Özgür Er
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Özgür Er has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Emir Esim
Mechatronics Engineering Department, Engineering Faculty, Erciyes University, Kayseri, Turkey
2 shared publications - Gökmen Kurt
Faculty of Dentistry, Department of Orthodontics, Bezmialem Vakif University, Istanbul, Türkiye
2 shared publications - Tuğrul Aslan
Erciyes University
2 shared publications - Veysel Aslantas
Department of Computer Engineering, Erciyes University, Kayseri, Turkey
2 shared publications Ayca Ustdal
Research Assistant, Department of Orthodontics, Faculty of Dentistry, Erciyes University, Kayseri, Turkey
1 shared publication- Ayşe Tuğba Eminsoy Avcı
Department of Endodontics, Faculty of Dentistry, Erciyes University, Kayseri, Turkiye
1 shared publication
Latest Publications
- Open Access
- 10 March 2026
- Published by Springer Nature in BMC Oral Health
- Vol. 26 (1)
Radiographic evaluation of preoperative and postoperative quality of root canal retreatments: a retrospective study
The aim of this study was to examine radiographic quality of root canal fillings retrospectively in teeth undergoing retreatment compared with primary root canal treatment. The radiographic quality of root canal fillings was retrospectively assessed in the preoperative and postoperative stages of retreatment. Seventy-six teeth were included in the study. The radiographic quality of the treatments was evaluated in terms of length, density, and taper, based on the criteria of the European Society of Endodontology (ESE). Across all teeth, 28.9% were classified as having acceptable root canal treatment quality in the preoperative phase, whereas 86.5% were classified as acceptable postoperatively. Moreover, when assessing acceptability for each parameter individually, as well as for all three parameters combined, the postoperative results were significantly more favourable. Within the limitations of this retrospective study, the radiographic quality of root canal retreatments demonstrated a statistically significant improvement postoperatively compared with their preoperative state.
- 10 March 2026
- Published by Springer Nature in BMC Oral Health
- Vol. 26 (1)
Open AccessRadiographic evaluation of preoperative and postoperative quality of root canal retreatments: a retrospective study
The aim of this study was to examine radiographic quality of root canal fillings retrospectively in teeth undergoing retreatment compared with primary root canal treatment. The radiographic quality of root canal fillings was retrospectively assessed in the preoperative and postoperative stages of retreatment. Seventy-six teeth were included in the study. The radiographic quality of the treatments was evaluated in terms of length, density, and taper, based on the criteria of the European Society of Endodontology (ESE). Across all teeth, 28.9% were classified as having acceptable root canal treatment quality in the preoperative phase, whereas 86.5% were classified as acceptable postoperatively. Moreover, when assessing acceptability for each parameter individually, as well as for all three parameters combined, the postoperative results were significantly more favourable. Within the limitations of this retrospective study, the radiographic quality of root canal retreatments demonstrated a statistically significant improvement postoperatively compared with their preoperative state.
- 9 October 2025
- Published by Springer Nature in Clinical Oral Investigations
- Vol. 29 (11) , 1-13
Factors affecting long-term success and survival in non-surgical root canal retreatment; a retrospective cohort study
Objectives This retrospective study aimed to evaluate the long-term (≥ 5 years) survival and success rates of nonsurgical root canal retreatment (NSRT) and to determine the prognostic factors associated with these outcomes. Materials and methods A total of 943 teeth from 740 patients treated with NSRT by two experienced endodontists between January 1, 2015, and January 1, 2020, were reviewed. Based on strict inclusion and exclusion criteria, 408 teeth (376 patients) were included. Clinical and radiographic follow-ups were conducted. Periapical healing was assessed using the periapical index (PAI) by two calibrated examiners. Tooth retention was defined as survival, regardless of periapical status. Treatment success was determined using combined clinical and radiographic criteria. Multivariate logistic regression analysis was used to identify significant predictors. Results A total of 408 teeth (376 patients) that met the inclusion criteria were included. The survival and success rates were 73.5%. Among surviving teeth, the success rate was 79%, after a follow-up of 78.5 ± 10.5 months. Restoration type (p < 0.001) and initial root canal obturation quality (p = 0.007) significantly influenced survival. Root or crown fractures accounted for 66.7% of extractions, with restoration type significantly related to extraction reason (p < 0.001). Success was significantly associated with pre-NSRT obturation quality (p = 0.035) and restoration quality (p < 0.001). Conclusions Coronal restoration quality and initial obturation status appear to be important predictors of long-term NSRT outcomes. Clinical relevance Observational data from routine endodontic practice help clarify long-term retreatment outcomes by revealing survival and success rates and identifying possible prognostic factors over a follow-up of at least five years.
