Ali Ghamarian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ali Ghamarian has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
Sajad Azarakhsh
Young Researchers and Elite Club, Arak Branch, Islamic Azad University, Arak, Iran
1 shared publication
Latest Publications
- 1 January 2020
- Published by Taylor & Francis in Australian Journal of Structural Engineering
- Vol. 21 (3) , 234-243
Collapse mechanism investigation of the direct tension indicator washers under axial compression
Direct tension indicators (DTIs) are one alternative method that is commonly used to verify that high-strength bolts have been properly tensioned during installation. This paper investigates collapse mechanisms and crushing load during the axial compression of the DTI washer. An experimental technique is used to evaluate the function of the DTI washer under compressive quasi-static strain rate. A numerical model is presented based on finite element analysis to simulate crushing of DTI washer considering nonlinear responses due to material behaviour, contact boundary conditions and large deformations. The predicted numerical crushing load and collapse pattern were found to be in good agreement with the experimental results. Finally, the effect of the geometry parameters of the DTI washer on crushing loads is investigated. This study provides practical information about using the DTI washers to confirm proper pre-tensioning of bolts in structural steel fasteners industry.
- 1 January 2020
- Published by Taylor & Francis in Australian Journal of Structural Engineering
- Vol. 21 (3) , 234-243
Collapse mechanism investigation of the direct tension indicator washers under axial compression
Direct tension indicators (DTIs) are one alternative method that is commonly used to verify that high-strength bolts have been properly tensioned during installation. This paper investigates collapse mechanisms and crushing load during the axial compression of the DTI washer. An experimental technique is used to evaluate the function of the DTI washer under compressive quasi-static strain rate. A numerical model is presented based on finite element analysis to simulate crushing of DTI washer considering nonlinear responses due to material behaviour, contact boundary conditions and large deformations. The predicted numerical crushing load and collapse pattern were found to be in good agreement with the experimental results. Finally, the effect of the geometry parameters of the DTI washer on crushing loads is investigated. This study provides practical information about using the DTI washers to confirm proper pre-tensioning of bolts in structural steel fasteners industry.
- 2 November 2018
- Published by Taylor & Francis in International Journal of Crashworthiness
- Vol. 24 (6) , 632-644
Axial crushing analysis of polyurethane foam-filled combined thin-walled structures: experimental and numerical analysis
Axial crushing behaviour of the polyurethane foam-filled aluminum cylindrical tubes with shallow spherical caps (combined thin-walled structures) is studied both experimentally and numerically. Non-linear dynamic finite element analyses were carried out to simulate the quasi-static tests. Satisfactory agreements were generally achieved between the finite element model and experimental deformed shapes, load–displacements, fold lengths and specific energy absorptions. Influence of important parameters such as semi-apical angle, length of cylindrical and spherical caps, diameter and density of foam filler was discussed and the results highlight the advantages of using foam-filled shell of the combined geometry as energy absorber.
- 2 November 2018
- Published by Taylor & Francis in International Journal of Crashworthiness
- Vol. 24 (6) , 632-644
Axial crushing analysis of polyurethane foam-filled combined thin-walled structures: experimental and numerical analysis
Axial crushing behaviour of the polyurethane foam-filled aluminum cylindrical tubes with shallow spherical caps (combined thin-walled structures) is studied both experimentally and numerically. Non-linear dynamic finite element analyses were carried out to simulate the quasi-static tests. Satisfactory agreements were generally achieved between the finite element model and experimental deformed shapes, load–displacements, fold lengths and specific energy absorptions. Influence of important parameters such as semi-apical angle, length of cylindrical and spherical caps, diameter and density of foam filler was discussed and the results highlight the advantages of using foam-filled shell of the combined geometry as energy absorber.