Meiqi Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Meiqi Liu has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Jing Zhao
Univ. of Shanghai for Science and Technology
1 shared publication - Liang Xu
Beihang Hangzhou Innovation Institute Yuhang, Hangzhou, China
1 shared publication - Lixiao Shen
Zhejiang Univ
1 shared publication M. Wang
Department of Transport & Planning, Delft University of Technology, Delft, The Netherlands
1 shared publication- Serge Paul Hoogendoorn
Department of Transport & Planning, Faculty of Civil Engineering and Geosciences, Delft University of Technology, Stevinweg 1, Delft, 2628 CN, Zuid-Holland, The Netherlands
1 shared publication - Sheng Jin
Institute of Intelligent Transportation Systems, College of Civil Engineering and Architecture, Zhejiang University, Hangzhou 310058, China
1 shared publication
Latest Publications
- Open Access
- 21 October 2021
- Published by Taylor & Francis in Transportmetrica B: Transport Dynamics
- Vol. 10 (1) , 971-987
An optimal control approach of integrating traffic signals and cooperative vehicle trajectories at intersections
An integrated approach for optimising traffic signals and cooperative vehicle trajectories at urban intersections is proposed. The upper layer determines the optimal signals using enumeration and the lower layer optimises trajectories under each feasible signal plan. In the lower layer, platoon accelerations are optimised considering comfort and delay while satisfying motion constraints and safe requirements. The red phase is enforced as a logic constraint, which restricts vehicles to stay behind the stop-line. Typical platoon manoeuvres such as split and approach can be included in the lower layer. The integrated control approach is adaptive to traffic demands and flexible in incorporating different traffic movements during multiple signal phases. The controller performance is verified by simulation of three designed scenarios. The comparison with trajectory optimization and signal optimization demonstrates the advantages on throughput, fuel economy, delay and vehicle stops, and reveals insights into the optimal patterns on signals and trajectories.
- 21 October 2021
- Published by Taylor & Francis in Transportmetrica B: Transport Dynamics
- Vol. 10 (1) , 971-987
Open AccessAn optimal control approach of integrating traffic signals and cooperative vehicle trajectories at intersections
An integrated approach for optimising traffic signals and cooperative vehicle trajectories at urban intersections is proposed. The upper layer determines the optimal signals using enumeration and the lower layer optimises trajectories under each feasible signal plan. In the lower layer, platoon accelerations are optimised considering comfort and delay while satisfying motion constraints and safe requirements. The red phase is enforced as a logic constraint, which restricts vehicles to stay behind the stop-line. Typical platoon manoeuvres such as split and approach can be included in the lower layer. The integrated control approach is adaptive to traffic demands and flexible in incorporating different traffic movements during multiple signal phases. The controller performance is verified by simulation of three designed scenarios. The comparison with trajectory optimization and signal optimization demonstrates the advantages on throughput, fuel economy, delay and vehicle stops, and reveals insights into the optimal patterns on signals and trajectories.
- 1 February 2019
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering, Part A: Systems
- Vol. 145 (2)
Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan
Adding lanes is a common method to increase the capacity at intersections. The additional turning lanes are often limited by the road configuration. The paper presents a probabilistic model to calculate the total capacity at signalized intersections for a full through lane and an additional left-turn lane. The proposed model has an advantage over current estimation methodologies by considering not only stochastic arrivals of vehicles but also the signal timing plan, especially signal phasing sequence. Two blockage situations under this channelization form are taken into account. The proposed capacity model shows that the capacities of the through and left-turn movements are related to the proportion of the through traffic volume, the length of the additional turning lane, and the effective green time of both through and left-turn signal phases. It is also found that the through capacity increases with the increase of the proportion of the through traffic and the length of the additional lane, whereas the left-turn capacity declines with an increase of the proportion of the through traffic but increases with an increase of the length of the additional lane. Both capacities decrease with the increase of the green time when the ratio is fixed. The proposed model is compared with design recommendations and verified using the microscopic traffic software VISSIM as well as field data. The results show that the capacities obtained by theoretical models are consistent with the simulated results, and have an advantage over the design recommendations. The capacity models can provide theoretical suggestions for the design of additional turning lanes and signal timing plans.- 1 February 2019
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering, Part A: Systems
- Vol. 145 (2)
Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan
Adding lanes is a common method to increase the capacity at intersections. The additional turning lanes are often limited by the road configuration. The paper presents a probabilistic model to calculate the total capacity at signalized intersections for a full through lane and an additional left-turn lane. The proposed model has an advantage over current estimation methodologies by considering not only stochastic arrivals of vehicles but also the signal timing plan, especially signal phasing sequence. Two blockage situations under this channelization form are taken into account. The proposed capacity model shows that the capacities of the through and left-turn movements are related to the proportion of the through traffic volume, the length of the additional turning lane, and the effective green time of both through and left-turn signal phases. It is also found that the through capacity increases with the increase of the proportion of the through traffic and the length of the additional lane, whereas the left-turn capacity declines with an increase of the proportion of the through traffic but increases with an increase of the length of the additional lane. Both capacities decrease with the increase of the green time when the ratio is fixed. The proposed model is compared with design recommendations and verified using the microscopic traffic software VISSIM as well as field data. The results show that the capacities obtained by theoretical models are consistent with the simulated results, and have an advantage over the design recommendations. The capacity models can provide theoretical suggestions for the design of additional turning lanes and signal timing plans.