- 9 October 2025
- Published by Springer Nature in Clinical Oral Investigations
- Vol. 29 (11) , 1-13
Factors affecting long-term success and survival in non-surgical root canal retreatment; a retrospective cohort study
Objectives This retrospective study aimed to evaluate the long-term (≥ 5 years) survival and success rates of nonsurgical root canal retreatment (NSRT) and to determine the prognostic factors associated with these outcomes. Materials and methods A total of 943 teeth from 740 patients treated with NSRT by two experienced endodontists between January 1, 2015, and January 1, 2020, were reviewed. Based on strict inclusion and exclusion criteria, 408 teeth (376 patients) were included. Clinical and radiographic follow-ups were conducted. Periapical healing was assessed using the periapical index (PAI) by two calibrated examiners. Tooth retention was defined as survival, regardless of periapical status. Treatment success was determined using combined clinical and radiographic criteria. Multivariate logistic regression analysis was used to identify significant predictors. Results A total of 408 teeth (376 patients) that met the inclusion criteria were included. The survival and success rates were 73.5%. Among surviving teeth, the success rate was 79%, after a follow-up of 78.5 ± 10.5 months. Restoration type (p < 0.001) and initial root canal obturation quality (p = 0.007) significantly influenced survival. Root or crown fractures accounted for 66.7% of extractions, with restoration type significantly related to extraction reason (p < 0.001). Success was significantly associated with pre-NSRT obturation quality (p = 0.035) and restoration quality (p < 0.001). Conclusions Coronal restoration quality and initial obturation status appear to be important predictors of long-term NSRT outcomes. Clinical relevance Observational data from routine endodontic practice help clarify long-term retreatment outcomes by revealing survival and success rates and identifying possible prognostic factors over a follow-up of at least five years.
- 22 December 2024
- Published by Adnan Menderes University in Meandros Medical and Dental Journal
- Vol. 25 (4) , 379-395
FINITE ELEMENT ANALYSIS OF 3D TRANSIENT LINEAR TEMPERATURE CHANGES IN THE PERIODONTAL LIGAMENT DURING THERMOPLASTICIZED GUTTA-PERCHA OBTURATION TECHNIQUES
Objective: This study used finite element analysis to evaluate temperature changes in the periodontal ligament due to various thermoplasticized gutta-percha obturation techniques. Methods: Mandibular premolar models were created in SolidWorks software, simulating carrier-based obturation (CBO) and continuous wave of condensation with backfill obturation (CWC+BFO). Results: Upon analyzing seven models, the study revealed that the CWC+BFO models with the highest temperature settings (Models 4 and 7) recorded the highest maximum temperatures, nearing 127°C. In contrast, the CBO model (Model 1) exhibited the lowest maximum temperature at 47.835°C. These temperatures were primarily measured at the apical region. The duration exceeding 10°C above body temperature was highest in Models 4 and 7. CBO caused a brief 10.835°C rise for 0.43 s, deemed safe, while all CWC+BFO techniques exceeded 10°C above body temperature, lasting up to 14.40 s. Lower temperature settings, particularly during CWC, are recommended for safer CWC+BFO application. Conclusion: The CBO technique caused minimal temperature increase and appears safe. However, the CWC technique with BFO resulted in significantly higher temperatures, potentially harming the periodontal ligament. The authors recommend using lower temperatures with both techniques, especially with the CWC technique, and applying the BFO technique in multiple layers to minimize risks.
- 22 December 2024
- Published by Adnan Menderes University in Meandros Medical and Dental Journal
- Vol. 25 (4) , 379-395
FINITE ELEMENT ANALYSIS OF 3D TRANSIENT LINEAR TEMPERATURE CHANGES IN THE PERIODONTAL LIGAMENT DURING THERMOPLASTICIZED GUTTA-PERCHA OBTURATION TECHNIQUES
Objective: This study used finite element analysis to evaluate temperature changes in the periodontal ligament due to various thermoplasticized gutta-percha obturation techniques. Methods: Mandibular premolar models were created in SolidWorks software, simulating carrier-based obturation (CBO) and continuous wave of condensation with backfill obturation (CWC+BFO). Results: Upon analyzing seven models, the study revealed that the CWC+BFO models with the highest temperature settings (Models 4 and 7) recorded the highest maximum temperatures, nearing 127°C. In contrast, the CBO model (Model 1) exhibited the lowest maximum temperature at 47.835°C. These temperatures were primarily measured at the apical region. The duration exceeding 10°C above body temperature was highest in Models 4 and 7. CBO caused a brief 10.835°C rise for 0.43 s, deemed safe, while all CWC+BFO techniques exceeded 10°C above body temperature, lasting up to 14.40 s. Lower temperature settings, particularly during CWC, are recommended for safer CWC+BFO application. Conclusion: The CBO technique caused minimal temperature increase and appears safe. However, the CWC technique with BFO resulted in significantly higher temperatures, potentially harming the periodontal ligament. The authors recommend using lower temperatures with both techniques, especially with the CWC technique, and applying the BFO technique in multiple layers to minimize risks.
