Mandar S. Bhoir
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mandar S. Bhoir has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Nihar Ranjan Mohapatra
Indian Institute of Technology Gandhinagar
8 shared publications Jerome Mitard
Interuniversity Microelectronics Center (IMEC), 3001 Leuven, Belgium
2 shared publications- Kumari Neeraj Kaushal
Department of Electrical Engineering, IIT Gandhinagar, Gandhinagar, India
2 shared publications Naoto Horiguchi
Interuniversity Microelectronics Center (IMEC), 3001 Leuven, Belgium
2 shared publicationsNihar R. Mohapatra
Indian Institute of Technology Gandhinagar, India
2 shared publicationsPragya Kushwaha
UC Berkeley, USA
2 shared publications
Latest Publications
- 8 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Physics-based parameter extraction methodology for channel doping gradient (CDG) LDMOS transistors based on HiSIM-HV2 model
A physics-based parameter extraction methodology based on HiSIM-HV2 model is developed to capture the effect of CDG on the performance of LDMOS transistors. The CDG shows up to 30% performance benefit. The physics behind this is investigated using TCAD simulations and the learning from the simulations is used to efficiently extract the model parameters. The spice simulations with extracted parameters further confirm advantage of CDG on circuit performance.
- 8 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Physics-based parameter extraction methodology for channel doping gradient (CDG) LDMOS transistors based on HiSIM-HV2 model
A physics-based parameter extraction methodology based on HiSIM-HV2 model is developed to capture the effect of CDG on the performance of LDMOS transistors. The CDG shows up to 30% performance benefit. The physics behind this is investigated using TCAD simulations and the learning from the simulations is used to efficiently extract the model parameters. The spice simulations with extracted parameters further confirm advantage of CDG on circuit performance.
- 7 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (11) , 4691-4695
Vₜ Extraction Methodologies Influence Process Induced Vₜ Variability: Does This Fact Still Hold for Advanced Technology Nodes?
In this work, we have investigated the influence of Vt extraction procedure on overall Vt variability of sub-10 nm Wfin FinFETs. Using six different Vt extraction techniques, we have experimentally demonstrated that the Vt variability is independent of Vt extraction procedure (unlike reported earlier). Furthermore, through systematic evaluation on commonly used Vt extraction techniques, the physics behind this anomalous behavior is investigated. It is shown that the significant variation in metal gate work-function and gate dielectric charges in advanced CMOS nodes is mainly responsible for this behavior. This claim is further validated for FinFETs with deeply scaled fin-width and effective oxide thickness (EOT).
- 7 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (11) , 4691-4695
Vₜ Extraction Methodologies Influence Process Induced Vₜ Variability: Does This Fact Still Hold for Advanced Technology Nodes?
In this work, we have investigated the influence of Vt extraction procedure on overall Vt variability of sub-10 nm Wfin FinFETs. Using six different Vt extraction techniques, we have experimentally demonstrated that the Vt variability is independent of Vt extraction procedure (unlike reported earlier). Furthermore, through systematic evaluation on commonly used Vt extraction techniques, the physics behind this anomalous behavior is investigated. It is shown that the significant variation in metal gate work-function and gate dielectric charges in advanced CMOS nodes is mainly responsible for this behavior. This claim is further validated for FinFETs with deeply scaled fin-width and effective oxide thickness (EOT).
- 24 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (8) , 3035-3041
Effects of Scaling on Analog FoMs of UTBB FD-SOI MOS Transistors: A Detailed Analysis
In this article, the combined effect of BOX thickness ( ${T}_{\text {BOX}}$ ) and ground-plane (GP) doping ( ${N}_{\text {GP}}$ ) on channel carrier mobility and analog figures of merit (FoMs) is investigated. It is reported that the thin BOX along with higher ${N}_{\text {GP}}$ will limit the electron/hole mobility of ultrathin body and BOX fully depleted silicon-on-insulator (UTBB FD-SOI) MOS transistors. The physics responsible for this observation is discussed in detail. The contrasting behavior of different GPs, the effect of ${T}_{\text {BOX}}$ scaling, and gate-length scaling on device behavior is also analyzed. It is also shown that in advanced UTBB FD-SOI MOS transistors, a tradeoff exists between transistor intrinsic gain, cutoff frequency, and non-linearity. In nMOS transistors, the best intrinsic gain and cut-off frequency can be achieved with ultrathin BOX and n-type GP (or with no GP), whereas the best linearity can be achieved with ultrathin BOX and p-type GP implant.
