Ahmed AlSayed
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ahmed AlSayed has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Ahmed Eldyasti
Department of Civil Engineering, Lassonde School of Engineering, York University, ON, M3J1P3, Canada
1 shared publication - Elsayed Elbeshbishy
Department of Civil Engineering, Toronto Metropolitan University, Toronto, ON M5B 2K3, Canada
1 shared publication - Joseph B. McPhee
Toronto Metropolitan University
1 shared publication - Moomen Soliman
Civil Engineering Department, York University, 4700 Keele Street, Toronto, ON M3J 1P3, Canada
1 shared publication - Reshmi Misir
Department of Chemistry and Biology, Toronto Metropolitan University, Toronto, ON M5G 2A7, Canada
1 shared publication - Umme Sharmeen Hyder
Department of Civil Engineering, Toronto Metropolitan University, Toronto, Canada
1 shared publication
Latest Publications
- Open Access
Iron and Hydrogen Peroxidation-Induced Post-Treatment Improvement of Municipal Mesophilic Digestate in an Alkaline Environment and Its Impact on Biosolids Quality
Challenges associated with mesophilic digestate (MD) involve volume, odor, and pathogens, which effective post-digestion treatments can address. The efficiency of MD post-treatment can be enhanced by conditioning with ferric chloride (FeCl3), hydrogen peroxide (H2O2), and polymer. This study aimed to observe the effect of combined chemical conditioning on volume reduction, phosphorus (P) release, odor, and pathogen reduction potential for MD. MD was conditioned with polymer only, polymer and FeCl3 at pH adjusted to 8.0 with lime (Ca(OH)2), and a blend of polymer, FeCl3, and hydrogen peroxide (H2O2) at pH 8.0. The results show that adding all three chemicals improved post-treatment efficiency at 2.1 kg/t DS FeCl3, 2.1 kg/t DS polymer, and 600 mg/L H2O2 at pH 8.0, compared with polymer or dual conditioning. At the combined dose, cake solid content, centrate P removal, and odor reduction capability improved compared with raw MD by 20%, 99%, and 66%, respectively. Combined chemical treatment reduced fecal coliform by 98% but does not fulfil class A requirements and showed 50% regrowth potential. The synergic effect of polymer, FeCl3, H2O2, and alkaline pH breakdown EPS, reduced water holding capacity and formed compacted flocs for better water removal and settling. This combination also precipitated P through FeCl3 while H2O2 oxidation curbs odor, enhancing further P removal from centrate.
Open AccessIron and Hydrogen Peroxidation-Induced Post-Treatment Improvement of Municipal Mesophilic Digestate in an Alkaline Environment and Its Impact on Biosolids Quality
Challenges associated with mesophilic digestate (MD) involve volume, odor, and pathogens, which effective post-digestion treatments can address. The efficiency of MD post-treatment can be enhanced by conditioning with ferric chloride (FeCl3), hydrogen peroxide (H2O2), and polymer. This study aimed to observe the effect of combined chemical conditioning on volume reduction, phosphorus (P) release, odor, and pathogen reduction potential for MD. MD was conditioned with polymer only, polymer and FeCl3 at pH adjusted to 8.0 with lime (Ca(OH)2), and a blend of polymer, FeCl3, and hydrogen peroxide (H2O2) at pH 8.0. The results show that adding all three chemicals improved post-treatment efficiency at 2.1 kg/t DS FeCl3, 2.1 kg/t DS polymer, and 600 mg/L H2O2 at pH 8.0, compared with polymer or dual conditioning. At the combined dose, cake solid content, centrate P removal, and odor reduction capability improved compared with raw MD by 20%, 99%, and 66%, respectively. Combined chemical treatment reduced fecal coliform by 98% but does not fulfil class A requirements and showed 50% regrowth potential. The synergic effect of polymer, FeCl3, H2O2, and alkaline pH breakdown EPS, reduced water holding capacity and formed compacted flocs for better water removal and settling. This combination also precipitated P through FeCl3 while H2O2 oxidation curbs odor, enhancing further P removal from centrate.
- Open Access
Anaerobic-Based Water Resources Recovery Facilities: A Review
The concept of water resources recovery facilities (WRRFs) has gained more attention as a more sustainable substitute for the conventional activated sludge-based wastewater treatment plant (CAS-WWTPs). Anaerobic treatment is advantageous due to its lower energy use, limited sludge production, and higher recovery of the soluble chemical oxygen demand (sCOD) from the received wastewater. In this article, a critical review of the proposed scheme for the anaerobic-based WRRF (An-WRRFs) is presented which is preceded with discussion of CAS-WWTPs limitations. In addition, the evolution of anaerobic treatment from being viewed as wastewater treatment plant (WWTP) to WRRF is demonstrated. It is attained that, even though anaerobic WWTPs (An-WWTPs) have simple and low energy mainline and very limited sludge handling process, its limited removal and recovery capacity have been widely reported, especially in cold weather. On the other hand, in the An-WRRF, higher energy expenditures are employed by using membranes, dissolved methane recovery unit, and primary treatment (extra sludge handling). Yet, energy recovery in the form of biogas is notably increased, as well as the removal efficiency under moderate residence times. The three key challenges to be overcome are the low value of biogas, reducing the energy use associated with membranes, and maintaining high performance in full-scale, especially in cold weather.
Open AccessAnaerobic-Based Water Resources Recovery Facilities: A Review
The concept of water resources recovery facilities (WRRFs) has gained more attention as a more sustainable substitute for the conventional activated sludge-based wastewater treatment plant (CAS-WWTPs). Anaerobic treatment is advantageous due to its lower energy use, limited sludge production, and higher recovery of the soluble chemical oxygen demand (sCOD) from the received wastewater. In this article, a critical review of the proposed scheme for the anaerobic-based WRRF (An-WRRFs) is presented which is preceded with discussion of CAS-WWTPs limitations. In addition, the evolution of anaerobic treatment from being viewed as wastewater treatment plant (WWTP) to WRRF is demonstrated. It is attained that, even though anaerobic WWTPs (An-WWTPs) have simple and low energy mainline and very limited sludge handling process, its limited removal and recovery capacity have been widely reported, especially in cold weather. On the other hand, in the An-WRRF, higher energy expenditures are employed by using membranes, dissolved methane recovery unit, and primary treatment (extra sludge handling). Yet, energy recovery in the form of biogas is notably increased, as well as the removal efficiency under moderate residence times. The three key challenges to be overcome are the low value of biogas, reducing the energy use associated with membranes, and maintaining high performance in full-scale, especially in cold weather.