DZDahuai Zheng

Dahuai Zheng

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Dahuai Zheng has a total of 79 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    High-Temperature XRD and DFT Investigation of Dispersion and Birefringence in Mg-Doped LiNbO₃ for Tunable SPDC Phase-Matching

    by Weiwei Wang, Shuolin Wang, Hongde Liu, Dahuai Zheng, Yongfa Kong

    Spontaneous parametric down-conversion (SPDC) via birefringent phase matching offers a cost-effective route to free-space entangled photon pairs, but its performance is limited by the temperature-dependent dispersion and birefringence of nonlinear crystals. Mg-doped lithium niobate (LN:Mg) is promising because of its resistance to photorefractive damage, yet systematic broad-temperature optical studies remain scarce. Here, congruent undoped lithium niobate (CLN) and 5 mol% Mg-doped lithium niobate were investigated from room temperature to 350 °C. High-temperature X-ray diffraction (XRD) determined lattice parameters as a function of temperature. First-principles calculations provided temperature-dependent dispersion curves, thermo-optic coefficients, and birefringence. We correlated temperature, lattice distortion, and optical response and assessed the feasibility of predicting dispersion from lattice parameters. Mg doping significantly enhanced the thermal stability of the ordinary refractive index (no), which showed negligible drift from 25 to 350 °C. In contrast, the extraordinary refractive index (ne) of LN:Mg exhibited pronounced fluctuations below 110 °C and linear variation at medium-to-high temperatures. Mg-induced defect-cluster reconstruction led to anomalous V-shaped temperature dependence of birefringence. For SPDC via birefringent phase matching, temperature control is therefore an effective strategy for tuning phase-matching conditions. This work provides theoretical guidance for crystal selection and parameter optimization in room-temperature, low-noise entangled-photon sources and a cost-effective method for predicting phase-matching temperatures without large quantities of high-precision crystal samples.

  • Open Access

    Single mode on-chip erbium-doped lithium niobate Fabry-Pérot laser with high side-mode suppression ratio

    by Yiyang Zou, Yuqi Zhang, Chunyu Zhang, Xiaomin Wang, Rui Ma, Dahuai Zheng, Shiguo Liu, Hongde Liu, Fang Bo, Li Wu, et al.

    Erbium-doped lithium niobate on insulator (LNOI) has attracted significant attention for integrated active photonic devices. Here we demonstrate an erbium-doped LNOI Fabry-Pérot (F-P) laser monolithically terminated with a pair of Sagnac loop reflectors, fabricated by a CMOS-compatible process. The device lases in a single mode at 1561.8 nm, with a slope efficiency of 0.24%. Remarkably, we achieved a side-mode suppression ratio (SMSR) as high as 40.0 dB. To the best of our knowledge, this is the highest SMSR reported to date for an LNOI F-P laser, highlighting its potential for high-performance integrated laser sources.

  • Open Access

    Lithium niobate volatile memristors for efficient reservoir computing

    by Jiashun Song, Tianqi Xiao, Binwen Niu, Xiaomin Wang, Hongde Liu, Dahuai Zheng, Yongfa Kong, Jingjun Xu

    Lithium niobate (LiNbO3) thin films, serving as next-generation optoelectronic integration platforms, enable nonvolatile memristors with exceptional convolutional computing capabilities through inherent ferroelectricity. Although volatile memristors offer distinct advantages for temporal information processing due to their transient dynamics, such devices remain underexplored in LiNbO3 systems. Critically, grain boundary-associated conductive channel formation provides an effective approach for regulating volatile resistive switching behavior. Herein, we report a polycrystalline LiNbO3-based volatile memristor fabricated via pulsed laser deposition. Oxygen-vacancy-related dynamics contribute to the volatile switching behavior, while the polycrystalline grain-boundary structure provides favorable environments for localized conductive-channel evolution, which is essential for emulating the transient nature of biological neural signals. This memristor is capable of accurately emulating biorealistic synaptic functions, including paired-pulse facilitation (PPF; τ1 = 1.2 ms and τ2 = 11.6 ms) and spike-dependent synaptic plasticity. As a seven-bit physical reservoir computing unit, it achieves accuracy of 94.11% in MNIST digit classification by leveraging its intrinsic nonlinear dynamics. The memristor’s simplified structure and fabrication process ensure excellent scalability, while its inherent optical/piezoelectric multimodality enables interaction with optical and piezoelectric signals. This work lays the foundation for advanced intelligent sensing and neuromorphic computing systems.

