Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Anna Maria Łoboda has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Seasonal dynamics of macroplastic transport and accumulation in an urban lowland stream: the role of flash flood hydrology and riparian vegetation

    by Łukasz Przyborowski, Anna Łoboda, Weronika Skorupa, Luca Gallitelli

    Urban streams are increasingly recognized as dynamic reservoirs of macroplastic pollution, where short-lived hydrological events and riparian vegetation jointly regulate plastic transport and storage. However, the seasonal variability of macroplastic accumulation in small urban rivers remains poorly quantified. In this study, we investigated year-round macroplastic dynamics in a 100-m stream reach, combining monthly field surveys and water-level monitoring. Throughout the monitoring year, 67% of recorded macroplastic items were classified as new items transported by river flow. This ratio peaked at 100% in May and June, following numerous high-water events. This indicates that episodic flood events represented the dominant mechanism driving plastic redistribution within the stream corridor. However, the highest number of new accumulated flow-transported macroplastics for most vegetation classes was in the autumn season, following senescence and a change in vegetation structure, which was the best period for macroplastic trapping efficiency. The dense reed belts (Phragmites australis) showed the highest accumulation density among vegetation types (0.94 items/m2), despite covering a smaller area than grass-dominated habitats. Those results highlight the importance of vegetation structure in controlling plastic interception, which is subject to seasonal changes. Our findings demonstrate that macroplastic storage in urban streams results from the interaction between flashy hydrological regimes and seasonally changing vegetation filters. Incorporating hydrological event monitoring and vegetation characteristics into plastic pollution assessments is therefore essential to accurately quantify riverine plastic retention and to identify nature-based solutions for reducing downstream plastic transport.

  • Open Access

    Effect of two distinct patches of Myriophyllum species on downstream turbulence in a natural river

    by Łukasz Przyborowski, Anna Maria Łoboda, Robert Józef Bialik


  • Flow field downstream of individual aquatic plants—Experiments in a natural river with Potamogeton crispus L. and Myriophyllum spicatum L.

    by Łukasz Przyborowski, Anna Maria Łoboda, Robert Józef Bialik, Kaisa Västilä


  • Open Access

    Two Simultaneously Occurring Potamogeton Species: Similarities and Differences in Seasonal Changes of Biomechanical Properties

    by Anna Maria Łoboda, Robert Józef Bialik, Mikołaj Karpiński, Łukasz Przyborowski

    Two common Potamogeton species, Potamogeton pectinatus L. and Potamogeton crispus L., were collected in 2016 and 2017 from a lowland, sandy bed in the Wilga River in Poland to investigate the ability of the plants to adapt to changing hydrological conditions. Measurements included biomechanical properties as well as the morphological characteristics of their stems. Specifically, experiments included three-point bending and tension tests as well as stem diameter and cross-sectional morphology at various periods in the plants’ life cycles. Detailed information about the seasonal changes in biomechanical traits and the similarities between the two investigated plants are presented. The data show significant differences in the three-point bending and tension parameters. The flexural rigidity proved to be the most sensitive parameter to changes in hydrological conditions during the season. The maximum forces in the three-point bending tests needed to complete the fracture of P. crispus were much higher, reaching values up to 0.097 N, than those for P. pectinatus (0.035 N), due to P. crispus having thicker shoots, which resulted in greater resistance to elastic deformity. Moreover, the modulus of elasticity values shows that P. pectinatus is much more prone to return to its original shape after the removal of the acting forces. For instance, the maximum Young’s modulus for P. pectinatus was 116.23 MPa, whereas for P. crispus, the highest value was four times lower (26.60 MPa). The present study supplements an aquatic plant biomechanics database that has been created in recent years.


