Banqiao Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Banqiao Wang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Nan Li
School of Geology Engineering and Geomatics, Chang’an University, Xi’an, China
3 shared publicationsXueling Liu
School of Geology Engineering and Geomatics, Chang’an University, Xi’an, China
3 shared publicationsJun Li
School of Geology Engineering and Geomatics, Chang’an University, Xi’an, China
2 shared publicationsLiqun Yuan
School of Architecture and Civil Engineering, Liaocheng University, Liaocheng, China
2 shared publicationsYuming Men
School of Geology Engineering and Geomatics, Chang’an University, Xi’an, China
2 shared publicationsJianbin Hao
School of Geology Engineering and Geomatics, Chang’an University, Xi’an, China
1 shared publication
Latest Publications
- 19 June 2020
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 38 (6) , 6057-6067
Study on Dynamic Response of Pressure Type Anchor and Lattice Beam System Under Seismic Loadings
- 19 June 2020
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 38 (6) , 6057-6067
Study on Dynamic Response of Pressure Type Anchor and Lattice Beam System Under Seismic Loadings
- 10 March 2020
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 13 (6) , 1-13
Seismic response of soil slope reinforced by compression anchor and frame beam based on shaking table test
- 10 March 2020
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 13 (6) , 1-13
Seismic response of soil slope reinforced by compression anchor and frame beam based on shaking table test
- Open Access
- 1 January 2019
- Published by Taylor & Francis in Geomatics, Natural Hazards and Risk
- Vol. 10 (1) , 2030-2050
Seismic response of micropiles-reinforced landslide based on shaking table test
A series of shaking table tests were conducted on unreinforced and micropiles-reinforced soil landslides to investigate the seismic response of micropiles-reinforced landslide and the dynamic mechanical behaviour of micropiles in landslide under earthquake. The test results indicate that: (1) The micropiles can raise the anti-seismic performance of landslide, and it can efficiently delay the development of earthquake landslide hazards. (2) After earthquake, the flexural failure of micropile mainly occurs in the area that 1.4–4 times pile diameter above the sliding surface and the area that 1.4–3.4 times pile diameter below the sliding surface. (3) After reinforced by micropiles, the acceleration response on the slope surface of landslide can be decreased, especially the slope toe. (4) Both thrust of sliding mass and resistance of sliding bed are mainly concentrated near the sliding surface. The dynamic bending moment distributions of the three rows of micropiles present as reverse ‘S’. The maximum bending moment of the pile above sliding surface is located at the point that 3.7 times pile diameter above sliding surface, and the maximum bending moment of the pile below sliding surface is located to the point that 1.43 times pile diameter below sliding surface.
- 1 January 2019
- Published by Taylor & Francis in Geomatics, Natural Hazards and Risk
- Vol. 10 (1) , 2030-2050
Open AccessSeismic response of micropiles-reinforced landslide based on shaking table test
A series of shaking table tests were conducted on unreinforced and micropiles-reinforced soil landslides to investigate the seismic response of micropiles-reinforced landslide and the dynamic mechanical behaviour of micropiles in landslide under earthquake. The test results indicate that: (1) The micropiles can raise the anti-seismic performance of landslide, and it can efficiently delay the development of earthquake landslide hazards. (2) After earthquake, the flexural failure of micropile mainly occurs in the area that 1.4–4 times pile diameter above the sliding surface and the area that 1.4–3.4 times pile diameter below the sliding surface. (3) After reinforced by micropiles, the acceleration response on the slope surface of landslide can be decreased, especially the slope toe. (4) Both thrust of sliding mass and resistance of sliding bed are mainly concentrated near the sliding surface. The dynamic bending moment distributions of the three rows of micropiles present as reverse ‘S’. The maximum bending moment of the pile above sliding surface is located at the point that 3.7 times pile diameter above sliding surface, and the maximum bending moment of the pile below sliding surface is located to the point that 1.43 times pile diameter below sliding surface.
- Open Access
- 1 January 2019
- Published by Taylor & Francis in Geomatics, Natural Hazards and Risk
- Vol. 10 (1) , 271-286
Dynamic behavior of soil anchorage landslide at different frequencies
To reveal the dynamic behavior of soil anchorage landslide and the mechanical feature of anchors at different frequencies, a shaking table test was performed on a 1:7 scale soil anchorage landslide. Actual seismic wave measured from the Wenchuan earthquake, sinusoidal waves with different frequencies were applied to the model. The acceleration response of the anchorage landslide in frequency domain was analyzed, and the strain distribution of anchors at 1.15 Hz sinusoidal wave and 3.45 Hz sinusoidal wave were investigated separately. The testing results indicate that the anchorage landslide is sensitive not only to higher frequencies (near the natural frequency of the landslide) at low loading amplitude but also to ultra-low frequencies at high loading amplitude. At ultra-low frequency 1.15 Hz sinusoidal wave, when the loading amplitude is low and medium (0.05-0.6 g), the bottom anchor bears greater force. But when the loading amplitude is high (0.8 g), the top anchor bears most of the anchorage force. At 3.45 Hz sinusoidal wave that near the natural frequency of the landslide, no matter how the loading amplitude, the top anchor plays significant role, especially at higher loading amplitude (0.3-0.6 g).
- 1 January 2019
- Published by Taylor & Francis in Geomatics, Natural Hazards and Risk
- Vol. 10 (1) , 271-286
Open AccessDynamic behavior of soil anchorage landslide at different frequencies
To reveal the dynamic behavior of soil anchorage landslide and the mechanical feature of anchors at different frequencies, a shaking table test was performed on a 1:7 scale soil anchorage landslide. Actual seismic wave measured from the Wenchuan earthquake, sinusoidal waves with different frequencies were applied to the model. The acceleration response of the anchorage landslide in frequency domain was analyzed, and the strain distribution of anchors at 1.15 Hz sinusoidal wave and 3.45 Hz sinusoidal wave were investigated separately. The testing results indicate that the anchorage landslide is sensitive not only to higher frequencies (near the natural frequency of the landslide) at low loading amplitude but also to ultra-low frequencies at high loading amplitude. At ultra-low frequency 1.15 Hz sinusoidal wave, when the loading amplitude is low and medium (0.05-0.6 g), the bottom anchor bears greater force. But when the loading amplitude is high (0.8 g), the top anchor bears most of the anchorage force. At 3.45 Hz sinusoidal wave that near the natural frequency of the landslide, no matter how the loading amplitude, the top anchor plays significant role, especially at higher loading amplitude (0.3-0.6 g).