Yuriy I. Velikodsky
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Yuriy I. Velikodsky has a total of 215 co-authors. Here are the top co-authors by number of shared publications:
- Viktor Korokhin
Kharkiv National University
18 shared publications - Vadym Kaydash
Institute of Astronomy, V. N. Karazin Kharkiv National University, Kharkiv, Ukraine
12 shared publications G. Videen
8 shared publications- Evgenij Zubko
University of Helsinki
6 shared publications Gorden Videen
6 shared publications- Andrii Tereshchenko
Department of Architecture, Land Management and Geographic Information Systems, National University “Kyiv Aviation Institute”, Liubomyra Huzara Aven., 1, 03058 Kyiv, Ukraine
4 shared publications
Latest Publications
- Open Access
Hierarchical Fourier–Mellin Phase-Correlation Matching for UAV Vision-Based Sensing: Independent Geometric Validation and Relative Orientation
We evaluated a hierarchical Fourier–Mellin phase-correlation method for sequential UAV images. Two global registration passes initialize recursive local matching; only fragments that pass spectral, geometric and radiometric checks produce correspondences. Against bundle-adjusted Pix4D geometry in 338 pairs from a previously examined Kyiv survey, 216 pairs (63.91%) yielded at least eight matches, 203 (60.06%) had at least eight near the reference epipolar lines, and 215 (63.61%) returned a pose. Of those 215 pairs, median rotation and baseline-direction errors were 0.0322° and 3.7987°. Of 146 well-conditioned pairs, the method returned only 52 poses, compared with 146 for SIFT. Of 150 pairs from five public JB3D sequences, the unchanged method returned 49 poses, with median errors of 0.5316° and 45.121°; SIFT, XFeat and Efficient LoFTR each returned 150. Equalizing the number of input matches in the 49 eligible pairs did not remove the advantage of SIFT or Efficient LoFTR. The spectral method exceeded Area-LSM in reference-valid yield in Kyiv, but its lower coverage limits its use as a sole matcher. Agreement with estimated camera geometry does not establish physical point identity or ground-point reconstruction accuracy.
Open AccessHierarchical Fourier–Mellin Phase-Correlation Matching for UAV Vision-Based Sensing: Independent Geometric Validation and Relative Orientation
We evaluated a hierarchical Fourier–Mellin phase-correlation method for sequential UAV images. Two global registration passes initialize recursive local matching; only fragments that pass spectral, geometric and radiometric checks produce correspondences. Against bundle-adjusted Pix4D geometry in 338 pairs from a previously examined Kyiv survey, 216 pairs (63.91%) yielded at least eight matches, 203 (60.06%) had at least eight near the reference epipolar lines, and 215 (63.61%) returned a pose. Of those 215 pairs, median rotation and baseline-direction errors were 0.0322° and 3.7987°. Of 146 well-conditioned pairs, the method returned only 52 poses, compared with 146 for SIFT. Of 150 pairs from five public JB3D sequences, the unchanged method returned 49 poses, with median errors of 0.5316° and 45.121°; SIFT, XFeat and Efficient LoFTR each returned 150. Equalizing the number of input matches in the 49 eligible pairs did not remove the advantage of SIFT or Efficient LoFTR. The spectral method exceeded Area-LSM in reference-valid yield in Kyiv, but its lower coverage limits its use as a sole matcher. Agreement with estimated camera geometry does not establish physical point identity or ground-point reconstruction accuracy.
