RJRobert H. Jackson

Robert H. Jackson

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Robert H. Jackson has a total of 26 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Zero-Compression, Laminar Electron Beams From Convex Cathodes in Uniform Magnetic Fields

    by R. H. Jackson, R. Lawrence Ives, M. E. Read

    The need for enhanced performance of high-power RF vacuum electron devices has led to the investigation of multiple-beam, sheet beam, and annular beam configurations. A key issue with such devices is the magnetic field shaping required producing high-power, laminar beams. Field shaping is difficult when Pierce-type gun geometries are employed. The development of high current density cathodes makes the necessary beam power achievable without compression. Such cathodes can operate within a uniform magnetic field yielding advantages for both single and distributed-beam RF devices. However, the quality of the resulting beams presents problems. A project to optimize beam quality in zero-convergence electron guns was undertaken by Calabazas Creek Research, Inc. (CCR) and North Carolina State University (NCSU). The surprising result was that high-quality electron beams can be generated in uniform magnetic fields using convex (dome)-shaped cathodes. The underlying physics involves perturbation of the beam cyclotron motion by a nonadiabatic radial electric field impulse. This article examines this physical mechanism and extends the initial result to additional diode and beam geometries.


  • Open Access

    Zero-Compression, Laminar Electron Beam Generation in a Uniform Magnetic Field

    by Robert Jackson, R. L. Ives, M. E. Read

    The need for enhanced performance of high- power RF vacuum electron devices has led to investigation of multiple-beam, sheet beam and annular beam configu- rations. A key issue with such devices is the magnetic field shaping required to produce high-power, laminar beams. Field shaping is difficult when Pierce-type gun geometries are employed. The development of high current density cathodes makes the necessary beam power achievable without compression. Such cathodes can operate within a uniform magnetic field yielding advantages for both single and distributed-beam RF devices. However, the quality of the resulting beams presents problems. A project to optimize beam quality in zero-convergence electron guns was undertaken by Calabazas Creek Research (CCR) and North Carolina State University (NCSU). The surprising result was that high quality electron beams can be gener- ated in uniform magnetic fields using convex (dome) shaped cathodes. The underlying physics involves perturbation of the beam cyclotron motion by a non-adiabatic radial electric field impulse. This paper examines this physical mechanism and extends the initial result to additional diode and beam geometries.

  • Beam-RF Simulation via Partial Decomposition of the Maxwell Equations Part I: Mathematical Framework

    by Robert H. Jackson

    Simulating the interaction of RF-waves with charged particle beams is difficult and computationally expensive, even on present high-end computers. There is a tradeoff between fidelity and complexity/expense of the two primary techniques, particle-in-cell and envelope methods. This paper presents an approach based on the partial decomposition of the Maxwell equations to achieve a fully second-order set of ordinary differential equations (ODEs) describing the interaction. It has the potential for self-consistent inclusion of ac and dc space-charge effects through a solution of evanescent ODEs, effects that are handled poorly, if at all, by existing envelope methods. The resulting technique provides flexibility in adjusting simulation fidelity versus computational costs. The developments presented in this paper establish a mathematical framework for this technique and test its core aspects by demonstrating accurate solution of the ODEs using analytic sources.

  • A Compact THz Source: 100/200 GHz Operation of a Cylindrical Smith–Purcell Free-Electron Laser

    by Jacques Gardelle, Patrick Modin, Hans P. Bluem, Robert H. Jackson, Jonathan D. Jarvis, Alan M. M. Todd, John T. Donohue

    We report first operation in the terahertz regime of a cylindrical grating Smith-Purcell free-electron laser. Propagation of an annular electron beam in proximity to a cylindrical grating causes strong electron bunching due to a beam-surface wave interaction. Electromagnetic radiation results from the bunching (fundamental) and, at bunch harmonics, the Smith-Purcell effect. In the experiment, over 2.5 kW was generated at 100 GHz (fundamental) and over 100 W at 200 GHz (Smith-Purcell). The results illustrate the potential of this configuration for generation of high-power terahertz radiation.