  • Predominance of Lone-Pair Electron Effects in Bi-Doped LiNbO3 Crystals Enhanced by Codoping with Non-Photorefractive Ions of Various Valence States

    by Weiwei Wang, Shuolin Wang, Hongde Liu, Dahuai Zheng, Ang Bian, Yongfa Kong

    This study investigates the stabilization mechanisms of lone-pair electron effects in bismuth (Bi) and non-photorefractive (NPR) ions (Zn, In, Zr)-codoped lithium niobate (LiNbO3, LN) crystals. The results demonstrate that distinct defect cluster configurations are formed in Bi- and NPR ion-codoped lithium niobate depending on dopant concentrations. The most stable structures occur when NPR ions are positioned as the second or third nearest neighbors (2NN or 3NN) relative to Bi ions, as opposed to the first nearest neighbor (1NN), which disrupt the symmetry of the crystal. The band structure and density of states (DOS) analyses reveal that Zn, In, and Zr substantially modulate the reactivity of Bi’s lone pair electrons. Specifically, when Zn exceeds the threshold concentration, its 3d orbitals generate discrete energy levels due to the influence of Bi ions, thereby improving the photorefractive (PR) properties of LN crystals. Furthermore, femtosecond transient absorption spectroscopy kinetically reveals how the lone-pair electron effect of bismuth ions modulates optical transitions by enhancing carrier density and lifetime. These findings offer a significant mechanistic understanding for designing and optimizing Bi- and NPR ion-codoped LN crystals for advanced optical applications.

  • Open Access

    Photorefraction and Optical Damage Resistance Enhancement in Uranium-Doped Lithium Niobate Crystals by Hafnium Co-Doping

    by Jiayue Xu, Ming Xi, Dong Zhang, Chenkai Fang, Dahuai Zheng, Hongde Liu, Yaoqing Chu, Hui Shen, Tian Tian

    A series of Hf co-doped uranium-doped lithium niobate (LN:U,Hf) crystals with a diameter of one inch were grown by the modified Bridgman method. XPS analysis showed that U ions coexist in mixed valence states of U4+, U5+, and U6+. At 442 nm, LN:U,Hf1.0 exhibited a fast photorefractive response of 0.32 s together with a high saturation diffraction efficiency of 82.01%. With increasing Hf concentration, the optical damage resistance was significantly enhanced, and LN:U,Hf5.0 achieved an optical damage threshold of 2.8 × 105 W/cm2. Two-beam coupling experiments indicated that electrons are the dominant charge carriers and diffusion is the main transport mechanism. It demonstrates that co-doping Hf4+ provides an effective route to simultaneously enhance photorefractive response and optical damage resistance in LN:U, offering potential for high-power and fast-response photonic devices.

  • Enhanced photorefractive performance and optical damage resistance in zirconium and uranium co-doped lithium niobate crystals

    by Tian Tian, Dong Zhang, Tingfeng Wu, Weiwei Wang, Hongde Liu, Dahuai Zheng, Yaoqing Chu, Hui Shen, Jiayue Xu

    Millisecond level photorefractive response together with high saturated diffraction efficiency and strongly enhanced photodamage resistance are achieved in Zr,U co-doped LiNbO 3 (LN:Zr,U) crystals at 442 nm.

  • Open Access

    Lithium Niobate Thin Film on Silicon Fabricated by Pulsed Laser Deposition

    by Shaoqing Song, Tianqi Xiao, Jiashun Song, Hongde Liu, Dahuai Zheng, Yongfa Kong, Jingjun Xu

    Lithium niobate (LiNbO3, LN) is a multifunctional material with broad applicability in photonic and electronic devices. Recent advances in lithium niobate on insulator (LNOI) technology have significantly enhanced the integration density and miniaturization potential of LN-based platforms. Among the various fabrication techniques available, pulsed laser deposition (PLD) presents a cost-effective and versatile alternative to crystalline ion slicing (CIS), particularly advantageous for achieving high doping concentrations. However, a persistent challenge in PLD-grown lithium niobate film is cracking, primarily induced by the substantial thermal stress resulting from the mismatch in thermal expansion coefficients between LN and the substrate. In this study, we implemented a series of process modifications to address the cracking issue and successfully achieved crack-free LN films by introducing a lithium-deficient phase. This approach enabled the successful fabrication of highly Fe3+-doped LN films with a high electrical conductivity of 9.95 × 10−5 S/m while also exhibiting characteristic polarization switching behavior. These results demonstrate that PLD enables the fabrication of highly doped, structurally robust LN films and holds significant potential for the development of advanced electronic and optoelectronic devices.


