Mehmet N. Tomac
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mehmet N. Tomac has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- James W. Gregory
The Ohio State University, Columbus, Ohio 43235
9 shared publications Abdullah Gul University
1 shared publication- James Loftus
Honda R&D Americas, Inc., 21001 State Route 739, Raymond, OH 43067
1 shared publication Kevin Yugulis
The Ohio State University, Columbus, OH
1 shared publication- Kevin Yugulis
Aeronautical and Astronautical Research Laboratory, The Ohio State University, 2300 West Case Road, Columbus, OH 43235
1 shared publication - Tony Ferrito
Honda R&D Americas, Inc., 21001 State Route 739, Raymond, OH 43067
1 shared publication
Latest Publications
- 5 March 2020
- Published by Springer Nature in Journal of Visualization
- Vol. 23 (3) , 369-372
Novel impinging jets-based non-periodic sweeping jets
- 5 March 2020
- Published by Springer Nature in Journal of Visualization
- Vol. 23 (3) , 369-372
Novel impinging jets-based non-periodic sweeping jets
- 18 February 2020
- Published by Springer Nature in Journal of Visualization
- Vol. 23 (3) , 373-375
Novel jet impingement atomization by synchronizing the sweeping motion of the fluidic oscillators
- 18 February 2020
- Published by Springer Nature in Journal of Visualization
- Vol. 23 (3) , 373-375
Novel jet impingement atomization by synchronizing the sweeping motion of the fluidic oscillators
- 1 February 2019
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 57 (2) , 670-681
Phase-Synchronized Fluidic Oscillator Pair
The relative phase of oscillating jets from a pair of fluidic oscillators was synchronized in this work. The means for this synchronization was mutual interaction through a shared feedback channel between the two oscillators. Flow visualization and hot-wire measurements indicated a strong correlation and phase synchronization between the two oscillators. A numerical analysis offered better understanding of the internal flow physics that led to the synchronization phenomenon. A portion of the output jet from one fluidic oscillator was redirected and crossed over into the adjacent oscillator, leading to momentum transfer between the two oscillators. A portion of this cross-oscillator flow was directed into the shared feedback channel and constituted the main feedback flow. In this process, one of the shared feedback channel outlets was blocked by a vortex, allowing only one oscillator to receive feedback flow. The primary mechanism for in-phase synchronization was the cross-oscillator flow, which was divided into phase-modulated momentum injection to the primary jet and modulated flow input to the shared channel feedback channel.
- 1 February 2019
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 57 (2) , 670-681
Phase-Synchronized Fluidic Oscillator Pair
The relative phase of oscillating jets from a pair of fluidic oscillators was synchronized in this work. The means for this synchronization was mutual interaction through a shared feedback channel between the two oscillators. Flow visualization and hot-wire measurements indicated a strong correlation and phase synchronization between the two oscillators. A numerical analysis offered better understanding of the internal flow physics that led to the synchronization phenomenon. A portion of the output jet from one fluidic oscillator was redirected and crossed over into the adjacent oscillator, leading to momentum transfer between the two oscillators. A portion of this cross-oscillator flow was directed into the shared feedback channel and constituted the main feedback flow. In this process, one of the shared feedback channel outlets was blocked by a vortex, allowing only one oscillator to receive feedback flow. The primary mechanism for in-phase synchronization was the cross-oscillator flow, which was divided into phase-modulated momentum injection to the primary jet and modulated flow input to the shared channel feedback channel.
- Open Access
- 1 November 2018
- Published by AIP Publishing in Physics of Fluids
- Vol. 30 (11) , 117102
Oscillation characteristics of mutually impinging dual jets in a mixing chamber
In this study, we consider the oscillatory behavior of mutually impinging jets in an enclosed, dome-shaped mixing chamber. The frequency of the impinging jet oscillations is dictated by the flow rate, with the oscillatory behavior being grouped into three regimes: a low flow rate regime (Re < 1500), a transition regime (1500 < Re < 2000), and a high flow rate regime (Re > 2000). The detailed characteristics of the oscillations in the high flow rate regime (Re = 6800 in the present study) are investigated through simultaneous frequency and refractive-index-matched particle image velocimetry measurements. The oscillation mechanism in the high flow rate regime was found to be similar to that of the other two regimes, where jets collide and interact in an oscillatory manner. However, in the high flow rate regime, there is a distinct and phase-evolving process of saddle point formation and jet bifurcation that is not present at the lower flow rates. The jet bifurcation process is also distinctly related to the balance of vortical structures inside the mixing chamber, and saddle point formation plays a key role in the internal and external flow field of this configuration. The external sweep angle of the exiting jet increases with the flow rate throughout the low and transition flow rate regimes, but a constant sweep angle was found to persist in the high flow rate regime. Thus, formation and location of the internal saddle point is directly linked to the external sweep angle of the jet.