  • Open Access

    First Lasing From a High-Power Cylindrical Grating Smith–Purcell Device

    by Hans P. Bluem, Robert H. Jackson, Jonathan D. Jarvis, Alan M. M. Todd, Jacques Gardelle, Patrick Modin, John T. Donohue

    Over the past year, a collaborative effort between Advanced Energy Systems and Commissariat à l'Energie Atomique/Centre d'Etudes Scientifiques et Techniques d'Aquitaine has achieved the first lasing of a cylindrical Smith-Purcell free-electron laser (CSPFEL). These proof-of-principle experiments employed an 80-keV 45-A 200-ns full-width at half-maximum thin annular electron beam propagating just above a cylindrical grating. The interaction of the beam with the evanescent grating mode resulted in strong beam bunching and generation of high-power millimeter-wave radiation. First lasing of the CSPFEL was achieved with a grating period of 2 cm (5-GHz fundamental). Further experiments were performed with a 6-mm period grating (15-GHz fundamental) yielding 10 kW at the second harmonic, 30 GHz. This paper discusses only the second experiment. Comparison of the experimental results with particle-in-cell (PIC) simulations shows good agreement. An experiment at 100 GHz is in progress. The basic properties of Smith-Purcell radiation and the evanescent grating mode will be presented first. Then the experimental configuration and results will be discussed. The next section will cover the PIC simulations and comparison with the experiment. The final section will summarize the results and discuss the future directions for this research. The long-term goal is the development of compact terahertz devices with sufficient power to address applications that are impractical or impossible with the existing sources.


  • Compact High-Power THz Source Development

    by Hans P. Bluem, Alan M. M. Todd, Robert H. Jackson

    A compact, affordable THz source to provide high power is under development. The prototype is designed to operate around 600 GHz with reasonable gain and efficiency. The goal of the present project is development of a tunable THz source, based on the ubitron concept, utilizing an RF gun with an electron beam energy less than 2 MeV. This configuration results in a cost-effective, compact system capable of generating flexible, high-power THz radiation. Our simulations projected the source deliver THz radiation with 10s of watts of output power.

  • Status of the Field Marshal Environment and Toolset

    by Robert H. Jackson, Michael McLay, R. P. Joshi, A. Mishra

    The field Marshal electromagnetic simulation environment (FM-EMSE) is aimed at small research groups involved in electromagnetics design and analysis. Project goals include improved user interface consistency, single- geometry to drive multiple tools and inclusion of legacy codes. A key objective is a simulation system that can be modified, extended and maintained by researchers who are not expert programmers. The present status of the FM environment and the basic FM simulation toolset will be presented.

  • Femtomolar isothermal desorption using microhotplate sensors

    by Amol G. Shirke, Richard E. Cavicchi, Steve Semancik, Robert H. Jackson, Brian G. Frederick, M. Clayton Wheeler

    The authors describe a technique that utilizes the fast heating rates (106K∕s) of a microhotplate sensor along with a calibrated thermal desorption system to determine the initial coverage and kinetic parameters using isothermal desorption on a millisecond time scale. Models for isothermal desorption including both pumping and desorption rate effects are presented for zero, first, and second order kinetics. Analysis of the first order model illustrates the domain of the desorption, pumping speed, and heating rate time constants that permit the desorption parameters to be estimated from the mass spectrometer signal. The technique is demonstrated using isothermal temperature programed desorption of benzoic acid from a single SnO2 covered microhotplate at surface temperatures ranging from 296to347K. The data indicate that desorption is best represented by first order kinetics. The first order preexponential factor and the desorption energy in the zero coverage limit are determined to be 1×1017s−1 and 97kJ∕mol, respectively, from desorption of 108molecules which corresponds to an initial coverage of 1012cm−2 (⩽0.005 ML).


  • Demonstration of a new free-electron laser harmonic interaction

    by H. Bluem, R.H. Jackson, H.P. Freund, D.E. Pershing, V.L. Granatstein

    The first experimental demonstration of a harmonic free-electron laser amplifier utilizing a periodic position instability is described for a planar wiggler configuration. The interaction occurs at the even harmonics of the fundamental. A maximum gain of 7 dB was observed over a frequency band ranging from 14 to 15 GHz. The experimental results are compared with predictions from the three-dimensional simulation code WIGGLIN with excellent agreement. Improvements due to a tapered wiggler for this interaction are discussed.<>