Ulugbek Saidvaliev
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ulugbek Saidvaliev has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Dror Fixler
Tel Aviv University
2 shared publications - Farkhad R. Akhmedzhanov
Institute of Ion-Plasma and Laser Technologies, Tashkent, Uzbekistan
2 shared publications - Arulappan Durairaj
Department of Chemistry, Bar-Ilan Institute for Nanotechnology and Advanced Materials, Bar-Ilan University, Ramat-Gan 52900, Israel
1 shared publication Astemir R. Likhov
Bach Institute of Biochemistry Research Center of Biotechnology of the Russian Academy of Sciences Moscow Russian Federation
1 shared publicationBar Atuar
Faculty of Engineering and the Institute of Nanotechnology and Advanced Materials Bar Ilan University Ramat Gan Israel
1 shared publicationDmitry Demin
MIREA — Russian Technological University Moscow Russia
1 shared publication
Latest Publications
- Open Access
- 20 October 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (20) , 1328
Hydrothermal Synthesis of Water-Dispersible Fluorescent Carbon Dots from Renewable Plant Precursors: Antibacterial Activity and Comparative Characterization
We present here a one-pot hydrothermal synthesis of fluorescent carbon dots (CDs) using olive, rosemary, sage, and thyme leaves as a carbon source. The hydrothermal reaction was conducted at 180 °C for 12 h, thereby converting biomass into water-dispersible CDs without a passivating agent. The average size of the CDs, determined by TEM, was 3–6 nm, with a spherical morphology. All synthesized CDs displayed excitation-dependent fluorescence, with emission maxima at 400–440 nm (blue) with excitation at 340–370 nm. FLIM measurements yielded similar fluorescence lifetimes of approximately 5 ns in aqueous solutions of CDs. FTIR spectra indicated surface hydroxyl and nitrogen-containing functionalities that may contribute to photoluminescence. The antibacterial activity of the as-synthesized CDs against a panel of Gram-positive and Gram-negative bacteria (Staphylococcus aureus, Listeria innocua, Escherichia coli, Pseudomonas aeruginosa, methicillin-resistant S. aureus (MRSA), multidrug-resistant (MDR) E. coli, and Klebsiella pneumoniae (MDR)) was investigated. It was shown that biomass-derived CDs exhibit antibacterial activity, being more effective against Gram-positive bacteria, with MIC values as low as 0.625 mg/mL for olive-, rosemary-, and thyme-derived CDs against S. aureus and MRSA. These findings suggest that the developed CDs are fluorescent materials offering viable possibilities in biomedical research, as well as antimicrobial agents.
- 20 October 2026
- Published by MDPI AG in Nanomaterials
- Vol. 16 (20) , 1328
Open AccessHydrothermal Synthesis of Water-Dispersible Fluorescent Carbon Dots from Renewable Plant Precursors: Antibacterial Activity and Comparative Characterization
We present here a one-pot hydrothermal synthesis of fluorescent carbon dots (CDs) using olive, rosemary, sage, and thyme leaves as a carbon source. The hydrothermal reaction was conducted at 180 °C for 12 h, thereby converting biomass into water-dispersible CDs without a passivating agent. The average size of the CDs, determined by TEM, was 3–6 nm, with a spherical morphology. All synthesized CDs displayed excitation-dependent fluorescence, with emission maxima at 400–440 nm (blue) with excitation at 340–370 nm. FLIM measurements yielded similar fluorescence lifetimes of approximately 5 ns in aqueous solutions of CDs. FTIR spectra indicated surface hydroxyl and nitrogen-containing functionalities that may contribute to photoluminescence. The antibacterial activity of the as-synthesized CDs against a panel of Gram-positive and Gram-negative bacteria (Staphylococcus aureus, Listeria innocua, Escherichia coli, Pseudomonas aeruginosa, methicillin-resistant S. aureus (MRSA), multidrug-resistant (MDR) E. coli, and Klebsiella pneumoniae (MDR)) was investigated. It was shown that biomass-derived CDs exhibit antibacterial activity, being more effective against Gram-positive bacteria, with MIC values as low as 0.625 mg/mL for olive-, rosemary-, and thyme-derived CDs against S. aureus and MRSA. These findings suggest that the developed CDs are fluorescent materials offering viable possibilities in biomedical research, as well as antimicrobial agents.
- 3 February 2025
- Published by Wiley in Journal of Biophotonics
- Vol. 18 (12) , e202400147
Enhanced Fluorescence Imaging of Implants Based on Polyester Copolymers in Combination With MRI
Nowadays, many biodegradable materials are offered for biomedical applications, but there are only a few in vivo methods for their detection and monitoring. In this work, implants based on biodegradable polyester copolymers were labeled with indocyanine green (ICG) for fluorescence imaging in combination with tissue optical clearing (TOC) and magnetic resonance imaging (MRI). The results include in vitro degradation modeling followed by in vivo imaging of copolymer samples that were subcutaneously implanted in BALB/c mice. TOC with 70% glycerol has been demonstrated to significantly improve sample visualization. The TOC efficiency parameter Q demonstrated the variability of effects correlating with the timing of follow‐up in the postimplantation period. It has been shown that nonhealing wounds, peri‐implantation inflammation, or fibrosis, confirmed by MRI, affect the effectiveness of TOC in the range from Q = −30% to 70%.
