Yue Zeng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yue Zeng has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Yunqin Li
Fuzhou University
6 shared publicationsMeiling Xiao
Fuzhou University
3 shared publicationsRong Yu
Fujian Provincial Institute of Environmental Protection Design Co., Ltd, Fuzhou, 350025, China
3 shared publicationsWei Yu
Fujian Provincial Institute of Environmental Protection Design Co., Ltd, Fuzhou, 350025, China.
3 shared publicationsXiang Xu
Fujian Provincial Institute of Environmental Protection Design Co., Ltd, Fuzhou, 350025, China
3 shared publicationsYajie Jiang
College of Environment & Safety Engineering, Fuzhou University, Fuzhou, 350108, China
3 shared publications
Latest Publications
- 29 May 2026
- Published by Taylor & Francis in Inland Waters
- Vol. 16 (1)
Response of CH 4 and CO 2 concentrations and emission fluxes to cyanobacterial blooms in a subtropical dammed river
- 29 May 2026
- Published by Taylor & Francis in Inland Waters
- Vol. 16 (1)
Response of CH 4 and CO 2 concentrations and emission fluxes to cyanobacterial blooms in a subtropical dammed river
- 10 March 2026
- Published by Springer Nature in Environmental Geochemistry and Health
- Vol. 48 (5)
Development and validation of a copolymerized thiol-silica based DGT technique for the assessment of bioavailable As(Ⅲ) speciation
Arsenic (As), particularly in its bioavailable species of inorganic As(Ⅲ) known for its significant toxicity and mobility, is a carcinogenic risk to humans. Serving as an innovative analytical tool, the diffusive gradients in thin films (DGT) technique facilitates on-site detection of bioavailable metals. However, the options of DGT binding gels tailored for As(Ⅲ) detection remain elusive. This study undertook the modification of tetraethyl orthosilicate with a 3-mercaptopropyl-trimethoxysilane to synthesize cost-effective nanomaterials endowed with the capacity for selective adsorption of As(Ⅲ) through copolymerization and atmospheric pressure drying. The synthesized materials were systematically characterized using X-ray diffraction, scanning electron microscopy, and C/H/N/S elemental analysis, revealing a specific surface area of 472.39 m2/g, a particle size of 12.7 nm, and a loading capacity of 3.115 mmol/g. The DGT combined with gel prepared from this material has a specific affinity for As(III) without adsorbing As(V).Its adsorption efficiency for As(III) may reach 84.5% within the first hour. This DGT technique has a linear detection range of 0.5-15 mg/L (R2 = 0.99995), an elution recovery of 85.1%-102.7% (RSD < 10%, n = 3), and a maximum adsorption capacity of 301.7 μg/cm2, meeting requirements for long-term environmental monitoring. The experiment studied the effects of interfering factors, including pH values ranging from 3-9, ionic strength of 10-500 mmol/L NaNO₃, Fe2⁺ 0-5.0 mg/L, Mn2⁺ 0-1.0 mg/L, As(V) 0-5.0 mg/L, dissolved organic carbon 0-20.0 mg/L, SO₄2⁻ 0.55-1.10 g/L, and PO₄3⁻ 5.0-10.0 mg/L. The device maintained a stable treatment performance under all these conditions. When the DGT device was deployed in spiked river water, estuarine water, and seawater, a comparison of its adsorption performance with existing methods showed that the device had a comparable adsorption performance and demonstrated excellent long-term stability in practical water environment applications.
- 10 March 2026
- Published by Springer Nature in Environmental Geochemistry and Health
- Vol. 48 (5)
Development and validation of a copolymerized thiol-silica based DGT technique for the assessment of bioavailable As(Ⅲ) speciation
Arsenic (As), particularly in its bioavailable species of inorganic As(Ⅲ) known for its significant toxicity and mobility, is a carcinogenic risk to humans. Serving as an innovative analytical tool, the diffusive gradients in thin films (DGT) technique facilitates on-site detection of bioavailable metals. However, the options of DGT binding gels tailored for As(Ⅲ) detection remain elusive. This study undertook the modification of tetraethyl orthosilicate with a 3-mercaptopropyl-trimethoxysilane to synthesize cost-effective nanomaterials endowed with the capacity for selective adsorption of As(Ⅲ) through copolymerization and atmospheric pressure drying. The synthesized materials were systematically characterized using X-ray diffraction, scanning electron microscopy, and C/H/N/S elemental analysis, revealing a specific surface area of 472.39 m2/g, a particle size of 12.7 nm, and a loading capacity of 3.115 mmol/g. The DGT combined with gel prepared from this material has a specific affinity for As(III) without adsorbing As(V).Its adsorption efficiency for As(III) may reach 84.5% within the first hour. This DGT technique has a linear detection range of 0.5-15 mg/L (R2 = 0.99995), an elution recovery of 85.1%-102.7% (RSD < 10%, n = 3), and a maximum adsorption capacity of 301.7 μg/cm2, meeting requirements for long-term environmental monitoring. The experiment studied the effects of interfering factors, including pH values ranging from 3-9, ionic strength of 10-500 mmol/L NaNO₃, Fe2⁺ 0-5.0 mg/L, Mn2⁺ 0-1.0 mg/L, As(V) 0-5.0 mg/L, dissolved organic carbon 0-20.0 mg/L, SO₄2⁻ 0.55-1.10 g/L, and PO₄3⁻ 5.0-10.0 mg/L. The device maintained a stable treatment performance under all these conditions. When the DGT device was deployed in spiked river water, estuarine water, and seawater, a comparison of its adsorption performance with existing methods showed that the device had a comparable adsorption performance and demonstrated excellent long-term stability in practical water environment applications.