- Open Access
- 20 September 2026
- Published by MDPI AG in Preprints.org
Hierarchical Fourier–Mellin Phase-Correlation Matching for UAV Vision-Based Sensing: Independent Geometric Validation and Relative Orientation
Accurate image correspondences are essential for geometric inference in vision-based UAV sensing because camera pose, 3D reconstruction, and spatial measurement depend on the geometric validity of matched points rather than on match count alone. This study develops a hierarchical Fourier–Mellin/phase-correlation framework for sequential RGB imagery acquired by a UAV camera sensor. Global similarity registration is followed by recursive local refinement with spectral, forward–backward, overlap, and radiometric acceptance criteria. Performance was assessed on 338 held-out stereo pairs using independently bundle-adjusted camera geometry as an external reference and a common relative-orientation pipeline for all methods. The proposed method achieved 63.91% matching success and 60.06% reference-valid success, compared with 89.05% and 27.81%, respectively, for Area-LSM. For successfully oriented pairs, median relative-rotation and baseline-direction errors were 0.0322° and 3.7987°, respectively. On common successfully oriented pairs, the proposed approach yielded lower errors than Area-LSM and ORB, whereas SIFT, Harris, Förstner, Moravec, and FAST generally retained higher success rates and lower errors. Baseline-direction accuracy was strongly dependent on parallax and homography dominance. These results support independent sensor-geometry validation and geometry-aware hybrid matching for UAV vision-based sensing.
- 20 September 2026
- Published by MDPI AG in Preprints.org
Open AccessHierarchical Fourier–Mellin Phase-Correlation Matching for UAV Vision-Based Sensing: Independent Geometric Validation and Relative Orientation
Accurate image correspondences are essential for geometric inference in vision-based UAV sensing because camera pose, 3D reconstruction, and spatial measurement depend on the geometric validity of matched points rather than on match count alone. This study develops a hierarchical Fourier–Mellin/phase-correlation framework for sequential RGB imagery acquired by a UAV camera sensor. Global similarity registration is followed by recursive local refinement with spectral, forward–backward, overlap, and radiometric acceptance criteria. Performance was assessed on 338 held-out stereo pairs using independently bundle-adjusted camera geometry as an external reference and a common relative-orientation pipeline for all methods. The proposed method achieved 63.91% matching success and 60.06% reference-valid success, compared with 89.05% and 27.81%, respectively, for Area-LSM. For successfully oriented pairs, median relative-rotation and baseline-direction errors were 0.0322° and 3.7987°, respectively. On common successfully oriented pairs, the proposed approach yielded lower errors than Area-LSM and ORB, whereas SIFT, Harris, Förstner, Moravec, and FAST generally retained higher success rates and lower errors. Baseline-direction accuracy was strongly dependent on parallax and homography dominance. These results support independent sensor-geometry validation and geometry-aware hybrid matching for UAV vision-based sensing.
- Open Access
- 13 December 2021
- Published by Vilnius Gediminas Technical University in Geodesy and Cartography
- Vol. 47 (4) , 191-199
COMPARATIVE ANALYSIS FOR METHODS OF BUILDING DIGITAL ELEVATION MODELS FROM TOPOGRAPHIC MAPS USING GEOINFORMATION TECHNOLOGIES
The article considers the question of estimating the accuracy of interpolation methods for building digital elevation models using Soviet topographic maps. The territory of the Kursk region of the Russian Federation was used as the study area, because it is located on the Central Russian Upland and characterized by the complex structure of the vertical and horizontal dissection of the relief. Contour lines automatically obtained using a Python algorithm were used as the initial elevation data to build a digital elevation model. Digital elevation models obtained by thirteen different interpolation methods in ArcGIS and Surfer software were built and analyzed. Special attention is paid to the ANUDEM method, which allows to obtain hydrologically correct digital elevation models. Recommendations for the use of one or another method of interpolation are given. The results can be useful for professionals who use topographic maps in their work and deals with the design using digital elevation models.
