Yi-Jen Chiu

Yi-Jen Chiu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yi-Jen Chiu has a total of 184 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Tantalum pentoxide based on-chip femtosecond pulse compression

    by Xue Zhou, Li-Cheng Chuang, Yu-Hsiang Lin, Po-Hsun Lin, Siheng Chen, Guan-Hong Li, Yi-Jen Chiu, Chao-Kuei Lee

    In this study, we present experimental and numerical investigations of pulse compression based on high-order soliton dynamics in Ta 2 O 5 waveguides. We measure the temporal coherence of supercontinuum generation in the waveguide and deduce the pulse duration using the coherence time-pulse width relation. With a dispersion-engineered waveguide, an input pulse of 140 fs is compressed to 34.26 fs at a coupled peak power of 1.31 kW. Further optimization of dispersion and waveguide design to reduce propagation losses is expected to enable even better compression performance.


  • Hybrid InGaAsP/SiC Fabry-Perot Laser on Low Thermal Impedance SiC Substrate via Adhesive Wafer Bonding Technique

    by Wei-Cheng Feng, Yang-Jeng Chen, Chung-Wei Hsiao, Bo-Hong Chen, Jing-Ya Chiu, Lu-Kuan Du, Zong-Ting Wang, Chih-Min Liao, Yi-Jen Chiu

    Herein, a new approach of semiconductor laser is developed by integrating a vertical 1500-nm ridge-type InGaAsP P-i-N heterojunction Fabry–Pérot laser structure onto a SiC substrate via BCB adhesive wafer bonding technique. By taking advantage of a high thermal conductivity SiC substrate and thin <50nm BCB, the whole laser structure with a low thermal impedance (TI) of 19.7 K/W was observed by measuring the wavelength shift, overall dissipated power, and substrate temperature, which could thus yield a high continuous wave output power of 30.4 mW. The laser exhibited a higher optical power level and a lower threshold current density than two other lasers with the same active regions but with InP and silicon-on-insulator (SOI) substrates, confirming that the low TI of the SiC substrate contributed to the laser performance enhancement. By simulating TI in structures with different substrate, it shows that the high thermal conductivity in SiC substrate with thin BCB can still be beneficial to the overall TI. The luminescent peak wavelength of the laser with the SiC substrate exhibited a strong blue-shift phenomenon, even at current densities above the threshold current density, indicating that the low TI of the substrate considerably reduced laser self-heating caused by current injection. A III–V material heterogeneously integrated into a SiC substrate scheme using the wafer bonding technique could have wide applications in high-performance, low-cost, process-facilitated photonic integrated circuits.

  • Intrinsic two-photon absorption and damage-onset windows in Ta2O5 thin films with Z-scan approach

    by Shunyi Zhou, Yiyuan Pao, Chi-Yang Lee, Chao Wang, Rui Li, Chan-Shan Yang, Yi-Jen Chiu, Chao-Kuei Lee, Hsiang-Chen Chui


  • Supercontinuum generation from capping waveguide with Tunable Nonlinearity

    by Hsin-Han Peng, Cheng-Hsin Lin, Siyao Li, Min-Hsiung Shih, Hao-Chung Kuo, Yi-Jen Chiu, Chao-Kuei Lee, Ju Han Lee, Hsiang-Chen Chui


  • Efficient High Order Mode Supercontinuum Generation and Third-Harmonic Generation via Shortcut to Adiabaticity Coupling in Communication Band

    by Guan-Hong Li, Feng-Jung Kao, Huai Wei Tu, Min-Hsiung Shih, Hao-Chung Kuo, Shuo-Yen Tseng, Yi-Jen Chiu, Chao-Kuei Lee

    This study pioneers the application of Shortcut to Adiabaticity (STA) technology for efficient high-order mode supercontinuum generation (SCG) and third-harmonic generation (THG) in Ta2O5-based nonlinear waveguides, specifically designed for the 1550 nm communication band. Using the Lewis-Riesenfeld invariant method, we developed an STA-based directional coupler that achieves over 85% coupling efficiency from the TE00 to TE10 mode, surpassing the bandwidth and length limitations of conventional couplers while maintaining robust broadband performance. Leveraging Ta2O5’s exceptionally high nonlinear refractive index—far exceeding that of Si3N4—we achieved broadband SCG spanning 1250 nm to 1900 nm with an ultralow pump energy of just 75 pJ. Additionally, we observed stable THG at 522 nm, confirmed through power dependence analysis, with remarkable conversion efficiency at only 83 pJ pulse energy—outperforming traditional Si3N4 waveguides by an order of magnitude. This synergy between STA's advanced coupling design and Ta2O5’s superior nonlinearity not only expands the frontiers of high-order mode nonlinear optics in the telecommunications regime but also establishes a transformative framework for compact, energy-efficient photonic integrated circuits, driving advancements in ultrafast and quantum optical applications.


  • Open Access

    Optimising (Al,Ga) (As,Bi) Quantum Well Laser Structures for Reflectance Mode Pulse Oximetry

    by Aivaras Špokas, Andrea Zelioli, Andrius Bičiūnas, Bronislovas Čechavičius, Justinas Glemža, Sandra Pralgauskaitė, Mindaugas Kamarauskas, Virginijus Bukauskas, Janis Spigulis, Yi-Jen Chiu, et al.

