David A. Yocky
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
David A. Yocky has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Roger Derek West
Sandia National Laboratories, Albuquerque, NM, USA
3 shared publications Charles V Jakowatz
1 shared publicationCharles V. Jakowatz
The authors are with Sandia National Laboratories, P.O. Box 5800, Albuquerque New Mexico 87185-1207
1 shared publication- Daniel Wahl
Department of Planetary Geodesy Institute of Geodesy and Geoinformation Science Technische Universität Berlin Berlin Germany
1 shared publication Paul H. Eichel
The authors are with Sandia National Laboratories, P.O. Box 5800, Albuquerque New Mexico 87185-1207
1 shared publication- Robert Abbott
Sandia National Laboratories, Albuquerque, New Mexico, U.S.A.
1 shared publication
Latest Publications
- Open Access
- 9 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 14 (19391404) , 6165-6178
Comparison of Surface Phenomena Created by Underground Chemical Explosions in Dry Alluvium and Granite Geology From Fully Polarimetric VideoSAR Data
Phase I of the Source Physics Experiment (SPE) series involved six underground chemical explosions, all of which were conducted at the same experimental pad. Research from the sixth explosion of the series (SPE-6) demonstrated that polarimetric synthetic aperture radar (PolSAR) is a viable technology for monitoring an underground chemical explosion when the geologic structure is Cretaceous granitic intrusive. It was shown that a durable signal is measurable by the $H/A/\alpha$ polarimetric decomposition parameters. After the SPE-6 experiment, the SPE program moved to the Phase II location, which is composed of dry alluvium geology (DAG). The loss of wavefront energy is greater through dry alluvium than through granite. In this article, we compare the SPE-6 analysis to the second DAG (DAG-2) experiment. We hypothesize that despite the geology at the DAG site being more challenging than at the Phase I location, combined with the DAG-2 experiment having a 3.37 times deeper scaled depth of burial than the SPE-6, a durable nonprompt signal is still measurable by a PolSAR sensor. We compare the PolSAR time-series measures from videoSAR frames, from the SPE-6 and DAG-2 experiments, with accelerometer data. We show which PolSAR measures are invariant to the two types of geology and which are geology dependent. We compare a coherent change detection (CCD) map from the DAG-2 experiment with the data from a fiber-optic distributed acoustic sensor to show the connection between the spatial extent of coherence loss in CCD maps and spallation caused by the explosion. Finally, we also analyze the spatial extent of the PolSAR measures from both explosions.
- 9 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 14 (19391404) , 6165-6178
Open AccessComparison of Surface Phenomena Created by Underground Chemical Explosions in Dry Alluvium and Granite Geology From Fully Polarimetric VideoSAR Data
Phase I of the Source Physics Experiment (SPE) series involved six underground chemical explosions, all of which were conducted at the same experimental pad. Research from the sixth explosion of the series (SPE-6) demonstrated that polarimetric synthetic aperture radar (PolSAR) is a viable technology for monitoring an underground chemical explosion when the geologic structure is Cretaceous granitic intrusive. It was shown that a durable signal is measurable by the $H/A/\alpha$ polarimetric decomposition parameters. After the SPE-6 experiment, the SPE program moved to the Phase II location, which is composed of dry alluvium geology (DAG). The loss of wavefront energy is greater through dry alluvium than through granite. In this article, we compare the SPE-6 analysis to the second DAG (DAG-2) experiment. We hypothesize that despite the geology at the DAG site being more challenging than at the Phase I location, combined with the DAG-2 experiment having a 3.37 times deeper scaled depth of burial than the SPE-6, a durable nonprompt signal is still measurable by a PolSAR sensor. We compare the PolSAR time-series measures from videoSAR frames, from the SPE-6 and DAG-2 experiments, with accelerometer data. We show which PolSAR measures are invariant to the two types of geology and which are geology dependent. We compare a coherent change detection (CCD) map from the DAG-2 experiment with the data from a fiber-optic distributed acoustic sensor to show the connection between the spatial extent of coherence loss in CCD maps and spallation caused by the explosion. Finally, we also analyze the spatial extent of the PolSAR measures from both explosions.
- Open Access
- 21 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 14 (19391404) , 165-174
Comparison of PolSAR Surface Measurements From Underground Chemical Explosions to Recorded and Predicted Surface Ground Motion
The Source Physics Experiment (SPE) Phase I conducted six underground chemical explosions at the same experimental pad with the goal of characterizing underground explosions to enhance the United States (U.S.) ability to detect and discriminate underground nuclear explosions (UNEs). A fully polarimetric synthetic aperture RADAR (PolSAR) collected imagery in VideoSAR mode during the fifth and sixth explosions in the series (SPE-5 and SPE-6). Previously, we reported the prompt PolSAR surface changes cause by SPE-5 and SPE-6 explosions within seconds or minutes of the underground chemical explosions, including a drop of spatial coherence and polarimetric scattering changes. Therein it was hypothesized that surface changes occurred when surface particles experienced upward acceleration greater than 1 g. Because the SPE site was instrumented with surface accelerometers, we explore that hypothesis and report our findings in this article. We equate explosion-caused prompt surface expressions measured by PolSAR to the prompt surface movement measured by accelerometers. We tie these findings to UNE detection by comparing the PolSAR and accelerometer results to empirical ground motion predictions derived from accelerometer recordings of UNEs collected prior to cessation of U.S. nuclear testing. We find the single threshold greater than 1 g hypothesis is not correct for it does not explain the PolSAR results. Our findings show PolSAR surface coherence spatial extent is highly correlated with surface velocity, both measured and predicted, and the resulting surface deformation extent is corroborated by accelerometer records and the predicted lateral spall extent. PolSAR scattering changes measured during SPE-6 are created by the prompt surface displacement being larger than the spall gap.