- 4 April 2019
- Published by Galenos Yayinevi in Turkish Journal of Orthodontics
- Vol. 32 (1) , 22-27
Effects of High-Energy Curing Lights on Time-Dependent Temperature Changes of Pulp Space During Orthodontic Bonding
Turkish Journal of Orthodontics, turkjorthod
- 4 April 2019
- Published by Galenos Yayinevi in Turkish Journal of Orthodontics
- Vol. 32 (1) , 22-27
Effects of High-Energy Curing Lights on Time-Dependent Temperature Changes of Pulp Space During Orthodontic Bonding
Turkish Journal of Orthodontics, turkjorthod
- Open Access
- 30 December 2018
- Published by Zeus Publishing in International Dental Research
- Vol. 8 (3) , 105-110
Effects of the geometric shape and placing length of a fiber post on the stress distribution in a mandibular premolar tooth: A finite element analysis study
Aim: The aim of this study was to evaluate the effects of two geometrically different fiber post systems and two different placing lengths on the stress distribution of endodontically treated teeth. Methodology: Four different mandibular premolar tooth models were created. These models were restored using oval or circular fiber posts with two different placing lengths. An oblique force of 300 N was applied to the top of the tooth, and von Mises stress evaluations were carried out on the dentin tissue, luting cement, and fiber posts. Results: The maximum von Mises stresses were observed in the 10-mm long circular fiber post model, while the minimum stresses were seen in the 5-mm long oval fiber post model. In general, the oval fiber post models presented more homogeneous stresses than the circular fiber post models. Moreover, the 10-mm long fiber post models generated greater von Mises stresses than the 5-mm long fiber post models in the dentin tissue and luting cement. Conclusion: According to the study findings, the use of oval fiber posts at both placing lengths is suggested for oval shaped root canals due to the lower stress concentrations.
- 30 December 2018
- Published by Zeus Publishing in International Dental Research
- Vol. 8 (3) , 105-110
Open AccessEffects of the geometric shape and placing length of a fiber post on the stress distribution in a mandibular premolar tooth: A finite element analysis study
Aim: The aim of this study was to evaluate the effects of two geometrically different fiber post systems and two different placing lengths on the stress distribution of endodontically treated teeth. Methodology: Four different mandibular premolar tooth models were created. These models were restored using oval or circular fiber posts with two different placing lengths. An oblique force of 300 N was applied to the top of the tooth, and von Mises stress evaluations were carried out on the dentin tissue, luting cement, and fiber posts. Results: The maximum von Mises stresses were observed in the 10-mm long circular fiber post model, while the minimum stresses were seen in the 5-mm long oval fiber post model. In general, the oval fiber post models presented more homogeneous stresses than the circular fiber post models. Moreover, the 10-mm long fiber post models generated greater von Mises stresses than the 5-mm long fiber post models in the dentin tissue and luting cement. Conclusion: According to the study findings, the use of oval fiber posts at both placing lengths is suggested for oval shaped root canals due to the lower stress concentrations.
- 13 March 2017
- Published by Springer Nature in Journal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie
- Vol. 78 (4) , 330-337
Thermal imaging of the pulp during residual adhesive removal
The aim of this study was to evaluate the temperature changes of the pulpal area during different adhesive clean-up procedures.
- 13 March 2017
- Published by Springer Nature in Journal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie
- Vol. 78 (4) , 330-337
Thermal imaging of the pulp during residual adhesive removal
The aim of this study was to evaluate the temperature changes of the pulpal area during different adhesive clean-up procedures.
- 1 November 2009
- Published by Elsevier in American Journal of Orthodontics and Dentofacial Orthopedics
- Vol. 136 (5) , 689-694
Can intracoronally bleached teeth be bonded safely?
- 1 November 2009
- Published by Elsevier in American Journal of Orthodontics and Dentofacial Orthopedics
- Vol. 136 (5) , 689-694
Can intracoronally bleached teeth be bonded safely?