Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Arturo Popoli has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Merlino2D: An open-source code for non-thermal gas discharge simulations

    by Fabio Ragazzi, Arturo Popoli, Luís Lemos Alves, Andrea Cristofolini

  • Open Access

    Design, characterization, and scale-up of oscillating plasma actuators for turbulent drag reduction

    by Gabriele Neretti, Lorenzo Magnani, Gabriele Bellani, Andrea Cristofolini, Arturo Popoli, Alessandro Talamelli, Jacopo Serpieri

  • Open Access

    Nanosecond-pulsed volume DBD plasma in saturated humid air: a combined experimental and computational study using EFISH and LIF

    by Lorenzo Ibba, Giacomo Pierotti, Arturo Popoli, Domenico Aceto, Carlos D Pintassilgo, Andrea Cristofolini, Paolo F Ambrico, Ivo Furno

    This study presents a detailed investigation of a nanosecond-pulsed volume dielectric barrier discharge (VDBD) plasma in saturated humid air at atmospheric pressure, combining experimental diagnostics with kinetic modeling. Electric field-induced second harmonic generation (EFISH), employing a spatial filter and a picosecond laser, enabled electric field measurements with high spatial (270 µm) and temporal (28 ps) resolution at three distinct positions across the inter-electrode VDBD gap. These measurements revealed previously unobserved features and consistent differences between the discharge center and regions near the ground and high-voltage (HV) electrodes. Near the ground electrode, a higher electric field was observed prior to the first positive plasma discharge, along with an overshoot up to 50 kV cm−1 during plasma breakdown, absent at the center and near the HV electrode. A sharper post-breakdown decrease and recovery in the electric field was also observed near the ground electrode, differently from the other positions. This pattern inverted during the subsequent negative discharge at the end of the HV pulse, with the higher electric field being measured near the HV electrode. To complement the electric field data, the concentrations of nitric oxide (NO) and hydroxyl radical (OH) were measured using laser-induced fluorescence (LIF), providing insight into their temporal dynamics during and after the discharge. The EFISH data served as input for a zero-dimensional kinetic model, which revealed the dynamics of both charged and neutral species, showing excellent agreement with the LIF data and validating the model accuracy. The simulation identified OH−, O 2 − , and O 4 − as the key negative ions responsible for the stable electric field after plasma breakdown. This research highlights the importance of understanding electric field dynamics and reactive species formation in low-temperature plasmas. Integrating EFISH and LIF data with kinetic modeling provides a robust framework to optimize plasma-based systems, improving their performance and safety in practical applications.


  • Influence of Magnetic Field on the Kinetics of Ho(III) Solvent Extraction Using D2EHPA: A Comprehensive Study

    by Konrad Wojtaszek, Andrea Cristofolini, Arturo Popoli, Karolina Kołczyk Siedlecka, Robert P Socha, Maria Owińska, Marek Wojnicki

    The kinetics of Ho(III) extraction using di(2‐ethylhexyl)phosphoric acid (D2EHPA) under the influence magnetic field are examined. The methodology for kinetics research is based on spectrophotometric techniques. Initial experiments without a magnetic field assess the influence of Ho(III) concentration (0.00625–0.1 m), pH (1–6), D2EHPA concentration (0.1–2 m), and temperatures (5–35 °C). Subsequent tests (5–35 °C) determine the influence of the magnetic field. Experimental considerations are supplemented with numerical simulations of the magnetic field affecting the extraction system. A white precipitate formed at the phase boundary is characterized using X‐ray fluorescence (XRF), X‐ray diffraction (XRD), Fourier transform infrared spectroscopy (FT‐IR), and X‐ray photoelectron spectroscopy (XPS) techniques. Post‐extraction solutions are analyzed with nuclear magnetic resonance (NMR) spectroscopy to investigate the structure and magnetic properties of the D2EHPA‐Ho(III) complex. The conducted research indicate that magnetic fields notably enhance kinetics of extraction above 25 °C, suggesting a possible change in the extraction mechanism.


