CTCarl Tape

Carl Tape

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Carl Tape has a total of 186 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Evaluation of a 3D Crustal Velocity Model for Northern Israel Using Wavefield Simulations

    by Guy Ben-Dor, Ittai Kurzon, Carl Tape, Michael Tsesarsky

    We evaluate a recently developed 3D crustal velocity model for northern Israel using numerical simulations of seismic wave propagation for eighteen earthquakes (3≤Mw≤4.5). Synthetic seismograms were compared with observed recordings from the Israel Seismic Network in the frequency range 0.1–0.5 Hz in the time domain through cross correlation, and in the frequency domain through a spectral-misfit analysis. Cross correlations of observed records with synthetics show higher similarities to those generated by the 3D model. In addition, the time lags between synthetic and observed waveforms are concentrated around zero. By contrast, synthetics generated using the 1D regional model show increasing time lags with increasing distance. The 3D model also substantially reduces the median spectral misfit relative to the 1D model across all components, with Gitt1D median misfit values of 0.72 (Z), 1.03 (R), and 1.02 (T) reduced to −0.19 (Z), 0.23 (R), and 0.38 (T) in Be3D, yielding a more balanced reproduction of observed amplitudes. Spatially, the 3D model performs best in regions of relatively simple crustal structure but underestimates spectral amplitudes within narrow sedimentary basins, particularly along the Kinneret–Kinarot and Hula basins, likely due to unresolved near-surface low-velocity zones. This study represents an intermediate step in an ongoing model development cycle. Although the 3D model demonstrates clear improvements over the 1D reference, the evaluation also identifies key limitations that must be addressed. These findings directly inform planned future modeling efforts, including the incorporation of finer-resolution sedimentary basin structures constrained by additional geophysical datasets.


  • Open Access

    Implementing three-dimensional Earth models for wavefield simulations and seismic moment tensor estimation

    by Amanda M McPherson, Carl Tape, Daniel Peter

    SUMMARY: Seismic moment tensors provide simple representations of a wide range of event types, including earthquakes, volcanic events, landslides, and explosions. Estimating the six parameters of a seismic moment tensor is subject to inaccuracies in the assumed Earth model, whether it is characterized by a simple layered structure (1-D) or by heterogeneities (3-D). Using recorded data and seismic wavefield simulations in 3-D Earth models, we estimate double-couple and full moment tensors using MTUQ software, and then we quantify the differences among moment tensors due to the different Earth models. We establish new capabilities for implementing 3-D Earth models from the EarthScope Earth Model Collaboration (EMC) into the wave propagation code SPECFEM3D Globe. The three workflow components—EMC, SPECFEM3D Globe, and MTUQ—are publicly available, thereby maximizing possibilities for access, reproducibility, and future enhancements. We demonstrate the source estimation workflow in the region of Alaska, using five earthquakes and five 3-D Earth models. Using misfit measures from the moment tensor estimation, we can quantify the performance of both the moment tensor and also the underlying Earth model. For this limited data set of five well-recorded events, we demonstrate how to examine basic questions of source variability, tomographic model evaluation, and the reliability of non-double-couple components of moment tensors. The procedures enable quantification and visualization of moment tensor uncertainties due to Earth models, while also offering direct comparison of tomographic models with an independent reference set of data.

  • Open Access

    Observational Evidence of a Very‐Low‐Frequency Earthquake ( M w 3.8) Leading to an Earthquake ( M w 4.2): Minto Flats Strike‐Slip Fault Zone, Central Alaska

    by A. M. McPherson, C. Tape, Y. Kaneko

    The physical conditions governing earthquake initiation are largely unknown, particularly in the minutes to seconds preceding rupture. While there is geodetic and seismic evidence of precursory activity in the hours to weeks prior to large earthquakes, the observational evidence immediately preceding the earthquake rupture is limited and controversial. Here we present evidence of a well‐recorded earthquake from the Minto Flats fault zone in central Alaska having 43 s of high‐frequency precursory signals. Within these signals was a M w 3.8 very‐low‐frequency earthquake (VLFE) on a dipping strike‐slip fault. The VLFE was followed by a M w 4.2 earthquake having the same focal mechanism as the VLFE. The distinct signals and the close similarity in focal mechanisms between the VLFE and the earthquake provide evidence for a slow‐to‐fast rupture transition during earthquake initiation.

