ZLZhenlong Liu

Zhenlong Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Zhenlong Liu has a total of 44 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Piezoelectric-Transducer-Controlled Low-Temperature Microwave Atmospheric Pressure Plasma Jet

    by Chaoxia Zhao, Ruiming Lu, Ming Luo, Bozhang Lan, Siyi Yang, Peng Liu, Yilin Liu, Zhenlong Liu, Zelin Zheng, Damin Gou, et al.

  • Bandwidth-Extended High-Efficiency Rectifier Using Shunt and Serial Impedance Compensation

    by Pengde Wu, Yunfei Li, Peng-Yu Yu, Yuhua Cheng, Zhenlong Liu, Changjun Liu

    This letter presents a compact microwave rectifier using a novel impedance matching technique to extend the operating bandwidth. Originating from conducting impedance controls at the edge and central part of the targeted frequency band, the matching network can manipulate the impedance over a wide frequency band. By paralleling an open-circuit stub and then connecting a capacitance in series, the impedance variation in the rectifying diode can be significantly reduced. Theoretical analysis and simulations of the proposed structure were carried out. A prototype was fabricated, which demonstrates a broadband bandwidth of 51.9% (2.5–4.25 GHz) where the RF–dc conversion efficiency is higher than 70% at 11 dBm, and $|S_{11}|$ is also less than –10 dB within this frequency range.

  • Effect of Free-Running Frequency Fluctuation on the Injection-Locking Magnetron Based on Conditional Distribution Analysis

    by Yi Zhang, Chao Huang, Chaguo Mi, Yibing Yao, Chaoxia Zhao, Zhenglong Liu, Ce Wang, Kama Huang

    Injection-locking technology is a primary way to solve the frequency instability and uncontrollable problems of a magnetron; however, conventional injection-locking theory ignores the free-running frequency fluctuation of a magnetron, which usually exists in vacuum sources. Herein, the injection locking of a magnetron, considering its free-running frequency fluctuation, is systematically studied based on statistics and probability theory. First, the output frequency of an injected magnetron with a specific hypothetical single free-running frequency is demonstrated. Then, the fluctuation of the unstable instantaneous frequency of a free-running magnetron could be statistically taken as a random variable, in which each element could be one specific single free-running frequency with a certain probability. By using the theorem of conditional probability and joint distribution, the probability density function of the output frequency of the injected magnetron can be derived. Analysis based on the derived equations indicates that the injection-locking bandwidth (BWL) is less than that calculated from Adler’s condition if the fluctuation of the free-running magnetron’s frequency is considered; moreover, BWL decreases with increasing free-running frequency bandwidth, while the peak frequency pulling bandwidth (BWP) increases. The experimental results show that BWL decreases from 5.8 to 4.8 MHz as the 3 dB bandwidth of the free-running magnetron spectrum increases from 0.38 to 1.05 MHz. Simultaneously, BWP increases from 6.8 to 10.8 MHz, which is consistent with the theoretical prediction. In general, this study illustrates the vital importance of the free-running frequency condition on the injection-locking results of a magnetron and develops the injection-locking theory.


  • Cellulose nanocrystals as sustainable additives in water-based cutting fluids

    by Zhenlong Liu, Ge Zhu, Jianchun Dai, Yan Zhu, Ning Lin


  • Effect of Transverse DC Magnetic Field on the Impedance Matching and Morphology of a Microwave Atmospheric Pressure Plasma Jet

    by Chuan Peng, Yilin Liu, Wenjiao Luo, Zhenlong Liu, Boyu Wang, Li Wu, Chaoxia Zhao, Siyao Qi, Yao Liu, Ce Wang, et al.

    Impedance matching plays a vital role in a microwave atmospheric pressure plasma jet (MW-APPJ). However, real-time tuning of MW-APPJ impedance matching has rarely been investigated. In this study, we have found that the dissipated microwave power and length of a MW-APPJ are effected by the application of a DC-bias magnetic field. By placing a MW-APPJ in a gap between two electromagnets, the consumed microwave power varied with the insertion position of the MW-APPJ. When the MW-APPJ was fixed at the center of the electromagnets, the consumed microwave power decreased as the DC magnetic field intensities increased, from 12 to 750 mT. The variation of consumed microwave power was much higher at lower gas velocities, which indicates that the DC magnetic field has a relatively strong effect on microwave plasma with lower gas velocity. The length of the plasma jet also decreased with increasing DC magnetic field, which was mainly due to the variation of the consumed microwave power. To explain these interesting phenomena, the effective permittivity of microwave plasma and the equivalent circuit model of a generator under DC-bias magnetic field have been analyzed. The effective permittivity of the plasma is related to its cyclotron frequency, which is a function of the DC-bias magnetic field. The variation of the effective permittivity changes the load impedance of the plasma generator. Therefore, the reflection coefficient of the plasma generator is adjusted and the length of the plasma jet varies with the change in consumed microwave power.


