Aleksander V. MAZANIK
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Aleksander V. MAZANIK has a total of 298 co-authors. Here are the top co-authors by number of shared publications:
- Anis M. Saad
Al-Balqa Applied University
31 shared publications A.K. Fedotov
23 shared publications- Eugene A. Streltsov
Belarusian State University
17 shared publications - Ivan A. Svito
Belarusian State University
14 shared publications - Aleksander K. Fedotov
Belarusian State University
12 shared publications - Tomasz N. Koltunowicz
Department of Electrical Devices and High Voltage Technology, Lublin University of Technology, Nadbystrzycka 38a, 20-618 Lublin, Poland
12 shared publications
Latest Publications
- 22 July 2026
- Published by Springer Nature in Journal of Applied Spectroscopy
- Vol. 93 (2) , 346-353
Raman and Photoluminescence Spectroscopic Analysis as a Multifunctional Tool for Studying Energy Materials
- 22 July 2026
- Published by Springer Nature in Journal of Applied Spectroscopy
- Vol. 93 (2) , 346-353
Raman and Photoluminescence Spectroscopic Analysis as a Multifunctional Tool for Studying Energy Materials
- 12 March 2025
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 57 (3) , 1-13
Photosensitivity enhancement in Cu2O based visible light photodetector: the effect of Eu(III)
- 12 March 2025
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 57 (3) , 1-13
Photosensitivity enhancement in Cu2O based visible light photodetector: the effect of Eu(III)
- 14 December 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (24) , 242103
Carrier recombination and diffusion in high-purity diamond after electron irradiation and annealing
Carrier-transport mechanisms are studied in high-purity diamond irradiated with 6 MeV electrons in the dose range of 1012–1016 cm−2 and annealed at different temperatures up to 1450 °C. Lifetimes and diffusion coefficients are extracted using two pump–probe techniques based on free-carrier absorption and transient-grating principles and then correlated with the corresponding defect evolution from spectroscopic measurements. The neutral monovacancy is revealed as the main carrier recombination center in the as-irradiated diamond, providing bipolar carrier lifetimes of a few nanoseconds at the highest irradiation dose. Carrier-capture cross sections are reduced during annealing as vacancies aggregate into divacancies at ≤1000 °C and extended vacancy clusters at 1450 °C.
- 14 December 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (24) , 242103
Carrier recombination and diffusion in high-purity diamond after electron irradiation and annealing
Carrier-transport mechanisms are studied in high-purity diamond irradiated with 6 MeV electrons in the dose range of 1012–1016 cm−2 and annealed at different temperatures up to 1450 °C. Lifetimes and diffusion coefficients are extracted using two pump–probe techniques based on free-carrier absorption and transient-grating principles and then correlated with the corresponding defect evolution from spectroscopic measurements. The neutral monovacancy is revealed as the main carrier recombination center in the as-irradiated diamond, providing bipolar carrier lifetimes of a few nanoseconds at the highest irradiation dose. Carrier-capture cross sections are reduced during annealing as vacancies aggregate into divacancies at ≤1000 °C and extended vacancy clusters at 1450 °C.
- Open Access
- 25 August 2020
- Published by Belarusian State University in Journal of the Belarusian State University. Chemistry
- No. 2
Electrocatalysis of oxygen reduction reaction on gold nanoparticles modified titanium dioxide films with different morphology
Dense and mesoporous titanium dioxide films have been obtained on titanium substrate by means of thermal oxidation, hydrolysis of polybutyltitanate, deposition of titanium dioxide sol, ultrasonic treatment and anodic oxidation and characterized by scanning electron microscopy, transmission electron microscopy and Raman spectroscopy. Electrochemical activity of titanium dioxide films, initial and modified by gold nanoparticles, in oxygen reduction reaction (ORR) in alkaline medium has been studied by cyclic voltammetry. It has been demonstrated that the efficiency of the dense and mesoporous titanium dioxide films in ORR is determined by their morphology, structure and pore ordering degree. Modification of titanium dioxide films by gold nanoparticles results in the decrease in overpotential of the ORR. It has been found that the electrodes consisted of highly ordered layers of titania nanotubes with deposited gold nanoparticles demonstrate sufficiently higher electrocatalytic activity toward the oxygen electroreduction in comparison with TiO2/Au systems based on dense films and mesoporous films with disordered pore structure. Features of electrochemical behavior of TiO2/Au (nanotubes/nanoparticles) system are explained by the peculiarities of electron transport to the electrode surface and structure of space charge layer in the mesoporous oxide film.
