Maksim Ermolaev
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Maksim Ermolaev has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Gregory Belenky
Department of Electrical and Computer Engineering, Stony Brook University, Stony Brook, New York 11794, USA
5 shared publicationsGela Kipshidze
Department of ECE, Stony Brook University 1 , Stony Brook, New York 11794, USA
4 shared publications- Sergey Suchalkin
Department of Electrical and Computer Engineering Stony Brook University 11794 Stony Brook New York USA
4 shared publications - Mykhaylo Ozerov
National High Magnetic Field Laboratory, Florida State University, Tallahassee, Florida 32310, USA
3 shared publications Seongphill Moon
National High Magnetic Field Laboratory, Tallahassee, Florida 32310, USA
3 shared publicationsDmitry Smirnov
National High Magnetic Field Laboratory, Tallahassee, Florida 32310, USA
2 shared publications
Latest Publications
- 6 September 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (12) , L121201
-factor engineering with InAsSb alloys toward zero band gap limitBand gap is known as an effective parameter for tuning the Landé factor in semiconductors and can be manipulated in a wide range through the bowing effect in ternary alloys. In this work, using the recently developed virtual substrate technique, high-quality InAsSb alloys throughout the whole Sb composition range are fabricated and a large factor of at the minimum band gap of eV, which is almost twice that in bulk InSb, is found. Further analysis to the zero gap limit reveals a possible gigantic factor of with a peculiar relativistic Zeeman effect that disperses as the square root of magnetic field. Such a -factor enhancement toward the narrow gap limit cannot be quantitatively described by the conventional Roth formula, as the orbital interaction effect between the nearly triply degenerated bands becomes the dominant source for the Zeeman splitting. These results may provide insights into realizing large factors and spin-polarized states in semiconductors and topological materials.- 6 September 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (12) , L121201
-factor engineering with InAsSb alloys toward zero band gap limitBand gap is known as an effective parameter for tuning the Landé factor in semiconductors and can be manipulated in a wide range through the bowing effect in ternary alloys. In this work, using the recently developed virtual substrate technique, high-quality InAsSb alloys throughout the whole Sb composition range are fabricated and a large factor of at the minimum band gap of eV, which is almost twice that in bulk InSb, is found. Further analysis to the zero gap limit reveals a possible gigantic factor of with a peculiar relativistic Zeeman effect that disperses as the square root of magnetic field. Such a -factor enhancement toward the narrow gap limit cannot be quantitatively described by the conventional Roth formula, as the orbital interaction effect between the nearly triply degenerated bands becomes the dominant source for the Zeeman splitting. These results may provide insights into realizing large factors and spin-polarized states in semiconductors and topological materials.- 21 December 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (25) , 250501
Perspective on advances in InAsSb type II superlattices grown on virtual substrates
Metamorphic InAs1−xSbx/InAs1−ySby strained layer superlattice (SLS) structures allow for great flexibility of engineering artificial band structures and, therefore, the design of new optical and electrical properties. By using tailored virtual substrates, the average lattice constant of the SLS can be chosen anywhere between 0.606 nm (InAs) and 0.648 nm (InSb), which allows for flexibility in the choice of compositions and thicknesses of the constituent layers. These parameters can then be tuned in a wide range, which is not possible when using binary substrates. Specifically, the layer thicknesses can be nearly arbitrarily small. Short period InAs1−xSbx/InAs1−ySby SLSs exhibit strong optical absorption and improved perpendicular carrier transport and can demonstrate Dirac-type carrier dispersion, a large g-factor, and deep band inversion. The prospects for the development of devices based on these structures are discussed.
- 21 December 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (25) , 250501
Perspective on advances in InAsSb type II superlattices grown on virtual substrates
Metamorphic InAs1−xSbx/InAs1−ySby strained layer superlattice (SLS) structures allow for great flexibility of engineering artificial band structures and, therefore, the design of new optical and electrical properties. By using tailored virtual substrates, the average lattice constant of the SLS can be chosen anywhere between 0.606 nm (InAs) and 0.648 nm (InSb), which allows for flexibility in the choice of compositions and thicknesses of the constituent layers. These parameters can then be tuned in a wide range, which is not possible when using binary substrates. Specifically, the layer thicknesses can be nearly arbitrarily small. Short period InAs1−xSbx/InAs1−ySby SLSs exhibit strong optical absorption and improved perpendicular carrier transport and can demonstrate Dirac-type carrier dispersion, a large g-factor, and deep band inversion. The prospects for the development of devices based on these structures are discussed.
