Luis Antonio Pozo Suclupe
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Luis Antonio Pozo Suclupe has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- César Augusto Monteza Arbulú
Facultad de Ingenieria Quimica e Industrias Alimentarias, Universidad Nacional Pedro Ruiz Gallo, Juan XXIII 391, Lambayeque 14013, Peru
2 shared publications - Noemí León-Roque
Facultad de Ingenieria Quimica e Industrias Alimentarias, Universidad Nacional Pedro Ruiz Gallo, Juan XXIII 391, Lambayeque 14013, Peru
2 shared publications - Walter Manuel Hoyos-Alayo
Departamento de Ingeniería Industrial, Universidad Tecnològica del Perú, Avenida Augusto B. Leguía con la Avenida Hernán Güiner s/n, Chiclayo 14001, Peru
2 shared publications Abraham Guillermo Ygnacio Santa Cruz
Escuela Profesional de Ingeniería de Industrias Alimentarias, Universidad Nacional Pedro Ruíz Gallo, Lambayeque, Peru
1 shared publication- Alfredo Arroyo Sanchez
Research Department, Universidad Nacional Pedro Ruiz Gallo, Juan XXIII 391, Lambayeque 14013, Peru
1 shared publication - Denesy Pelagia Palacios Jimenez
Facultad de Ingeniería de Industrias Alimentarias y Biotecnología, Universidad Nacional de Frontera, Sullana, Peru
1 shared publication
Latest Publications
- Open Access
- 27 October 2026
- Published by MDPI AG in Encyclopedia
- Vol. 6 (11) , 239
Rice Cultivation and Nitrogen Transport Across Connected Catchment–Coastal Systems: A Systematic Review (2016–2025)
Rice-growing landscapes connect nitrogen management with coastal water quality, but mixed sources and transformations complicate attribution. This systematic review examines transport, management, attribution and monitoring across connected catchment–coastal systems. Scopus was searched on 1 September 2026 for articles published during 2016–2025. Archived exports identify 89 initial records and 26 retained articles, including rice studies and contextual agricultural and coastal evidence. All six authors participated in selection and extraction. Study-specific design, measurement and transferability domains informed a narrative synthesis; heterogeneous endpoints precluded meta-analysis. In the Albufera network, nitrate-N averaged 1.947 ± 0.188 mg N L−1 (SE; range 0.013–4.705). At one lagoon site, reported nitrate rose from 2.26 to 7.94 mg L−1 across the October 2024 flood; its unspecified mass basis prevents conversion to nitrate-N. These observations describe mixed-source exposure rather than rice-derived coastal loads. Red River isotope evidence identifies substantial domestic and manure contributions, while Po Delta incubations support season-specific denitrification. Rice experiments inform fertiliser management but do not establish marine effects; non-rice modelling provides conditional management comparisons. Single-database and open-access search restrictions, incompletely assigned exclusion reasons and partial full-text verification limit reproducibility and appraisal. The synthesis supports coordinated fertiliser and drainage management, source apportionment and flow-weighted monitoring. A universal rice-specific effect on marine eutrophication remains unestablished. The review received no external funding; no verifiable registration identifier was available.
- 27 October 2026
- Published by MDPI AG in Encyclopedia
- Vol. 6 (11) , 239
Open AccessRice Cultivation and Nitrogen Transport Across Connected Catchment–Coastal Systems: A Systematic Review (2016–2025)
Rice-growing landscapes connect nitrogen management with coastal water quality, but mixed sources and transformations complicate attribution. This systematic review examines transport, management, attribution and monitoring across connected catchment–coastal systems. Scopus was searched on 1 September 2026 for articles published during 2016–2025. Archived exports identify 89 initial records and 26 retained articles, including rice studies and contextual agricultural and coastal evidence. All six authors participated in selection and extraction. Study-specific design, measurement and transferability domains informed a narrative synthesis; heterogeneous endpoints precluded meta-analysis. In the Albufera network, nitrate-N averaged 1.947 ± 0.188 mg N L−1 (SE; range 0.013–4.705). At one lagoon site, reported nitrate rose from 2.26 to 7.94 mg L−1 across the October 2024 flood; its unspecified mass basis prevents conversion to nitrate-N. These observations describe mixed-source exposure rather than rice-derived coastal loads. Red River isotope evidence identifies substantial domestic and manure contributions, while Po Delta incubations support season-specific denitrification. Rice experiments inform fertiliser management but do not establish marine effects; non-rice modelling provides conditional management comparisons. Single-database and open-access search restrictions, incompletely assigned exclusion reasons and partial full-text verification limit reproducibility and appraisal. The synthesis supports coordinated fertiliser and drainage management, source apportionment and flow-weighted monitoring. A universal rice-specific effect on marine eutrophication remains unestablished. The review received no external funding; no verifiable registration identifier was available.
