Guanyi Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Guanyi Wang has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
Mamoru Ishii
14 shared publicationsXiaohong Yang
7 shared publicationsZhuoran Dang
6 shared publicationsQingzi Zhu
5 shared publications- Mamoru Ishii
School of Nuclear Engineering, Purdue University, West Lafayette, IN 47906, USA
4 shared publications Cezary Bojanowski
3 shared publications
Latest Publications
- Open Access
- 14 June 2024
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 426
Evaluation of flow-induced plate deflection for University of Missouri research reactor low-enriched uranium fuel element
- 14 June 2024
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 426
Open AccessEvaluation of flow-induced plate deflection for University of Missouri research reactor low-enriched uranium fuel element
- Open Access
- 12 June 2023
- Published by Taylor & Francis in Nuclear Technology
- Vol. 209 (11) , 1797-1818
Numerical Simulations of Flow-Induced Deflections in MITR LEU Fuel Plate Due to Channel Size Disparity
- 12 June 2023
- Published by Taylor & Francis in Nuclear Technology
- Vol. 209 (11) , 1797-1818
Open AccessNumerical Simulations of Flow-Induced Deflections in MITR LEU Fuel Plate Due to Channel Size Disparity
- 9 February 2023
- Published by Taylor & Francis in Nuclear Technology
- Vol. 209 (12) , 1953-1964
Experiment and Modeling of Interfacial Area Concentration of Liquid Film in Upward Annular Two-Phase Flow
To accurately quantify the interfacial transfer terms in the two-fluid model, the reliable prediction of the interfacial area concentration (IAC) is crucial. The IAC in annular flow, especially the interface between the liquid film and gas core, is particularly important due to its relevance to critical heat flux and reactor operation safety. However, very few experimental and analytical studies have been performed that focus on the IAC of the liquid film in annular flow. In this work, the IAC of the liquid film is measured using a parallel-wire conductance probe for upward annular flow in a 25.4-mm one-dimensional pipe. A total of 25 flow conditions are measured with the range of superficial liquid velocity from 0.15 to 2.00 m/s and the range of superficial gas velocity from 10.0 to 29.6 m/s. The IAC radial profile is obtained from the liquid film time trace measured by the conductance probe, and the accuracy of this method is verified by flow visualization. The effects of the inlet gas and liquid flow rates on the characteristics of the IAC radial distribution as well as area-averaged IACs are analyzed. A new model is developed to predict the IAC radial distribution of the liquid film. The IAC profiles predicted by the model agree very well with the measured IAC profiles for typical annular flow conditions and have a reasonable agreement for the wispy annular flow conditions.
- 9 February 2023
- Published by Taylor & Francis in Nuclear Technology
- Vol. 209 (12) , 1953-1964
Experiment and Modeling of Interfacial Area Concentration of Liquid Film in Upward Annular Two-Phase Flow
To accurately quantify the interfacial transfer terms in the two-fluid model, the reliable prediction of the interfacial area concentration (IAC) is crucial. The IAC in annular flow, especially the interface between the liquid film and gas core, is particularly important due to its relevance to critical heat flux and reactor operation safety. However, very few experimental and analytical studies have been performed that focus on the IAC of the liquid film in annular flow. In this work, the IAC of the liquid film is measured using a parallel-wire conductance probe for upward annular flow in a 25.4-mm one-dimensional pipe. A total of 25 flow conditions are measured with the range of superficial liquid velocity from 0.15 to 2.00 m/s and the range of superficial gas velocity from 10.0 to 29.6 m/s. The IAC radial profile is obtained from the liquid film time trace measured by the conductance probe, and the accuracy of this method is verified by flow visualization. The effects of the inlet gas and liquid flow rates on the characteristics of the IAC radial distribution as well as area-averaged IACs are analyzed. A new model is developed to predict the IAC radial distribution of the liquid film. The IAC profiles predicted by the model agree very well with the measured IAC profiles for typical annular flow conditions and have a reasonable agreement for the wispy annular flow conditions.
- Open Access
- 1 September 2021
- Published by Office of Scientific and Technical Information (OSTI)
Massachusetts Institute of Technology Reactor LEU Fuel Element Flow Test Conceptual Design
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 September 2021
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessMassachusetts Institute of Technology Reactor LEU Fuel Element Flow Test Conceptual Design
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 January 2021
- Published by Elsevier in Experimental Thermal and Fluid Science
- Vol. 120
Wave structure and velocity in vertical upward annular two-phase flow
- 1 January 2021
- Published by Elsevier in Experimental Thermal and Fluid Science
- Vol. 120
Wave structure and velocity in vertical upward annular two-phase flow
- 1 March 2020
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 124
A new entrainment rate model for annular two-phase flow
- 1 March 2020
- Published by Elsevier in International Journal of Multiphase Flow
- Vol. 124
A new entrainment rate model for annular two-phase flow
- 1 February 2020
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 147
Flow structure of bubbly to slug transition flow in a small pipe
- 1 February 2020
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 147
Flow structure of bubbly to slug transition flow in a small pipe
- 1 July 2019
- Published by Taylor & Francis in Nuclear Technology
- Vol. 206 (2) , 347-357
Interfacial Structures in Bubbly-to-Slug Transition Flows in a Duct
As a critical closure equation to the two-fluid model and an important tool to characterize the two-phase-flow interfacial transport, the interfacial area transport equation (IATE) was formulated by taking various physical mechanisms causing interfacial area change into account. To fulfill the dynamic prediction advantage of IATE and further replace the flow regime–based constitutive relations, the IATE model should be validated by transition data to ensure model reliability and robustness. Air-water experiments are performed in bubbly-to-slug transition flows in a 200 × 10-mm narrow rectangular duct. Four-sensor conductivity probes are used to measure the local void fraction, interfacial area concentration (IAC), and bubble velocity at three axial locations. The void fraction distribution changes significantly with the flow developing. Flow conditions with a similar area-averaged void fraction but different superficial mixture velocities are compared, and it is found that the superficial mixture velocity significantly affects the IAC. In addition, the two-group IATE model for narrow rectangular channel is evaluated using the collected data. The average relative error for the total IAC prediction is 11.4%, but the group II IAC is overestimated for most flow conditions.
- 1 July 2019
- Published by Taylor & Francis in Nuclear Technology
- Vol. 206 (2) , 347-357
Interfacial Structures in Bubbly-to-Slug Transition Flows in a Duct
As a critical closure equation to the two-fluid model and an important tool to characterize the two-phase-flow interfacial transport, the interfacial area transport equation (IATE) was formulated by taking various physical mechanisms causing interfacial area change into account. To fulfill the dynamic prediction advantage of IATE and further replace the flow regime–based constitutive relations, the IATE model should be validated by transition data to ensure model reliability and robustness. Air-water experiments are performed in bubbly-to-slug transition flows in a 200 × 10-mm narrow rectangular duct. Four-sensor conductivity probes are used to measure the local void fraction, interfacial area concentration (IAC), and bubble velocity at three axial locations. The void fraction distribution changes significantly with the flow developing. Flow conditions with a similar area-averaged void fraction but different superficial mixture velocities are compared, and it is found that the superficial mixture velocity significantly affects the IAC. In addition, the two-group IATE model for narrow rectangular channel is evaluated using the collected data. The average relative error for the total IAC prediction is 11.4%, but the group II IAC is overestimated for most flow conditions.