- 25 August 2020
- Published by Belarusian State University in Journal of the Belarusian State University. Chemistry
- No. 2
Open AccessElectrocatalysis of oxygen reduction reaction on gold nanoparticles modified titanium dioxide films with different morphology
Dense and mesoporous titanium dioxide films have been obtained on titanium substrate by means of thermal oxidation, hydrolysis of polybutyltitanate, deposition of titanium dioxide sol, ultrasonic treatment and anodic oxidation and characterized by scanning electron microscopy, transmission electron microscopy and Raman spectroscopy. Electrochemical activity of titanium dioxide films, initial and modified by gold nanoparticles, in oxygen reduction reaction (ORR) in alkaline medium has been studied by cyclic voltammetry. It has been demonstrated that the efficiency of the dense and mesoporous titanium dioxide films in ORR is determined by their morphology, structure and pore ordering degree. Modification of titanium dioxide films by gold nanoparticles results in the decrease in overpotential of the ORR. It has been found that the electrodes consisted of highly ordered layers of titania nanotubes with deposited gold nanoparticles demonstrate sufficiently higher electrocatalytic activity toward the oxygen electroreduction in comparison with TiO2/Au systems based on dense films and mesoporous films with disordered pore structure. Features of electrochemical behavior of TiO2/Au (nanotubes/nanoparticles) system are explained by the peculiarities of electron transport to the electrode surface and structure of space charge layer in the mesoporous oxide film.
- Open Access
- 28 June 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 127 (24) , 245707
Carrier recombination parameters in diamond after surface boron implantation and annealing
An optical pump–probe technique was used to detect spatial distribution of carrier lifetimes across the thickness of a high-quality diamond device structure. Two samples with as-received and boron implanted surfaces were compared to assess the role of implantation and related processing on carrier recombination mechanisms. It was found that the two implanted surfaces show very different behaviors despite undergoing the same treatment. At one of the surfaces, carrier lifetimes remained relatively unchanged, indicating surface recombination rates in the 102–103 cm/s range. At the other surface, carrier lifetimes were almost a magnitude lower and correlated with the locally detected nitrogen vacancy defect that was attributed to the elevated concentration of residual nitrogen.
- 28 June 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 127 (24) , 245707
Open AccessCarrier recombination parameters in diamond after surface boron implantation and annealing
An optical pump–probe technique was used to detect spatial distribution of carrier lifetimes across the thickness of a high-quality diamond device structure. Two samples with as-received and boron implanted surfaces were compared to assess the role of implantation and related processing on carrier recombination mechanisms. It was found that the two implanted surfaces show very different behaviors despite undergoing the same treatment. At one of the surfaces, carrier lifetimes remained relatively unchanged, indicating surface recombination rates in the 102–103 cm/s range. At the other surface, carrier lifetimes were almost a magnitude lower and correlated with the locally detected nitrogen vacancy defect that was attributed to the elevated concentration of residual nitrogen.
