JJJobin D. John

Jobin D. John

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jobin D. John has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Finite Element Human Body Models to study Sex-differences in Whiplash Injury: Validation of VIVA+ passive response in rear-impact

    by Jobin John, I. P. A. Putra, Johan Iraeus

    Neck whiplash injury in rear impact is known to affect females more than males. However, there is a lack of female human body models (HBM) to study whiplash. This paper reports the low-speed passive head-neck kinematic response of a new lineup of models representing an average female and an average male, called VIVA+. The female model serves as the baseline model in the HBM lineup, and the male model is a morphed derivative from the base model. The head-neck kinematics of these two models were evaluated at multiple levels: from cervical spine functional spine unit (FSU) level to head-neck response to mini-sled rear impacts, and finally, whole-body response to rear-impacts. In general, the female FSU were more compliant in moment-rotation responses. In the head-neck mini-sled simulation, the female upper-cervical spine segments responded with more flexion than male segments, resulting in a more pronounced S-Curve formation. In the whole-body rear impact, although the head responded with rearward retraction and rotation and so also T1 with smaller magnitudes, these responses showed considerable differences when compared to the experiments. This could be attributed to the uncertainties in posture and anthropometrical characteristics of the post-mortem human subjects. These evaluations serve as the first step toward providing models to study sex-differences in whiplash injury risks.


  • Open Access

    Hello, World! VIVA+: A Human Body Model lineup to evaluate Sex-Differences in Crash Protection

    by Jobin John, Corina Klug, Matej Kranjec, Erik Svenning, Johan Iraeus

    Finite element Human Body Models are increasingly becoming vital tools for injury assessment and are expected to play an important role in virtual vehicle safety testing. With the aim of realizing models to study sex-differences seen in the injury- and fatality-risks from epidemiology, we developed models that represent an average female and an average male. The models were developed with an objective to allow tissue-based skeletal injury assessment, and thus non-skeletal organs and joints were defined with simplified characterizations to enhance computational efficiency and robustness. The model lineup comprises female and male representations of (seated) vehicle occupants and (standing) vulnerable road users, enabling the safety assessment of broader segments of the road user population. In addition, a new workflow utilized in the model development is presented. In this workflow, one model (the seated female) served as the base model while all the other models were generated as closely-linked derivative models, differing only in terms of node coordinates and mass distribution. This approach opens new possibilities to develop and maintain further models as part of the model lineup, representing different types of road users to reflect the ongoing transitions in mobility patterns (like bicyclists and e-scooter users). In this paper, we evaluate the kinetic and kinematic responses of the occupant and standing models to blunt impacts, mainly on the torso, in different directions (front, lateral, and back). The front and lateral impacts to the thorax showed responses comparable to the experiments, while the back impact varied with the location of impact (T1 and T8). Abdomen bar impact showed a stiffer load-deflection response at higher intrusions beyond 40 mm, because of simplified representation of internal organs. The lateral shoulder impact responses were also slightly stiffer, presumably from the simplified shoulder joint definition. This paper is the first in a series describing the development and validation of the new Human Body Model lineup, VIVA+. With the inclusion of an average-sized female model as a standard model in the lineup, we seek to foster an equitable injury evaluation in future virtual safety assessments.


  • Influence of cervical spine sagittal alignment on range of motion after corpectomy: a finite element study

    by Jobin D. John, Gurunathan Saravana Kumar, Narayan Yoganandan, Vedantam Rajshekhar

    Background Sagittal alignment of the cervical spine might influence the development of radiological adjacent segment pathology (RASP) after central corpectomy (CC). Range of motion (ROM) of the adjacent segments is closely linked to the development of RASP. Methods To investigate the ROM of the adjacent segments after CC, we developed a C2-T1 finite element (FE) model. The model with a lordotic sagittal alignment served as the baseline model. Models with straight and kyphotic alignment were generated using mesh morphing methods. Single-level corpectomy at C5 was done on these models. Segmental ROMs of intact and corpectomized spines were compared for physiologic flexion-extension loads. Results The flexion ROM decreased by an average of 13% with the change in sagittal alignment from lordosis to kyphosis; however, a consistent decrease was not observed in extension. After CC, the ROM increased by an average of 95% and 31% in the superior and inferior adjacent segments. With kyphotic change in the sagittal alignment, the postoperative increase in flexion ROM exhibited a decreasing trend, while this was not seen in extension. Conclusions Kyphotic changes of the intact spine resulted in segmental stiffening, and after corpectomy, it resulted in inconsistent variations of segmental extension ROMs.


  • Influence of morphological variations on cervical spine segmental responses from inertial loading

    by Jobin D. John, Narayan Yoganandan, Mike W. J. Arun, G. Saravana Kumar

    Objectives: The objective of this study was to investigate the influence of morphological variations in osteoligamentous lower cervical spinal segment responses under postero-anterior inertial loading. Methods: A parametric finite element model of the C5–C6 spinal segment was used to generate models. Variations in the vertebral body and facet depth (anteroposterior), posterior process length, intervertebral disc height, facet articular process height and slope, segment orientation ranging from lordotic to straight, and segment size were parameterized. These variations included male–female differences. A Latin hypercube sampling method was used to select parameter values for model generation. Forces and moments associated with the inertial loading were applied to the generated model segments. The 7 parameters were grouped as local or global depending on the number of spinal components involved in the shape variation. Four output responses representing overall segmental and soft tissue responses were analyzed for each model variation: response angle of the segment, anterior longitudinal ligament stretch, anterior capsular ligament stretch, and facet joint compression in the posterior region. Pearson's correlation coefficient was used to compute the correlations of these output responses with morphological variations. Results: Fifty models were generated from the parameterized model using a Latin hypercube sampling technique. Variation in response angle among the models was 4° and was most influenced by change in the combined dimension of vertebral body and facet depth, followed by size of the segment. The maximum anterior longitudinal ligament stretch varied between 0.1 and 0.3 and was strongly influenced by the change in the segment orientation. The anterior facet joint region sustained tension, whereas the posterior region sustained compression. For the anterior capsular ligament stretch, the most influential global variation was segment orientation, whereas the most influential local variations were the facet height and facet angle parameters. In the case of posterior facet joint compression, segment orientation was again most influential, whereas among the local variations, the facet angle had the most influence. Conclusion: Shape variations in the intervertebral disc influenced segmental rotation and ligament responses; however, the influence of shape variations in the facet joint was confined to capsular ligament responses. Response angle was most influenced by the vertebral body depth variations, explaining greater segmental rotations in female spines. Straighter spine segments sustained greater posterior facet joint compression, which may offer an explanation for the higher incidence of whiplash-associated disorders among females, who exhibit a straighter cervical spine. The anterior longitudinal ligament stretch was also greater in straighter segments. These findings indicate that the morphological features specific to the anatomy of the female cervical spine may predispose it to injury under inertial loading.