RZRuichong Zhang

Ruichong Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ruichong Zhang has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Comparative study on blasting simulation vibration reduction and field vibration reduction experiment of adjacent oil pipeline

    by Yi Chen, Ruichong Zhang, Lujia Liang, Yi Wang, Jiaozhong Chen, Chengyu Xie

    Introduction: Yongxing Tunnel No.1’s complex geology near a buried oil pipeline on the Guizhou-Nanning high-speed route poses blasting risks. Prioritizing pipeline safety, efforts focus on minimizing vibration impacts.Methods: Research uses numerical simulations and field tests to analyze three delay times and three spacing charge materials for vibration reduction.Results: Optimal delay is 30 ms, yielding a 0.52 cm/s vibration velocity, 20%-29% lower than 28 ms and 32 ms. Soil is the most effective spacer, achieving 0.46 cm/s, 30.30%-22.03% lower than water and air. Field tests align with simulations.Discussion: Findings provide a reference for optimal vibration reduction and safe construction under similar conditions.


  • Open Access

    Study on the Geological Condition Analysis and Grade Division of High Altitude and Cold Stope Slope

    by Ruichong Zhang, Shiwei Wu, Chenyu Xie, Qingfa Chen

    Analysis of the geological conditions of high-altitude and low-temperature stope slopes and the study of grade division are the basis for the evaluation of slope stability. Based on the engineering background of the eastern slope of the Preparatory iron mine in Hejing County, Xinjiang, we comprehensively analyse and summarize the factors that affect the geological conditions of high-altitude and cold slopes and finally determine nine geological conditions that affect the index parameters. Based on a back-propagation (BP) neural network algorithm, we establish an applicable network model to analyse the geological conditions of slopes in cold areas. The model is applied to the eastern slope to analyse and classify the geological conditions of the high-altitude and low-temperature slopes. The research results show that the skarn rock layer in the eastern slope is in a stable state and not prone to landslides, and its corresponding geological condition is Grade I; meanwhile, the monzonite porphyry rock layer is in a relatively stable state, with a potential for landslides and a corresponding geological condition Grade II. The marble rock layer is in a generally stable state, there is the possibility of landslide accidents, and the corresponding geological condition level is Grade III. The limestone rock layer is in an unstable state and prone to landslide accidents, it has a corresponding geology condition Grade IV. Therefore, the eastern slope can be divided into different geological condition regions: Zone I, Zone II, Zone III, and Zone IV, and the corresponding geological condition levels for these are Grade I, Grade II, Grade III, and Grade IV. These results may provide a basis for the stability evaluation of high altitudes and cold slopes.


  • Open Access

    Experimental study on minimum ignition energy of tapioca starch

    by Ruichong Zhang, Keping Zhou, Chenyu Xie, Shikang Qin

    The minimum ignition energy of tapioca starch was studied by using 1.2L Hartmann tube, and the three main influencing factors: tapioca starch quality, ignition delay time and dusting pressure were tested. The experimental results show that the effect of dusting pressure on the minimum ignition energy is the most obvious. With the increase of powder pressure, the minimum ignition energy first decreases and then increases, and when the powder pressure is 90Kpa, the minimum ignition energy is the smallest, which is 58mj; ignition delay time is different, the degree of dust dispersion is different, and the optimum ignition delay time is 30ms. The minimum ignition energy decreases first and then increases with the increase of the quality of tapioca starch. When the mass is 0.5 g, the ignition energy is the smallest. It is 60mJ.