- 3 February 2025
- Published by Wiley in Journal of Biophotonics
- Vol. 18 (12) , e202400147
Enhanced Fluorescence Imaging of Implants Based on Polyester Copolymers in Combination With MRI
Nowadays, many biodegradable materials are offered for biomedical applications, but there are only a few in vivo methods for their detection and monitoring. In this work, implants based on biodegradable polyester copolymers were labeled with indocyanine green (ICG) for fluorescence imaging in combination with tissue optical clearing (TOC) and magnetic resonance imaging (MRI). The results include in vitro degradation modeling followed by in vivo imaging of copolymer samples that were subcutaneously implanted in BALB/c mice. TOC with 70% glycerol has been demonstrated to significantly improve sample visualization. The TOC efficiency parameter Q demonstrated the variability of effects correlating with the timing of follow‐up in the postimplantation period. It has been shown that nonhealing wounds, peri‐implantation inflammation, or fibrosis, confirmed by MRI, affect the effectiveness of TOC in the range from Q = −30% to 70%.
- 17 February 2020
- Published by Taylor & Francis in Ferroelectrics
- Vol. 556 (1) , 23-28
Parameters of elastic anisotropy in bismuth silicate crystals
To describe the elastic anisotropy of the noncentrosymmetric cubic bismuth silicate crystals (point symmetry group 23), real and imaginary elastic moduli of these crystals were determined. These data were used to determine the real and imaginary elastic anisotropy parameters of this crystal. It is shown that the attenuation coefficients of acoustic waves, determined through the introduced anisotropy parameter Δc′ and Δc″ are in good agreement with the experimental values of the attenuation both longitudinal and transverse acoustic waves. The obtained results can be useful for predicting the general characteristic of the anisotropy of the elastic properties of cubic crystals, including the attenuation of acoustic waves.
- 17 February 2020
- Published by Taylor & Francis in Ferroelectrics
- Vol. 556 (1) , 23-28
Parameters of elastic anisotropy in bismuth silicate crystals
To describe the elastic anisotropy of the noncentrosymmetric cubic bismuth silicate crystals (point symmetry group 23), real and imaginary elastic moduli of these crystals were determined. These data were used to determine the real and imaginary elastic anisotropy parameters of this crystal. It is shown that the attenuation coefficients of acoustic waves, determined through the introduced anisotropy parameter Δc′ and Δc″ are in good agreement with the experimental values of the attenuation both longitudinal and transverse acoustic waves. The obtained results can be useful for predicting the general characteristic of the anisotropy of the elastic properties of cubic crystals, including the attenuation of acoustic waves.
- 1 January 2018
- Published by Acoustical Society of America (ASA) in Proceedings of Meetings on Acoustics
- Vol. 34 (1) , 045045
Singularities of anisotropy of acoustic attenuation in paratellurite crystals
The attenuation coefficient of acoustics waves in paratellurite crystals has been investigated by the Bragg diffraction of light method in the frequency range 0.4–1.6 GHz. The results were used for the determination of the real and imaginary components of the complex tensor of elastic constants. To determine the attenuation and velocity of acoustic waves in the (001) plane at the angles close to the X (or Y) axis (the angles less than 4 degrees) approximate formulas were used for the first time instead of the Christoffel – Green equations. The obtained effective elastic constants allow more correctly describe the anisotropy of the acoustic attenuation and velocity in this plane. It is shown that anomalously strong anisotropy of acoustic attenuation is observed for the transverse wave propagating in the plane (1-10).
- 1 January 2018
- Published by Acoustical Society of America (ASA) in Proceedings of Meetings on Acoustics
- Vol. 34 (1) , 045045
Singularities of anisotropy of acoustic attenuation in paratellurite crystals
The attenuation coefficient of acoustics waves in paratellurite crystals has been investigated by the Bragg diffraction of light method in the frequency range 0.4–1.6 GHz. The results were used for the determination of the real and imaginary components of the complex tensor of elastic constants. To determine the attenuation and velocity of acoustic waves in the (001) plane at the angles close to the X (or Y) axis (the angles less than 4 degrees) approximate formulas were used for the first time instead of the Christoffel – Green equations. The obtained effective elastic constants allow more correctly describe the anisotropy of the acoustic attenuation and velocity in this plane. It is shown that anomalously strong anisotropy of acoustic attenuation is observed for the transverse wave propagating in the plane (1-10).