  • Open Access

    Winter Seismic Soundscape of the Parks Highway Corridor, Central Alaska

    by Isabella Seppi, Carl Tape, Elizabeth M. Berg, Evans A. Onyango

    In February 2019, 302 nodal seismometers were deployed every 1 km along the Parks Highway in Alaska, from Nenana to Trapper Creek, for a period of 35 days. Concurrently, 95 seismometers were deployed away from the highway, in a 1.3 km array spanning the Denali fault. The Parks Highway seismometers recorded a variety of signals, including from local, regional, and teleseismic earthquakes, mining blasts, helicopters, planes, trains, and automobiles. Our overarching goal is to characterize the seismic soundscape for this region, composed of source types—defined by durations and frequency ranges—as well as temporal and spatial variations in ambient noise. We present several novel observations for this region, including air-to-ground coupled waves from mining blasts, loaded-versus-unloaded trains, the noise produced by a river frozen at its surface, and the influence of sedimentary basin structures on ambient noise. This documentation of events and noise provides a step toward quantifying the seismic soundscape, establishing distance-based detection limits for different source types, and providing guidance for future detailed studies and deployments in Alaska.


  • A Seismic Nodal Deployment on the Denali Fault in the Region of Canwell Glacier and the Alaska Pipeline, Central Alaska

    by Pieter-Ewald Share, Carl Tape, Amir A. Allam, Fan-Chi Lin

    The Denali fault is a continental-scale feature carving through the Alaska Range. It exhibits hundreds of kilometers of right-lateral displacement, and it most recently ruptured a 226 km section as part of a three-fault, 340 km rupture during the 2002 Mw 7.9 earthquake. Little is known about the subsurface structure of the Denali fault zone. In April 2016, a set of 189 nodal seismic sensors was deployed between the Richardson Highway and the toe of the Canwell Glacier. The sensors recorded continuously for about three weeks. Here, we provide an introduction to this dataset and a preliminary analysis using local earthquakes and ambient noise. The array shows clear sensitivity to fault-zone structures that are aligned with the 2002 surface rupture. We identify opportunities for more expansive analyses with the 2016 data, and we provide recommendations for a future possible deployment in the same region.


  • Open Access

    Earthquake Catalog for the Fairbanks Region of Central Alaska, 2014–2024, Based on Waveform Cross-Correlation

    by Nealey E. Sims, Carl Tape, Natalia A. Ruppert, Michael E. West

    The Fairbanks region of central Alaska is part of a broad zone of intraplate crustal deformation, situated north of the Denali fault and north of the ongoing collision and flat-slab subduction of the Yakutat oceanic plateau. Seismicity in the Fairbanks region occurs both in diffuse areas as well as in well-defined lineaments, such as the left-lateral Salcha fault, which hosted the 1937 Ms 7.3 earthquake. Starting with the regional seismicity catalog, we perform waveform cross-correlation, network-matched filtering, and relative relocation to obtain an enhanced seismicity catalog over the time period 2014–2024. Based on the relocated catalog, we interpret a set of 15 fault segments, including two conjugate faults and two new faults east of the previously documented fault system. Considering the combined seismicity in the Minto and Fairbanks regions, the median depth of seismicity decreases from east (6 km) to west (20 km). Our interpreted faults provide guidance for future tectonic modeling and assessment of seismic hazards in this region.


  • Open Access

    The 20 June 2025 Mw 4.9 Event in the Central Alborz, Iran: A Rare Normal-Faulting Earthquake Within a Complex Transpressional Regime

    by Felix Rodriguez-Cardozo, Jochen Braunmiller, Julien Thurin, Jinyin Hu, Thanh-Son Phạm, Abdolreza Ghods, Celso Alvizuri, Hrvoje Tkalčić, Carl Tape

    On 20 June 2025, an Mw 4.9 earthquake struck the central Alborz Mountains in northern Iran. Using high‐quality broadband data from in‐country seismic stations, we estimated source mechanisms using different estimation approaches. All approaches consistently yielded a double‐couple normal‐faulting solution at 7–8 km depth. This event is anomalous for the region because the Alborz accommodates deformation primarily through thrust and left‐lateral strike‐slip faulting within a complex transpressional regime. The earthquake is the first significant normal‐faulting event in the central Alborz in 37 yr. Its mechanism provides the best‐constrained and most direct seismological evidence of extensional tectonism within the transpressional central Alborz Mountains, in agreement with previous geological observations and geodynamic models.