- 1 November 2018
- Published by AIP Publishing in Physics of Fluids
- Vol. 30 (11) , 117102
Open AccessOscillation characteristics of mutually impinging dual jets in a mixing chamber
In this study, we consider the oscillatory behavior of mutually impinging jets in an enclosed, dome-shaped mixing chamber. The frequency of the impinging jet oscillations is dictated by the flow rate, with the oscillatory behavior being grouped into three regimes: a low flow rate regime (Re < 1500), a transition regime (1500 < Re < 2000), and a high flow rate regime (Re > 2000). The detailed characteristics of the oscillations in the high flow rate regime (Re = 6800 in the present study) are investigated through simultaneous frequency and refractive-index-matched particle image velocimetry measurements. The oscillation mechanism in the high flow rate regime was found to be similar to that of the other two regimes, where jets collide and interact in an oscillatory manner. However, in the high flow rate regime, there is a distinct and phase-evolving process of saddle point formation and jet bifurcation that is not present at the lower flow rates. The jet bifurcation process is also distinctly related to the balance of vortical structures inside the mixing chamber, and saddle point formation plays a key role in the internal and external flow field of this configuration. The external sweep angle of the exiting jet increases with the flow rate throughout the low and transition flow rate regimes, but a constant sweep angle was found to persist in the high flow rate regime. Thus, formation and location of the internal saddle point is directly linked to the external sweep angle of the jet.
- 1 January 2017
- Published by Academic World Research in Journal of Applied Fluid Mechanics
- Vol. 10 (1) , 283-291
Effect of Geometry Modifications on the Vectoring Performance of a Controlled Jet
- 1 January 2017
- Published by Academic World Research in Journal of Applied Fluid Mechanics
- Vol. 10 (1) , 283-291
Effect of Geometry Modifications on the Vectoring Performance of a Controlled Jet
- 1 January 2016
- Published by Begell House Inc. Publishers in Atomization and Sprays
- Vol. 26 (7) , 673-686
INTERNAL FLOW PHYSICS OF A FLUIDIC OSCILLATOR SPRAY IN THE TRANSITION REGIME
An experimental investigation of the underlying flow physics of a dual-jet interaction fluidic oscillator spray has been conducted in the transition regime for a Reynolds number of 1680. The transition regime is defined as a narrow range of flow rates between two other operating modes of the fluidic oscillator. Particle image velocimetry (PIV) was used with refractive index-matching sodium iodide solution to minimize reflections from the spray geometry and obtain detailed internal velocity fields. PIV results show that the interaction of the two internal jets and the resultant vortices are responsible for the oscillation mechanism in the transition regime. Two side vortices sustain their existence throughout the oscillation period by altering their size, shape, and strength, and a dome vortex is created twice each oscillation period (once from each jet). The dome vortex plays a key role in the kinetic energy transfer mechanism inside the oscillator by means of jet bifurcations. The primary oscillation mechanism in the transition regime is that each internal jet's connection with the exiting jet is cut completely by the dome vortex in every period. This is in contrast to the low-flow rate oscillation mechanism, in which the oscillations are created by continuous collisions of the jets. Furthermore, the internal jets are observed to energize the side vortex on the opposite side of the chamber-a phenomenon that was not observed in the low-flow rate regime.
- 1 January 2016
- Published by Begell House Inc. Publishers in Atomization and Sprays
- Vol. 26 (7) , 673-686
INTERNAL FLOW PHYSICS OF A FLUIDIC OSCILLATOR SPRAY IN THE TRANSITION REGIME
An experimental investigation of the underlying flow physics of a dual-jet interaction fluidic oscillator spray has been conducted in the transition regime for a Reynolds number of 1680. The transition regime is defined as a narrow range of flow rates between two other operating modes of the fluidic oscillator. Particle image velocimetry (PIV) was used with refractive index-matching sodium iodide solution to minimize reflections from the spray geometry and obtain detailed internal velocity fields. PIV results show that the interaction of the two internal jets and the resultant vortices are responsible for the oscillation mechanism in the transition regime. Two side vortices sustain their existence throughout the oscillation period by altering their size, shape, and strength, and a dome vortex is created twice each oscillation period (once from each jet). The dome vortex plays a key role in the kinetic energy transfer mechanism inside the oscillator by means of jet bifurcations. The primary oscillation mechanism in the transition regime is that each internal jet's connection with the exiting jet is cut completely by the dome vortex in every period. This is in contrast to the low-flow rate oscillation mechanism, in which the oscillations are created by continuous collisions of the jets. Furthermore, the internal jets are observed to energize the side vortex on the opposite side of the chamber-a phenomenon that was not observed in the low-flow rate regime.
- 1 May 2014
- Published by Springer Nature in Experiments in Fluids
- Vol. 55 (5) , 1-14
Internal jet interactions in a fluidic oscillator at low flow rate
- 1 May 2014
- Published by Springer Nature in Experiments in Fluids
- Vol. 55 (5) , 1-14
Internal jet interactions in a fluidic oscillator at low flow rate