HBHabiba Begum

Habiba Begum

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Habiba Begum has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Piezoelectric Square-Extensional Mode Oscillator for Mass Sensing in Liquid

    by Habiba Begum, Mahjabin Mobarak, Luoke Hu, Jingui Qian, Haoshen Zhu

    We present the frequency stability measurements of a piezoelectric resonator-based oscillator operating in the liquid phase. The frequency setting element is fabricated using aluminum nitride (AlN) on silicon (Si) and is excited in square-extensional (SE) mode, which enhances the electromechanical coupling. This electromechanical coupling reduces the motional resistance of the resonator, which simplifies the overall circuit setup toward improving the performance. The resonator is embedded within a phase-locked loop (PLL), allowing for real-time frequency tracking. We achieve an Allan deviation of 70 ppb through this setup. The result demonstrates a superior stability result compared to other resonators in the liquid phase that do not apply a microfluidic cell. The strain profile of SE mode resonator is a critical aspect of this work as it enhances the performance in liquid. Additionally, we briefly discuss the liquid–air boundary effect on frequency stability in liquid sensing environments. This research highlights the potential of piezoelectric resonator-based oscillator using PLL for liquid-phase sensing applications offering significant frequency stability improvements. These findings could contribute to biomedical applications, where liquid-phase sensing is crucial.


  • Integrated functions of microfluidics and gravimetric sensing enabled by piezoelectric driven microstructures

    by Jingui Qian, Yue Wang, Yuhang Xue, Habiba Begum, Yong-Qing Fu, Joshua E.-Y. Lee

    Micro- and nano-electromechanical systems resonators have been regarded as powerful tools for precision mass detection, and their abilities to measure these in a liquid environment open various opportunities for biosensing, chemical analysis, and environmental monitoring. Apart from overcoming issues of fluidic damping and electrical interfaces, there is a great challenge of bringing microanalytes to these devices with the required precision and scaling for high throughput sensing. Herein, we address the above challenges by proposing a self-excited localized acoustic manipulation methodology based on a piezoelectric micromechanical diaphragm resonator (PMDR). Such a PMDR integrates acoustofluidics and mass sensing functions in tandem on a single device. Particle enrichment is realized within tens of seconds and the limit of detection is enhanced by mitigating common issues such as low capture rate and non-uniform distribution. The developed PMDR is versatile in its applicability to a range of particle sizes and densities for both acoustofluidic actuation and in situ mass sensing. This work addresses long-term technical challenges of inaccurate and inefficient measurement of liquid phase resonance mass sensing with great application potentials in biochemical detection and environmental monitoring.


  • Acoustic Centrifugation Facilitating Particle Sensing in Liquid on a Piezoelectric Resonator

    by Jingui Qian, Habiba Begum, Joshua E.-Y. Lee

    We have developed a hybrid device that fuses the techniques of acoustofluidic localization and resonator-based mass sensing of particles in liquid-phase for in-situ analysis in a $\mu \text{L}$ droplet. An elliptic plate resonator (EPR) was used in this work to verify the capability of acoustofluidic manipulation on a resonator chip. Particles were focused on the EPR by the acoustic tweezers to increase the effectiveness of detection. The EPR has a reasonably high liquid-phase quality factor ( ${Q}$ ) and low motional resistance ( ${R}_{m}$ ) to allow the detection of focused particles in liquid. Moreover, the resonator chip can be detached from the acoustic tweezing device without damage. This allows replacement of just the chip when required. A potential application of this work is organizing and sensing cells on-chip using the concepts herein.


  • Fully differential higher order transverse mode piezoelectric membrane resonators for enhanced liquid-phase quality factors

    by Habiba Begum, Jingui Qian, Joshua Ey Lee

    This paper investigates the characteristics of higher-order transverse mode fully clamped membrane resonators that are piezoelectrically transduced as a class of resonators that completely seal the domain above the resonator from the domain below. Such isolation between the top and bottom of a resonator is preferable when encasing the device in a microfluidic cell for liquid-phase sensing measurements, a setup that can be beneficial for sensing applications. Most fully clamped membrane resonators are hampered by low liquid-phase quality factor ( Q ) and large motional resistance ( R m ). This paper describes the design of higher-order transverse (2, 2) mode square membrane and (2, 0) mode circular membrane resonators, and the effect of device scaling on liquid-phase Q and R m . We show a best-case liquid-phase R m of 54 kΩ and Q of 270 among the various membrane sizes tested. This level of liquid-phase Q is higher than some contour mode resonators. Compared to other fully clamped membrane resonators in the literature, the results here represent a significant improvement in both R m and Q , highlighting the potential of these membrane resonators for liquid-phase mass sensing applications.