- Open Access
Comparative Multi-Descriptor Structure-Performance Patterns in Silicon-Rich Sewage-Sludge-Derived Carbons for As(V) and Pb(II) Removal from Water
Municipal sewage sludge contains carbon and mineral constituents that can be recovered as water-treatment materials. This study compared four silicon-rich carbons prepared under different carbon dioxide activation and nitric-acid modification conditions to examine whether material properties ranked arsenic(V) and lead(II) removal consistently. Pre-contact characterisation combined spectroscopy, microscopy, elemental analysis, nitrogen sorption and surface-charge assessment. Separate model-groundwater solutions containing each contaminant were treated in triplicate at pH 6.0, 6.5 and 7.0. Mean removal ranged from 47.8 to 76.2% for As(V) and from 68.8 to 96.3% for Pb(II). Two-factor analyses detected no significant material, pH or interaction effects at the 5% level. Averaged across the three pH levels, M3 had the highest numerical As(V) removal (71.7%), whereas M1 had the highest numerical Pb(II) removal (92.2%). A separate low-concentration test with M3 reported final concentrations of 0.0080 ± 0.0006 mg L−1 As(V) and 0.0041 ± 0.0004 mg L−1 Pb(II). Fifth-cycle removal remained above 80% for both contaminants, with 88.2% dry sorbent mass recovery after five cycles. The different material rankings indicate that total surface area alone does not describe performance across both contaminants. Further analytical, leaching and natural-water assessments are needed before application to drinking-water treatment.
Open AccessComparative Multi-Descriptor Structure-Performance Patterns in Silicon-Rich Sewage-Sludge-Derived Carbons for As(V) and Pb(II) Removal from Water
Municipal sewage sludge contains carbon and mineral constituents that can be recovered as water-treatment materials. This study compared four silicon-rich carbons prepared under different carbon dioxide activation and nitric-acid modification conditions to examine whether material properties ranked arsenic(V) and lead(II) removal consistently. Pre-contact characterisation combined spectroscopy, microscopy, elemental analysis, nitrogen sorption and surface-charge assessment. Separate model-groundwater solutions containing each contaminant were treated in triplicate at pH 6.0, 6.5 and 7.0. Mean removal ranged from 47.8 to 76.2% for As(V) and from 68.8 to 96.3% for Pb(II). Two-factor analyses detected no significant material, pH or interaction effects at the 5% level. Averaged across the three pH levels, M3 had the highest numerical As(V) removal (71.7%), whereas M1 had the highest numerical Pb(II) removal (92.2%). A separate low-concentration test with M3 reported final concentrations of 0.0080 ± 0.0006 mg L−1 As(V) and 0.0041 ± 0.0004 mg L−1 Pb(II). Fifth-cycle removal remained above 80% for both contaminants, with 88.2% dry sorbent mass recovery after five cycles. The different material rankings indicate that total surface area alone does not describe performance across both contaminants. Further analytical, leaching and natural-water assessments are needed before application to drinking-water treatment.
- Open Access
- 29 April 2022
- Published by Enviro Research Publishers in Current Research in Nutrition and Food Science Journal
- Vol. 10 (1) , 01-18
A Critical Review on The Integration of Metal Nanoparticles in Biopolymers: An Alternative for Active and Sustainable Food Packaging
The use of plastic polymers in food packaging causes serious environmental and health problems and as a result, natural biopolymers are being developed (NBPs). Although NBPs have several shortcomings as a packaging material, these can be overcome with the help of nanotechnology. In this context, this review will report on the main findings about the effect of the integration of metal nanoparticles (MNPs) on the characteristics of NBPs. A systematic review was carried out using PRISMA methodology to select relevant studies from the last 5 years. According to the analysis performed, MNPs provide NBPs with a broad spectrum against bacteria, fungi and even viruses of interest. MNPs have also been shown to improve the physical, mechanical, optical, antioxidant and barrier characteristics of NBPs. MNPs are used at low concentrations (generally 0.5 to 5%) and this avoids their potential toxicity. MNPs are shown to be efficient materials to obtain bionanocomposites suitable for active food packaging. Studies focusing on the control of the antimicrobial effect of MNPs on desirable microorganisms are suggested. In addition, further studies on the evaluation of the potential toxicity of MNPs are needed to ensure food quality and safety.
