GSGregory M. Stiehl

Gregory M. Stiehl

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Gregory M. Stiehl has a total of 26 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Layer-dependent spin-orbit torques generated by the centrosymmetric transition metal dichalcogenide β−MoTe2

    by Gregory M. Stiehl, Ruofan Li, Vishakha Gupta, Ismail El Baggari, Shengwei Jiang, Hongchao Xie, Lena F. Kourkoutis, Kin Fai Mak, Jie Shan, Robert A. Buhrman, et al.

    Single-crystal materials with sufficiently low crystal symmetry and strong spin-orbit interactions can be used to generate novel forms of spin-orbit torques on adjacent ferromagnets, such as the out-of-plane antidamping torque previously observed in WTe2/ferromagnet heterostructures. Here, we present measurements of spin-orbit torques produced by the low-symmetry material β−MoTe2, which, unlike WTe2, retains bulk inversion symmetry. We measure spin-orbit torques on β−MoTe2/Permalloy heterostructures using spin-torque ferromagnetic resonance as a function of crystallographic alignment and MoTe2 thickness down to the monolayer limit. We observe an out-of-plane antidamping torque with a spin-torque conductivity as strong as 1/3 of that of WTe2, demonstrating that the breaking of bulk inversion symmetry in the spin-generation material is not a necessary requirement for producing an out-of-plane antidamping torque. We also measure an unexpected dependence on the thickness of the β−MoTe2—the out-of-plane antidamping torque is present in MoTe2/Permalloy heterostructures when the β−MoTe2 is a monolayer or trilayer thick, but goes to zero for devices with bilayer β−MoTe2.


  • Current-Induced Torques with Dresselhaus Symmetry Due to Resistance Anisotropy in 2D Materials

    by Gregory M. Stiehl, David MacNeill, Nikhil Sivadas, Ismail El Baggari, Marcos H. D. Guimarães, Neal D. Reynolds, Lena F. Kourkoutis, Craig J. Fennie, Robert A. Buhrman, Daniel C. Ralph

    We report measurements of current-induced torques in heterostructures of Permalloy (Py) with TaTe2, a transition-metal dichalcogenide (TMD) material possessing low crystal symmetry, and observe a torque component with Dresselhaus symmetry. We suggest that the dominant mechanism for this Dresselhaus component is not a spin-orbit torque, but rather the Oersted field arising from a component of current that flows perpendicular to the applied voltage due to resistance anisotropy within the TaTe2. This type of transverse current is not present in wires made from a single uniform layer of a material with resistance anisotropy, but will result whenever a material with resistance anisotropy is integrated into a heterostructure with materials having different resistivities, thereby producing a spatially non-uniform pattern of current flow. This effect will therefore influence measurements in a wide variety of heterostructures incorporating 2D TMD materials and other materials with low crystal symmetries.


  • Atomic-resolution Cryo-STEM Imaging of a Structural Phase Transition in TaTe2

    by Ismail El Baggari, Gregory M. Stiehl, Jacob Waelder, Daniel C. Ralph, Lena F. Kourkoutis


  • Open Access

    Code-division multiplexing for x-ray microcalorimeters

    by G. M. Stiehl, W. B. Doriese, J. W. Fowler, G. C. Hilton, K. D. Irwin, C. D. Reintsema, D. R. Schmidt, D. S. Swetz, J. N. Ullom, L. R. Vale

    We demonstrate the code-division multiplexing (CDM) readout of eight transition-edge sensor microcalorimeters. The energy resolution is 3.0 eV (full width at half-maximum) or better at 5.9 keV, with a best resolution of 2.3 eV and a mean of 2.6 eV over the seven modulated detectors. The flux-summing CDM system is described and compared with similar time-division multiplexing (TDM) readout. We show that the Npixels multiplexing disadvantage associated with TDM is not present in CDM. This demonstration establishes CDM as both a simple route to higher performance in existing TDM microcalorimetric experiments and a long-term approach to reaching higher multiplexing factors.