  • Piezoelectric Elliptical Plate Micromechanical Resonator With Low Motional Resistance for Resonant Sensing in Liquid

    by Habiba Begum, Jingui Qian, Joshua E.-Y. Lee

    Key to realizing practical resonators for liquid-phase sensing applications is efficient electromechanical transduction and reasonable Q in liquid, which determine the motional resistance (Rm). Both lower Rm and high liquid phase Q are important for realizing a more stable close-loop oscillator to allow a lower detection limit. But Rm usually increases when scaling down resonator size, leading to weak output signals in liquid. This paper describes a piezoelectrically transduced micromechanical elliptical plate resonator (EPR) targeting liquid-phase sensing applications. The proposed EPR delivers lower Rm relative to other disk-based modes and has a reasonable Q in water. These two features are critical for eventually realizing a closed-loop system to enable real-time frequency tracking for sensing applications. The low Rm arises from enhanced transduction efficiency associated with the modal lateral strain profile. The EPR’s moderate liquid phase Q stems from transducing a stiff lateral bulk mode that increases energy storage. The proposed EPR can be scaled down more efficiently compared to other disk-based modes in the limit of mode shape distortion by anchors when scaling down the resonator below a threshold. Experimental results in water are demonstrated for a 500 μm by 400 μm EPR, which delivers an Rm of only 2.68 kΩ in water without feedthrough cancellation. Scaling down the device to 300 μm by 200 μm, we demonstrate an Rm of just 5.5 kΩ and Q of 245 in water. The proposed EPR topology boasts the lowest Rm among resonators immersed in liquid after normalizing over the device area.


  • Open Access

    Technique and Circuit for Contactless Readout of Piezoelectric MEMS Resonator Sensors

    by Marco Baù, Marco Ferrari, Habiba Begum, Abid Ali, Joshua E.-Y. Lee, Vittorio Ferrari

    A technique and electronic circuit for contactless electromagnetic interrogation of piezoelectric micro-electromechanical system (MEMS) resonator sensors are proposed. The adopted resonator is an aluminum-nitride (AlN) thin-film piezoelectric-on-silicon (TPoS) disk vibrating in radial contour mode at about 6.3 MHz. The MEMS resonator is operated in one-port configuration and it is connected to a spiral coil, forming the sensor unit. A proximate electronic interrogation unit is electromagnetically coupled through a readout coil to the sensor unit. The proposed technique exploits interleaved excitation and detection phases of the MEMS resonator. A tailored electronic circuit manages the periodic switching between the excitation phase, where it generates the excitation signal driving the readout coil, and the detection phase, where it senses the transient decaying response of the resonator by measuring through a high-impedance amplifier the voltage induced back across the readout coil. This approach advantageously ensures that the readout frequency of the MEMS resonator is first order independent of the interrogation distance between the readout and sensor coils. The reported experimental results show successful contactless readout of the MEMS resonator independently from the interrogation distance over a range of 12 mm, and the application as a resonant sensor for ambient temperature and as a resonant acoustic-load sensor to detect and track the deposition and evaporation processes of water microdroplets on the MEMS resonator surface.


  • Centrifugation of Microparticles Inside a Sessile Droplet on a Micromachined Silicon Chip Using Acoustic Tweezers

    by Jingui Qian, Habiba Begum, Joshua E.-Y. Lee

    This paper reports the first demonstration of acoustic tweezers to manipulate microparticles in a sessile droplet over a functional surface-micromachined silicon chip fabricated with polysilicon micromechanical sensing structures. The proposed plug-and-play setup comprises two interchangeable parts: a detachable silicon micromachined sensor chip (acting as a superstrate) and a surface acoustic wave (SAW) device substrate. The SAW device provides the off-chip acoustic source from which Rayleigh waves couple into the functional silicon chip. We demonstrate concentration of initially randomly dispersed microparticles in a water droplet loaded on the functional silicon chip by means of acoustic streaming forces using a drive power of 1 W.

  • Mass Sensitivity Measurements of a Novel High Q-Factor Disk Resonator for Liquid-Phase Sensing Applications

    by Habiba Begum, Abid Ali, Joshua En-Yuan Lee

    We present, for the first time, mass sensitivity measurements of a novel resonant mode based on a disk resonator that delivers the one of the highest Q-factors among resonators tested in liquid (Q of 362). The mode of interest is referred to as the Button-like (BL) mode as its associated lateral strain profile resembles a shirt button. In the context of mass sensing, the high Q-factor of the BL mode enhances mass resolution. Its motional resistance (R m ) in water is 5.3kΩ, which greatly eases the difficulty in designing control circuits. In this paper, we measured the mass sensitivity of the device by depositing chrome (Cr) on the bottom surface of the device through a back cavity. The resonator has a measured mass sensitivity of 17.2ppm/ng for uniformly deposited mass on the resonator’s surface.


  • Open Access

    Self-Sustaining Square-Extensional Mode Resonator Oscillator for Mass Sensing in Liquid

    by Habiba Begum, Abid Ali, Joshua En-Yuan Lee

    We present a 5.41 MHz square-extensional (SE) mode resonator in closed-loop oscillation for resonant mass sensing in the liquid phase. The resonator has been fabricated in piezoelectric thin film aluminum nitride (AlN) on silicon (Si). The strain profile of the SE mode allows for higher electromechanical coupling efficiency using piezoelectric transduction to lower the motional resistance (Rm) given the expected low quality factors (Q) in liquid (136 compared to 942 in air). By locking the device into self-sustained oscillation, the minimum detectable frequency shift is reduced from 3680 ppm (open-loop in water) to 8.76 ppm (closed-loop in air).