of Tio2 and ZnO Nanopowders / Tio2 un Zno Nanopulveru Fotokatalitiskās Īpašības
Photocatalytic activity of TiO2 and ZnO nanopowders is studied depending on the morphology, grain sizes and method of synthesizing. Photocatalysis of the prepared powders was evaluated by degradation of the methylene blue aqueous solution. Absorbance spectra (190-100 nm) were measured during exposure of the solution to UV light. The relationships between the photocatalytic activity and the particle size, crystal polymorph phases and grain morphology were analyzed. The photocatalytic activity of prepared TiO2 nanopowders has been found to depend of the anatase-to-rutile phase ratio. Comparison is given for the photocatalytic activity of ZnO nanopowders prepared by sol-gel and solar physical vapour deposition (SPVD) methods
- Open Access
- 20 August 2012
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 38 (1) , 012037
Near-band luminescence of CdZnTe detector crystals
The near-band luminescence due to both neutral donor and neutral acceptor bound excitons (D0 Ex), (A0Ex) and its phonon replicas as well as luminescence of donor-acceptor pair (DAP) and deep energy level due to undefined defect state (A band) were studied in CZT detector crystals. The near-band luminescence correlation with detector characteristics was analyzed and the results could be applied for nondestructive detector material selection. It is obtained that some parameters such as a presence and intensity of A and DAP luminescence bands, the decay kinetics in A0Ex-1LO and DAP luminescence bands, are most important characteristics for detector material characterization.
- 20 August 2012
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 38 (1) , 012037
Open AccessNear-band luminescence of CdZnTe detector crystals
The near-band luminescence due to both neutral donor and neutral acceptor bound excitons (D0 Ex), (A0Ex) and its phonon replicas as well as luminescence of donor-acceptor pair (DAP) and deep energy level due to undefined defect state (A band) were studied in CZT detector crystals. The near-band luminescence correlation with detector characteristics was analyzed and the results could be applied for nondestructive detector material selection. It is obtained that some parameters such as a presence and intensity of A and DAP luminescence bands, the decay kinetics in A0Ex-1LO and DAP luminescence bands, are most important characteristics for detector material characterization.