Piotr Rutkowski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Piotr Rutkowski has a total of 87 co-authors. Here are the top co-authors by number of shared publications:
- Ewa Lorenc-Grabowska
Faculty of Chemistry Wrocław University of Science and Technology Wrocław Poland
6 shared publications Grażyna Gryglewicz
6 shared publications- Karolina Kordek-Khalil
Department of Process Engineering and Technology of Polymer and Carbon Materials, Faculty of Chemistry, Wrocław University of Science and Technology, Wrocław, Poland
6 shared publications - Jakub Mokrzycki
AGH University of Krakow, Faculty of Energy and Fuels, Al. A. Mickiewicza 30, 30-059 Kraków, Poland
5 shared publications - Izabela Michalak
Department of Advanced Material Technologies, Faculty of Chemistry, Wrocław University of Science and Technology, Smoluchowskiego 25, 50-372 Wrocław, Poland
4 shared publications - Monika Zabłocka-Malicka
Division of Analytical Chemistry and Chemical Metallurgy, Faculty of Chemistry, Wroclaw University of Science and Technology, Wybrzeze Wyspianskiego 27, 50-370 Wroclaw, Poland
4 shared publications
Latest Publications
- Open Access
- 22 June 2026
- Published by Elsevier in Biomass and Bioenergy
- Vol. 216
The pyrolysis and co-pyrolysis processes used to obtain biochar from waste as potential biosorbents for Cu(II) and Zn(II) ions
- 22 June 2026
- Published by Elsevier in Biomass and Bioenergy
- Vol. 216
Open AccessThe pyrolysis and co-pyrolysis processes used to obtain biochar from waste as potential biosorbents for Cu(II) and Zn(II) ions
- 27 March 2026
- Published by Wiley in Chemphyschem
- Vol. 27 (6) , e202500596
Adsorption of CO 2 on Vermiculite‐Derived Samples
Vermiculite was subjected to acid treatments in HNO 3 , HCl, and a mixture of both acid solutions to improve its physicochemical properties for CO 2 adsorption. To assess the structural changes resulting from these treatments, all samples were characterized by XRD, XRF, FTIR, TGA, TEM, and nitrogen physisorption. Raw vermiculite and acid treated vermiculite samples have been evaluated in CO 2 adsorption processes at 1 bar and 0°C, 20°C, and 30°C. The unmodified sample exhibited a CO 2 uptake of only 25.91 mg g −1 , attributed to its low specific surface area and pore volume. In contrast, the sample modified with a 3 M HNO 3 solution showed the highest adsorption capacity, reaching 70.48 mg g −1 . The results demonstrate that the CO 2 adsorption capacity of clay can be significantly improved by acid modification. The adsorption process was modeled using various isotherm equations, including Langmuir, Freundlich, and Sips. Among them, the Sips model provided the best fit to the experimental data for acid‐activated vermiculites. In general, the study confirms that both the chemical composition and the textural properties of the material play a crucial role in its CO 2 adsorption performance.
- 27 March 2026
- Published by Wiley in Chemphyschem
- Vol. 27 (6) , e202500596
Adsorption of CO 2 on Vermiculite‐Derived Samples
Vermiculite was subjected to acid treatments in HNO 3 , HCl, and a mixture of both acid solutions to improve its physicochemical properties for CO 2 adsorption. To assess the structural changes resulting from these treatments, all samples were characterized by XRD, XRF, FTIR, TGA, TEM, and nitrogen physisorption. Raw vermiculite and acid treated vermiculite samples have been evaluated in CO 2 adsorption processes at 1 bar and 0°C, 20°C, and 30°C. The unmodified sample exhibited a CO 2 uptake of only 25.91 mg g −1 , attributed to its low specific surface area and pore volume. In contrast, the sample modified with a 3 M HNO 3 solution showed the highest adsorption capacity, reaching 70.48 mg g −1 . The results demonstrate that the CO 2 adsorption capacity of clay can be significantly improved by acid modification. The adsorption process was modeled using various isotherm equations, including Langmuir, Freundlich, and Sips. Among them, the Sips model provided the best fit to the experimental data for acid‐activated vermiculites. In general, the study confirms that both the chemical composition and the textural properties of the material play a crucial role in its CO 2 adsorption performance.
- Open Access
- 1 March 2026
- Published by Elsevier in Desalination and Water Treatment
- Vol. 325
Waste valorization for phosphate ions removal: Magnesium-modified biochars from agro- and marine biomass residues
- 1 March 2026
- Published by Elsevier in Desalination and Water Treatment
- Vol. 325
Open AccessWaste valorization for phosphate ions removal: Magnesium-modified biochars from agro- and marine biomass residues
- 1 July 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 52, 494-506
Excellent performance of nitrogen-doped carbon nanofibers as electrocatalysts for water splitting reactions
- 1 July 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 52, 494-506
Excellent performance of nitrogen-doped carbon nanofibers as electrocatalysts for water splitting reactions
- 7 April 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 48 (66) , 25741-25754
Quick-to-synthesize hybrid electrodes composed of activated carbon cloth with Co/Fe-based films as bifunctional electrocatalysts for water splitting
- 7 April 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 48 (66) , 25741-25754
Quick-to-synthesize hybrid electrodes composed of activated carbon cloth with Co/Fe-based films as bifunctional electrocatalysts for water splitting
- Open Access
- 7 October 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-10
Revealing the effect of electrocatalytic performance boost during hydrogen evolution reaction on free-standing SWCNT film electrode
Large-scale sustainable hydrogen production by water electrolysis requires a highly active yet low-cost hydrogen evolution reaction (HER) electrocatalyst. Conductive carbon nanomaterials with high surface areas are promising candidates for this purpose. In this contribution, single-walled carbon nanotubes (SWCNTs) are assembled into free-standing films and directly used as HER electrodes. During the initial 20 h of electrocatalytic performance in galvanostatic conditions, the films undergo activation, which results in a gradual overpotential decrease to the value of 225 mV. Transient physicochemical properties of the films at various activation stages are characterized to reveal the material features responsible for the activity boost. Results indicate that partial oxidation of iron nanoparticles encapsulated in SWCNTs is the major contributor to the activity enhancement. Furthermore, besides high activity, the material, composed of only earth-abundant elements, possesses exceptional performance stability, with no activity loss for 200 h of galvanostatic performance at − 10 mA cm−2. In conclusion, the work presents the strategy of engineering a highly active HER electrode composed of widely available elements and provides new insights into the origins of electrocatalytic performance of SWCNT-based materials in alkaline HER.