- 24 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (8) , 3035-3041
Effects of Scaling on Analog FoMs of UTBB FD-SOI MOS Transistors: A Detailed Analysis
In this article, the combined effect of BOX thickness ( ${T}_{\text {BOX}}$ ) and ground-plane (GP) doping ( ${N}_{\text {GP}}$ ) on channel carrier mobility and analog figures of merit (FoMs) is investigated. It is reported that the thin BOX along with higher ${N}_{\text {GP}}$ will limit the electron/hole mobility of ultrathin body and BOX fully depleted silicon-on-insulator (UTBB FD-SOI) MOS transistors. The physics responsible for this observation is discussed in detail. The contrasting behavior of different GPs, the effect of ${T}_{\text {BOX}}$ scaling, and gate-length scaling on device behavior is also analyzed. It is also shown that in advanced UTBB FD-SOI MOS transistors, a tradeoff exists between transistor intrinsic gain, cutoff frequency, and non-linearity. In nMOS transistors, the best intrinsic gain and cut-off frequency can be achieved with ultrathin BOX and n-type GP (or with no GP), whereas the best linearity can be achieved with ultrathin BOX and p-type GP implant.
- 3 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (11) , 4823-4828
Source Underlap—A Novel Technique to Improve Safe Operating Area and Output-Conductance in LDMOS Transistors
- 3 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (11) , 4823-4828
Source Underlap—A Novel Technique to Improve Safe Operating Area and Output-Conductance in LDMOS Transistors
- Open Access
- 12 August 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of the Electron Devices Society
- Vol. 7 (1) , 1217-1224
Analog Performance and its Variability in Sub-10 nm Fin-Width FinFETs: a Detailed Analysis
This paper discusses in detail the effects of Sub-10nm fin-width (Wfin) on the analog performance and variability of FinFETs. It is observed through detailed measurements that the trans-conductance degrades and output conductance improves with the reduction in fin-width. Through different analog performance metrics, it is shown that analog circuit performance, in Sub-10nm Wfin regime, cannot be improved just by Wfin scaling but by optimizing source/drain resistance, gate dielectric thickness together with the Wfin scaling. We also explored the effect of process induced systematic and random variability on trans-conductance and output conductance of FinFETs. A systematic strategy to decouple different variability sources has been discussed and it is shown that mobility, source/drain resistance and oxide thickness are the critical parameters to reduce variability.
- 12 August 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of the Electron Devices Society
- Vol. 7 (1) , 1217-1224
Open AccessAnalog Performance and its Variability in Sub-10 nm Fin-Width FinFETs: a Detailed Analysis
This paper discusses in detail the effects of Sub-10nm fin-width (Wfin) on the analog performance and variability of FinFETs. It is observed through detailed measurements that the trans-conductance degrades and output conductance improves with the reduction in fin-width. Through different analog performance metrics, it is shown that analog circuit performance, in Sub-10nm Wfin regime, cannot be improved just by Wfin scaling but by optimizing source/drain resistance, gate dielectric thickness together with the Wfin scaling. We also explored the effect of process induced systematic and random variability on trans-conductance and output conductance of FinFETs. A systematic strategy to decouple different variability sources has been discussed and it is shown that mobility, source/drain resistance and oxide thickness are the critical parameters to reduce variability.
- 1 March 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Impact of BOX thickness and ground-plane on non-linearity of UTBB FD-SOI MOS transistors
This work investigates, for the first time, the impact of BOX thickness (Tbox) and Ground-plane (GP) on the non-linearity of transistors fabricated using UTBB FD-SOI CMOS technology. By extracting 2nd and 3rd order harmonic distortions, we have shown that the TBOX scaling and GP improve the transistor linearity at lower drain currents (low-power applications) in advanced FD-SOI technology nodes. The physics behind this observation i.e the additional mobility limiting factors, is explained in detail by using well calibrated TCAD simulations.
