Timothy K. Oliver
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Timothy K. Oliver has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Michael Stockenhuber
Chemical Engineering, School of Engineering, University of Newcastle, Callaghan, NSW, 2308, Australia
8 shared publications - Eric M. Kennedy
Discipline of Chemical Engineering, University of Newcastle, Callaghan, NSW 2308, Australia
6 shared publications - Faezeh Farhang
Western Australian School of Mines: Minerals, Energy and Chemical Engineering, Curtin University, Bentley, WA 6102, Australia
4 shared publications Geoff F. Brent
Mineral Carbonation International (MCi), Newcastle, New South Wales 2308, Australia
4 shared publications- Muhammad Imran Rashid
Department of Chemical, Polymer and Composite Material Engineering University of Engineering and Technology (New Campus) Lahore Pakistan
4 shared publications - Ammar Abu Fara
Discipline of Chemical Engineering, University of Newcastle, Callaghan, NSW 2308, Australia
3 shared publications
Latest Publications
- Open Access
Direct Aqueous Carbonation of Heat-Activated Lizardite; Effect of Particle Size and Solids Loading on Magnesite Yield
In this study, we investigated the effect of particle size and solids loading on the magnesite yield in the direct aqueous mineral carbonation of heat-activated lizardite. Experimentation was conducted under single-step reaction conditions (130 bar partial pressure of carbon dioxide (CO2) and 150 °C, with 0.64 M sodium bicarbonate (NaHCO3) and 15 wt% solids) as developed by the Albany Research Center (ARC). The objective of the study was to enhance the understanding of the direct aqueous mineral carbonation process in heat-activated lizardite. Furthermore, we aimed to shed light on how variations in particle size could affect the reaction rate, yield, and the development of protective silica layers. Our experimental data suggest that the extraction of magnesium from finer particles (sub 20 µm) is marginally more effective than from the larger size fractions. This difference likely stems from the larger surface area of fine particles (sub 20 µm) in both low and high solids loading experiments. The highest magnesite yield was 50% after 60 min, and this was achieved for both solids loadings (5 and 15 wt%), demonstrating that the solids loading had no impact on the yield. Our findings indicate rapid heat-activated lizardite reaction within 20 min, which achieved 34% and 40% conversion for 5 wt% and 15 wt% solids loading, respectively. This is followed by declining rates with increasing solids loading.
Open AccessDirect Aqueous Carbonation of Heat-Activated Lizardite; Effect of Particle Size and Solids Loading on Magnesite Yield
In this study, we investigated the effect of particle size and solids loading on the magnesite yield in the direct aqueous mineral carbonation of heat-activated lizardite. Experimentation was conducted under single-step reaction conditions (130 bar partial pressure of carbon dioxide (CO2) and 150 °C, with 0.64 M sodium bicarbonate (NaHCO3) and 15 wt% solids) as developed by the Albany Research Center (ARC). The objective of the study was to enhance the understanding of the direct aqueous mineral carbonation process in heat-activated lizardite. Furthermore, we aimed to shed light on how variations in particle size could affect the reaction rate, yield, and the development of protective silica layers. Our experimental data suggest that the extraction of magnesium from finer particles (sub 20 µm) is marginally more effective than from the larger size fractions. This difference likely stems from the larger surface area of fine particles (sub 20 µm) in both low and high solids loading experiments. The highest magnesite yield was 50% after 60 min, and this was achieved for both solids loadings (5 and 15 wt%), demonstrating that the solids loading had no impact on the yield. Our findings indicate rapid heat-activated lizardite reaction within 20 min, which achieved 34% and 40% conversion for 5 wt% and 15 wt% solids loading, respectively. This is followed by declining rates with increasing solids loading.
- Open Access
Effect of Solid Ratio and Particle Size on Dissolution of Heat-Activated Lizardite at Elevated Pressures and Moderate Temperatures
This study investigates the effect of the particle size and solid-to-liquid ratio on the dissolution rate of magnesium (Mg) and silicon (Si) in heat-activated lizardite. The investigation was conducted under specific conditions: without the presence of sodium bicarbonate (NaHCO3), at a moderate temperature (40 °C), and under elevated CO2 pressure (100 bar). The aim was to isolate the dissolution reactions and enhance comprehension of the factors constraining the overall yields in the Albany Research Center (ARC) mineral carbonation process. Our study disclosed two distinct dissolution regimes: an initial stage with a rapid initial rate of Mg extraction, resulting in the fraction of Mg extracted ranging from 30 to 65% during the first 20 min of the experiment, following which the dissolution rate decreases dramatically. The initial rapid dissolution stage is primarily driven by the low pH of the supernatant solution, resulting from CO2 dissolution, leading to a higher concentration of protons that extract Mg2+ cations. However, as the heat-activated lizardite dissolution progresses, the pH increases due to the high level of leached Mg2+, and a diffusion barrier forms due to the precipitation of amorphous silica. This phenomenon ultimately slows down the mineral’s dissolution rate during the latter stages of particle dissolution.