- 25 July 2025
- Published by Elsevier in Science of The Total Environment
- Vol. 995, 180095
Regulatory mechanism of microplastics on arsenic bioavailability in a subtropical estuary, China
- 25 July 2025
- Published by Elsevier in Science of The Total Environment
- Vol. 995, 180095
Regulatory mechanism of microplastics on arsenic bioavailability in a subtropical estuary, China
- 9 February 2025
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 489, 137539
Climate warming will alter the impact of microplastics on the bioavailability of arsenic in a subtropical estuary
- 9 February 2025
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 489, 137539
Climate warming will alter the impact of microplastics on the bioavailability of arsenic in a subtropical estuary
- 17 March 2021
- Published by Wiley in Journal of Environmental Quality
- Vol. 50 (3) , 744-755
Accumulation and health implications of metals in topsoil of an urban riparian zone adjacent to different functional areas in a subtropical city
The riparian zone is a river–land ecotone, and its environmental conditions have a significant effect on the river ecosystem and population health. In this study, As, Cu, Cr, Cd, Mn, Fe, Ni, Pb, and Zn in the topsoils of urban riparian zones in a subtropical city in southeast China were quantitatively estimated by inductively coupled plasma–optical emission spectrometry. The geoaccumulation index and health risk evaluation model were adopted to assess the accumulation characteristic and health risk of residents’ exposure to metals. Principle component analysis was used to determine the source of metals. The results showed that the mean contents of metals (except Fe) were higher than the soil background value, but none of the metal contents exceeded the mass limit of environmental quality standards. The order of the geoaccumulation index was Cd > Mn > Cu > Cr > Pb > Zn > As > Ni > Fe. The contamination level of Cd was classified as slight, whereas the other metals did not contribute to pollution. The spatial distribution of metals in the riparian zone was compatible with the pattern of functional zones in the adjacent urban areas, where levels of Cr, Cd, Fe, Mn, and Ni were higher in commercial areas, as were Pb and Zn in under‐construction land and As in residential and industrial areas. Carcinogenic risks of Cr, As, and Pb were acceptable. The hazard index indicated no significant noncarcinogenic risks from any metals. However, noncarcinogenic risks of metals other than Mn were higher for children than for adults, and the primary exposure route of metal into the human body was ingestion for children and inhalation for adults. Principle component analysis indicated that the primary sources of Cr, Ni, Mn, Cu, and Fe were pedogenic processes and mineral weathering, whereas Zn, As, Pb, and Cd mainly originated from anthropogenic sources, specifically, Zn from transportation emission, Pb from transportation emission and industry waste, As from coal combustion and residential waste, and Cd from pigments/paint used in commercial buildings, urban greening, consumer waste, and transportation emission.
