Kyohei Otani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kyohei Otani has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Masatoshi Sakairi
Faculty of Engineering, Hokkaido University
2 shared publications - Takahiro Igarashi
Nuclear Science and Engineering Center, Japan Atomic Energy Agency
2 shared publications A. Kaneko
Nikkei Research & Development Center, Nippon Light Metal Co. Ltd
1 shared publication- Akihiro Okamoto
Research Center for Macromolecules and Biomaterials, National Institute for Materials Science
1 shared publication Akira Kaneko
Nikkei Research & Development Center Nippon Light Metal Co. Ltd. Shizuoka Japan
1 shared publicationChiaki Kato
Japan Atomic Energy Agency, 2-4 Shirakata, Tokai-mura, Ibaraki, 319-1195, Japan
1 shared publication
Latest Publications
- 1 September 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (9) , 091503
Effect of Liquid Film Thickness and Flow Velocity on the Cathodic Reaction of Carbon Steel Under Liquid Film Flow Conditions
This study examines how liquid film thickness and flow velocity affect the cathodic reaction rate of carbon steel under flowing liquid film conditions, relevant to the Fukushima Daiichi Nuclear Power Station environment. Liquid film flow equipment was developed, enabling independent control of film thickness (200–1000 μm) and flow velocity (0.3–1.3 m s−1). Carbon steel and pure silver electrodes were tested using electrochemical methods to clarify the effects of oxygen transport under different flow conditions. The cathodic limiting current density increased with increased flow velocity and decreased film thickness. However, for carbon steel, the experimental limiting current density associated with changes in flow velocity was different from the theoretical value, mainly because corrosion products formed on the electrode surface. Corrosion products hinder the transport of oxygen, and the increase in flow velocity suppresses the increase in limiting current density. In contrast, the experimental values for pure silver, which does not produce corrosion products, were close to the theoretical values.
- 1 September 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (9) , 091503
Effect of Liquid Film Thickness and Flow Velocity on the Cathodic Reaction of Carbon Steel Under Liquid Film Flow Conditions
This study examines how liquid film thickness and flow velocity affect the cathodic reaction rate of carbon steel under flowing liquid film conditions, relevant to the Fukushima Daiichi Nuclear Power Station environment. Liquid film flow equipment was developed, enabling independent control of film thickness (200–1000 μm) and flow velocity (0.3–1.3 m s−1). Carbon steel and pure silver electrodes were tested using electrochemical methods to clarify the effects of oxygen transport under different flow conditions. The cathodic limiting current density increased with increased flow velocity and decreased film thickness. However, for carbon steel, the experimental limiting current density associated with changes in flow velocity was different from the theoretical value, mainly because corrosion products formed on the electrode surface. Corrosion products hinder the transport of oxygen, and the increase in flow velocity suppresses the increase in limiting current density. In contrast, the experimental values for pure silver, which does not produce corrosion products, were close to the theoretical values.
- Open Access
- 15 November 2024
- Published by Iron and Steel Institute of Japan in Tetsu-to-Hagane
- Vol. 110 (15) , 1244-1250
Evaluation of Corrosion on Steel Surface Using Image Processing
Using two types of image processing techniques without machine learning, edge extraction processing and keypoint extraction processing, progressively corroded regions under the rust layer from images of corroded steel surfaces was extracted. We found that there was a relatively good correlation between the keypoint strength obtained from the keypoint extraction processing for HSL transformed and histogram flattened corroded surface images and the corrosion depth after rust removal.
- 15 November 2024
- Published by Iron and Steel Institute of Japan in Tetsu-to-Hagane
- Vol. 110 (15) , 1244-1250
Open AccessEvaluation of Corrosion on Steel Surface Using Image Processing
Using two types of image processing techniques without machine learning, edge extraction processing and keypoint extraction processing, progressively corroded regions under the rust layer from images of corroded steel surfaces was extracted. We found that there was a relatively good correlation between the keypoint strength obtained from the keypoint extraction processing for HSL transformed and histogram flattened corroded surface images and the corrosion depth after rust removal.
