Agnese Osite
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Agnese Osite has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Adrian Covaci
University of Antwerp
1 shared publication - Aigerim A. Kazakbaeva
Tomsk State University, 36 Lenin ave., Tomsk, 634050, Russia
1 shared publication - Alisa Sabalina
Institute for Mechanics of Materials, University of Latvia, Jelgavas 3, LV-1004 Riga, Latvia
1 shared publication - Argelia Castaño
National Centre for Environmental Health, Instituto de Salud Carlos III, 28220 Majadahonda, Spain
1 shared publication - Arturs Viksna
University of Latvia
1 shared publication - Cathrine Thomsen
Department of Food Safety, Norwegian Institute of Public Health (NIPH), Oslo, Norway
1 shared publication
Latest Publications
- Open Access
Environmental Effects on Strength and Failure Strain Distributions of Sheep Wool Fibers
Sheep wool is an eco-friendly, renewable, and totally recyclable material increasingly used in textiles, filters, insulation, and building materials. Recently, wool fibers have become good alternatives for reinforcement of polymer composites and filaments for 3D printing. Wool fibers are susceptible to environmental degradation that could shorten their lifetime and limit applications. This study reports on the mechanical properties of sheep wool fibers under the impact of humid air and UV irradiation. The results of single fiber tensile tests showed a noticeable gauge length effect on the fibers’ strength and failure strain. Long (50 mm) fibers possessed about 40% lower characteristics than short (10 mm) fibers. Environmental aging decreased the elastic modulus and strength of the fibers. Moisture-saturated fibers possessed up to 43% lower characteristics, while UV aging resulted in up to a twofold reduction of the strength. The most severe degradation effect is observed under the coupled influence of UVs and moisture. The two-parameter Weibull distribution was applied for the fiber strength and failure strain statistical assessment. The model well predicted the gauge length effects. Moisture-saturated and UV-aged fibers were characterized by less extensive strength dependences on the fiber length. The strength and failure strain distributions of aged fibers were horizontally shifted to lower values. The results will contribute to be reliable predictions of the environmental durability of sheep wool fibers and will extend their use in technical applications.
Open AccessEnvironmental Effects on Strength and Failure Strain Distributions of Sheep Wool Fibers
Sheep wool is an eco-friendly, renewable, and totally recyclable material increasingly used in textiles, filters, insulation, and building materials. Recently, wool fibers have become good alternatives for reinforcement of polymer composites and filaments for 3D printing. Wool fibers are susceptible to environmental degradation that could shorten their lifetime and limit applications. This study reports on the mechanical properties of sheep wool fibers under the impact of humid air and UV irradiation. The results of single fiber tensile tests showed a noticeable gauge length effect on the fibers’ strength and failure strain. Long (50 mm) fibers possessed about 40% lower characteristics than short (10 mm) fibers. Environmental aging decreased the elastic modulus and strength of the fibers. Moisture-saturated fibers possessed up to 43% lower characteristics, while UV aging resulted in up to a twofold reduction of the strength. The most severe degradation effect is observed under the coupled influence of UVs and moisture. The two-parameter Weibull distribution was applied for the fiber strength and failure strain statistical assessment. The model well predicted the gauge length effects. Moisture-saturated and UV-aged fibers were characterized by less extensive strength dependences on the fiber length. The strength and failure strain distributions of aged fibers were horizontally shifted to lower values. The results will contribute to be reliable predictions of the environmental durability of sheep wool fibers and will extend their use in technical applications.
- Open Access
- 14 December 2021
- Published by Springer Nature in Air Quality, Atmosphere & Health
- Vol. 15 (7) , 1275-1286
Fireworks—a source of nanoparticles, PM2.5, PM10, and carbonaceous aerosols
Fireworks pollute the local atmosphere with various air pollutants, which can pose a health hazard for the local population. Mass and number concentrations of aerosols were measured before, during, and after the 2016/2017 New Year event in Ljubljana, Slovenia. Our findings highlight the negative impact of fireworks on the environment. First, both the mass concentration of black carbon and the number of concentrations of nanoparticles between 80 and 150 nm increased shortly after midnight. Second, on Jan 1, 2017, there was an increase in the average daily mass concentrations of PM10 and PM2.5. Third, on this day, our devices also detected increased air pollution by Al, Ba, Sr, and Cu, that is, heavy metals usually associated with fireworks. Their Jan 1 mass concentrations were more than 10 times (and Sr more than 140 times) higher than their average daily mass concentrations from Jan 3 (when their mass concentrations returned to more normal levels) to Jan 31. We also found that pairwise correlations between nanoparticles, PM10, and black carbon are positive, strong, and statistically significant. Besides carbon, the chemical analysis of the collected particles revealed the presence of typical elements used in pyrotechnic devices and their significant positive correlation.
