Florentina Nicolau
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Florentina Nicolau has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Witold Respondek
Institute of Automatic Control, Lodz University of Technology, d, Poland
7 shared publications Witold Respondek
4 shared publicationsJean-Pierre Barbot
3 shared publications- Jean-Pierre Barbot
QUARTZ EA7393 Laboratory, ENSEA 5 , 6 Avenue du Ponceau, 95014 Cergy-Pontoise
3 shared publications Hugues Mounier
CentraleSupélec Laboratoire des signaux et systèmes Université Paris-Saclay CNRS 3 Rue Joliot-Curie 91192 Gif-sur-Yvette Cedex France
2 shared publications- Malek Ghanes
Nantes Universite-cole Centrale de Nantes-LS2N, UMR 6004 CNRS, Nantes, France
2 shared publications
Latest Publications
- Open Access
- 21 October 2026
- Published by Elsevier in Annual Reviews in Control
- Vol. 62
Differential flatness in optimization-based motion planning and control
- 21 October 2026
- Published by Elsevier in Annual Reviews in Control
- Vol. 62
Open AccessDifferential flatness in optimization-based motion planning and control
- Open Access
Numerical Discretization Schemes that Preserve Flatness
Differential flatness serves as a powerful tool for controlling continuous time nonlinear systems in problems such as motion planning and trajectory tracking. A similar notion, called difference flatness, exists for discrete-time systems. Although many control systems evolve in continuous time, control implementation is performed digitally, requiring discretization. It is well known in the literature that discretization does not necessarily preserve structural properties, and it has been established that, in general, flatness is not preserved under discretization (whether exact or approximate). In this paper, inspired by our previous work [1] and based on the notion of discretization maps, we construct numerical schemes that preserve flatness.
Open AccessNumerical Discretization Schemes that Preserve Flatness
Differential flatness serves as a powerful tool for controlling continuous time nonlinear systems in problems such as motion planning and trajectory tracking. A similar notion, called difference flatness, exists for discrete-time systems. Although many control systems evolve in continuous time, control implementation is performed digitally, requiring discretization. It is well known in the literature that discretization does not necessarily preserve structural properties, and it has been established that, in general, flatness is not preserved under discretization (whether exact or approximate). In this paper, inspired by our previous work [1] and based on the notion of discretization maps, we construct numerical schemes that preserve flatness.
- 23 July 2025
- Published by Elsevier in European Journal of Control
- Vol. 86
Active fault-tolerant flatness-based control for a three-phase grid connected inverter with LCL filters
- 23 July 2025
- Published by Elsevier in European Journal of Control
- Vol. 86
Active fault-tolerant flatness-based control for a three-phase grid connected inverter with LCL filters
- 16 July 2025
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 362 (13)
Dynamic feedback linearization of two-input control systems via successive one-fold prolongations
- 16 July 2025
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 362 (13)
Dynamic feedback linearization of two-input control systems via successive one-fold prolongations
- 16 June 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 9, 1886-1891
Identifying a Distinguished Control in Dynamic Feedback Linearization and in Reduction
In this paper we discuss two important problems in control theory: a) dynamic feedback linearization via successive prolongations of a suitably chosen control, and b) linearization via a one-fold reduction. Despite their differences, both problems require identifying a special control, called distinguished control, which is a smooth combination of the original controls of the system. In each case, this control is determined with the help of a corank-one suitable subdistribution of D0, the distribution spanned by the original control vector fields. The main result of the paper provides a direct explicit construction of that corank-one distinguished distribution and of the distinguished control.
- 16 June 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 9, 1886-1891
Identifying a Distinguished Control in Dynamic Feedback Linearization and in Reduction
In this paper we discuss two important problems in control theory: a) dynamic feedback linearization via successive prolongations of a suitably chosen control, and b) linearization via a one-fold reduction. Despite their differences, both problems require identifying a special control, called distinguished control, which is a smooth combination of the original controls of the system. In each case, this control is determined with the help of a corank-one suitable subdistribution of D0, the distribution spanned by the original control vector fields. The main result of the paper provides a direct explicit construction of that corank-one distinguished distribution and of the distinguished control.
- Open Access
Dynamic feedback linearization of two-input control systems via successive one-fold prolongations
In this paper, we propose a constructive algorithm to dynamically linearize two-input control systems via successive one-fold prolongations of a control that has to be suitably chosen at each step of the algorithm. Linearization via successive one-fold prolongations requires special properties of the linearizability distributions $\mathcal{D}^0 \subset \mathcal{D}^1 \subset\mathcal{D}^2 \subset \cdots$. Contrary to the case of static feedback linearizability, they need not be involutive but the first noninvolutive one has to contain an involutive subdistribution of corank one. The main idea of the proposed algorithm is to replace, at each step, the first noninvolutive distribution by its involutive subdistribution of corank one, thus for the prolonged system we gain at least one new involutive distribution. Our algorithm is constructive, gives sufficient conditions for flatness, and can be seen as the dual of the dynamic feedback linearization algorithm of Battilotti and Califano [2003, 2005].Open AccessDynamic feedback linearization of two-input control systems via successive one-fold prolongations
In this paper, we propose a constructive algorithm to dynamically linearize two-input control systems via successive one-fold prolongations of a control that has to be suitably chosen at each step of the algorithm. Linearization via successive one-fold prolongations requires special properties of the linearizability distributions $\mathcal{D}^0 \subset \mathcal{D}^1 \subset\mathcal{D}^2 \subset \cdots$. Contrary to the case of static feedback linearizability, they need not be involutive but the first noninvolutive one has to contain an involutive subdistribution of corank one. The main idea of the proposed algorithm is to replace, at each step, the first noninvolutive distribution by its involutive subdistribution of corank one, thus for the prolonged system we gain at least one new involutive distribution. Our algorithm is constructive, gives sufficient conditions for flatness, and can be seen as the dual of the dynamic feedback linearization algorithm of Battilotti and Califano [2003, 2005]. - 18 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 8, 1769-1774
Fault Detection, Isolation, and Estimation for a Three-Phase Grid Connected DC-AC Inverter With LCL Filters
The paper is dedicated to symmetric and asymmetric fault detection, isolation, and estimation of a three-phase DC-AC (Direct Current-Alternating Current) inverter connected to the grid by three LCL filters. The system modeling and the faults estimation algorithm are performed in the abc frame allowing to take into account phase by phase asymmetrical faults. It is based on a left inversion technique and uses the super-twisting differentiator in order to estimate the state components of the system from the given measurements. Simulations to support the proposed approach are presented.