- Open Access
- 21 January 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 116 (3) , 032101
Dirac energy spectrum and inverted bandgap in metamorphic InAsSb/InSb superlattices
A Dirac-type energy spectrum was demonstrated in gapless ultrashort-period metamorphic InAsSb/InSb superlattices by angle-resolved photoemission spectroscopy (ARPES) measurements. The Fermi velocity value of 7.4 × 105 m/s in a gapless superlattice with a period of 6.2 nm is in good agreement with the results of magnetoabsorption experiments. An “inverted” bandgap opens in the center of the Brillouin zone at higher temperatures and in the superlattice with a larger period. The ARPES data indicate the presence of a surface electron accumulation layer.
- 21 January 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 116 (3) , 032101
Open AccessDirac energy spectrum and inverted bandgap in metamorphic InAsSb/InSb superlattices
A Dirac-type energy spectrum was demonstrated in gapless ultrashort-period metamorphic InAsSb/InSb superlattices by angle-resolved photoemission spectroscopy (ARPES) measurements. The Fermi velocity value of 7.4 × 105 m/s in a gapless superlattice with a period of 6.2 nm is in good agreement with the results of magnetoabsorption experiments. An “inverted” bandgap opens in the center of the Brillouin zone at higher temperatures and in the superlattice with a larger period. The ARPES data indicate the presence of a surface electron accumulation layer.
- 19 November 2018
- Published by AIP Publishing in Applied Physics Letters
- Vol. 113 (21) , 213104
Metamorphic narrow-gap InSb/InAsSb superlattices with ultra-thin layers
Metamorphic strain compensated InSb/InAsSb0.52 superlattices (SLs) with ultrathin layers and different periods grown on GaSb substrate were designed, fabricated, and characterized. It was shown that a period increase from 3 to 6.2 nm reduced the effective bandgap energy from 70 to 0 meV. A further increase in the period leads to inversion of the valence and conduction bands. Magneto-optical experiments demonstrated that Dirac-like carrier dispersion is characteristic of almost gapless InSb/InAsSb0.52 SLs. Indication of hole transport enhancement over that found in InAsSb/InAsSb SL structures is presented.
- 19 November 2018
- Published by AIP Publishing in Applied Physics Letters
- Vol. 113 (21) , 213104
Metamorphic narrow-gap InSb/InAsSb superlattices with ultra-thin layers
Metamorphic strain compensated InSb/InAsSb0.52 superlattices (SLs) with ultrathin layers and different periods grown on GaSb substrate were designed, fabricated, and characterized. It was shown that a period increase from 3 to 6.2 nm reduced the effective bandgap energy from 70 to 0 meV. A further increase in the period leads to inversion of the valence and conduction bands. Magneto-optical experiments demonstrated that Dirac-like carrier dispersion is characteristic of almost gapless InSb/InAsSb0.52 SLs. Indication of hole transport enhancement over that found in InAsSb/InAsSb SL structures is presented.
- 2 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 30 (9) , 869-872
GaSb-Based Type-I Quantum Well 3–3.5- $\mu$ m Cascade Light Emitting DiodesMid-infrared light emitting diodes based on cascade pumping of the type-I quantum wells were designed and fabricated. The 500-μm-diameter mesa ten-stage devices emitted more than 2 mW of continuous wave power in a wide spectrum peaking at 3.1 μm at room temperature. More than 6 mW was obtained at 77 K. The above-mentioned output power levels were measured from an uncoated window in the substrate-side contact metallization of epi-side-down mounted emitters. The maximum output power and the device operating voltage are roughly scaled with the number of cascades in the device heterostructure. The low-current device slope efficiency per stage decreased with increasing the acceptor doping level in the layers adjacent to the active quantum wells. Increase of the number of quantum wells in each stage from one to three led to about 25% improvement of the output power at 300 K.
- 2 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 30 (9) , 869-872
GaSb-Based Type-I Quantum Well 3–3.5- $\mu$ m Cascade Light Emitting DiodesMid-infrared light emitting diodes based on cascade pumping of the type-I quantum wells were designed and fabricated. The 500-μm-diameter mesa ten-stage devices emitted more than 2 mW of continuous wave power in a wide spectrum peaking at 3.1 μm at room temperature. More than 6 mW was obtained at 77 K. The above-mentioned output power levels were measured from an uncoated window in the substrate-side contact metallization of epi-side-down mounted emitters. The maximum output power and the device operating voltage are roughly scaled with the number of cascades in the device heterostructure. The low-current device slope efficiency per stage decreased with increasing the acceptor doping level in the layers adjacent to the active quantum wells. Increase of the number of quantum wells in each stage from one to three led to about 25% improvement of the output power at 300 K.