Patricia Martín Rodríguez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Patricia Martín Rodríguez has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Vivian Beatriz Elena Parnás
CUJAE, Department of Civil Engineering
4 shared publications - Bruno Clavelo
KU Leuven, Department of Civil Engineering
2 shared publications - Federica Tubino
University of Genoa
2 shared publications - Ingrid Fernández Lorenzo
Universidad Tecnológica de la Havana José Antonio Echeverría
2 shared publications - Kristof Maes
KU Leuven
2 shared publications - A. A. El Damatty
Western University
1 shared publication
Latest Publications
- Open Access
- 17 November 2026
- Published by Springer Nature
- p. 81-95
The Use of Experimentally Determined Aerodynamic Coefficients for the Reconstruction of Wind Loads on Antenna Masts
- 17 November 2026
- Published by Springer Nature
- p. 81-95
Open AccessThe Use of Experimentally Determined Aerodynamic Coefficients for the Reconstruction of Wind Loads on Antenna Masts
- 23 November 2025
- Published by Springer Nature
- p. 235-247
Advancing Performance-Based Wind Design: Bridging the Gap Between Seismic Insights and Novel Strategies for Tall Building Resilience
- 23 November 2025
- Published by Springer Nature
- p. 235-247
Advancing Performance-Based Wind Design: Bridging the Gap Between Seismic Insights and Novel Strategies for Tall Building Resilience
- 1 November 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 151 (11)
Experimental Evaluation of the Aerodynamic Coefficients of an Antenna Mast by Wind Tunnel Tests
- 1 November 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 151 (11)
Experimental Evaluation of the Aerodynamic Coefficients of an Antenna Mast by Wind Tunnel Tests
- Open Access
- 30 December 2019
- Published by Editorial CSIC in Informes de la Construcción
- Vol. 70 (552) , e274
Estudio comparativo de normas para el análisis dinámico de una torre autosoportada bajo carga de viento
El estudio de los métodos de análisis dinámicos para la consideración de la carga de viento es de gran importancia en las torres autosoportadas de telecomunicaciones debido a que son estructuras altamente vulnerables a los vientos extremos. En Cuba el análisis de las torres autosoportadas se realiza según lo establecido en la norma cubana de viento NC-285:2003 (NC). Esta norma es de carácter general para todas las edificaciones y no presenta las particularidades del análisis de las torres reticuladas bajo carga de viento por esta razón es necesario evaluar sus diferencias con respecto a otras normas internacionales. El presente trabajo tiene como objetivo comparar los valores de fuerzas en los elementos y desplazamientos en una torre autosoportada obtenidos de la aplicación de los métodos de análisis propuestos en las normas NC, ISO 4354- 2009 (ISO), AS/NZS1170.2-2011 (AS/NZ) y EC3: 2007 (EC3). La comparación entre las normas arrojó como resultado que las fuerzas axiales y desplazamientos obtenidos por la norma NC son menores que las obtenidos por las normas ISO, AS/NZ, EC3.
- 30 December 2019
- Published by Editorial CSIC in Informes de la Construcción
- Vol. 70 (552) , e274
Open AccessEstudio comparativo de normas para el análisis dinámico de una torre autosoportada bajo carga de viento
El estudio de los métodos de análisis dinámicos para la consideración de la carga de viento es de gran importancia en las torres autosoportadas de telecomunicaciones debido a que son estructuras altamente vulnerables a los vientos extremos. En Cuba el análisis de las torres autosoportadas se realiza según lo establecido en la norma cubana de viento NC-285:2003 (NC). Esta norma es de carácter general para todas las edificaciones y no presenta las particularidades del análisis de las torres reticuladas bajo carga de viento por esta razón es necesario evaluar sus diferencias con respecto a otras normas internacionales. El presente trabajo tiene como objetivo comparar los valores de fuerzas en los elementos y desplazamientos en una torre autosoportada obtenidos de la aplicación de los métodos de análisis propuestos en las normas NC, ISO 4354- 2009 (ISO), AS/NZS1170.2-2011 (AS/NZ) y EC3: 2007 (EC3). La comparación entre las normas arrojó como resultado que las fuerzas axiales y desplazamientos obtenidos por la norma NC son menores que las obtenidos por las normas ISO, AS/NZ, EC3.
- Open Access
- 1 June 2018
- Published by Universidad Catolica de la Santisima Concepcion in Obras Y Proyectos
- No. 23,p. 78-86
Análisis dinámico de una torre autosoportada sujeta a cargas de viento y sismo
Self-supporting towers are structures that require special attention under the dynamic actions generated by wind loads and seismic loads. Three approaches can be identified for the dynamic analysis of these structures: equivalent static methods, methods in the frequency domain and methods in the time domain. The development of computation in recent decades has made easier the applications of complex dynamic analysis methods, such as the time domain method, that can be solved by means of modal superposition or direct integration techniques. Given the coexistence in the literature of both techniques in the analysis of the self-supported towers, the present work aims to compare the response in terms of displacements and support reactions, of a self-supported tower under the action of dynamic loads of wind and earthquake, using modal superposition and direct integration. The results of the application of both techniques showed differences of less than 2% in the values of support reactions and the displacements of the tower. The procedure based on modal superposition is more efficient since it consumes less time and computational memory.
- 1 June 2018
- Published by Universidad Catolica de la Santisima Concepcion in Obras Y Proyectos
- No. 23,p. 78-86
Open AccessAnálisis dinámico de una torre autosoportada sujeta a cargas de viento y sismo
Self-supporting towers are structures that require special attention under the dynamic actions generated by wind loads and seismic loads. Three approaches can be identified for the dynamic analysis of these structures: equivalent static methods, methods in the frequency domain and methods in the time domain. The development of computation in recent decades has made easier the applications of complex dynamic analysis methods, such as the time domain method, that can be solved by means of modal superposition or direct integration techniques. Given the coexistence in the literature of both techniques in the analysis of the self-supported towers, the present work aims to compare the response in terms of displacements and support reactions, of a self-supported tower under the action of dynamic loads of wind and earthquake, using modal superposition and direct integration. The results of the application of both techniques showed differences of less than 2% in the values of support reactions and the displacements of the tower. The procedure based on modal superposition is more efficient since it consumes less time and computational memory.
- Open Access
- 3 April 2013
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 35 (2) , 61-67
Structural behavior of guyed mast with asymmetrical anchors
- 3 April 2013
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 35 (2) , 61-67
Open AccessStructural behavior of guyed mast with asymmetrical anchors