- 7 October 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-10
Open AccessRevealing the effect of electrocatalytic performance boost during hydrogen evolution reaction on free-standing SWCNT film electrode
Large-scale sustainable hydrogen production by water electrolysis requires a highly active yet low-cost hydrogen evolution reaction (HER) electrocatalyst. Conductive carbon nanomaterials with high surface areas are promising candidates for this purpose. In this contribution, single-walled carbon nanotubes (SWCNTs) are assembled into free-standing films and directly used as HER electrodes. During the initial 20 h of electrocatalytic performance in galvanostatic conditions, the films undergo activation, which results in a gradual overpotential decrease to the value of 225 mV. Transient physicochemical properties of the films at various activation stages are characterized to reveal the material features responsible for the activity boost. Results indicate that partial oxidation of iron nanoparticles encapsulated in SWCNTs is the major contributor to the activity enhancement. Furthermore, besides high activity, the material, composed of only earth-abundant elements, possesses exceptional performance stability, with no activity loss for 200 h of galvanostatic performance at − 10 mA cm−2. In conclusion, the work presents the strategy of engineering a highly active HER electrode composed of widely available elements and provides new insights into the origins of electrocatalytic performance of SWCNT-based materials in alkaline HER.
- Open Access
- 26 September 2020
- Published by MDPI AG in Sustainability
- Vol. 12 (19) , 7980
Intensity of the Process Gas Emission from the Thermal Treatment of the 60–340 mm MSW Fraction under Steam
Gasification under steam excess of the residual from mechanical treatment of municipal solid waste (RMT-MSW, refuse derived fuel (RDF)-type) was investigated in a laboratory batch reactor, equipped with a section for high-temperature gas equilibration. Experiments were performed with recirculation of the condensate and residual tars/oils, for closing of the process loop. Gas emissions were registered at 300–500 °C (pyrolysis; maximum at 390 °C) and 650–800 °C (gasification; maximum at 740 °C). Peak areas, equivalent to the gas volume, were in a general proportion of 55:45. Mass of tars and oils collected together with condensing steam was only equal to 0.15% of the average weight loss of the RMT-MSW. Ninety-seven percent of organic compounds, mainly naphthalene, phenanthrene and derivatives, was separable by a simple filtration. Concentration of metals in aqueous condensate was equal to 135 mg/dm3, 98.5% by mass was potassium and sodium ions. Concentration of NH4+ was equal to 2.49 g/dm3 (mostly carbonate). According to the thermodynamic evaluation, volume of the process gas was equal to 2.11 m3 (dry, 25 °C, 1 bar) per 1 kg of the dry waste. Standard enthalpy of the gas combustion was 24.6 MJ/kg of the dry waste; approximately 16% of this energy was due to endothermicity of the process.
- 26 September 2020
- Published by MDPI AG in Sustainability
- Vol. 12 (19) , 7980
Open AccessIntensity of the Process Gas Emission from the Thermal Treatment of the 60–340 mm MSW Fraction under Steam
Gasification under steam excess of the residual from mechanical treatment of municipal solid waste (RMT-MSW, refuse derived fuel (RDF)-type) was investigated in a laboratory batch reactor, equipped with a section for high-temperature gas equilibration. Experiments were performed with recirculation of the condensate and residual tars/oils, for closing of the process loop. Gas emissions were registered at 300–500 °C (pyrolysis; maximum at 390 °C) and 650–800 °C (gasification; maximum at 740 °C). Peak areas, equivalent to the gas volume, were in a general proportion of 55:45. Mass of tars and oils collected together with condensing steam was only equal to 0.15% of the average weight loss of the RMT-MSW. Ninety-seven percent of organic compounds, mainly naphthalene, phenanthrene and derivatives, was separable by a simple filtration. Concentration of metals in aqueous condensate was equal to 135 mg/dm3, 98.5% by mass was potassium and sodium ions. Concentration of NH4+ was equal to 2.49 g/dm3 (mostly carbonate). According to the thermodynamic evaluation, volume of the process gas was equal to 2.11 m3 (dry, 25 °C, 1 bar) per 1 kg of the dry waste. Standard enthalpy of the gas combustion was 24.6 MJ/kg of the dry waste; approximately 16% of this energy was due to endothermicity of the process.
- Open Access
- 1 April 2020
- Published by Elsevier in Applied Surface Science
- Vol. 509
Influence of pulsed laser ablation temperature on structure, morphology and electrocatalytic properties of cobalt-based films deposited on carbon cloth
- 1 April 2020
- Published by Elsevier in Applied Surface Science
- Vol. 509
Open AccessInfluence of pulsed laser ablation temperature on structure, morphology and electrocatalytic properties of cobalt-based films deposited on carbon cloth