Victoria K. Davis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Victoria K. Davis has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
Allison C. Hu
Keck Sci. Dep., Claremont McKenna, Pitzer Scripps Coll., Claremont, CA 91711, USA
2 shared publicationsAndrew R. S. Vinson
Keck Sci. Dep., Claremont McKenna, Pitzer Scripps Coll., Claremont, CA 91711, USA
2 shared publicationsArunamarie Arunasalam
Keck Sci. Dep., Claremont McKenna, Pitzer Scripps Coll., Claremont, CA 91711, USA
2 shared publications- Christopher M. Bates
University of California
2 shared publications Kate A. Jesse
Keck Sci. Dep., Claremont McKenna, Pitzer Scripps Coll., Claremont, CA 91711, USA
2 shared publicationsMorgan A. Shattuck
Keck Sci. Dep., Claremont McKenna, Pitzer Scripps Coll., Claremont, CA 91711, USA
2 shared publications
Latest Publications
- 2 September 2025
- Published by Elsevier in Coordination Chemistry Reviews
- Vol. 547
The influence of metal and anion electronic states on the stability of high valent metals
- 2 September 2025
- Published by Elsevier in Coordination Chemistry Reviews
- Vol. 547
The influence of metal and anion electronic states on the stability of high valent metals
- 16 October 2019
- Published by Royal Society of Chemistry (RSC) in Materials Chemistry Frontiers
- Vol. 3 (12) , 2721-2727
Fluoride-ion solvation in non-aqueous electrolyte solutions
Understanding the factors that influence ion-solvent properties for the fluoride ion in organic solvents is key to the development of useful liquid electrolytes for fluoride-ion batteries. Using both experimental and computational methods, we examined a range of chemical and electrochemical properties for a set of organic solvents in combination with dry N,N,N-trimethylneopentylammonium fluoride (Np1F) salt. Results showed that solvent electronic structure strongly influences Np1F dissolution, and the pKa of solvent protons provides a good guide to potential F− reactivity. We found a number of organic solvents capable of dissolving Np1F while providing chemically-stable F− in solution and characterized three of them in detail: propionitrile (PN), 2,6-difluoropyridine (2,6-DFP), and bis(2,2,2-trifluoroethyl) ether (BTFE). Arrhenius analysis for Np1F/PN, Np1F/DFP, and Np1F/BTFE electrolytes suggests that DFP facilitates the highest F− ion mobility of the three neat solvents. Electrolyte mixtures of BTFE and amide co-solvents exhibit higher ionic conductivity than the neat solvents. This improved ionic conductivity is attributed to the ability of BTFE:co-solvent mixtures to partition between Np1 + and F− ion-aggregates, promoting better ion dissociation.
- 16 October 2019
- Published by Royal Society of Chemistry (RSC) in Materials Chemistry Frontiers
- Vol. 3 (12) , 2721-2727
Fluoride-ion solvation in non-aqueous electrolyte solutions
Understanding the factors that influence ion-solvent properties for the fluoride ion in organic solvents is key to the development of useful liquid electrolytes for fluoride-ion batteries. Using both experimental and computational methods, we examined a range of chemical and electrochemical properties for a set of organic solvents in combination with dry N,N,N-trimethylneopentylammonium fluoride (Np1F) salt. Results showed that solvent electronic structure strongly influences Np1F dissolution, and the pKa of solvent protons provides a good guide to potential F− reactivity. We found a number of organic solvents capable of dissolving Np1F while providing chemically-stable F− in solution and characterized three of them in detail: propionitrile (PN), 2,6-difluoropyridine (2,6-DFP), and bis(2,2,2-trifluoroethyl) ether (BTFE). Arrhenius analysis for Np1F/PN, Np1F/DFP, and Np1F/BTFE electrolytes suggests that DFP facilitates the highest F− ion mobility of the three neat solvents. Electrolyte mixtures of BTFE and amide co-solvents exhibit higher ionic conductivity than the neat solvents. This improved ionic conductivity is attributed to the ability of BTFE:co-solvent mixtures to partition between Np1 + and F− ion-aggregates, promoting better ion dissociation.