- 13 December 2021
- Published by Vilnius Gediminas Technical University in Geodesy and Cartography
- Vol. 47 (4) , 191-199
Open AccessCOMPARATIVE ANALYSIS FOR METHODS OF BUILDING DIGITAL ELEVATION MODELS FROM TOPOGRAPHIC MAPS USING GEOINFORMATION TECHNOLOGIES
The article considers the question of estimating the accuracy of interpolation methods for building digital elevation models using Soviet topographic maps. The territory of the Kursk region of the Russian Federation was used as the study area, because it is located on the Central Russian Upland and characterized by the complex structure of the vertical and horizontal dissection of the relief. Contour lines automatically obtained using a Python algorithm were used as the initial elevation data to build a digital elevation model. Digital elevation models obtained by thirteen different interpolation methods in ArcGIS and Surfer software were built and analyzed. Special attention is paid to the ANUDEM method, which allows to obtain hydrologically correct digital elevation models. Recommendations for the use of one or another method of interpolation are given. The results can be useful for professionals who use topographic maps in their work and deals with the design using digital elevation models.
- 1 January 2020
- Published by State University "Kyiv Aviation Institute" in Astronomical School’s Report
- Vol. 16 (1) , 16-21
Telescope pointing software for slit spectroscopy of the lunar exosphere
Detailed description of the original pointing software used for spectral observations of the lunar exosphere is given. The software allows to point the spectrograph of 2-m telescope of Terskol Observatory inside and outside the lunar disk with accuracy of about 2″. Observations of Na lines in the exosphere of the Moon on January 8 and October 7, 2017, do not reveal quick variability of Na lines at time scales of about 20 minutes. On January 8, 2017, the intensity of Na lines above the south pole of the Moon was stronger than that above the north pole of the Moon.
- 1 January 2020
- Published by State University "Kyiv Aviation Institute" in Astronomical School’s Report
- Vol. 16 (1) , 16-21
Telescope pointing software for slit spectroscopy of the lunar exosphere
Detailed description of the original pointing software used for spectral observations of the lunar exosphere is given. The software allows to point the spectrograph of 2-m telescope of Terskol Observatory inside and outside the lunar disk with accuracy of about 2″. Observations of Na lines in the exosphere of the Moon on January 8 and October 7, 2017, do not reveal quick variability of Na lines at time scales of about 20 minutes. On January 8, 2017, the intensity of Na lines above the south pole of the Moon was stronger than that above the north pole of the Moon.
- 1 November 2019
- Published by Elsevier in Planetary and Space Science
- Vol. 177, 104689
Detection of impact-produced dust clouds near the lunar terminator
- 1 November 2019
- Published by Elsevier in Planetary and Space Science
- Vol. 177, 104689
Detection of impact-produced dust clouds near the lunar terminator
- 1 October 2018
- Published by Elsevier in Planetary and Space Science
- Vol. 160, 120-135
Using LROC WAC data for Lunar surface photoclinometry
- 1 October 2018
- Published by Elsevier in Planetary and Space Science
- Vol. 160, 120-135
Using LROC WAC data for Lunar surface photoclinometry
- 1 September 2018
- Published by Pleiades Publishing Ltd in JETP Letters
- Vol. 108 (6) , 356-363
Formation of Dusty Plasma Clouds at Meteoroid Impact on the Surface of the Moon
The nature of two dusty plasma clouds appearing because of the impact of a meteoroid on the surface of the Moon has been discussed. It has been shown that one of the clouds is formed by particles (or...
- 1 September 2018
- Published by Pleiades Publishing Ltd in JETP Letters
- Vol. 108 (6) , 356-363
Formation of Dusty Plasma Clouds at Meteoroid Impact on the Surface of the Moon
The nature of two dusty plasma clouds appearing because of the impact of a meteoroid on the surface of the Moon has been discussed. It has been shown that one of the clouds is formed by particles (or...
- 1 April 2018
- Published by Elsevier in Planetary and Space Science
- Vol. 153, 22-38
Characterizing dark mantle deposits in the lunar crater Alphonsus
- 1 April 2018
- Published by Elsevier in Planetary and Space Science
- Vol. 153, 22-38
Characterizing dark mantle deposits in the lunar crater Alphonsus