Tsuguhide Aoki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Tsuguhide Aoki has a total of 62 co-authors. Here are the top co-authors by number of shared publications:
- Kensuke Nakanishi
Toshiba Corporation, Kawasaki 212-8580, Japan
4 shared publications Takeshi Kumagaya
System Core Technology Development Dept. I System Technology Research & Development Center, Toshiba Memory Corp., Kanagawa, 212-0013, Japan
3 shared publicationsHideki Yamada
Toshiba Memory Corporation, Yokohama 247-8585, Japan
2 shared publicationsHiroki Mori
Wireless System Laboratory, Corporate Research & Development Center, Toshiba Corp., Kanagawa, 212-8582, Japan
2 shared publicationsKatsuyuki Ikeuchi
Toshiba Corporation, Kawasaki 212-8580, Japan
2 shared publicationsKazuhisa Horiuchi
Toshiba Memory Corporation, Yokohama 247-8585, Japan
2 shared publications
Latest Publications
- 9 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (12) , 3688-3699
An 802.11ax 4 $\times$ 4 High-Efficiency WLAN AP Transceiver SoC Supporting 1024-QAM With Frequency-Dependent IQ Calibration and Integrated Interference AnalyzerA fully integrated 4 x 4 802.11abgn/ac/ax transceiver system-on-chip (SoC) with integrated interference analyzer and frequency-dependent in-phase and quadrature (IQ) (FD-IQ) calibration is presented. The FD-IQ technique helps meeting the extremely strict IQ imbalance requirement for 1-K quadratic-amplitude modulation (QAM). The pure current-mode TX baseband (BB) improves SNR to better than 50 dB, and a multi-mode local oscillator (LO) distribution circuit provides non-contiguous operation with the error vector magnitude (EVM) of less than -37 dB. The integrated interference analyzer achieves the highly reliable connection in the presence of the undesired signal and hence improves the frequency usage efficiency by identifying the wireless LAN (WLAN) and other signals in the 2G/5G band.
- 9 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (12) , 3688-3699
An 802.11ax 4 $\times$ 4 High-Efficiency WLAN AP Transceiver SoC Supporting 1024-QAM With Frequency-Dependent IQ Calibration and Integrated Interference AnalyzerA fully integrated 4 x 4 802.11abgn/ac/ax transceiver system-on-chip (SoC) with integrated interference analyzer and frequency-dependent in-phase and quadrature (IQ) (FD-IQ) calibration is presented. The FD-IQ technique helps meeting the extremely strict IQ imbalance requirement for 1-K quadratic-amplitude modulation (QAM). The pure current-mode TX baseband (BB) improves SNR to better than 50 dB, and a multi-mode local oscillator (LO) distribution circuit provides non-contiguous operation with the error vector magnitude (EVM) of less than -37 dB. The integrated interference analyzer achieves the highly reliable connection in the presence of the undesired signal and hence improves the frequency usage efficiency by identifying the wireless LAN (WLAN) and other signals in the 2G/5G band.
- 21 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Cognitive Communications and Networking
- Vol. 4 (2) , 368-378
Signal Detection Method for Interference From Inverter Microwave Ovens in WLAN Systems
Inverter microwave ovens (inv. MWOs) are day-to-day appliances that can severely interfere with 2.4 GHz wireless LAN (WLAN) devices. However, interference is avoidable by using a signal detection method that recognizes MWO signals. In our previous work, we have proposed a specialized detection method that recognizes characteristic power levels of leakage signals from inv. MWOs, which drastically vary depending on the switching of the inverter. Using experimental MWO data obtained in a shielded room, we also demonstrated that the proposed method correctly detects inv. MWO signals with robustness against different products, different receiving environments, and the presence of other signals. In this paper, we begin with a discussion of the influence of MWO interference, and then review process and evaluation of the proposed method, along with new additional analysis. By simplifying the process, we also provide a test chip implementation for method realization and real-time signal detection to enhance the reliability of WLAN systems. Finally, we use the test chip to show that it is also possible to detect jammer signals.
- 21 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Cognitive Communications and Networking
- Vol. 4 (2) , 368-378
Signal Detection Method for Interference From Inverter Microwave Ovens in WLAN Systems
Inverter microwave ovens (inv. MWOs) are day-to-day appliances that can severely interfere with 2.4 GHz wireless LAN (WLAN) devices. However, interference is avoidable by using a signal detection method that recognizes MWO signals. In our previous work, we have proposed a specialized detection method that recognizes characteristic power levels of leakage signals from inv. MWOs, which drastically vary depending on the switching of the inverter. Using experimental MWO data obtained in a shielded room, we also demonstrated that the proposed method correctly detects inv. MWO signals with robustness against different products, different receiving environments, and the presence of other signals. In this paper, we begin with a discussion of the influence of MWO interference, and then review process and evaluation of the proposed method, along with new additional analysis. By simplifying the process, we also provide a test chip implementation for method realization and real-time signal detection to enhance the reliability of WLAN systems. Finally, we use the test chip to show that it is also possible to detect jammer signals.
