Qiang Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Qiang Yang has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Chang Geun Yoo
Department of Chemical Engineering, State University of New York College of Environmental Science and Forestry, Syracuse, NY, 13210, USA
3 shared publications Duo He
Western Michigan University
3 shared publications- Yan Jiang
Guangxi University
2 shared publications - Chao Yang
International Joint Research Center of Green Energy Chemical Engineering East China University of Science and Technology Shanghai China
1 shared publication Chengrong Qin
College of Light Industry and Food Engineering, Guangxi University, Daxue Road 100, Nanning 530004, P. R. China
1 shared publicationDanni Xie
Department of Chemical and Paper Engineering, College of Applied Science and Engineering, Western Michigan University, Kalamazoo, Michigan 49008, United States
1 shared publication
Latest Publications
- Open Access
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Physically Doped and Printed Elastomer Films as Flexible High-Performance Triboelectric Nanogenerator for Self-Powered Acoustic and Electrocardiograph Sensors
Flexible triboelectric nanogenerator (f-TENG) is usually fabricated from elastomer. However, elastomer is generally not as effective as fluorine or amine plastics in gaining or donating electrons, which compromises the electrical performance of the fabricated f-TENG. Herein, this study demonstrates a simple solution-casting based physical doping strategy to develop highperformance triboelectric elastomer films and f-TENGs. Styrenic elastomer film was physically doped using various fluorines or amines. The doped elastomer films were further printed with flexible silver electrodes and then were used to construct a wide spectrum of f-TENGs. Remarkably, at vertical contact-separation mode, the f-TENG fabricated from the trifluoroacetic acid and polystyrene-bound triazabicyclodecene respectively doped films generated up to 385 V voltage with maximum 39.7 μA/cm 2 current density and 15.1 mW/cm 2 power density. This f-
- 1 January 2022
- Published by Elsevier in SSRN Electronic Journal
Open AccessPhysically Doped and Printed Elastomer Films as Flexible High-Performance Triboelectric Nanogenerator for Self-Powered Acoustic and Electrocardiograph Sensors
Flexible triboelectric nanogenerator (f-TENG) is usually fabricated from elastomer. However, elastomer is generally not as effective as fluorine or amine plastics in gaining or donating electrons, which compromises the electrical performance of the fabricated f-TENG. Herein, this study demonstrates a simple solution-casting based physical doping strategy to develop highperformance triboelectric elastomer films and f-TENGs. Styrenic elastomer film was physically doped using various fluorines or amines. The doped elastomer films were further printed with flexible silver electrodes and then were used to construct a wide spectrum of f-TENGs. Remarkably, at vertical contact-separation mode, the f-TENG fabricated from the trifluoroacetic acid and polystyrene-bound triazabicyclodecene respectively doped films generated up to 385 V voltage with maximum 39.7 μA/cm 2 current density and 15.1 mW/cm 2 power density. This f-
- 1 June 2021
- Published by Elsevier in Carbohydrate Polymers
- Vol. 261, 117895
Introducing hydroxyl groups as cellulose-binding sites into polymeric solid acids to improve their catalytic performance in hydrolyzing cellulose
- 1 June 2021
- Published by Elsevier in Carbohydrate Polymers
- Vol. 261, 117895
Introducing hydroxyl groups as cellulose-binding sites into polymeric solid acids to improve their catalytic performance in hydrolyzing cellulose
- 2 April 2021
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 9 (15) , 5364-5376
Fractionation of Poplar Wood Using a Bifunctional Aromatic Acid under Mild Conditions
- 2 April 2021
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 9 (15) , 5364-5376
Fractionation of Poplar Wood Using a Bifunctional Aromatic Acid under Mild Conditions
- 10 November 2020
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 8 (47) , 17508-17519
Highly Transparent, UV-Shielding, and Water-Resistant Lignocellulose Nanopaper from Agro-Industrial Waste for Green Optoelectronics
- 10 November 2020
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 8 (47) , 17508-17519
Highly Transparent, UV-Shielding, and Water-Resistant Lignocellulose Nanopaper from Agro-Industrial Waste for Green Optoelectronics
- 14 July 2020
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 22 (16) , 5414-5422
The fractionation of woody biomass under mild conditions using bifunctional phenol-4-sulfonic acid as a catalyst and lignin solvent
The complete and mild-condition fractionation of woody biomass without energy-intensive size reduction still remains a significant challenge. This study reports an innovative cellulose-centred fractionation process based on bifunctional, recyclable, inexpensive, and lignin-derivable phenol-4-sulfonic acid (PSA). The results showed that aqueous PSA solution (e.g., 72 wt%) near-completely fractionated centimetre-sized hardwood, such as poplar and birch chips, into cellulose fibres of high quality (length: >1 mm, crystallinity index: 61–65, DPv: 830–887), fermentable hemicellulose sugars, and lignin in theoretical maximum yields under mild conditions (e.g., 50–80 °C, 0.5–3 h, atm). Calculations and experimental results suggest that PSA, as a small amphiphile, could form aggregates and clusters in water. Therefore, during fractionation, PSA acted as not only a selective catalyst through the immobilized sulfonic acid groups to depolymerize hemicellulose and lignin, but also as a mesoscale solvent to solubilize and protect lignin fragments through aggregates and accumulating around them due to the hydrophobic effect.