- 17 March 2021
- Published by Wiley in Journal of Environmental Quality
- Vol. 50 (3) , 744-755
Accumulation and health implications of metals in topsoil of an urban riparian zone adjacent to different functional areas in a subtropical city
The riparian zone is a river–land ecotone, and its environmental conditions have a significant effect on the river ecosystem and population health. In this study, As, Cu, Cr, Cd, Mn, Fe, Ni, Pb, and Zn in the topsoils of urban riparian zones in a subtropical city in southeast China were quantitatively estimated by inductively coupled plasma–optical emission spectrometry. The geoaccumulation index and health risk evaluation model were adopted to assess the accumulation characteristic and health risk of residents’ exposure to metals. Principle component analysis was used to determine the source of metals. The results showed that the mean contents of metals (except Fe) were higher than the soil background value, but none of the metal contents exceeded the mass limit of environmental quality standards. The order of the geoaccumulation index was Cd > Mn > Cu > Cr > Pb > Zn > As > Ni > Fe. The contamination level of Cd was classified as slight, whereas the other metals did not contribute to pollution. The spatial distribution of metals in the riparian zone was compatible with the pattern of functional zones in the adjacent urban areas, where levels of Cr, Cd, Fe, Mn, and Ni were higher in commercial areas, as were Pb and Zn in under‐construction land and As in residential and industrial areas. Carcinogenic risks of Cr, As, and Pb were acceptable. The hazard index indicated no significant noncarcinogenic risks from any metals. However, noncarcinogenic risks of metals other than Mn were higher for children than for adults, and the primary exposure route of metal into the human body was ingestion for children and inhalation for adults. Principle component analysis indicated that the primary sources of Cr, Ni, Mn, Cu, and Fe were pedogenic processes and mineral weathering, whereas Zn, As, Pb, and Cd mainly originated from anthropogenic sources, specifically, Zn from transportation emission, Pb from transportation emission and industry waste, As from coal combustion and residential waste, and Cd from pigments/paint used in commercial buildings, urban greening, consumer waste, and transportation emission.
- 20 November 2019
- Published by Oxford University Press (OUP) in Integrated Environmental Assessment and Management
- Vol. 16 (3) , 342-352
Health Risk Assessment and Source Apportionment for Heavy Metals in a Southern Chinese Reservoir Impacted by Stone Mining Activities
Metal contaminants in drinking water pose a potential threat to human health. Metal elements (Fe, Mn, Cu, Cr, Cd, As, and Pb) in Shanzi Reservoir, China, a drinking water source for nearby cities, were measured in 2013 and 2014. The distribution characteristics of metal elements in water were identified and a health risk assessment model was used to evaluate potential harm. Principal component analysis and cluster analysis were used to determine the main sources of metal pollutants. The results showed that Pb and As exceeded the standard at some sampling sites, whereas other metal elements met the drinking water standards. The spatial distribution of metal elements was extremely uneven and might be affected by either the geochemical environment or human activities in the study region. The total risk value of metals (5 × 10–5 a–1) was below the recommended value of the United States Environmental Protection Agency (USEPA), the total cancer risk was higher than the total noncancer risk, and both risks were higher for children than for adults. Arsenic was the priority control pollutant, and the priority control site was located upstream of the reservoir. Source analysis showed that Fe, Mn, and Cu were mainly from soil formation and stone mining and processing industries; Pb and As were mainly from agricultural activities, free dumping and burning of domestic garbage, and atmospheric deposition from transportation emissions; Cd was mainly from agricultural application of fertilizers and pesticides; and Cr was from the stone mining and processing industry and from the electroplating and metal manufacturing industries. Integr Environ Assess Manag 2020;16:342–352. © 2019 SETAC
- 20 November 2019
- Published by Oxford University Press (OUP) in Integrated Environmental Assessment and Management
- Vol. 16 (3) , 342-352
Health Risk Assessment and Source Apportionment for Heavy Metals in a Southern Chinese Reservoir Impacted by Stone Mining Activities
Metal contaminants in drinking water pose a potential threat to human health. Metal elements (Fe, Mn, Cu, Cr, Cd, As, and Pb) in Shanzi Reservoir, China, a drinking water source for nearby cities, were measured in 2013 and 2014. The distribution characteristics of metal elements in water were identified and a health risk assessment model was used to evaluate potential harm. Principal component analysis and cluster analysis were used to determine the main sources of metal pollutants. The results showed that Pb and As exceeded the standard at some sampling sites, whereas other metal elements met the drinking water standards. The spatial distribution of metal elements was extremely uneven and might be affected by either the geochemical environment or human activities in the study region. The total risk value of metals (5 × 10–5 a–1) was below the recommended value of the United States Environmental Protection Agency (USEPA), the total cancer risk was higher than the total noncancer risk, and both risks were higher for children than for adults. Arsenic was the priority control pollutant, and the priority control site was located upstream of the reservoir. Source analysis showed that Fe, Mn, and Cu were mainly from soil formation and stone mining and processing industries; Pb and As were mainly from agricultural activities, free dumping and burning of domestic garbage, and atmospheric deposition from transportation emissions; Cd was mainly from agricultural application of fertilizers and pesticides; and Cr was from the stone mining and processing industry and from the electroplating and metal manufacturing industries. Integr Environ Assess Manag 2020;16:342–352. © 2019 SETAC