- 7 December 2018
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 362 (6419) , 1144-1148
Room-temperature cycling of metal fluoride electrodes: Liquid electrolytes for high-energy fluoride ion cells
Working toward fluoride batteries: Owing to the low atomic weight of fluorine, rechargeable fluoride-based batteries could offer very high energy density. However, current batteries need to operate at high temperatures that are required for the molten salt electrolytes. Davis et al. push toward batteries that can operate at room temperature, through two advances. One is the development of a room-temperature liquid electrolyte based on a stable tetraalkylammonium salt–fluorinated ether combination. The second is a copper–lanthanum trifluoride core-shell cathode material that demonstrates reversible partial fluorination and defluorination reactions. Science , this issue p. 1144
- 7 December 2018
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 362 (6419) , 1144-1148
Room-temperature cycling of metal fluoride electrodes: Liquid electrolytes for high-energy fluoride ion cells
Working toward fluoride batteries: Owing to the low atomic weight of fluorine, rechargeable fluoride-based batteries could offer very high energy density. However, current batteries need to operate at high temperatures that are required for the molten salt electrolytes. Davis et al. push toward batteries that can operate at room temperature, through two advances. One is the development of a room-temperature liquid electrolyte based on a stable tetraalkylammonium salt–fluorinated ether combination. The second is a copper–lanthanum trifluoride core-shell cathode material that demonstrates reversible partial fluorination and defluorination reactions. Science , this issue p. 1144
- 22 May 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (24) , 12712-12722
Electric Fields Detected on Dye-Sensitized TiO2 Interfaces: Influence of Electrolyte Composition and Ruthenium Polypyridyl Anchoring Group Type
- 22 May 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 122 (24) , 12712-12722
Electric Fields Detected on Dye-Sensitized TiO2 Interfaces: Influence of Electrolyte Composition and Ruthenium Polypyridyl Anchoring Group Type
- Open Access
- 28 August 2015
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 162 (12) , A2259-A2265
Aluminum Borate Coating on High-Voltage Cathodes for Li-Ion Batteries
Li-rich layered-layered nickel manganese cobalt oxides (LLNMC) of the type Li2MnO3-LiMO2 (M = Mn, Co, Ni) are promising cathode materials due to their higher specific capacities and discharge voltages compared to state of art materials. However, these materials have yet to exhibit adequate cycle life and power characteristics in practical cells, partly due to the instability of electrolytes at these high voltages. Thin coatings of inorganic materials such as Al2O3, AlPO4, and AlF3 have been shown to minimize these degradation processes, especially on high voltage cathodes. Here, we report the use of a new aluminum borate-based coating material on the LLNMC cathode at high active mass loadings. AlBO3-coated cathodes demonstrate a sevenfold increase in lifetime compared to uncoated material, as well as higher specific discharge energies vs. analogous AlPO4-coated materials. SEM and TEM confirm the thin coatings of amorphous material. Detailed electrochemical studies including Tafel polarization, PITT, and Electrochemical Impedance Spectroscopy (EIS) show that the AlBO3 coating improves the kinetics of electron transfer.
- 28 August 2015
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 162 (12) , A2259-A2265
Open AccessAluminum Borate Coating on High-Voltage Cathodes for Li-Ion Batteries
Li-rich layered-layered nickel manganese cobalt oxides (LLNMC) of the type Li2MnO3-LiMO2 (M = Mn, Co, Ni) are promising cathode materials due to their higher specific capacities and discharge voltages compared to state of art materials. However, these materials have yet to exhibit adequate cycle life and power characteristics in practical cells, partly due to the instability of electrolytes at these high voltages. Thin coatings of inorganic materials such as Al2O3, AlPO4, and AlF3 have been shown to minimize these degradation processes, especially on high voltage cathodes. Here, we report the use of a new aluminum borate-based coating material on the LLNMC cathode at high active mass loadings. AlBO3-coated cathodes demonstrate a sevenfold increase in lifetime compared to uncoated material, as well as higher specific discharge energies vs. analogous AlPO4-coated materials. SEM and TEM confirm the thin coatings of amorphous material. Detailed electrochemical studies including Tafel polarization, PITT, and Electrochemical Impedance Spectroscopy (EIS) show that the AlBO3 coating improves the kinetics of electron transfer.
- 28 July 2015
- Published by Wiley in ChemInform
- Vol. 46 (33)
ChemInform Abstract: Gold‐Catalyzed, SN1‐Type Reaction of Alcohols to Afford Ethers and Cbz‐Protected Amines.
