Takeo Watanabe
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Takeo Watanabe has a total of 86 co-authors. Here are the top co-authors by number of shared publications:
Tetsuo Harada
Univ. of Hyogo (Japan)
9 shared publicationsHiroo Kinoshita
Univ. of Hyogo (Japan)
4 shared publicationsAtsushi Sekiguchi
Litho Tech Japan Co., Ltd. (Japan)
2 shared publications- Hiroaki Oizumi
Tsumura Research Laboratories, Tsumura & Co., Ibaraki 200-1192, Japan
2 shared publications - Hironori Fujii
Department of Pharmacy, Gifu University Hospital, Gifu, Japan
2 shared publications - Hiroshi Nagata
National Institute of Advanced Industrial Science and Technology (AIST), Central 5, 1-1-1 Higashi, Tsukuba, Ibaraki 305-8565, Japan
2 shared publications
Latest Publications
- Open Access
- 1 December 2022
- Published by SPIE-Intl Soc Optical Eng
- p. 62
The measurement of the refractive index n and k value of the EUV resist which used EUV reflectivity measurement method
SPIE Digital Library Proceedings
- 1 December 2022
- Published by SPIE-Intl Soc Optical Eng
- p. 62
Open AccessThe measurement of the refractive index n and k value of the EUV resist which used EUV reflectivity measurement method
SPIE Digital Library Proceedings
- 12 December 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 16.4.1-16.4.4
A Global Shutter Wide Dynamic Range Soft X-ray CMOS Image Sensor with BSI Pinned Photodiode, Two-stage LOFIC and Voltage Domain Memory Bank
A prototype 22.4μm pixel pitch global shutter wide dynamic range soft X-ray CMOS image sensor (sxCMOS) is presented. The sxCMOS employs backside-illuminated (BSI) pinned photodiode with a 45μm-thick Si substrate for low noise and high light resistance to high energy photons, two-stage LOFIC for wide dynamic range and voltage domain memory bank with high density capacitors for global shutter. The developed chip successfully demonstrated a high quantum efficiency (QE) toward soft X-ray with a single exposure 129dB dynamic range by global shutter.
- 12 December 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 16.4.1-16.4.4
A Global Shutter Wide Dynamic Range Soft X-ray CMOS Image Sensor with BSI Pinned Photodiode, Two-stage LOFIC and Voltage Domain Memory Bank
A prototype 22.4μm pixel pitch global shutter wide dynamic range soft X-ray CMOS image sensor (sxCMOS) is presented. The sxCMOS employs backside-illuminated (BSI) pinned photodiode with a 45μm-thick Si substrate for low noise and high light resistance to high energy photons, two-stage LOFIC for wide dynamic range and voltage domain memory bank with high density capacitors for global shutter. The developed chip successfully demonstrated a high quantum efficiency (QE) toward soft X-ray with a single exposure 129dB dynamic range by global shutter.
- Open Access
- 24 June 2019
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 32 (2) , 327-331
Resonant Soft X-ray Scattering for the Stochastic Origin Analysis in EUV Resist
The resist development is a critical issue in EUV lithography for high volume manufacturing of semiconductor devices. Especially, the resist should have low line-width roughness (LWR) performance in fine patterning. To reduce the LWR, it is significant to control and reduce the stochastic behavior in the resist material. We employed the resonant soft X-ray scattering (RSoXS) method to evaluate the non-uniformity of the resist material components such as base polymer, functional group, and photo-acid generator and so on. In RSoXS method, the soft X-ray scattering intensity from the resist is recorded by a CCD camera, which the incident photon energy irradiated to the resist sample was varied around the carbon absorption K-edge of 284 eV. Around the carbon absorption edge, the absorption spectrum had resonant absorption peaks that depended on the chemical bonding structure of carbon. The scattering signal profile of a commercial chemical-amplified resist was different at each absorption peaks, which indicated non-uniformity of resist material. Thus, the non-uniformity of the resist material was measured by RSoXS method, which was important for development of low LWR resist.
- 24 June 2019
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 32 (2) , 327-331
Open AccessResonant Soft X-ray Scattering for the Stochastic Origin Analysis in EUV Resist
The resist development is a critical issue in EUV lithography for high volume manufacturing of semiconductor devices. Especially, the resist should have low line-width roughness (LWR) performance in fine patterning. To reduce the LWR, it is significant to control and reduce the stochastic behavior in the resist material. We employed the resonant soft X-ray scattering (RSoXS) method to evaluate the non-uniformity of the resist material components such as base polymer, functional group, and photo-acid generator and so on. In RSoXS method, the soft X-ray scattering intensity from the resist is recorded by a CCD camera, which the incident photon energy irradiated to the resist sample was varied around the carbon absorption K-edge of 284 eV. Around the carbon absorption edge, the absorption spectrum had resonant absorption peaks that depended on the chemical bonding structure of carbon. The scattering signal profile of a commercial chemical-amplified resist was different at each absorption peaks, which indicated non-uniformity of resist material. Thus, the non-uniformity of the resist material was measured by RSoXS method, which was important for development of low LWR resist.
