Maximiliano Andrés Zensich
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Maximiliano Andrés Zensich has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Gustavo Marcelo Morales
Universidad Nacional de Río Cuarto
4 shared publications - A. Rozenblit
Instituto de Química de Los Materiales, Ambiente y Energía (INQUIMAE), UBA-CONICET, Pabellón II, Ciudad, , Ciudad Autónoma de Buenos Aires, Argentina
1 shared publication Adrian Marcelo Granero
1 shared publication- Alvaro Yamil Tesio
Centro de Investigación y Desarrollo en Materiales Avanzados y Almacenamiento de Energía de Jujuy (CIDMEJu) Centro de Desarrollo Tecnológico General Manuel Savio Av. Martijena W/N Y4612 Palpalá Argentina
1 shared publication - Cristina Elena Hoppe
UNMDP‐CONICET Instituto de Investigaciones en Ciencia y Tecnología de Materiales (INTEMA) Mar del Plata Argentina
1 shared publication César A. Barbero
1 shared publication
Latest Publications
- 6 August 2025
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 13 (5)
Chemical modification of graphene oxide for CO2 capture: Impact on structure, defects, and adsorption behavior
- 6 August 2025
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 13 (5)
Chemical modification of graphene oxide for CO2 capture: Impact on structure, defects, and adsorption behavior
- 1 June 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (6) , 063512
Electrodialysis of LiH 2 PO 4 for High-Purity LiOH and Green H 2 Production
The current soda-lime evaporation process to recover lithium carbonate from continental brines by treatment with Solvay has a low efficiency due to the high solubility of Li 2 CO 3 , unlike precipitation of Li 3 PO 4 after removal of alkaline earth cations, which has a very high efficiency. The main goal of this work is to provide a proof of concept for replacing the present method of LiOH.H 2 O production, i.e. replacing the reaction of Li 2 CO 3 with Ca(OH) 2 , by a single step electrodialysis of LiH 2 PO 4 from insoluble Li 3 PO 4 with no waste generation, recycling of phosphoric acid, better efficiency than the lithium carbonate pathway and green hydrogen generation. Experimental results have been complemented with numerical simulation of the electro-dialysis system solving the time-dependent concentration and potential profiles for two configurations: two compartments using a cation-selective membrane and a three-compartment cell with cation and anion-selective membranes operating at constant current, along with the voltage evolution and current efficiency for LiOH production.
- 1 June 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (6) , 063512
Electrodialysis of LiH 2 PO 4 for High-Purity LiOH and Green H 2 Production
The current soda-lime evaporation process to recover lithium carbonate from continental brines by treatment with Solvay has a low efficiency due to the high solubility of Li 2 CO 3 , unlike precipitation of Li 3 PO 4 after removal of alkaline earth cations, which has a very high efficiency. The main goal of this work is to provide a proof of concept for replacing the present method of LiOH.H 2 O production, i.e. replacing the reaction of Li 2 CO 3 with Ca(OH) 2 , by a single step electrodialysis of LiH 2 PO 4 from insoluble Li 3 PO 4 with no waste generation, recycling of phosphoric acid, better efficiency than the lithium carbonate pathway and green hydrogen generation. Experimental results have been complemented with numerical simulation of the electro-dialysis system solving the time-dependent concentration and potential profiles for two configurations: two compartments using a cation-selective membrane and a three-compartment cell with cation and anion-selective membranes operating at constant current, along with the voltage evolution and current efficiency for LiOH production.
- 4 June 2019
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 35 (26) , 8732-8740
Improving the Electropolymerization Properties of Fluorene-Bridged Dicarbazole Monomers through Polyfluoroalkyl Side Chains
The facile functionalization of the fluorene scaffold at the 2,7-positions was utilized to provide access to two soluble carbazole-π-carbazole derivatives CFC-H1 and CFC-F1 featuring fully hydrogenated- and polyfluorinated alkyl chains at the 9-position of the fluorene π-bridging unit, respectively. The optical and electrochemical properties of the new dicarbazoles were investigated. Their electrochemical polymerization over Pt and indium tin oxide electrodes allowed the generation of electro-active polymeric films, which physicochemical characteristics were strongly dependent on the kind of alkyl chain present on the fluorene bridge. In particular, the electropolymerization of the polyfluorinated monomer allowed the fabrication of thin films with good electrical conductivity, reversible electrochemical processes, electrochromic properties and enhanced water repellency with respect to its non-fluorinated analog
- 4 June 2019
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 35 (26) , 8732-8740
Improving the Electropolymerization Properties of Fluorene-Bridged Dicarbazole Monomers through Polyfluoroalkyl Side Chains
The facile functionalization of the fluorene scaffold at the 2,7-positions was utilized to provide access to two soluble carbazole-π-carbazole derivatives CFC-H1 and CFC-F1 featuring fully hydrogenated- and polyfluorinated alkyl chains at the 9-position of the fluorene π-bridging unit, respectively. The optical and electrochemical properties of the new dicarbazoles were investigated. Their electrochemical polymerization over Pt and indium tin oxide electrodes allowed the generation of electro-active polymeric films, which physicochemical characteristics were strongly dependent on the kind of alkyl chain present on the fluorene bridge. In particular, the electropolymerization of the polyfluorinated monomer allowed the fabrication of thin films with good electrical conductivity, reversible electrochemical processes, electrochromic properties and enhanced water repellency with respect to its non-fluorinated analog
- 1 February 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 296, 243-250
A top-down approach to build Li2S@rGO cathode composites for high-loading lithium–sulfur batteries in carbonate-based electrolyte
- 1 February 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 296, 243-250
A top-down approach to build Li2S@rGO cathode composites for high-loading lithium–sulfur batteries in carbonate-based electrolyte
- 21 January 2019
- Published by Royal Society of Chemistry (RSC) in Molecular Systems Design & Engineering
- Vol. 4 (1) , 133-143
PEG-based cross-linked films with aligned channels: combining cryogenic processing and photopolymerization for the design of micro-patterned oriented platforms
Liquid flow along single channels occurs on micro-patterned polymeric platforms prepared by directional freezing and photopolymerization.
- 21 January 2019
- Published by Royal Society of Chemistry (RSC) in Molecular Systems Design & Engineering
- Vol. 4 (1) , 133-143
PEG-based cross-linked films with aligned channels: combining cryogenic processing and photopolymerization for the design of micro-patterned oriented platforms
Liquid flow along single channels occurs on micro-patterned polymeric platforms prepared by directional freezing and photopolymerization.
- 1 December 2016
- Published by Elsevier in Journal of Electroanalytical Chemistry
- Vol. 783, 258-267
Characterization of the surface redox process of caffeic acid adsorbed at glassy carbon electrodes modified with partially reduced graphene oxide
- 1 December 2016
- Published by Elsevier in Journal of Electroanalytical Chemistry
- Vol. 783, 258-267
Characterization of the surface redox process of caffeic acid adsorbed at glassy carbon electrodes modified with partially reduced graphene oxide