    We explore quantum well laser diodes for applications in pulse oximetry based on two material systems, namely, classical AlGaAs and a rather exotic GaAsBi, with lasing at around 800 nm and 1100 nm, respectively. These spectral regions and material families were selected due to their closely matched effective penetration depths into soft tissue. An improved design of the band structure of device active areas was tested on both material systems, yielding enhancement of the two main parameters, namely, output power and threshold current. A maximum emission power of the AlGaAs laser diode was registered at 4.9 mW (I = 60 mA, λ = 801 nm). For the GaAsBi-based devices, the target emission of 1106 nm was measured in pulsed mode with a peak output power of 9.4 mW (I = 3 A). The most optimized structure was based on three GaAsBi quantum wells surrounded by parabolically graded AlGaAs barriers. This structure was capable of 130 mW peak power (I = 2 A, λ = 1025 nm) along with a more than tenfold decrease in threshold current to 250 mA compared to a classical rectangular quantum well active region.


  • Open Access

    Optimising (Al, GA) (as, Bi) Quantum Well Laser Structures for Reflectance Mode Pulse Oximetry

    by Aivaras Špokas, Andrea Zelioli, Andrius Bičiūnas, Bronislovas Čechavičius, Justinas Glemža, Sandra Pralgauskaitė, Mindaugas Kamarauskas, Virginijus Bukauskas, Janis Spigulis, Yi-Jen Chiu, et al.

    We explore quantum well laser diodes based on two material systems, classical AlGaAs, and a rather exotic GaAsBi, with lasing at around 800 nm and 1100 nm, respectively for applications in pulse oximetry. These spectral regions and material families were selected due to closely matched effective penetration depth into soft tissue. An improved design of the band structure of device active areas was tested on both material systems, yielding enhancement of the two main parameters, output power and threshold current. A maximum emission power of the AlGaAs laser diode was registered at 4.9 mW (I = 60 mA, λ = 801 nm). For the GaAsBi-based devices, the target emission of 1106 nm was measured at pulsed mode with a peak output power of 9.4 mW (I = 3 A). While the most optimized structure based on three GaAsBi quantum wells surrounded by parabolically graded AlGaAs barriers was capable of 130 mW of peak power (I = 2 A, λ = 1025 nm) and a more than tenfold decrease in threshold current to 250 mA, when compared to a classical rectangular quantum well active region.

  • 16-Channel 25 Gb/s Electroabsorption Modulated Tunable Multi-Wavelength DFB Laser Array Based on REC Technique

    by Zhenxing Sun, Wentao Sun, Rulei Xiao, Jie Zhao, Jiaqiang Nie, Leilei Wang, Zijiang Yang, Jiale Xu, Zhenzhen Xu, Wenxuan Wang, et al.

    A 16-channel electroabsorption modulated tunable multi-wavelength DFB laser array is proposed and experimentally demonstrated. The sixteen DFB lasers, each with a wavelength spacing of 100 GHz, are arranged in a 4 × 4 matrix. The wavelengths are designed using an interleaving scheme to reduce grating crosstalk. The grating is designed and fabricated using the reconstruction equivalent chirp (REC) technique to simplify the grating fabrication and ensure precise wavelength control. The electroabsorption modulator and the tunable multi-wavelength laser array share the same active layer to reduce fabrication complexity and costs. Wavelength tuning is achieved by selecting the active laser without altering the thermoelectric cooler (TEC). Consequently, 16 channels with 100 GHz spacing are obtained, each operating in good single-mode properties with SMSRs of above 45 dB. The average wavelength spacing is 106.1 GHz, and only 6.1 GHz deviated from the design. The semiconductor optical amplifier (SOA) is integrated to compensate for the frequency chirp and amplify the output power, thus enabling long-distance transmission. The output power is amplified to over 18 mW with a 150 mA current injected into the SOA. The 3-dB bandwidth of the EAM exceeds 20 GHz, producing clear 25 Gb/s back-to-back eye diagrams with mask margins over 40% for the 16 channels. With the assistance of the chirp compensation by the SOA, the eye diagrams of the 16 channels remain clear after 10 km of transmission. Due to the superior performance, the proposed device is promising for use in DWDM systems, particularly in applications requiring fast channel switching, such as optical packet switching and NG-PON2 technology.


  • Distributed-feedback InP-based laser diode on high-thermal conductivity silicon carbide substrate

    by Wei-Cheng Feng, Yu-Hao Tu, Yang-Jeng Chen, Lu-Kuan Du, Chung-Wei Hsiao, Zhun-Hua Wang, Yi-Jen Chiu

    A distributed-feedback (DFB) laser diode on high thermal conductivity silicon carbide substrate has been shown. CW optical power operation with low current-driven red shift, and threshold current density of 4.8 kA/cm2 has been shown.

  • 4 x 150Gb/s Mode Division Multiplexing Integrated with internal SiGe EAM on a Silicon Photonics Platform

    by Rih-You Chen, Chen-Feng Huang, Yong-Kuan Guo, Chen-Yu Yeh, Wei-Cheng Feng, Yi-Jen Chiu

    Four-channel waveguide modes through asymmetric directional couplers and two-dimensional grating have been demonstrated on a Si-photonics chip forming Mode Division Multiplexing. Four integrated SiGe EAMs has then shown a 600Gb/s data transmission in a chip.