- 1 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 442-444
An 802.11ax 4×4 spectrum-efficient WLAN AP transceiver SoC supporting 1024QAM with frequency-dependent IQ calibration and integrated interference analyzer
An exponentially Increasing number of wireless-LAN (WLAN) devices In a dense environment causes a decrease in throughput owing to collisions among the devices and the lack of contiguous bandwidth. The next-generation standard of 802.11ax improves spectrum efficiency by additionally supporting 1024 (1K) QAM, OFDMA with 80+80MHz; these impose several challenges to silicon design. 1K-QAM demands extreme IQ balance with an IRR better than -50dB over a wide frequency range up to 80MHz to achieve at least -35dB RX EVM or less. Noise characteristics better than -44dBc LO integrated phase noise as well as 50dB isolation between each TRX chain are mandatory. To best make use of the essential features defined in the 11ax standard, a real-time and arbitrary spectrum-resource control capability at each access point (AP) is beneficial both in terms of further improvement in spectrum efficiency as well as communication reliability in ISM coexisting bands and legacy WLAN. Interference identification of the order of 10με while incorporating everything into a strictly limited silicon area is key to launching the advanced unique functionality. This paper presents a fully integrated 4×4 802.11abgn/ac/ax-compliant AP transceiver SoC. The chip offers frequency-dependent IQ (FD-IQ) mismatch calibration for both amplitude and phase, low-noise TX BB and multimode LO distribution techniques, and real-time interference detection including 2.4GHz inverter-type microwave (MW) ovens.
- 1 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 442-444
An 802.11ax 4×4 spectrum-efficient WLAN AP transceiver SoC supporting 1024QAM with frequency-dependent IQ calibration and integrated interference analyzer
An exponentially Increasing number of wireless-LAN (WLAN) devices In a dense environment causes a decrease in throughput owing to collisions among the devices and the lack of contiguous bandwidth. The next-generation standard of 802.11ax improves spectrum efficiency by additionally supporting 1024 (1K) QAM, OFDMA with 80+80MHz; these impose several challenges to silicon design. 1K-QAM demands extreme IQ balance with an IRR better than -50dB over a wide frequency range up to 80MHz to achieve at least -35dB RX EVM or less. Noise characteristics better than -44dBc LO integrated phase noise as well as 50dB isolation between each TRX chain are mandatory. To best make use of the essential features defined in the 11ax standard, a real-time and arbitrary spectrum-resource control capability at each access point (AP) is beneficial both in terms of further improvement in spectrum efficiency as well as communication reliability in ISM coexisting bands and legacy WLAN. Interference identification of the order of 10με while incorporating everything into a strictly limited silicon area is key to launching the advanced unique functionality. This paper presents a fully integrated 4×4 802.11abgn/ac/ax-compliant AP transceiver SoC. The chip offers frequency-dependent IQ (FD-IQ) mismatch calibration for both amplitude and phase, low-noise TX BB and multimode LO distribution techniques, and real-time interference detection including 2.4GHz inverter-type microwave (MW) ovens.
- 1 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
A Novel Signal Detection Method for Interference from Inverter Microwave Ovens in WLAN Systems
Inverter microwave ovens (MWOs) are day-to-day appliances that can act as fatal interferers for 2.4 GHz wireless LAN (WLAN) systems. However, the interference is avoidable, if it is possible to detect the MWO signal. In this paper, we propose an inverter MWO signal detection method in the time and frequency domains for reliable wireless communication. The operating inverter MWOs inherently generate RF signal whose leakage power level drastically varies depending on the switching of the inverter. The proposed method recognizes the changing signal power level due to the switching. In addition, we confirm the effectiveness of the proposed method in the presence or absence of WLAN systems by using the experimental MWO data obtained in a shielded room. It is revealed that the proposed method is able to detect the inverter MWO signal correctly and is robust against different products, different receiving environment, and presence of other signals.
- 1 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
A Novel Signal Detection Method for Interference from Inverter Microwave Ovens in WLAN Systems
Inverter microwave ovens (MWOs) are day-to-day appliances that can act as fatal interferers for 2.4 GHz wireless LAN (WLAN) systems. However, the interference is avoidable, if it is possible to detect the MWO signal. In this paper, we propose an inverter MWO signal detection method in the time and frequency domains for reliable wireless communication. The operating inverter MWOs inherently generate RF signal whose leakage power level drastically varies depending on the switching of the inverter. The proposed method recognizes the changing signal power level due to the switching. In addition, we confirm the effectiveness of the proposed method in the presence or absence of WLAN systems by using the experimental MWO data obtained in a shielded room. It is revealed that the proposed method is able to detect the inverter MWO signal correctly and is robust against different products, different receiving environment, and presence of other signals.