  • A Monolithic Active‐Passive LNOI Photonic Integration Platform via Localized Thermal Diffusion

    by Binwen Niu, Yuqi Zhang, Chunyu Zhang, Xiaomin Wang, Dahuai Zheng, Hongde Liu, Shiguo Liu, Fang Bo, Yongfa Kong, Jingjun Xu

    Lithium niobate on insulator (LNOI) provides a low‐loss, high‐density, multifunctional material platform for integrated photonics. However, owing to its indirect bandgap, electroluminescence cannot be realized in undoped LNOI. While rare earth (RE) ions doping provides a gain medium for lithium niobate (LN), it also brings about non‐negligible absorption losses. Here, a method for fabricating locally doped LNOI is introduced, and an active‐passive LNOI platform is presented via localized erbium (Er) ions thermal diffusion. The concentration of Er3+ ions remains uniform at 0.3 mol% throughout the LN film. The intrinsic quality (Qi) factors of microring resonators on active and passive regions are 2.64 × 105 and 7.48 × 105, respectively. As a demonstration, an integrated amplifier‐assisted microring laser is fabricated on this platform, which is transmitted through the passive region before output, achieving a maximum slope efficiency of 4.09 × 10−3%. The monolithic active‐passive LNOI photonic integration platform offers proven stability and compatibility, paving the way for advanced LNOI devices. It will undoubtedly promote the development and industrialization of LNOI integrated photonics.


  • Enhanced red-light photorefractive response speed of LiNbO3 crystals for full color holographic display

    by Shuolin Wang, Yidong Shan, Zhaojie Wu, Dahuai Zheng, Shiguo Liu, Hongde Liu, Yongfa Kong, Jingjun Xu

    As a promising candidate material for holographic displays, lithium niobate (LN) is limited by its slow photorefractive (PR) response. Recently, it was discovered that Bi3+, with its lone-pair electrons, can effectively enhance the PR speed of LN crystals. However, this enhancement is only effective in the short-wavelength range of visible light, and the response time remains inadequate for full-color dynamic displays. In this paper, a theoretical framework is established to guide the shallow energy-level PR doping of LN crystals. We simulate the energy band structure, electron mobility, and other properties of LN crystals doped with Tl, Pb, and Sb ions, which feature lone-pair electrons, using first-principles calculations. The theoretical results indicate that when Sb occupies the Nb site (SbNb0), the defect level position in the bandgap is shallow, and the electron mobility is 79.029 cm2 V–1 s–1 subsequently, we grew a series of LN:Sb and LN:Sb,Mg crystals and characterized their crystalline quality and PR properties. High-resolution x-ray rocking curve results demonstrate that all the as-grown crystals exhibit excellent crystalline quality, with FWHM values ranging from approximately 0.007° to 0.008°. Notably, the LN:Sb1.0,Mg6.0 crystal demonstrates a rapid PR response time of 1.67 s at 671 nm, nearly three times faster than that of the LN:Bi1.0,Mg6.0 crystal.


  • Open Access

    Property optimization of Er/Yb-codoped LiNbO3 crystals for LNOI lasers and amplifiers

    by Zhongzheng Zhang, Yuqi Zhang, Zhaojie Wu, Xin Yuan, Shiguo Liu, Hongde Liu, Dahuai Zheng, Yongfa Kong, Jingjun Xu

    Lithium-niobate-on-insulator (LNOI) is regarded as an ideal platform for integrated photonics. As an essential part, active devices based on rare-earth (RE) doped LNOI have made significant progress, with erbium/ytterbium-codoped lithium niobate (Er/Yb-codoped LN) showing great potential. In this paper, a series of Er/Yb-codoped LN crystals were successfully grown by the Czochralski method, featuring a fixed Er3+ concentration with various Yb3+ doping levels and a fixed RE3+ (RE3+ = Er3+ + Yb3+) concentration. The absorption and emission spectra were measured, and the transfer efficiencies along with relative conversion efficiencies were also displayed. It was concluded that the optimal composition of codoped LN is ∼1.0 mol. % Er3+ and 1.0 mol. % Yb3+, which can enhance active devices by providing lower threshold power, reduced transmission loss, higher transfer efficiency, and improved conversion efficiency. These results will advance the development of high performance LNOI lasers and amplifiers.