- 18 September 2023
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 79 (11) , 1277-1286
Synergistic Effect of Aluminum Lactate and Sodium Molybdate on Freshwater Corrosion of Carbon Steel Under Irradiation
In this study, a corrosion inhibitor suitable for the corrosion inhibition of primary containment vessels at the Fukushima Daiichi Nuclear Power Station is investigated. Considering the internal environment of the primary containment vessels, the corrosion inhibitor should inhibit the freshwater corrosion of carbon steel under irradiation and should not come under effluent standards in Japan. Herein, a corrosion inhibitor was devised by combining Al lactate and Na molybdate that met the above conditions, and its corrosion mechanism was investigated. It was found that 0.75 mM Al lactate and 0.25 mM Na molybdate were the most inhibitive to the corrosion of carbon steel. As Al lactate has never been reported as a corrosion inhibitor for metallic materials, it could be developed as a novel corrosion inhibitor in this study. The corrosion inhibitor inhibited the freshwater corrosion of carbon steel even under gamma irradiation of 200 Gy/h. Al and molybdate ions in the solution formed a metal cation layer on carbon steel with few defects and without iron. This metal cation layer inhibited both the cathodic oxygen reduction reaction and the anodic iron dissolving reaction, thereby enhancing the corrosion protection of carbon steel in freshwater.
- 18 September 2023
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 79 (11) , 1277-1286
Synergistic Effect of Aluminum Lactate and Sodium Molybdate on Freshwater Corrosion of Carbon Steel Under Irradiation
In this study, a corrosion inhibitor suitable for the corrosion inhibition of primary containment vessels at the Fukushima Daiichi Nuclear Power Station is investigated. Considering the internal environment of the primary containment vessels, the corrosion inhibitor should inhibit the freshwater corrosion of carbon steel under irradiation and should not come under effluent standards in Japan. Herein, a corrosion inhibitor was devised by combining Al lactate and Na molybdate that met the above conditions, and its corrosion mechanism was investigated. It was found that 0.75 mM Al lactate and 0.25 mM Na molybdate were the most inhibitive to the corrosion of carbon steel. As Al lactate has never been reported as a corrosion inhibitor for metallic materials, it could be developed as a novel corrosion inhibitor in this study. The corrosion inhibitor inhibited the freshwater corrosion of carbon steel even under gamma irradiation of 200 Gy/h. Al and molybdate ions in the solution formed a metal cation layer on carbon steel with few defects and without iron. This metal cation layer inhibited both the cathodic oxygen reduction reaction and the anodic iron dissolving reaction, thereby enhancing the corrosion protection of carbon steel in freshwater.
- Open Access
- 25 January 2022
- Published by MDPI AG in Microorganisms
- Vol. 10 (2) , 270
Novel Methanobacterium Strain Induces Severe Corrosion by Retrieving Electrons from Fe0 under a Freshwater Environment
Methanogens capable of accepting electrons from Fe0 cause severe corrosion in anoxic conditions. In previous studies, all iron-corrosive methanogenic isolates were obtained from marine environments. However, the presence of methanogens with corrosion ability using Fe0 as an electron donor and their contribution to corrosion in freshwater systems is unknown. Therefore, to understand the role of methanogens in corrosion under anoxic conditions in a freshwater environment, we investigated the corrosion activities of methanogens in samples collected from groundwater and rivers. We enriched microorganisms that can grow with CO2/NaHCO3 and Fe0 as the sole carbon source and electron donor, respectively, in ground freshwater. Methanobacterium sp. TO1, which induces iron corrosion, was isolated from freshwater. Electrochemical analysis revealed that strain TO1 can uptake electrons from the cathode at lower than −0.61 V vs SHE and has a redox-active component with electrochemical potential different from those of other previously reported methanogens with extracellular electron transfer ability. This study indicated the corrosion risk by methanogens capable of taking up electrons from Fe0 in anoxic freshwater environments and the necessity of understanding the corrosion mechanism to contribute to risk diagnosis.
- 25 January 2022
- Published by MDPI AG in Microorganisms
- Vol. 10 (2) , 270
Open AccessNovel Methanobacterium Strain Induces Severe Corrosion by Retrieving Electrons from Fe0 under a Freshwater Environment
Methanogens capable of accepting electrons from Fe0 cause severe corrosion in anoxic conditions. In previous studies, all iron-corrosive methanogenic isolates were obtained from marine environments. However, the presence of methanogens with corrosion ability using Fe0 as an electron donor and their contribution to corrosion in freshwater systems is unknown. Therefore, to understand the role of methanogens in corrosion under anoxic conditions in a freshwater environment, we investigated the corrosion activities of methanogens in samples collected from groundwater and rivers. We enriched microorganisms that can grow with CO2/NaHCO3 and Fe0 as the sole carbon source and electron donor, respectively, in ground freshwater. Methanobacterium sp. TO1, which induces iron corrosion, was isolated from freshwater. Electrochemical analysis revealed that strain TO1 can uptake electrons from the cathode at lower than −0.61 V vs SHE and has a redox-active component with electrochemical potential different from those of other previously reported methanogens with extracellular electron transfer ability. This study indicated the corrosion risk by methanogens capable of taking up electrons from Fe0 in anoxic freshwater environments and the necessity of understanding the corrosion mechanism to contribute to risk diagnosis.