  • Open Access

    Experimental Investigations of Interactions between Sand Wave Movements, Flow Structure, and Individual Aquatic Plants in Natural Rivers: A Case Study of Potamogeton Pectinatus L.

    by Łukasz Przyborowski, Anna Maria Łoboda, Robert Józef Bialik

    Long-duration measurements were performed in two sandy bed rivers, and three-dimensional (3D) flow velocity and bottom elevation changes were measured in a vegetated area and in a clear region of a river. Detailed flow velocity profiles downstream and upstream of a single specimen of Potamogeton pectinatus L. were obtained and the bed morphology was assessed. Potamogeton plants gathered from each river were subjected to tensile and bending tests. The results show that the existence of the plants was influenced by both bottom and flow conditions, as the plants were located where water velocity was lower by 12% to 16% in comparison to clear region. The characteristics of the flow and sand forms depended on the cross-sectional arrangement of the river, e.g., dunes were approximately four times higher in the middle of the river than in vegetated regions near the bank. Furthermore, the studied hydrophytes were too sparse to affect water flow and had no discernible impact on the sand forms’ movements. The turbulent kinetic energy downstream of a single plant was reduced by approximately 25%. Additionally, the plants’ biomechanical characteristics and morphology were found to have adjusted to match the river conditions.


  • Seasonal changes in the biomechanical properties of Elodea canadensis Michx.

    by Anna Maria Łoboda, Robert Józef Bialik, Mikołaj Karpiński, Łukasz Przyborowski


  • Open Access

    On the Relationship between Aquatic Plant Stem Characteristics and Drag Force: Is a Modeling Application Possible?

    by Anna Maria Łoboda, Mikołaj Karpiński, Robert Józef Bialik

    This paper presents a basic model that shows the relationship between the diameter of a stem and its flexural rigidity. The model was developed from experimental measurements of biomechanical traits (i.e., tensile and bending traits like maximum forces, stresses, moduli of elasticity, flexural rigidity, strain) of three freshwater macrophyte species (Elodea canadensis Michx., Potamogeton pectinatus L., and P. crispus L.), reflecting the seasonal changes in plant biomechanics throughout the vegetative season. These were obtained with the use of a bench-top testing machine in 2016 and 2017. The presented calculations are based on the ratio of drag-to-bending forces, in which the flexural rigidity plays a key role. The proposed model has the form EI = adb, and two approaches based on a regression analysis were applied to determine the parameters of the model—a and b. In the first method, the parameters were identified separately for each day of measurement, while in the second method, the coefficient b was calculated for all data from all days as a unified number for individual plants. The results suggest that coefficient b may provide information about the proportion of changes in drag forces depending on plant stiffness. The values of this coefficient were associated with the shape of the stem cross-section. The more circular the cross-section, the closer the value of the parameter was to 1. The parameter values were 1.60 for E. canadensis, 1.98 for P. pectinatus, and 2.46 for P. crispus. Moreover, this value also depended on the density of the cross-section structure. Most of the results showed that with an increase in stem diameter, the ratio between the drag and bending forces decreased, which led to fewer differences between these two forces. The model application may be introduced in many laboratory measurements of flow–biota interactions as well as in aquatic plant management applications. The implementation of these results in control methods for hydrophytes may help in mitigating floods caused by increases to a river channel’s resistance due to the occurrence of plants.


  • Biomechanical properties of aquatic plants: The effect of test conditions

    by A. M. Łoboda, Ł. Przyborowski, M. Karpiński, R. J. Bialik, V. I. Nikora

    Four aquatic plants (i.e.,Potamogeton pectinatusL.,Potamogeton crispusL.,Myriophyllum spicatumL., andCeratophyllum demersumL.) that commonly grow in European lowland rivers and lakes and exhibit a variety of morphologies and differences in the internal structures of their stem cross sections were selected to investigate the influence of initial conditions on biomechanical tests. A new method of sample testing in wet conditions is proposed and employed using a bench‐top testing machine. The obtained biomechanical characteristics, such as breaking strain, force, and stress; Young's modulus; flexural strain; flexural rigidity; and flexural modulus are presented and discussed. Even when fresh specimens were kept in water before testing in air, their biomechanical parameters were sensitive to fast drying. If the turgor pressure was not maintained in dry tests, specimen stiffness was not preserved and the measured biomechanical properties deviated from those observed in wet conditions. Approximately 43% of the three‐point bending tests and 20% of the tension tests showed significant differences between dry and wet conditions in all considered plant species. Bending tests for both conditions performed onP. pectinatusL. andP. crispusL. showed the highest differences in flexural rigidity values, reflecting the adaptation of these plants to changing hydraulic conditions. Stem resistance to tension forces in terms of Young's modulus was found to be different for wet and dry conditions only forP. pectinatusL. Overall, it was revealed that plants constantly submerged in water tend to be stiffer than plants exposed to dry conditions.