- 21 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 14 (19391404) , 165-174
Open AccessComparison of PolSAR Surface Measurements From Underground Chemical Explosions to Recorded and Predicted Surface Ground Motion
The Source Physics Experiment (SPE) Phase I conducted six underground chemical explosions at the same experimental pad with the goal of characterizing underground explosions to enhance the United States (U.S.) ability to detect and discriminate underground nuclear explosions (UNEs). A fully polarimetric synthetic aperture RADAR (PolSAR) collected imagery in VideoSAR mode during the fifth and sixth explosions in the series (SPE-5 and SPE-6). Previously, we reported the prompt PolSAR surface changes cause by SPE-5 and SPE-6 explosions within seconds or minutes of the underground chemical explosions, including a drop of spatial coherence and polarimetric scattering changes. Therein it was hypothesized that surface changes occurred when surface particles experienced upward acceleration greater than 1 g. Because the SPE site was instrumented with surface accelerometers, we explore that hypothesis and report our findings in this article. We equate explosion-caused prompt surface expressions measured by PolSAR to the prompt surface movement measured by accelerometers. We tie these findings to UNE detection by comparing the PolSAR and accelerometer results to empirical ground motion predictions derived from accelerometer recordings of UNEs collected prior to cessation of U.S. nuclear testing. We find the single threshold greater than 1 g hypothesis is not correct for it does not explain the PolSAR results. Our findings show PolSAR surface coherence spatial extent is highly correlated with surface velocity, both measured and predicted, and the resulting surface deformation extent is corroborated by accelerometer records and the predicted lateral spall extent. PolSAR scattering changes measured during SPE-6 are created by the prompt surface displacement being larger than the spall gap.
- 20 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 57 (5) , 2481-2493
Monitoring Surface Phenomena Created by an Underground Chemical Explosion Using Fully Polarimetric VideoSAR
- 20 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 57 (5) , 2481-2493
Monitoring Surface Phenomena Created by an Underground Chemical Explosion Using Fully Polarimetric VideoSAR
- Open Access
- 1 September 2014
- Published by Office of Scientific and Technical Information (OSTI)
A New Maximum-Likelihood Change Estimator for Two-Pass SAR Coherent Change Detection.
In this paper, we derive a new optimal change metric to be used in synthetic aperture RADAR (SAR) coherent change detection (CCD). Previous CCD methods tend to produce false alarm states (showing change when there is none) in areas of the image that have a low clutter-to-noise power ratio (CNR). The new estimator does not suffer from this shortcoming. It is a surprisingly simple expression, easy to implement, and is optimal in the maximum-likelihood (ML) sense. The estimator produces very impressive results on the CCD collects that we have tested.
- 1 September 2014
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessA New Maximum-Likelihood Change Estimator for Two-Pass SAR Coherent Change Detection.
In this paper, we derive a new optimal change metric to be used in synthetic aperture RADAR (SAR) coherent change detection (CCD). Previous CCD methods tend to produce false alarm states (showing change when there is none) in areas of the image that have a low clutter-to-noise power ratio (CNR). The new estimator does not suffer from this shortcoming. It is a surprisingly simple expression, easy to implement, and is optimal in the maximum-likelihood (ML) sense. The estimator produces very impressive results on the CCD collects that we have tested.
- 10 May 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (14) , 2310-2312
Interpolated spatially variant apodization in synthetic aperture radar imagery.
The original formulation of spatially variant apodization for complex synthetic aperture radar imagery concentrated on integer-oversampled data. Noninteger-oversampled data presented previously [IEEE Trans. Aerosp. Electron. Syst. 31, 267 (1995)] suggested use of different weightings in the algorithm. An alternative noninteger-oversampled approach that employs the same apodization concept but uses local spatial interpolation is presented. With this approach the combined image formation, apodization, and detection of 1.3x-versus-2.0x oversampled data can be performed in half the time without loss of image quality.
- 10 May 2000
- Published by Optica Publishing Group in Applied Optics
- Vol. 39 (14) , 2310-2312
Interpolated spatially variant apodization in synthetic aperture radar imagery.
The original formulation of spatially variant apodization for complex synthetic aperture radar imagery concentrated on integer-oversampled data. Noninteger-oversampled data presented previously [IEEE Trans. Aerosp. Electron. Syst. 31, 267 (1995)] suggested use of different weightings in the algorithm. An alternative noninteger-oversampled approach that employs the same apodization concept but uses local spatial interpolation is presented. With this approach the combined image formation, apodization, and detection of 1.3x-versus-2.0x oversampled data can be performed in half the time without loss of image quality.
- Open Access
- 1 January 1998
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 4, 1784-1786 vol.4
Interferometric SAR coherence classification utility assessment
The classification utility of a dual-antenna interferometric synthetic aperture radar (IFSAR) is explored by comparison of maximum likelihood classification results for synthetic aperture radar (SAR) intensity images and IFSAR intensity and coherence images. The addition of IFSAR coherence improves the overall classification accuracy for classes of trees, water, and fields. A threshold intensity-coherence classifier is also compared to the intensity-only classification results.
- 1 January 1998
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 4, 1784-1786 vol.4
Open AccessInterferometric SAR coherence classification utility assessment
The classification utility of a dual-antenna interferometric synthetic aperture radar (IFSAR) is explored by comparison of maximum likelihood classification results for synthetic aperture radar (SAR) intensity images and IFSAR intensity and coherence images. The addition of IFSAR coherence improves the overall classification accuracy for classes of trees, water, and fields. A threshold intensity-coherence classifier is also compared to the intensity-only classification results.