  • Open Access

    Plasma-substrate interaction in a dual frequency APPJ

    by Alessandro Patelli, Silvia Giuditta Scaltriti, Arturo Popoli, Emilio Martines, Andrea Cristofolini

    To achieve a uniform argon plasma in an atmospheric pressure jet, we explored the possibility of using dual-frequency excitation in a coaxial dielectric barrier discharge device. Two separate ring-shaped electrodes outside an alumina tube generate the two frequencies. The upstream electrode is powered at low frequency (LF, 17 kHz ), while the downstream electrode is powered at radio frequency (RF, 27 MHz ). To assess the interaction with the substrate, a grounded electrode, covered by a glass substrate, is placed 5 mm from the outlet of the alumina tube. We analyze the device with a fluid model and compare the results with experimental electrical and optical characterization. As the plasma is ignited by the LF, positive streamers develop from the LF electrode and reach the substrate in a few hundred nanoseconds. At this stage, the substrate is charged and a surface discharge propagates on the glass; however, no additional ionization occurs in the jet. As RF is added, the plasma is sustained by modulation in the Ω regime. At the same time, the LF polarization propagates through the plasma, influencing the sheaths on the facing dielectric walls. When the voltage drop in the sheaths exceeds a threshold level, an additional γ mode originates due to the secondary electrons emitted by the surfaces, leading to an increase in power dissipation. This coexistence of the two regimes is observed in the simulation, and it is validated experimentally by time-resolved photoemission measurements. As a result, the dual-frequency plasma exhibits a filamentary structure similar to that of an LF-driven jet. However, RF excitation caused diffused pre-ionization of the gas, which reduced the charge density gradients, resulting in wider microdischarge channels and a lower average electric field. Streamers propagation is therefore limited, while an ion flow to the substrate is maintained and controlled by the LF polarization.


  • Hybrid Modeling of Miniaturized 50 W Annular Hall Thruster

    by Arturo Popoli, Andrea Cristofolini, Laurent Garrigues, Dongho Lee, Guentae Doh, Holak Kim, Wonho Choe

    A 50-W-class annular Hall thruster is studied with a hybrid axial–radial two-dimensional model. Ions are described by a kinetic approach, whereas fluid conservation equations are solved for electrons. In such models, additional (anomalous) contributions must be added to the momentum-transfer electron collision frequency to obtain realistic values of the cross-field electron mobility. First, a parametric study is performed, where anomalous transport is described with a simple two-region model based on constant empirical parameters. The simulated global performance is subsequently compared with experimental measurements. Then, laser-induced fluorescence ion velocity measurements are employed to infer a continuous profile of the anomalous electron collision frequency along the channel centerline. The model reproduces the performance, the acceleration structure, the current oscillations, and the doubly charged ion fraction of the laboratory thruster. Measurements of the ion velocity distribution function highlight the presence of a slow ion population in the near plume. The production of the slow ions and their growth for increasing distances from the thruster channel exit is qualitatively reproduced by the model. The results obtained suggest that the generation and dynamics of the observed slow ions can be attributed to the presence of energetic electrons in the plume.

  • Open Access

    Lambert W Function Applications in Electrical Insulation Engineering

    by Mariani Daniele, Arturo Popoli, Paolo Seri, Andrea Cavallini, Leonardo Gasperini, Giacomo Selleri, Alberto Rumi, Simone Vincenzo Suraci, Davide Fabiani

    Mathematical modelling is a fundamental instrument in the development of theoretical validation for experimental results and in their interpretation. The gist of this paper is the application of a special multi-valued function, called Lambert W function, to several aspects of electrical engineering. This multi-valued function serves the purpose of inverting a vast gamut of expressions involving exponential functions, and can be used in many models concerning electrical insulation issues, yielding lower computational times as opposed to other methods solving nonlinear problems. In particular, this paper presents the analytical calculation of parameters for capacitor field and equipotential lines, Paschen’s law inversion, a model for electric field distribution in power cables, the inversion of Schottky and Dissado, Montanari, Mazzanti model for cable life estimation.