- 14 July 2020
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 22 (16) , 5414-5422
The fractionation of woody biomass under mild conditions using bifunctional phenol-4-sulfonic acid as a catalyst and lignin solvent
The complete and mild-condition fractionation of woody biomass without energy-intensive size reduction still remains a significant challenge. This study reports an innovative cellulose-centred fractionation process based on bifunctional, recyclable, inexpensive, and lignin-derivable phenol-4-sulfonic acid (PSA). The results showed that aqueous PSA solution (e.g., 72 wt%) near-completely fractionated centimetre-sized hardwood, such as poplar and birch chips, into cellulose fibres of high quality (length: >1 mm, crystallinity index: 61–65, DPv: 830–887), fermentable hemicellulose sugars, and lignin in theoretical maximum yields under mild conditions (e.g., 50–80 °C, 0.5–3 h, atm). Calculations and experimental results suggest that PSA, as a small amphiphile, could form aggregates and clusters in water. Therefore, during fractionation, PSA acted as not only a selective catalyst through the immobilized sulfonic acid groups to depolymerize hemicellulose and lignin, but also as a mesoscale solvent to solubilize and protect lignin fragments through aggregates and accumulating around them due to the hydrophobic effect.
- 1 July 2020
- Published by Elsevier in Biomass and Bioenergy
- Vol. 138, 105611
A recyclable and regenerable solid acid for efficient hydrolysis of cellulose to glucose
- 1 July 2020
- Published by Elsevier in Biomass and Bioenergy
- Vol. 138, 105611
A recyclable and regenerable solid acid for efficient hydrolysis of cellulose to glucose
- 22 May 2019
- Published by Springer Nature in Microchimica Acta
- Vol. 186 (6) , 368
Redox modulated fluorometric sensing of ascorbic acid by using a hybrid material composed of carbon dots and CoOOH nanosheets
Carbon dots (CDs) were hydrothermally prepared from gelatin as the sole precursor. The CDs were hybridized with CoOOH nanosheets (NSs) to obtain a fluorescent probe (CD-CoOOH) for ascorbic acid (AA). The blue luminescence of the CDs, with excitation/emission maxima of 350/443 nm, is quenched by the NSs. If the NSs are reduced to Co2+ by addition of AA, the CD-CoOOH hybrid is disintegrated and fluorescence recovers. The hybrid nanoprobe has a linear response in the 0.8–12.5 μM and 12.5–690 μM AA concentration ranges and a 0.025 μM limit of detection. Compared to previously reported methods for detecting AA, this methods has a wider linear range and a lower detection limit. The nanoprobe was utilized to quantify AA in spiked human serum samples and gave satisfactory results. The strategy was also applied to the construction of an “AND” logic gate, which avoided perplexed material decorations and chemical tracking.
- 22 May 2019
- Published by Springer Nature in Microchimica Acta
- Vol. 186 (6) , 368
Redox modulated fluorometric sensing of ascorbic acid by using a hybrid material composed of carbon dots and CoOOH nanosheets
Carbon dots (CDs) were hydrothermally prepared from gelatin as the sole precursor. The CDs were hybridized with CoOOH nanosheets (NSs) to obtain a fluorescent probe (CD-CoOOH) for ascorbic acid (AA). The blue luminescence of the CDs, with excitation/emission maxima of 350/443 nm, is quenched by the NSs. If the NSs are reduced to Co2+ by addition of AA, the CD-CoOOH hybrid is disintegrated and fluorescence recovers. The hybrid nanoprobe has a linear response in the 0.8–12.5 μM and 12.5–690 μM AA concentration ranges and a 0.025 μM limit of detection. Compared to previously reported methods for detecting AA, this methods has a wider linear range and a lower detection limit. The nanoprobe was utilized to quantify AA in spiked human serum samples and gave satisfactory results. The strategy was also applied to the construction of an “AND” logic gate, which avoided perplexed material decorations and chemical tracking.
- 19 November 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 7 (1) , 933-943
Cross-Linked Polyethylenimine for Selective Adsorption and Effective Recovery of Lignocellulose-Derived Organic Acids and Aldehydes
- 19 November 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 7 (1) , 933-943
Cross-Linked Polyethylenimine for Selective Adsorption and Effective Recovery of Lignocellulose-Derived Organic Acids and Aldehydes
- 1 August 2015
- Published by Elsevier in Industrial Crops and Products
- Vol. 70, 410-416
Ambient-temperature sulfuric acid pretreatment to alter structure and improve enzymatic digestibility of alfalfa stems
- 1 August 2015
- Published by Elsevier in Industrial Crops and Products
- Vol. 70, 410-416
Ambient-temperature sulfuric acid pretreatment to alter structure and improve enzymatic digestibility of alfalfa stems