  • Compact High-Efficiency Broadband Rectifier With Multi-Stage-Transmission-Line Matching

    by Pengde Wu, Shao Ying Huang, Wenshen Zhou, Wenwei Yu, Zhenlong Liu, Xiaojie Chen, Changjun Liu

    This brief proposes a compact high-efficiency broadband microwave rectifier for energy harvesting. The proposed rectifier is designed to operate over a broad bandwidth spanning from 2 to 3 GHz and an input power dynamic range from 0 dBm to 10 dBm. In the proposed structure, a compact broadband low-loss matching network and a dc-pass filter with a broad stopband were designed, leading to a high conversion efficiency in a wide frequency range with compactness. For the matching network, low loss and compact size were achieved by strategically choosing and designing three transmission line segments. Moreover, the proposed dc-pass filter is compact and can effectively block broadband RF signal and its in-band high order harmonics. Theoretical analysis and simulations of the proposed structure were carried out. A prototype was fabricated, which demonstrates a broadband bandwidth of 41.5% (2.0-3.05 GHz) where the RF-dc power conversion efficiency is higher than 70% at an input power of 10 dBm. The measured efficiency remains over 45% within 1.9-3.05 GHz when the input power decreases to 0 dBm. The maximum measured efficiency is 75.8% at an input power of 14 dBm.


  • Experimental Studies on a Four-Way Microwave Power Combining System Based on Hybrid Injection-Locked 20-kW S-Band Magnetrons

    by Zhenlong Liu, Xiaojie Chen, Menglin Yang, Pengde Wu, Kama Huang, Changjun Liu

    A microwave power combining system based on four 20-kW hybrid injection-locked magnetrons in the S-band was proposed and presented. A high-power-capacity power combiner was designed, and the behaviors of the hybrid injection-locking magnetrons were qualitatively explained. An excellent output amplitude stability of 0.01 dB (peak-to-peak), a phase stability of ± 0.9° (peak-to-peak), and a spur suppression ratio of -65.0 dBc at 500 kHz were achieved when the injection ratio was 0.07. The proposed four-way 20-kW magnetron coherent power combining system exhibits a total output power of over 60.6 kW and a combining efficiency of 91.5%. Simultaneously, neither real-time automatic phase tuning processes nor high-isolation circulators are required in the system. The results show that a high-efficiency magnetron power combining system has the potential to be applied as a cost-effective high-power microwave source for industrial applications. To the best of the authors' knowledge, a microwave power combining system featuring four 20-kW S-band continuous wave magnetrons has been successfully testified for the first time. The power output of over 60.0 kW and combining efficiency of 91.5% set a new performance record for S-band magnetron power combining systems and represent the best phase noise performance reported for any injection-locked magnetron with an output power of over 15 kW.


  • High-Efficient Rectifier With Extended Input Power Range Based on Self-Tuning Impedance Matching

    by Pengde Wu, Shao Ying Huang, Wenshen Zhou, Zhi Hua Ren, Zhenlong Liu, Kama Huang, Changjun Liu

    In this letter, a microwave rectifier with a wide input power range is presented by proposing a self-tuning impedance matching (STIM). The STIM consists of a varactor reversely biased by the output voltage of the rectifier to compensate the variation of the input impedance caused by the input power, so that impedance matching is obtained over a wider input power range. For validation, the proposed rectifier at 2.4 GHz was designed and implemented. The experimental results show that the RF-dc power conversion efficiency maintains over 50% and 70% within the input power ranges of 2.5-25.5 dBm and 11-24.5 dBm, respectively. Compared with the counterpart without the STIM, an improvement of 7.2 dB in terms of the input power range when the reflection coefficient is less than -10 dB was successfully demonstrated.


  • Phase-Shifterless Power Controlled Combining Based on 20-kW S-Band Magnetrons With an Asymmetric Injection

    by Zhenlong Liu, Xiaojie Chen, Jiang Wan, Pengde Wu, Menglin Yang, Kama Huang, Changjun Liu

    A real-time phase-shifterless power controlled combining based on 20-kW S-band continuous-wave magnetrons with an asymmetric injection was proposed in this letter. A high-power-capacity combiner was designed, and the behaviors of the asymmetric injection magnetrons were qualitatively characterized. The system showed a nearly 3-MHz injection-locked bandwidth and an output power control range over 3 dB at an injection ratio of 0.07. An excellent spur suppression ratio of −65.0 dBc at 500 kHz, an output amplitude stability of 0.02 dB (peak to peak), and a phase stability of ±0.9° (peak to peak) were also demonstrated. To the best of our knowledge, the power output of 34.0 kW with a total combining efficiency of 86.7% sets a new performance record for an S-band continuous wave magnetron power combining system, which is one of the best spur suppressions among all reported S-band injection locked magnetrons with an output power of over 15 kW.


  • Experimental Studies on a 1-kW High-Gain $S$ -Band Magnetron Amplifier With Output Phase Control Based on Load–Pull Characterization

    by Zhenlong Liu, Xiaojie Chen, Menglin Yang, Kama Huang, Changjun Liu

    A high power gain magnetron amplifier with output phase control based on load-pull characterization has been developed. The equivalent resonant cavity method was first introduced to facilitate the proposed magnetron amplifier system as a basic injection model, and the system behavior was qualitatively evaluated based on Alder's equation. It is the first time that a magnetron has been locked at a 58-dB gain. The magnetron amplifier shows an enhanced power-added efficiency of 72.0%, wide output phase control range, and 18.5-MHz bandwidth at a ratio of the output to the input power of 45 dB. This is the first time a successful magnetron output phase control based on load-pull at a power gain of 45 dB has been demonstrated. The magnetron output spectra were fully synchronized with a reference signal and the phase noise of the magnetron amplifier reached -106.3 dBc/Hz at an offset of 1 kHz. An output amplitude stability of 0.01 dB (peak to peak), a phase stability of 0.5° (peak to peak), and a high-efficiency dual 1-kW magnetron amplifier coherent-power combination based on the load-pull characterization was achieved. To the best of the authors' knowledge, this is one of the highest power gains and phase noise performances ever reported for an S-band injection-locked magnetron with a power output of over 1 kW.