- Open Access
- 24 June 2019
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 32 (2) , 333-337
Resonant Soft X-ray Reflectivity for the Chemical Analysis in Thickness Direction of EUV Resist
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 24 June 2019
- Published by Technical Association of Photopolymers, Japan in Journal of Photopolymer Science and Technology
- Vol. 32 (2) , 333-337
Open AccessResonant Soft X-ray Reflectivity for the Chemical Analysis in Thickness Direction of EUV Resist
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 3 October 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10809, 64
Reflectance measurement of EUV mirrors with s- and p-polarized light using polarization control units
We have developed the reflectometer to evaluate EUV mirrors and masks at BL-10 beamline of NewSUBARU synchrotron light facility. This reflectometer usually measures s-polarized reflectance. Reflectance of an EUV mirror is strongly depends on polarization state of incident light, if angle of incidence to the sample is not normal. The center radiation from a bending source of a synchrotron source is almost horizontally polarized. However, there was several percent of vertical polarized component at the center radiation on NewSUBARU. For accurate reflectometry, a horizontal-polarization control unit (PCU) has been developed to remove the unnecessary vertically-polarized EUV component. This unit consisted of two reflection polarizer mirrors coated with aperiodic Mo/Si broadband multilayer, which multilayer was coated in our laboratory. Using this unit, degree of horizontal polarization was improved to be 1.00. In addition, vertical-PCU has been developed for p-polarized reflectance measurement. There is vertical polarized light component on off-axis radiation from the bending source. This vertical-PCU also generated the fully-verticalpolarized light. As the results, the reflectometer measures accurate s- and p-polarized reflectance without setup change of the sample stage and the detector stage.
- 3 October 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10809, 64
Reflectance measurement of EUV mirrors with s- and p-polarized light using polarization control units
We have developed the reflectometer to evaluate EUV mirrors and masks at BL-10 beamline of NewSUBARU synchrotron light facility. This reflectometer usually measures s-polarized reflectance. Reflectance of an EUV mirror is strongly depends on polarization state of incident light, if angle of incidence to the sample is not normal. The center radiation from a bending source of a synchrotron source is almost horizontally polarized. However, there was several percent of vertical polarized component at the center radiation on NewSUBARU. For accurate reflectometry, a horizontal-polarization control unit (PCU) has been developed to remove the unnecessary vertically-polarized EUV component. This unit consisted of two reflection polarizer mirrors coated with aperiodic Mo/Si broadband multilayer, which multilayer was coated in our laboratory. Using this unit, degree of horizontal polarization was improved to be 1.00. In addition, vertical-PCU has been developed for p-polarized reflectance measurement. There is vertical polarized light component on off-axis radiation from the bending source. This vertical-PCU also generated the fully-verticalpolarized light. As the results, the reflectometer measures accurate s- and p-polarized reflectance without setup change of the sample stage and the detector stage.
- 1 October 2018
- Published by Elsevier in Reactive and Functional Polymers
- Vol. 131, 361-367
Synthesis of hyperbranched polyacetals containing C-(4-t-butylbenz)calix[4]resorcinarene: Resist properties for extreme ultraviolet (EUV) lithography
- 1 October 2018
- Published by Elsevier in Reactive and Functional Polymers
- Vol. 131, 361-367
Synthesis of hyperbranched polyacetals containing C-(4-t-butylbenz)calix[4]resorcinarene: Resist properties for extreme ultraviolet (EUV) lithography
- 19 March 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10583, 70
A study on enhancing EUV resist sensitivity (2)
To improve EUV resist sensitivity, studies have sought to enhance EUV light absorption by adding metals characterized by high EUV light absorption to the resist polymer. This approach is intended to increase secondary electron emission, thereby enhancing PAG reactivity and improving acid generation efficiency. As reported in our previous report, to determine whether adding metals characterized by high EUV light absorption actually enhances sensitivity, we performed transmittance measurements and sensitivity evaluations of resist samples doped with ZrO2 or TeO2 nanoparticles, which have low and high EUV light absorption, respectively, in molar quantities of 0-2 relative to PAG. The samples were subjected to EUV exposure at the NewSUBARU synchrotron radiation facility. The results of transmittance measurements and sensitivity evaluations showed that, while the ZrO2-doped resist showed no changes in absorption or sensitivity, the TeO2-doped resist showed enhancement in both properties. Based on these results, we confirmed that adding metals characterized by high EUV light absorption to the EUV resist enhances its EUV light absorption and increases secondary electron emission, thereby enhancing PAG reactivity and improving acid generation efficiency. In the efforts discussed in the present report, we examined whether adding metals directly to PAG could further enhance sensitivity by increasing the EUV light absorption of PAG itself, thereby efficiently heightening the effect of the secondary electron emission on PAG.
- 19 March 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10583, 70
A study on enhancing EUV resist sensitivity (2)
To improve EUV resist sensitivity, studies have sought to enhance EUV light absorption by adding metals characterized by high EUV light absorption to the resist polymer. This approach is intended to increase secondary electron emission, thereby enhancing PAG reactivity and improving acid generation efficiency. As reported in our previous report, to determine whether adding metals characterized by high EUV light absorption actually enhances sensitivity, we performed transmittance measurements and sensitivity evaluations of resist samples doped with ZrO2 or TeO2 nanoparticles, which have low and high EUV light absorption, respectively, in molar quantities of 0-2 relative to PAG. The samples were subjected to EUV exposure at the NewSUBARU synchrotron radiation facility. The results of transmittance measurements and sensitivity evaluations showed that, while the ZrO2-doped resist showed no changes in absorption or sensitivity, the TeO2-doped resist showed enhancement in both properties. Based on these results, we confirmed that adding metals characterized by high EUV light absorption to the EUV resist enhances its EUV light absorption and increases secondary electron emission, thereby enhancing PAG reactivity and improving acid generation efficiency. In the efforts discussed in the present report, we examined whether adding metals directly to PAG could further enhance sensitivity by increasing the EUV light absorption of PAG itself, thereby efficiently heightening the effect of the secondary electron emission on PAG.
- 18 March 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9776, 97762H-97762H-12
EUV resist outgassing analysis for the new platform resists at EIDEC
- 18 March 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9776, 97762H-97762H-12
EUV resist outgassing analysis for the new platform resists at EIDEC