- 14 December 2021
- Published by Springer Nature in Air Quality, Atmosphere & Health
- Vol. 15 (7) , 1275-1286
Open AccessFireworks—a source of nanoparticles, PM2.5, PM10, and carbonaceous aerosols
Fireworks pollute the local atmosphere with various air pollutants, which can pose a health hazard for the local population. Mass and number concentrations of aerosols were measured before, during, and after the 2016/2017 New Year event in Ljubljana, Slovenia. Our findings highlight the negative impact of fireworks on the environment. First, both the mass concentration of black carbon and the number of concentrations of nanoparticles between 80 and 150 nm increased shortly after midnight. Second, on Jan 1, 2017, there was an increase in the average daily mass concentrations of PM10 and PM2.5. Third, on this day, our devices also detected increased air pollution by Al, Ba, Sr, and Cu, that is, heavy metals usually associated with fireworks. Their Jan 1 mass concentrations were more than 10 times (and Sr more than 140 times) higher than their average daily mass concentrations from Jan 3 (when their mass concentrations returned to more normal levels) to Jan 31. We also found that pairwise correlations between nanoparticles, PM10, and black carbon are positive, strong, and statistically significant. Besides carbon, the chemical analysis of the collected particles revealed the presence of typical elements used in pyrotechnic devices and their significant positive correlation.
- Top Cited PapersOpen Access
- 1 January 2021
- Published by Elsevier in Environment International
- Vol. 146, 106082
Biomarkers, matrices and analytical methods targeting human exposure to chemicals selected for a European human biomonitoring initiative
- 1 January 2021
- Published by Elsevier in Environment International
- Vol. 146, 106082
Top Cited PapersOpen AccessBiomarkers, matrices and analytical methods targeting human exposure to chemicals selected for a European human biomonitoring initiative
- 12 December 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2051 (1) , 020269
Effect of the process voltage and electrolyte composition on the structure and properties of Sr-incorporated micro-arc calcium phosphate coatings formed on Mg–0.8Ca
Sr-incorporated calcium phosphate coatings were deposited on Mg–0.8 wt. % Ca alloy by the micro–arc oxidation method under the process voltages of 350–500 V, with using of Sr-substituted tricalcium phosphate (Sr-TCP) and Sr-substituted hydroxyapatite (Sr-HA). The current density for MAO process of Sr-HA coatings deposition was higher than that for the process of Sr-TCP coatings deposition. The coating morphology, microstructure and compositions have been studied using scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX) and X–ray diffraction (XRD). The phase composition of Sr-HA coatings included α-TCP, β-TCP, Mg3(PO4)2 and MgO. In addition, HA was contained in the composition of Sr-TCP. It was revealed that Sr is uniformly distributed within the coating layer. The highest concentration of Sr was 2.0 at. % in Sr-HA coatings deposited at 500 V.
- 12 December 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2051 (1) , 020269
Effect of the process voltage and electrolyte composition on the structure and properties of Sr-incorporated micro-arc calcium phosphate coatings formed on Mg–0.8Ca
Sr-incorporated calcium phosphate coatings were deposited on Mg–0.8 wt. % Ca alloy by the micro–arc oxidation method under the process voltages of 350–500 V, with using of Sr-substituted tricalcium phosphate (Sr-TCP) and Sr-substituted hydroxyapatite (Sr-HA). The current density for MAO process of Sr-HA coatings deposition was higher than that for the process of Sr-TCP coatings deposition. The coating morphology, microstructure and compositions have been studied using scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX) and X–ray diffraction (XRD). The phase composition of Sr-HA coatings included α-TCP, β-TCP, Mg3(PO4)2 and MgO. In addition, HA was contained in the composition of Sr-TCP. It was revealed that Sr is uniformly distributed within the coating layer. The highest concentration of Sr was 2.0 at. % in Sr-HA coatings deposited at 500 V.
- 1 January 2011
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 7 (-1) , 72-78
Air Quality in Riga and Its Improvement Options
Air Quality in Riga and Its Improvement Options: Air quality in the city of Riga is evaluated from direct monitoring results and from accounting registered air pollutants in the city. It is concluded that from all air polluting substances listed in the European Commission directives, only nitrogen dioxide NO2 and particulate matter PM10 exceed the limits. In assessing the projected measures to improve air quality in Riga, it can be concluded that the implementation of cleaner fuels and improvements in energy efficiency of household and industrial sectors will decrease particle pollution, but measures in the transport sector will also contribute to reducing air pollution from nitrogen oxides.
- 1 January 2011
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 7 (-1) , 72-78
Air Quality in Riga and Its Improvement Options
Air Quality in Riga and Its Improvement Options: Air quality in the city of Riga is evaluated from direct monitoring results and from accounting registered air pollutants in the city. It is concluded that from all air polluting substances listed in the European Commission directives, only nitrogen dioxide NO2 and particulate matter PM10 exceed the limits. In assessing the projected measures to improve air quality in Riga, it can be concluded that the implementation of cleaner fuels and improvements in energy efficiency of household and industrial sectors will decrease particle pollution, but measures in the transport sector will also contribute to reducing air pollution from nitrogen oxides.