- 18 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Control Systems Letters
- Vol. 8, 1769-1774
Fault Detection, Isolation, and Estimation for a Three-Phase Grid Connected DC-AC Inverter With LCL Filters
The paper is dedicated to symmetric and asymmetric fault detection, isolation, and estimation of a three-phase DC-AC (Direct Current-Alternating Current) inverter connected to the grid by three LCL filters. The system modeling and the faults estimation algorithm are performed in the abc frame allowing to take into account phase by phase asymmetrical faults. It is based on a left inversion technique and uses the super-twisting differentiator in order to estimate the state components of the system from the given measurements. Simulations to support the proposed approach are presented.
- Open Access
- 22 December 2023
- Published by EDP Sciences in ESAIM: Control, Optimisation and Calculus of Variations
- Vol. 29, 89
Flatness of Networks of Synaptically Coupled Excitatory-Inhibitory Neural Modules
In this paper, we consider networks of N synaptically coupled excitatory-inhibitory neural modules, with N arbitrary. It has been argued that the connection strengths may slowly vary with respect to time and that they can actually be considered as inputs of the network. The problem that we are studying is which connection strengths should be modified (in other words, which connection strengths should be considered as inputs) in order to achieve flatness for the resulting control system. Flatness of the control network depends on the number of inputs and we show that if enough connection strengths (at least N) can be considered as inputs, then the control network is flat without structural conditions. If the number of inputs is smaller than N. then flatness imposes particular configurations of the interactions between the subnetworks. Our main contribution is to identify, analyze and characterize several flat configurations in the latter case.
- 22 December 2023
- Published by EDP Sciences in ESAIM: Control, Optimisation and Calculus of Variations
- Vol. 29, 89
Open AccessFlatness of Networks of Synaptically Coupled Excitatory-Inhibitory Neural Modules
In this paper, we consider networks of N synaptically coupled excitatory-inhibitory neural modules, with N arbitrary. It has been argued that the connection strengths may slowly vary with respect to time and that they can actually be considered as inputs of the network. The problem that we are studying is which connection strengths should be modified (in other words, which connection strengths should be considered as inputs) in order to achieve flatness for the resulting control system. Flatness of the control network depends on the number of inputs and we show that if enough connection strengths (at least N) can be considered as inputs, then the control network is flat without structural conditions. If the number of inputs is smaller than N. then flatness imposes particular configurations of the interactions between the subnetworks. Our main contribution is to identify, analyze and characterize several flat configurations in the latter case.
- 24 November 2023
- Published by Oxford University Press (OUP) in IMA Journal of Mathematical Control and Information
- Vol. 40 (4) , 746-788
HPA axis differential flatness and Liouvillian study for higher resiliency investigations
In this paper, we study several existing quantitative models of the hypothalamic–pituitary–adrenal (HPA) axis from a control systems theory viewpoint, that is, we suppose that we can act on the dynamics of the HPA axis throughout some parameters, which are the system inputs. In particular, we will focus on flatness and Liouvillian properties of the considered control systems of the HPA axis. We first study the minimal three-dimensional model of Bangsgaard and Ottesen (2017, Math. Biosci., 287:24–35) and the semi-mechanistic four-dimensional model of Gupta et al. (2007, Theor. Biol. Medical Model., 4(1):8) which are shown to be flat, and then, we consider the more involved and important model proposed in Rao & Androulakis (2019, Sci. Rep., 9(1):11212; 2020, IFAC-PapersOnLine, 53(2):15858–15863), with seven states, for which we prove that for the nominal values of the parameters involved in the model, flatness no longer holds. The more involved model satisfies however a similar but weaker property than flatness: it is a Liouvillian system.
- 24 November 2023
- Published by Oxford University Press (OUP) in IMA Journal of Mathematical Control and Information
- Vol. 40 (4) , 746-788
HPA axis differential flatness and Liouvillian study for higher resiliency investigations
In this paper, we study several existing quantitative models of the hypothalamic–pituitary–adrenal (HPA) axis from a control systems theory viewpoint, that is, we suppose that we can act on the dynamics of the HPA axis throughout some parameters, which are the system inputs. In particular, we will focus on flatness and Liouvillian properties of the considered control systems of the HPA axis. We first study the minimal three-dimensional model of Bangsgaard and Ottesen (2017, Math. Biosci., 287:24–35) and the semi-mechanistic four-dimensional model of Gupta et al. (2007, Theor. Biol. Medical Model., 4(1):8) which are shown to be flat, and then, we consider the more involved and important model proposed in Rao & Androulakis (2019, Sci. Rep., 9(1):11212; 2020, IFAC-PapersOnLine, 53(2):15858–15863), with seven states, for which we prove that for the nominal values of the parameters involved in the model, flatness no longer holds. The more involved model satisfies however a similar but weaker property than flatness: it is a Liouvillian system.