- 29 April 2022
- Published by Enviro Research Publishers in Current Research in Nutrition and Food Science Journal
- Vol. 10 (1) , 01-18
Open AccessA Critical Review on The Integration of Metal Nanoparticles in Biopolymers: An Alternative for Active and Sustainable Food Packaging
The use of plastic polymers in food packaging causes serious environmental and health problems and as a result, natural biopolymers are being developed (NBPs). Although NBPs have several shortcomings as a packaging material, these can be overcome with the help of nanotechnology. In this context, this review will report on the main findings about the effect of the integration of metal nanoparticles (MNPs) on the characteristics of NBPs. A systematic review was carried out using PRISMA methodology to select relevant studies from the last 5 years. According to the analysis performed, MNPs provide NBPs with a broad spectrum against bacteria, fungi and even viruses of interest. MNPs have also been shown to improve the physical, mechanical, optical, antioxidant and barrier characteristics of NBPs. MNPs are used at low concentrations (generally 0.5 to 5%) and this avoids their potential toxicity. MNPs are shown to be efficient materials to obtain bionanocomposites suitable for active food packaging. Studies focusing on the control of the antimicrobial effect of MNPs on desirable microorganisms are suggested. In addition, further studies on the evaluation of the potential toxicity of MNPs are needed to ensure food quality and safety.
- Open Access
- 12 December 2018
- Published by Universidad Senor de Sipan SAC in TZHOECOEN
- Vol. 10 (4) , 593-609
IDENTIFICACIÓN DE IMPACTOS AMBIENTALES SIGNIFICATIVOS EN LA INDUSTRIA LADRILLERA UTILIZANDO UN MODELO DE SIMULACIÓN DINÁMICA
Este estudio busca identificar los impactos ambientales más significativos en la Industria ladrillera en la región Lambayeque mediante el uso de un modelo en dinámica de sistemas, prediciendo en el tiempo sus efectos sobre el medio ambiente y la salud. El estudio se inicia describiendo el proceso de fabricación de ladrillo industrial, permitiendo de esta manera identificar los impactos ambientales a través del análisis de cada etapa del proceso productivo, luego estableció límites para un modelo dinámico, elaborando un diagrama causal y de forrester, identificando las variables y estableciendo sus relaciones. El modelo utilizó para sus elementos de relación datos recolectados de instituciones estatales, resultados de encuestas, balance de mesa y usos de coeficientes de emisión. El modelo dinámico a diferencia de los métodos tradicionales de identificación de impactos, permitirá analizar posibles consecuencias en el tiempo, alternado o variando diferentes escenarios. A través de los datos obtenidos para un horizonte de 15 años, se concluyó que los impactos más significativos se generarán en la etapa de cocción, lo que se traducirá en la emisión de gases tóxicos (SOx, NOx), gases de efecto invernadero (CO2) y la generación de Material particulado (PM10) con efectos en la salud, específicamente enfermedades respiratorias en la población.
- 12 December 2018
- Published by Universidad Senor de Sipan SAC in TZHOECOEN
- Vol. 10 (4) , 593-609
Open AccessIDENTIFICACIÓN DE IMPACTOS AMBIENTALES SIGNIFICATIVOS EN LA INDUSTRIA LADRILLERA UTILIZANDO UN MODELO DE SIMULACIÓN DINÁMICA
Este estudio busca identificar los impactos ambientales más significativos en la Industria ladrillera en la región Lambayeque mediante el uso de un modelo en dinámica de sistemas, prediciendo en el tiempo sus efectos sobre el medio ambiente y la salud. El estudio se inicia describiendo el proceso de fabricación de ladrillo industrial, permitiendo de esta manera identificar los impactos ambientales a través del análisis de cada etapa del proceso productivo, luego estableció límites para un modelo dinámico, elaborando un diagrama causal y de forrester, identificando las variables y estableciendo sus relaciones. El modelo utilizó para sus elementos de relación datos recolectados de instituciones estatales, resultados de encuestas, balance de mesa y usos de coeficientes de emisión. El modelo dinámico a diferencia de los métodos tradicionales de identificación de impactos, permitirá analizar posibles consecuencias en el tiempo, alternado o variando diferentes escenarios. A través de los datos obtenidos para un horizonte de 15 años, se concluyó que los impactos más significativos se generarán en la etapa de cocción, lo que se traducirá en la emisión de gases tóxicos (SOx, NOx), gases de efecto invernadero (CO2) y la generación de Material particulado (PM10) con efectos en la salud, específicamente enfermedades respiratorias en la población.