- 31 May 2019
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 2 (6) , 4566
Correction to Dynamics of Photoinduced Degradation of Perovskite Photovoltaics: From Reversible to Irreversible Processes
- 31 May 2019
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 2 (6) , 4566
Correction to Dynamics of Photoinduced Degradation of Perovskite Photovoltaics: From Reversible to Irreversible Processes
- 1 May 2019
- Published by Elsevier in Journal of Fluorine Chemistry
- Vol. 221, 34-41
Effect of fluoride-mediated transformations on electrocatalytic performance of thermally treated TiO2 nanotubular layers
- 1 May 2019
- Published by Elsevier in Journal of Fluorine Chemistry
- Vol. 221, 34-41
Effect of fluoride-mediated transformations on electrocatalytic performance of thermally treated TiO2 nanotubular layers
- Open Access
- 16 April 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 498 (1) , 012012
Formation and optical properties of hybrid organic-inorganic MAPbI3 perovskite films
A rapid progress in the development of solar cells based on hybrid organic-inorganic perovskites CH3NH3PbI3 (MAPbI3) is observed in recent years, and power conversion efficiency as high as 22.1 % has been reported. However, a low stability is the main drawback of these materials, which impedes their practical use for solar energy conversion. This work is devoted to the synthesis of CH3NH3PbI3 films from CH3NH3I and PbI2 precursors and spectroscopic investigation of their stability under high-intensity laser illumination.
- 16 April 2019
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 498 (1) , 012012
Open AccessFormation and optical properties of hybrid organic-inorganic MAPbI3 perovskite films
A rapid progress in the development of solar cells based on hybrid organic-inorganic perovskites CH3NH3PbI3 (MAPbI3) is observed in recent years, and power conversion efficiency as high as 22.1 % has been reported. However, a low stability is the main drawback of these materials, which impedes their practical use for solar energy conversion. This work is devoted to the synthesis of CH3NH3PbI3 films from CH3NH3I and PbI2 precursors and spectroscopic investigation of their stability under high-intensity laser illumination.
- 4 April 2019
- Published by Wiley in ChemElectroChem
- Vol. 6 (9) , 2474-2481
Bismuth Oxysulfide Photoelectrodes with Giant Incident Photon‐to‐Current Conversion Efficiency: Chemical Stability in Aqueous Solutions
Bismuth oxysulfide (BOS) films demonstrate giant incident photon‐to‐current conversion efficiency (IPCE≫100 %) under cathodic polarization. Their photoelectrochemical behavior and corrosion stability in aqueous solutions containing different redox systems ([Fe(CN)6]3−/[Fe(CN)6]4−, Fe3+/Fe2+, I2/I−, Sn2−/S2−) has been investigated. We established that the chemical stability of the BOS is controlled mainly by three factors: i) potentials of cathodic and anodic destruction of the BOS (Bi3+ reduction and S2− oxidation)L ii) protolytic reactions leading to the dissolution of the semiconductor in acidic solutions at pH6] ⋅ 3H2O, BiOI and Bi2S3). The enrichment of the BOS surface with sulfur atoms (formation of S‐terminated surface) gives rise to the substantial increase in the electrocatalytic activity of [Fe(CN)6]3− cathodic reduction, which is accompanied by up to order increase of IPCE.
- 4 April 2019
- Published by Wiley in ChemElectroChem
- Vol. 6 (9) , 2474-2481
Bismuth Oxysulfide Photoelectrodes with Giant Incident Photon‐to‐Current Conversion Efficiency: Chemical Stability in Aqueous Solutions
Bismuth oxysulfide (BOS) films demonstrate giant incident photon‐to‐current conversion efficiency (IPCE≫100 %) under cathodic polarization. Their photoelectrochemical behavior and corrosion stability in aqueous solutions containing different redox systems ([Fe(CN)6]3−/[Fe(CN)6]4−, Fe3+/Fe2+, I2/I−, Sn2−/S2−) has been investigated. We established that the chemical stability of the BOS is controlled mainly by three factors: i) potentials of cathodic and anodic destruction of the BOS (Bi3+ reduction and S2− oxidation)L ii) protolytic reactions leading to the dissolution of the semiconductor in acidic solutions at pH6] ⋅ 3H2O, BiOI and Bi2S3). The enrichment of the BOS surface with sulfur atoms (formation of S‐terminated surface) gives rise to the substantial increase in the electrocatalytic activity of [Fe(CN)6]3− cathodic reduction, which is accompanied by up to order increase of IPCE.