Dániel Molnár
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Dániel Molnár has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
Botond Sánta
Department of Physics, Budapest University of Technology and Economics, Budafoki út 8, H-1111 Budapest, Hungary
2 shared publications- Miklós Csontos
Institute of Electromagnetic Fields ETH Zurich Gloriastrasse 35 Zurich 8092 Switzerland
2 shared publications Agnes Gubicza
Department of Physics, Budapest University of Technology and Economics, Budafoki út 8, H-1111 Budapest, Hungary
1 shared publication- Agnes Gubicza
Department of Physics, Budapest University of Technology and Economics, Budafoki ut 8, 1111 Budapest, Hungary.
1 shared publication András Halbritter
Department of Physics, Budapest University of Technology and Economics, Budafoki ut 8, 1111 Budapest, Hungary and MTA-BME Condensed Matter Research Group, Budafoki ut 8, 1111 Budapest, Hungary
1 shared publication- András Halbritter
Department of Physics Institute of Physics Budapest University of Technology and Economics Műegyetem rkp. 3. H-1111 Budapest Hungary
1 shared publication
Latest Publications
- Open Access
- 8 January 2020
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 11 (1) , 92-100
Nanosecond resistive switching in Ag/AgI/PtIr nanojunctions
Nanometer-scale resistive switching devices operated in the metallic conductance regime offer ultimately scalable and widely reconfigurable hardware elements for novel in-memory and neuromorphic computing architectures. Moreover, they exhibit high operation speed at low power arising from the ease of the electric-field-driven redistribution of only a small amount of highly mobile ionic species upon resistive switching. We investigate the memristive behavior of a so-far less explored representative of this class, the Ag/AgI material system in a point contact arrangement established by the conducting PtIr tip of a scanning probe microscope. We demonstrate stable resistive switching duty cycles and investigate the dynamical aspects of non-volatile operation in detail. The high-speed switching capabilities are explored by a custom-designed microwave setup that enables time-resolved studies of subsequent set and reset transitions upon biasing the Ag/AgI/PtIr nanojunctions with sub-nanosecond voltage pulses. Our results demonstrate the potential of Ag-based filamentary memristive nanodevices to serve as the hardware elements in high-speed neuromorphic circuits.
- 8 January 2020
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 11 (1) , 92-100
Open AccessNanosecond resistive switching in Ag/AgI/PtIr nanojunctions
Nanometer-scale resistive switching devices operated in the metallic conductance regime offer ultimately scalable and widely reconfigurable hardware elements for novel in-memory and neuromorphic computing architectures. Moreover, they exhibit high operation speed at low power arising from the ease of the electric-field-driven redistribution of only a small amount of highly mobile ionic species upon resistive switching. We investigate the memristive behavior of a so-far less explored representative of this class, the Ag/AgI material system in a point contact arrangement established by the conducting PtIr tip of a scanning probe microscope. We demonstrate stable resistive switching duty cycles and investigate the dynamical aspects of non-volatile operation in detail. The high-speed switching capabilities are explored by a custom-designed microwave setup that enables time-resolved studies of subsequent set and reset transitions upon biasing the Ag/AgI/PtIr nanojunctions with sub-nanosecond voltage pulses. Our results demonstrate the potential of Ag-based filamentary memristive nanodevices to serve as the hardware elements in high-speed neuromorphic circuits.
- Open Access
- 1 October 2018
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 10 (41) , 19290-19296
In situ impedance matching in Nb/Nb2O5/PtIr memristive nanojunctions for ultra-fast neuromorphic operation
We demonstrate Nb2O5 memristive devices with tuneable low-bias resistances and optimized high-bias impedance for high speed neuromorphic operation.
- 1 October 2018
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 10 (41) , 19290-19296
Open AccessIn situ impedance matching in Nb/Nb2O5/PtIr memristive nanojunctions for ultra-fast neuromorphic operation
We demonstrate Nb2O5 memristive devices with tuneable low-bias resistances and optimized high-bias impedance for high speed neuromorphic operation.
- 1 September 2010
- Published by World Scientific Pub Co Pte Ltd in Fluctuation and Noise Letters
- Vol. 09 (03) , 277-287
INCREASING CHEMICAL SELECTIVITY OF CARBON NANOTUBE-BASED SENSORS BY FLUCTUATION-ENHANCED SENSING
Nowadays gas detection in the ppm and sub-ppm domain is essential in terms of environmental protection as well as reducing sanitary risks. However, detecting systems to perform these measurements (e.g., gas chromatographs) are expensive and take up too much space, thus their use is not likely to become wide-spread. Small, cheap and easily mountable sensors, such as resistive sensors are more applicable for this purpose. But the main disadvantage of these sensors is the lack of chemical selectivity. Yet, a novel method called fluctuation-enhanced sensing (FES), which considers the sensor noise as the source of chemical information, can be used to improve selectivity. Since carbon nanotube (CNT)-based sensors are regarded as promising devices for FES measurements, we investigated whether stationary fluctuations in output signal (dc-resistance) of a CNT sensor could be used to increase chemical selectivity. In this work we prove that FES is applicable to increase selectivity of CNT sensors: air polluting gases ( N2O , NH 3 and H2S ) and their mixtures can be distinguished. Furthermore, we also show that different concentrations of the same analyte can be differentiated and chemical selectivity can be extended into the sub-ppm region.
- 1 September 2010
- Published by World Scientific Pub Co Pte Ltd in Fluctuation and Noise Letters
- Vol. 09 (03) , 277-287
INCREASING CHEMICAL SELECTIVITY OF CARBON NANOTUBE-BASED SENSORS BY FLUCTUATION-ENHANCED SENSING
Nowadays gas detection in the ppm and sub-ppm domain is essential in terms of environmental protection as well as reducing sanitary risks. However, detecting systems to perform these measurements (e.g., gas chromatographs) are expensive and take up too much space, thus their use is not likely to become wide-spread. Small, cheap and easily mountable sensors, such as resistive sensors are more applicable for this purpose. But the main disadvantage of these sensors is the lack of chemical selectivity. Yet, a novel method called fluctuation-enhanced sensing (FES), which considers the sensor noise as the source of chemical information, can be used to improve selectivity. Since carbon nanotube (CNT)-based sensors are regarded as promising devices for FES measurements, we investigated whether stationary fluctuations in output signal (dc-resistance) of a CNT sensor could be used to increase chemical selectivity. In this work we prove that FES is applicable to increase selectivity of CNT sensors: air polluting gases ( N2O , NH 3 and H2S ) and their mixtures can be distinguished. Furthermore, we also show that different concentrations of the same analyte can be differentiated and chemical selectivity can be extended into the sub-ppm region.