Unsymmetrical ethers and Cbz‐protected amines are directly obtained by a gold‐catalyzed and microwave‐assisted method to activate alcohols through an intermolecular SN1 type reaction.
- 28 July 2015
- Published by Wiley in ChemInform
- Vol. 46 (33)
ChemInform Abstract: Gold‐Catalyzed, SN1‐Type Reaction of Alcohols to Afford Ethers and Cbz‐Protected Amines.
Unsymmetrical ethers and Cbz‐protected amines are directly obtained by a gold‐catalyzed and microwave‐assisted method to activate alcohols through an intermolecular SN1 type reaction.
- 9 February 2015
- Published by Georg Thieme Verlag KG in Synlett
- Vol. 26 (06) , 765-770
Gold-Catalyzed, SN1-Type Reaction of Alcohols to Afford Ethers and Cbz-Protected Amines
The use of a gold-catalyzed, microwave protocol to activate alcohols through an intermolecular, SN1-type reaction to directly form unsymmetrical ethers and N-benzyloxy carbamate- (Cbz) protected amines is reported. Results have shown this reaction to be highly reproducible and tolerant of moisture, and moderate to high product yields (53–99%) were obtained. Significantly, the intermolecular catalytic amination of alcohols to directly afford Cbz-protected amines is heretofore unprecedented using gold catalysis.
- 9 February 2015
- Published by Georg Thieme Verlag KG in Synlett
- Vol. 26 (06) , 765-770
Gold-Catalyzed, SN1-Type Reaction of Alcohols to Afford Ethers and Cbz-Protected Amines
The use of a gold-catalyzed, microwave protocol to activate alcohols through an intermolecular, SN1-type reaction to directly form unsymmetrical ethers and N-benzyloxy carbamate- (Cbz) protected amines is reported. Results have shown this reaction to be highly reproducible and tolerant of moisture, and moderate to high product yields (53–99%) were obtained. Significantly, the intermolecular catalytic amination of alcohols to directly afford Cbz-protected amines is heretofore unprecedented using gold catalysis.
- 11 October 2013
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 90 (11) , 1514-1517
“Click” and Olefin Metathesis Chemistry in Water at Room Temperature Enabled by Biodegradable Micelles
The two laboratory reactions focus on teaching several concepts associated with green chemistry. Each uses a commercial, nontoxic, and biodegradable surfactant, TPGS-750-M, to promote organic reactions within the lipophilic cores of nanoscale micelles in water. These experiments are based on work by K. Barry Sharpless (an azide–alkyne “click” reaction) and Robert Grubbs (an olefin cross-metathesis reaction); both are suitable for an undergraduate organic laboratory. The copper-catalyzed azide–alkyne [3 + 2] cycloaddition of benzyl azide and 4-tolylacetylene is very rapid: the triazole product is readily isolated by filtration and is characterized by thin-layer chromatography and melting point analysis. The ruthenium-catalyzed olefin cross-metathesis reaction of benzyl acrylate with 1-hexene is readily monitored by thin-layer chromatography and gas chromatography. The metathesis experiment comparatively evaluates the efficacy of a TPGS-750-M/water medium relative to a traditional reaction performed in dichloromethane (a common solvent used for olefin metathesis).
- 11 October 2013
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 90 (11) , 1514-1517
“Click” and Olefin Metathesis Chemistry in Water at Room Temperature Enabled by Biodegradable Micelles
The two laboratory reactions focus on teaching several concepts associated with green chemistry. Each uses a commercial, nontoxic, and biodegradable surfactant, TPGS-750-M, to promote organic reactions within the lipophilic cores of nanoscale micelles in water. These experiments are based on work by K. Barry Sharpless (an azide–alkyne “click” reaction) and Robert Grubbs (an olefin cross-metathesis reaction); both are suitable for an undergraduate organic laboratory. The copper-catalyzed azide–alkyne [3 + 2] cycloaddition of benzyl azide and 4-tolylacetylene is very rapid: the triazole product is readily isolated by filtration and is characterized by thin-layer chromatography and melting point analysis. The ruthenium-catalyzed olefin cross-metathesis reaction of benzyl acrylate with 1-hexene is readily monitored by thin-layer chromatography and gas chromatography. The metathesis experiment comparatively evaluates the efficacy of a TPGS-750-M/water medium relative to a traditional reaction performed in dichloromethane (a common solvent used for olefin metathesis).