- 1 June 2021
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 62 (6) , 763-769
Analysis for the Mechanism of Accelerated Corrosion on Low Alloy Steel in Air-Solution Alternating Condition
In this study, the iron rust layer formed on the low alloy steel under air-solution alternating conditions was investigated by cross-sectional observation and analysis, and the mechanism of the accelerated corrosion of the steel under alternating conditions was clarified. The observations and analysis showed that the multilayered iron rust layer composed of the red rust layer (γ-FeOOH), rust crust layer (Fe3O4), inner crystal (Fe3O4), and inner rust layer was formed on the low alloy steel. It can be considered that the multilayered iron rust layer accelerated the cathodic reaction rate of dissolved oxygen under alternating conditions. This acceleration is the reason why the corrosion rate of the low alloy steel under alternating conditions was accelerated. This Paper was Originally Published in Japanese in Zairyo-to-Kankyo 68 (2019) 205–211.
- 1 June 2021
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 62 (6) , 763-769
Analysis for the Mechanism of Accelerated Corrosion on Low Alloy Steel in Air-Solution Alternating Condition
In this study, the iron rust layer formed on the low alloy steel under air-solution alternating conditions was investigated by cross-sectional observation and analysis, and the mechanism of the accelerated corrosion of the steel under alternating conditions was clarified. The observations and analysis showed that the multilayered iron rust layer composed of the red rust layer (γ-FeOOH), rust crust layer (Fe3O4), inner crystal (Fe3O4), and inner rust layer was formed on the low alloy steel. It can be considered that the multilayered iron rust layer accelerated the cathodic reaction rate of dissolved oxygen under alternating conditions. This acceleration is the reason why the corrosion rate of the low alloy steel under alternating conditions was accelerated. This Paper was Originally Published in Japanese in Zairyo-to-Kankyo 68 (2019) 205–211.
- 4 February 2019
- Published by Wiley in Surface and Interface Analysis
- Vol. 51 (12) , 1207-1213
Auger electron spectroscopic analysis of corrosion products formed on A3003 aluminum alloy in model fresh water with different Zn 2+ concentration
The corrosion morphology and composition of corrosion products of A3003 formed in model fresh water with different Zn 2+ concentrations were investigated by immersion tests combined with surface observations and analysis using an Auger electron spectroscope (AES). The cross‐sectional AES observations showed that the thickness of the corrosion product layer formed on A3003 decreases with increases in the Zn 2+ concentration of the model fresh water. A cross‐sectional AES point analysis suggested that the corrosion products formed on the A3003 in the Zn 2+ containing model fresh water (Zn 2+ > 0.1 mM) have a multilayered structure and that the inner of Zn‐rich layer would have high corrosion protective properties.
- 4 February 2019
- Published by Wiley in Surface and Interface Analysis
- Vol. 51 (12) , 1207-1213
Auger electron spectroscopic analysis of corrosion products formed on A3003 aluminum alloy in model fresh water with different Zn 2+ concentration
The corrosion morphology and composition of corrosion products of A3003 formed in model fresh water with different Zn 2+ concentrations were investigated by immersion tests combined with surface observations and analysis using an Auger electron spectroscope (AES). The cross‐sectional AES observations showed that the thickness of the corrosion product layer formed on A3003 decreases with increases in the Zn 2+ concentration of the model fresh water. A cross‐sectional AES point analysis suggested that the corrosion products formed on the A3003 in the Zn 2+ containing model fresh water (Zn 2+ > 0.1 mM) have a multilayered structure and that the inner of Zn‐rich layer would have high corrosion protective properties.
- 29 September 2013
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 18 (2) , 325-332
Effect of metal cations on corrosion behavior and surface film structure of the A3003 aluminum alloy in model tap waters
- 29 September 2013
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 18 (2) , 325-332
Effect of metal cations on corrosion behavior and surface film structure of the A3003 aluminum alloy in model tap waters