  • Open Access

    Analysis of Seismic Wave Amplification in Sedimentary Basins Using 3D Wavefield Simulations: Nenana Basin, Central Alaska

    by Yuan Tian, Carl Tape

    We investigate seismic wave amplification in Nenana basin, central Alaska, using 3D seismic wavefield simulations. We quantify frequency‐dependent amplification by comparing synthetic seismograms among four different seismic velocity models: (a) a tomographic model, (b) a tomographic model with the uppermost 6.5 km replaced by a 1D basin profile, (c) a tomographic model with an embedded ellipsoidal basin, and (d) a tomographic model with an embedded realistic basin. For each model we perform wavefield simulations accurate up to 2 Hz for a set of 10 different earthquakes, which provide a range of frequencies and incident angles for waves interacting with the basin. Average amplification ratios are four on the horizontal components and seven on the vertical component. The dominant influence of the amplification is the 3D geometry of the basin, not the slow‐velocity profile near the surface. Our synthetic amplification ratios are in general agreement with amplification estimates obtained from 14 stations that recorded the same set of earthquakes. Our approach offers a general strategy for documenting frequency‐dependent basin amplification for a region with realistic basin structures and local earthquakes.


  • Open Access

    Estimating an airborne dipole source using 3-D wavefield simulations and seismic receivers on the ground

    by Amanda M McPherson, Carl Tape, David Fee, Julien Thurin, Jordan W Bishop

    SUMMARY: Acoustic signals can couple to the ground, providing an opportunity to use seismic stations to investigate airborne sources. The study of Bishop et al. used wavefield simulations in a fluid-solid medium to quantify the role of topography on the seismic (ground) recordings of a monopole source in the air. We build upon this study by linking wavefield forward modelling with the source estimation code MTUQ, which can accommodate point forces or moment tensors in a solid medium, as well as sources in the air (or water) if they are enabled by the forward-modelling solver. We perform a series of synthetic numerical experiments to demonstrate that a dipole airborne source can be estimated using ground-based receivers, even within the presence of realistic topography. We investigate the influence of receiver coverage, topography, and assumed source location on the estimated results. The established capabilities raise the prospects for future efforts to estimate dipole sources in 3-D models that include heterogeneity in the air and the earth in addition to topography.


  • Open Access

    The 1912 Ms 7.2 Earthquake in the Denali Region of Central Alaska

    by Carl Tape, Anthony Lomax, Sean P. Bemis, Peter J. Haeussler, Jessalyn Ginnaty

    The 2002 Mw 7.9 earthquake in central Alaska ruptured 340 km on three faults—Susitna Glacier thrust fault, Denali fault, Totschunda fault—crossing both the Richardson Highway and the Alaska Pipeline. Its occurrence prompted renewed interest in historical large earthquakes that possibly originated on the Denali fault. One of these earthquakes was a Ms 7.2 event on July 7, 1912, which we revisit with two approaches: (1) probabilistic relocation of the epicenter using globally recorded arrival times, and (2) compilation and reassessment of shaking intensity reports to estimate a macroseismic epicenter. Our preferred instrumental epicenter is west of the Parks Highway and in agreement with the maximum-reported shaking, which was from the Parker–Browne expedition of Denali. We also relocated a Ms 6.4 aftershock, whose epicenter is 11 km from the mainshock. Candidate faults for the 1912 earthquake include the Denali fault, the McLeod Creek thrust fault, and the Kantishna Hills thrust fault. Future analysis of active faults, paleoseismic results, 1912 instrumental data, and 1912 felt reports may help in interpreting the fault and mechanism of the 1912 earthquake.