- 1 March 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Impact of BOX thickness and ground-plane on non-linearity of UTBB FD-SOI MOS transistors
This work investigates, for the first time, the impact of BOX thickness (Tbox) and Ground-plane (GP) on the non-linearity of transistors fabricated using UTBB FD-SOI CMOS technology. By extracting 2nd and 3rd order harmonic distortions, we have shown that the TBOX scaling and GP improve the transistor linearity at lower drain currents (low-power applications) in advanced FD-SOI technology nodes. The physics behind this observation i.e the additional mobility limiting factors, is explained in detail by using well calibrated TCAD simulations.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Split-gate architecture for higher breakdown voltage in STI based LDMOS transistors
Conventional Extended gate STI based LDMOS devices often have an overlap between gate and STI resulting in higher impact ionization at the STI left edge. In this work, we have proposed and analyzed a novel split gate architecture to reduce impact ionization and improve off-state breakdown voltage. The underlying physics behind the improved characteristics of the proposed architecture is explained using detailed TCAD simulations. Finally, necessary design guidelines are provided for proper optimization of the split gate architecture.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Split-gate architecture for higher breakdown voltage in STI based LDMOS transistors
Conventional Extended gate STI based LDMOS devices often have an overlap between gate and STI resulting in higher impact ionization at the STI left edge. In this work, we have proposed and analyzed a novel split gate architecture to reduce impact ionization and improve off-state breakdown voltage. The underlying physics behind the improved characteristics of the proposed architecture is explained using detailed TCAD simulations. Finally, necessary design guidelines are provided for proper optimization of the split gate architecture.
- 1 April 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Impact of substrate on the frequency behavior of trans-conductance in ultrathin body and BOX FDSOI MOS devices - a physical insight
The continuous reduction in the thickness of body and BOX of FDSOI MOS devices (to sustain scaling) have resulted in increased coupling between the top-gate and substrate underneath BOX. In this work, we have reported an increase in small signal trans-conductance (gm) with increase in frequency because of this coupling. This dependence is modulated by changing the substrate doping and BOX thickness. The physical mechanism responsible for this behavior is explained through measurement on different test structures and detailed device simulation.
- 1 April 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Impact of substrate on the frequency behavior of trans-conductance in ultrathin body and BOX FDSOI MOS devices - a physical insight
The continuous reduction in the thickness of body and BOX of FDSOI MOS devices (to sustain scaling) have resulted in increased coupling between the top-gate and substrate underneath BOX. In this work, we have reported an increase in small signal trans-conductance (gm) with increase in frequency because of this coupling. This dependence is modulated by changing the substrate doping and BOX thickness. The physical mechanism responsible for this behavior is explained through measurement on different test structures and detailed device simulation.
- 1 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 448-451
Predictive effective mobility model for FDSOI transistors using technology parameters
The formulation of effective mobility for fully depleted silicon-on-insulator (FDSOI) transistors is a very challenging task. As vertical electric field (Eeff) changes it's sign from positive to negative according to the front and back channel dominance which results in non-unique relationship between Eeff and carrier distribution. This is the first time, when a predictive mobility model for wide range of back gate biases, solely dependent on technology parameters (front and back gate oxide thickness Tox/box, threshold voltage Vth, front/back gate bias Vfg/bg and flat-band voltage Vfb) is proposed. This predictive mobility model allows the user to predict the deviation in device characteristics due to the variations in the device structure.
- 1 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 448-451
Predictive effective mobility model for FDSOI transistors using technology parameters
The formulation of effective mobility for fully depleted silicon-on-insulator (FDSOI) transistors is a very challenging task. As vertical electric field (Eeff) changes it's sign from positive to negative according to the front and back channel dominance which results in non-unique relationship between Eeff and carrier distribution. This is the first time, when a predictive mobility model for wide range of back gate biases, solely dependent on technology parameters (front and back gate oxide thickness Tox/box, threshold voltage Vth, front/back gate bias Vfg/bg and flat-band voltage Vfb) is proposed. This predictive mobility model allows the user to predict the deviation in device characteristics due to the variations in the device structure.