  • Open Access

    Modeling Study of Chemical Kinetics and Vibrational Excitation in a Volumetric DBD in Humid Air at Atmospheric Pressure

    by Giacomo Pierotti, Arturo Popoli, Carlos Daniel Pintassilgo, Andrea Cristofolini

    A zero-dimensionl model is developed to study the chemical kinetics of a volumetric dielectric barrier discharge (DBD) reactor operating with humid air at atmospheric pressure. This work focuses on the relation between molecular vibrational excitation, the plasma reactor input power and the number densities of several species that are known to play an important role in biomedical applications (e.g. $$\textrm{O}_{3},\textrm{NO, NO}_{2}$$ O 3 , NO, NO 2 , ...). A preliminary study is carried out to observe the influence of water molecules on the electron energy distribution function for different values of water concentration and reduced electric field. A simplified approach is then adopted to quantify the contribution of vibrationally-excited $$\textrm{O}_{2}$$ O 2 molecules to $$\textrm{NO}$$ NO formation. The results obtained using our detailed model suggest that for the physical conditions considered in this work $$\textrm{O}_{2}$$ O 2 vibrational kinetics can be neglected without compromising the overall accuracy of the simulation. Finally, a reaction set is coupled with an equivalent circuit model to simulate the E-I characteristic of a typical DBD reactor. Different simulations were carried out considering different values of the average plasma input power densities. A particular focus was given to the influence of the Zeldovich mechanism on $$\textrm{O}_{3}$$ O 3 and $$\textrm{NO}_\textrm{X}$$ NO X production performing simulations where this reaction is not considered. The obtained results are shown and the role of vibrationally excited $$\textrm{N}_{2}$$ N 2 molecules is discussed. The simulation results indicate also that $$\textrm{N}_{2}$$ N 2 vibrational excitation, and more precisely the Zeldovich mechanism, has a larger effect on $$\textrm{O}_{3}$$ O 3 and $$\textrm{NO}_\textrm{X}$$ NO X production at intermediate input power levels.


  • Open Access

    An Efficient Numerical Technique for the Simulation of Charge Transport in Polymeric Dielectrics

    by Fabio Ragazzi, Arturo Popoli, Andrea Cristofolini

    In recent years, the use of HVDC cables has grown exponentially. One of the main challenges that remains concerns the space charge accumulation inside the insulating materials. A better understanding of the mechanisms governing this phenomenon is essential to improve the performance of HVDC systems. Numerical simulations are often employed to achieve this goal. For this reason, it is important to perform them in an efficient way. In this work, we test several numerical techniques, aiming to assess which one is the best to use for fast and reliable simulations. We consider a well-known bipolar dynamic model from the literature for our simulations. The model considers a single level of deep traps and is implemented in a one-dimensional Cartesian coordinate system, considering a thin specimen of polymeric material. We compare three different time discretization methods: a fully explicit, a semi-implicit, and a fully implicit approaches. For the advective flux discretization, we compare the first-order upwind scheme (FOU) with a second-order upwind scheme coupled with the Koren flux limiter (SOU/KL). Regarding the computation of the polarization current, we introduce a simple approach using Sato’s equation and compare it with the well-established approach based on the total current density.


  • Open Access

    A Boltzmann Electron Drift Diffusion Model for Atmospheric Pressure Non-Thermal Plasma Simulations

    by Arturo Popoli, Fabio Ragazzi, Giacomo Pierotti, Gabriele Neretti, Andrea Cristofolini

    We introduce a fluid computational model for the numerical simulation of atmospheric pressure dielectric barrier discharge plasmas. Ion and neutral species are treated with an explicit drift diffusion approach. The Boltzmann relation is used to compute the spatial distribution of electrons as a function of the electrostatic potential and the ionic charge density. This technique, widely used to speed up particle and fluid models for low-pressure conditions, poses several numerical challenges for high-pressure conditions and large electric field values typical of applications involving atmospheric-pressure plasmas. We develop a robust algorithm to solve the non-linear electrostatic Poisson problem arising from the Boltzmann electron approach under AC electric fields based on a charge-conserving iterative computation of the reference electric potential and electron density. We simulate a volumetric reactor in dry air, comparing the results yielded by the proposed method with those obtained when the drift diffusion approach is used for all charged species, including electrons. We show that the proposed methodology retains most of the physical information provided by the reference modeling approach while granting a substantial advantage in terms of computation time.