Chun-Kai Tseng
Research Subjects
Chun-Kai Tseng has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Sau-Hsuan Wu
Institute of Communications Engineering, College of Electrical and Computer Engineering, National Yang Ming Chiao Tung University, Hsinchu, Taiwan
3 shared publications Chai-Hien Gan
1 shared publicationHsi-Lu Chao
1 shared publication- Tony Q. S. Quek
Singapore University of Technology and Design
1 shared publication
Latest Publications
- 19 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 18 (9) , 4283-4297
Effective Service Architecture and Antenna Allocation Mechanism for CoMP Transmissions in Ultra Dense Networks
- 19 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 18 (9) , 4283-4297
Effective Service Architecture and Antenna Allocation Mechanism for CoMP Transmissions in Ultra Dense Networks
- 5 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 67 (1) , 124-139
Selective and Opportunistic AF Relaying for Cooperative ARQ: An MLSD Perspective
Selective and opportunistic amplified-and-forward (SOAF) relaying has been shown more effective than the typical opportunistic AF (OAF) relaying for cooperative automatic repeat request (ARQ). The key to exploit the diversity potential of SOAF ARQ lies in a proper quality control mechanism for the relayed signals. Although quality control methods have been proposed from the viewpoint of capacity outage probability, the methods are shown herein not enough for SOAF ARQ to exploit the full diversity in packet error rates (PERs). Reinvestigating the quality control problem from the perspective of maximum likelihood sequence detection (MLSD), our analysis shows that the PERs can attain the full spatial diversity offered by relays in every ARQ round only if the thresholds to control the received signal qualities of the forwarding relays increase with the signal-to-noise ratio (SNR). Sufficient conditions on the thresholds settings are proposed, which explicitly characterize the relationship among the threshold requirements, the SNR, and the minimum codeword distance of the employed channel code. An effective threshold searching algorithm is further developed for SOAF ARQ to exploit both the diversity and the SNR gains in PER. Simulations with trellis codes also verify our analysis and the effectiveness of the proposed quality control method.
- 5 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 67 (1) , 124-139
Selective and Opportunistic AF Relaying for Cooperative ARQ: An MLSD Perspective
Selective and opportunistic amplified-and-forward (SOAF) relaying has been shown more effective than the typical opportunistic AF (OAF) relaying for cooperative automatic repeat request (ARQ). The key to exploit the diversity potential of SOAF ARQ lies in a proper quality control mechanism for the relayed signals. Although quality control methods have been proposed from the viewpoint of capacity outage probability, the methods are shown herein not enough for SOAF ARQ to exploit the full diversity in packet error rates (PERs). Reinvestigating the quality control problem from the perspective of maximum likelihood sequence detection (MLSD), our analysis shows that the PERs can attain the full spatial diversity offered by relays in every ARQ round only if the thresholds to control the received signal qualities of the forwarding relays increase with the signal-to-noise ratio (SNR). Sufficient conditions on the thresholds settings are proposed, which explicitly characterize the relationship among the threshold requirements, the SNR, and the minimum codeword distance of the employed channel code. An effective threshold searching algorithm is further developed for SOAF ARQ to exploit both the diversity and the SNR gains in PER. Simulations with trellis codes also verify our analysis and the effectiveness of the proposed quality control method.
- 9 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 67 (3) , 2382-2397
Effective Protocols and Channel Quality Control Mechanisms for Cooperative ARQ With Opportunistic AF Relaying
Incorporating relaying techniques into Automatic Repeat reQuest (ARQ) in general will provide diversity and throughput enhancements. However, when opportunistic amplify-and-forward (AF) relaying is applied to cooperative ARQ, the system design becomes much more involved. First, our capacity outage analysis shows that the temporal diversities of ARQs with a single AF relay cannot be exploited unless the channel quality to the relay exceeds a threshold that depends on the source data rate requirement. This notion of selective AF relaying is extended to systems with multiple relays in an attempt to jointly explore the temporal and spatial diversities with ARQ. Two types of selective and opportunistic AF (SOAF) relaying schemes are then developed for such kinds of relay-assisted ARQ. And our analysis further shows that the temporal and spatial diversities cannot be fully exploited without the use of overhearing among relays and a proper link quality control mechanism to pre-screen the overheard signals. This quality control mechanism is implemented with a set of thresholds designed for each hop of the relaying path. Feasible threshold setting methods are also developed for the proposed ARQ protocols to achieve their potential diversities. In contrast to our designs, the ARQ scheme with the typical opportunistic AF relaying method suffers from severe diversity losses. Simulations also show that the proposed ARQ schemes are more effective in throughput enhancement, and can provide cell-edge users almost three times the throughput gain in comparison with ARQ with no relay-assisted forwarding.
- 9 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 67 (3) , 2382-2397
Effective Protocols and Channel Quality Control Mechanisms for Cooperative ARQ With Opportunistic AF Relaying
Incorporating relaying techniques into Automatic Repeat reQuest (ARQ) in general will provide diversity and throughput enhancements. However, when opportunistic amplify-and-forward (AF) relaying is applied to cooperative ARQ, the system design becomes much more involved. First, our capacity outage analysis shows that the temporal diversities of ARQs with a single AF relay cannot be exploited unless the channel quality to the relay exceeds a threshold that depends on the source data rate requirement. This notion of selective AF relaying is extended to systems with multiple relays in an attempt to jointly explore the temporal and spatial diversities with ARQ. Two types of selective and opportunistic AF (SOAF) relaying schemes are then developed for such kinds of relay-assisted ARQ. And our analysis further shows that the temporal and spatial diversities cannot be fully exploited without the use of overhearing among relays and a proper link quality control mechanism to pre-screen the overheard signals. This quality control mechanism is implemented with a set of thresholds designed for each hop of the relaying path. Feasible threshold setting methods are also developed for the proposed ARQ protocols to achieve their potential diversities. In contrast to our designs, the ARQ scheme with the typical opportunistic AF relaying method suffers from severe diversity losses. Simulations also show that the proposed ARQ schemes are more effective in throughput enhancement, and can provide cell-edge users almost three times the throughput gain in comparison with ARQ with no relay-assisted forwarding.