Open AccessEffect of Solid Ratio and Particle Size on Dissolution of Heat-Activated Lizardite at Elevated Pressures and Moderate Temperatures
This study investigates the effect of the particle size and solid-to-liquid ratio on the dissolution rate of magnesium (Mg) and silicon (Si) in heat-activated lizardite. The investigation was conducted under specific conditions: without the presence of sodium bicarbonate (NaHCO3), at a moderate temperature (40 °C), and under elevated CO2 pressure (100 bar). The aim was to isolate the dissolution reactions and enhance comprehension of the factors constraining the overall yields in the Albany Research Center (ARC) mineral carbonation process. Our study disclosed two distinct dissolution regimes: an initial stage with a rapid initial rate of Mg extraction, resulting in the fraction of Mg extracted ranging from 30 to 65% during the first 20 min of the experiment, following which the dissolution rate decreases dramatically. The initial rapid dissolution stage is primarily driven by the low pH of the supernatant solution, resulting from CO2 dissolution, leading to a higher concentration of protons that extract Mg2+ cations. However, as the heat-activated lizardite dissolution progresses, the pH increases due to the high level of leached Mg2+, and a diffusion barrier forms due to the precipitation of amorphous silica. This phenomenon ultimately slows down the mineral’s dissolution rate during the latter stages of particle dissolution.
- Open Access
Editorial: Advances in Mineral Carbonation
Mineral carbonation stands out as a prominent technology aimed at reducing atmospheric CO2 emissions, a major contributor to the greenhouse effect, through a variety of processes
Open AccessEditorial: Advances in Mineral Carbonation
Mineral carbonation stands out as a prominent technology aimed at reducing atmospheric CO2 emissions, a major contributor to the greenhouse effect, through a variety of processes
- 10 January 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (3) , 1314-1320
Effect of NaHCO3 on the Magnesite Yield in Direct Aqueous Carbonation of Thermally-Activated Lizardite
- 10 January 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (3) , 1314-1320
Effect of NaHCO3 on the Magnesite Yield in Direct Aqueous Carbonation of Thermally-Activated Lizardite
- 1 June 2021
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 48, 101516
Application of concurrent grinding in direct aqueous carbonation of magnesium silicates
- 1 June 2021
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 48, 101516
Application of concurrent grinding in direct aqueous carbonation of magnesium silicates
- 10 November 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 59 (15) , 6828-6839
Structure of Silica Polymers and Reaction Mechanism for Formation of Silica-Rich Precipitated Phases in Direct Aqueous Carbon Mineralization
- 10 November 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 59 (15) , 6828-6839
Structure of Silica Polymers and Reaction Mechanism for Formation of Silica-Rich Precipitated Phases in Direct Aqueous Carbon Mineralization
- 1 March 2019
- Published by Elsevier in Journal of Cleaner Production
- Vol. 212, 151-161
Development of Concurrent grinding for application in aqueous mineral carbonation
- 1 March 2019
- Published by Elsevier in Journal of Cleaner Production
- Vol. 212, 151-161
Development of Concurrent grinding for application in aqueous mineral carbonation
- 1 November 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 33 (3) , 1753-1766
CO2 Capture Modeling Using Heat-Activated Serpentinite Slurries
- 1 November 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 33 (3) , 1753-1766
CO2 Capture Modeling Using Heat-Activated Serpentinite Slurries
- 17 October 2018
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 38 (3)
ACEME: Direct Aqueous Mineral Carbonation of Dunite Rock
This research explores the use of serpentinized dunite (which is comprised of 61% lizardite) as a feedstock for aqueous mineral carbonation. In initial experiments, dunite was heat‐activated (630°C, 4 h), adopting a procedure which is similar to that used for serpentinite to enhance their carbonation reactivity. Heat‐activation converts crystalline lizardite mineral into an amorphous, reactive phase, and the carbonation of this heat‐activated material resulted in a magnesite yield of 55% compared to 27% obtained with raw dunite under the same reaction conditions. The formation of silanol nests occurred during carbonation of heat‐activated dunite as deduced through FTIR and TGA‐MS analyses. Samples of dunite were also heat‐transformed at high temperatures (800°C, 3 h) to convert lizardite into forsterite, and these samples were also studied as potential feedstocks for mineral carbonation. Heat‐activated dunite was found to engender much higher magnesite yields compared to heat‐transformed dunite (forsterite rich) and raw dunite. This study suggests that during heat‐activation of dunite, as it is for lizardite, conditions should be maintained to avoid forsterite formation. © 2018 American Institute of Chemical Engineers Environ Prog, 38:e13075, 2019
- 17 October 2018
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 38 (3)
ACEME: Direct Aqueous Mineral Carbonation of Dunite Rock
This research explores the use of serpentinized dunite (which is comprised of 61% lizardite) as a feedstock for aqueous mineral carbonation. In initial experiments, dunite was heat‐activated (630°C, 4 h), adopting a procedure which is similar to that used for serpentinite to enhance their carbonation reactivity. Heat‐activation converts crystalline lizardite mineral into an amorphous, reactive phase, and the carbonation of this heat‐activated material resulted in a magnesite yield of 55% compared to 27% obtained with raw dunite under the same reaction conditions. The formation of silanol nests occurred during carbonation of heat‐activated dunite as deduced through FTIR and TGA‐MS analyses. Samples of dunite were also heat‐transformed at high temperatures (800°C, 3 h) to convert lizardite into forsterite, and these samples were also studied as potential feedstocks for mineral carbonation. Heat‐activated dunite was found to engender much higher magnesite yields compared to heat‐transformed dunite (forsterite rich) and raw dunite. This study suggests that during heat‐activation of dunite, as it is for lizardite, conditions should be maintained to avoid forsterite formation. © 2018 American Institute of Chemical Engineers Environ Prog, 38:e13075, 2019
- 1 October 2016
- Published by Elsevier in Chemical Geology
- Vol. 436, 11-23
Chemical and isotopic signatures of waters associated with the carbonation of ultramafic mine tailings, Woodsreef Asbestos Mine, Australia
- 1 October 2016
- Published by Elsevier in Chemical Geology
- Vol. 436, 11-23
Chemical and isotopic signatures of waters associated with the carbonation of ultramafic mine tailings, Woodsreef Asbestos Mine, Australia