HAHossein Afzalimehr

Hossein Afzalimehr

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hossein Afzalimehr has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Experimental Study on the Influence of Dune Dimensions on Flow Separation

    by Artemis Motamedi, Hossein Afzalimehr, Vijay P. Singh, Louis Dufresne

    Using laboratory experiments and a numerical model, this study examined the influence of dune dimensions on the separation of flow. Different conditions, depending on the dune height, material, and angle and flow depth and velocity, were considered. Experiments were conducted in a horizontal flume with one side wall being transparent for application of optical measuring devices. A train of two-dimensional (2D) fixed dunes were installed on the bottom of the flume starting just downstream of the entrance on the flume. Dunes were prepared with well-sorted gravel particles. Experiments were carried out using four types of dunes with different lee slopes. The numerical model used was sediment simulation in intakes with multiblock option (SSIIM), which is an open-source computational fluid dynamics model. Both experimental observations and numerical results were in agreement about the influence of dune characteristics on the flow separation, with particular regard to dune height, particle size, angle on the leeside, and flow velocity.


  • Evaluation of a Novel Approach to Determine the Critical Shields Stress

    by Artemis Motamedi, Hossein Afzalimehr, Vijay P. Singh

    This study investigated the sediment entrainment and critical shear stress in gravel-bed rivers. Measured rates of bed load transport were used to estimate the Shields stress parameter. The computed parameters were compared to those derived from the Meyer-Peter-Muller method. The agreement between these methods was good and the values of τ∗c obtained by the two methods can be justified by the Shields diagram and decreased with increasing d50 / d90 (where τ∗c is critical Shields stress, d50 is sediment size with 50% particles finer and d90 sediment size with 90% particles finer).


  • Hydraulic Geometry Relations for Stable Channel Design

    by Hossein Afzalimehr, Mohammad Abdolhosseini, Vijay P. Singh

    This study compared the downstream hydraulic geometry relations for stable channel design derived by other investigators with the equations derived from the data gathered from Iranian rivers based on the at-a-station method. For these rivers measurements of 425 velocity profiles and nearly 6,000 point velocities for 85 cross sections were employed to accurately determine flow discharge at a specified river section. For at-a-station method, grain size and the Shields parameter were not important for the determination of width and depth of a stable channel. It was found that the dominant or at-a-station discharge did not affect the discharge exponent in the depth equation, but it affected the discharge exponent in the width equation. Furthermore, discharge was not the controlling variable for the prediction of slope of stable channels, but grain size and the Shields parameter were.


  • Effect of Vegetation on Banks on Distributions of Velocity and Reynolds Stress under Accelerating Flow

    by Hossein Afzalimehr, Elham Fazel Najfabadi, Vijay P. Singh

    Vegetation on banks of natural channels exercises a significant influence on the flow structure and in turn on the velocity distribution as well as the distribution of Reynolds stress (the random turbulent fluctuations in fluid momentum). This study experimentally investigated the effect of vegetation on banks on accelerating flow in a gravel-bed flume. The results showed that in the presence of vegetation the Reynolds stress distribution became nonlinear and the velocity distribution took on a deformed S shape near the vegetated banks. In addition, vegetation on banks had more influence on the location of maximum velocity than had the aspect ratio. The log law fitted the data near the bed up to y/h=0.2 ( h=flow depth and y=distance from the bed), however, very near the bed the scatter in data was significant. Finally, the Coles law cannot be applied for accelerating flow when the vegetation was present on banks.


  • Estimation of Friction Factor in Open Channels

    by Artemis Motamedi, Hossein Afzalimehr, Vijay P. Singh

    Using a large set of field and laboratory data, this study investigated the effect of slope and the Shields parameter on the friction factor. It identified the ranges of critical shear stress and bed slope for which Froude number would or would not play an important role in the evaluation of friction. It was found that the prediction of friction factor for slopes less than 0.000 81 was not satisfactory. For the Shields parameter range of ( 0.01< τ∗c <0.1 ) and the range of slope of 0.000 82–0.01, the prediction of friction factor was satisfactory even without considering the effect of Froude number. On the other hand, the inclusion of Froude number improved the estimation of friction factor for the range of ( 0.01< τ∗c <0.05 ) and steeper slopes (0.01–0.02). Finally, in gravel/sand rivers in Iran, friction factor can be estimated whether or not the flow velocity is known.


  • Determination of Form Friction Factor

    by Hossein Afzalimehr, Vijay P. Singh, Elham Fazel Najafabadi

    Friction factor plays a fundamental role in hydraulic analysis and design. In coarse-bed rivers friction factor depends on grain size and bed forms. Considering boundary-layer characteristics, this study first determines the total friction factor in gravel-bed rivers with bed forms. Then it determines the grain friction factor by the Keulegan and the Shields parameter methods and compares these methods. Finally it determines the form friction factor by subtracting the grain friction factor from the total friction factor. Field observations are employed to test the methods.


  • Effect of non‐uniformity of flow on velocity and turbulence intensities over a cobble‐bed

    by Hossein Afzalimehr

    Non‐uniform flows encompassing both accelerating and decelerating flows over a cobble‐bed flume have been experimentally investigated in a flume at a scale of intermediate relative submergence. Measurements of mean longitudinal flow velocity u, and determinations of turbulence intensities u′, v′, w′, and Reynolds shear stress −ufwf have been made. The longitudinal velocity distribution was divided into the inner zone close to the bed and the outer zone far from the bed. In the inner zone of the boundary layer (near the bed) the velocity profile closely followed the ‘Log Law’; however, in the outer zone the velocity distribution deviated from the Log Law consistently for both accelerating and decelerating flows and the changes in bed slopes ranging from −2% to + 2% had no considerable effect on the outer zone. For a constant bed slope (S = ±0·015), the larger the flow rate, the smaller the turbulence intensities. However, no detectable pattern has been observed for u′, v′ and w′ distributions near the bed. Likewise, for a constant flow rate (Q = 0·040 m3/s), with variation in bed slope the longitudinal turbulent intensity profile in the longitudinal direction remained concave for both accelerating and decelerating flows; whereas vertical turbulent intensity (w′) profile presented no specific form. The results reveal that the positions of maximum values of turbulence intensities and the Reynolds shear stress depend not only on the flow structure (accelerating or decelerating) but also on the intermediate relative submergence scale. Copyright © 2009 John Wiley & Sons, Ltd.


  • Influence of Meandering on the Estimation of Velocity and Shear Velocity in Cobble-Bed Channels

    by Hossein Afzalimehr, Vijay P. Singh

    Field experiments carried out on five reaches of the meandering cobble-bed Beheshtabad River in central Iran showed that the position of the maximum velocity was independent of the relative submergence ( h/ d50 less or more than 4) and relative curvature ( R/W ) (where h is the flow depth, d50 is the median diameter of sediment, R is the radius of curvature, and W is the river width). A new method, called the boundary-layer characteristic method, was employed for the determination of shear velocity. The shear velocity values estimated with this method were in agreement with those obtained using the parabolic law. The law of the wall was valid for low and high relative curvatures in the inner, outer, and central zones of the meandering reaches. However, this law was not suitable for determining the shear velocity for the relative submergence range of 2.7<h/ d50 <9.6 due to its high sensitivity to near-bed velocities. Interestingly, it was possible to predict the flow velocity in meandering reaches using th...